• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.1
• /
• pp.219-226
• /
• 2000

In this paper, we design and implement a IF(intermediate frequency) module for WLL(wireless local loop) CDMA(code division multiple access) basestation. The implemented IF transceiver is consists of transmitter, receiver and local oscillator. The considered signal bandwidth is 10 MHz and the local carrier frequency is 40 MHz. As test results, the If transmitter output power is -5dBm $\pm3dB$when the baseband input is -10dBm $\pm3dB$, and the IF receiver output power is -10dBm $\pm3dB$when the IF input is -5dBm $\pm3dB$. Also the AGC(automatic gain control) circuit has dynamic range of 9 dB from -7dBm to +2dBm with output power 2dBm. And the group delay characteristic is analyzed by comparing the phase delay from 1 MHz to 5 MHz and the phase distortion is very low. We can conclude that this IF system can be applied to high speed data rate communication system.

• Journal of the Korea Society of Computer and Information
• /
• v.9 no.4 s.32
• /
• pp.185-189
• /
• 2004

In this paper, designed a diode detector and a log chip detector for mobile communication, and its application is proposed by compared results. In practice, fabricated a diode detector have showed detection voltage of $0{\sim}0.7V$ to RF input power of $-40dBm{\sim}-10dBm$, therefore it has suitable characteristic for small variable signal detection. And a log chip detector have showed wide dynamic range of 65dB, and $1.5{\sim}4.5V$ detection voltage to RF input power of $-65dBm{\sim}0dBm$. therefore we have found that it suit peak power measurement because it had insensible output detection voltage.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.2
• /
• pp.134-139
• /
• 2004

A clock recovery circuit for a 40 Gb/s optical receiver has been designed and implemented. The clock recovery circuit consists of pre-amplifiers, a nonlinear circuit with diodes, a bandpass filter and a clock amplifier. Before implementing the 40 Gb/s clock recovery circuit, a 10 Gb/s clock recovery circuit has been successfully implemented and tested. With the 40 Gb/s clock recovery circuit, when a 40 Gb/s signal of -10 dBm was applied to the input of the circuit, the 40 GHz clock was recovered with the -20 dBm output power after passing through the nonlinear circuit. The output signal from the nonlinear circuit passes through a narrow-band filter, and then amplified. The implemented clock recovery circuit is planned to be used for the input of a phase locked loop to further stabilize the recovered clock signal and to reduce the clock jitter.

• Journal of Sericultural and Entomological Science
• /
• v.40 no.2
• /
• pp.105-110
• /
• 1998

The baculovirus egt gene encodes an ecdysteroid UDP-glucosyltransferase(EGT) which catalyzes the transfer of glucose from UDP-glucose to the insect moltion hormone ecdysteroid resulting in a functionally inactive ecdysteroid. In baculovirus-infected insect larvae, EGT has been shown block molting and pupation. In this study, we compared the development of 4th and 5th instar silkworm, Bombyx mori, larvae injected with either wild-type bombyx mori nucleopolyhedrovirus (BmNPV) or a mutant BmNPV(BmEGTZ) in which the egt gene was disrupted by the insertion of a lacZ gene cassette. Larvae injected with BmEGTZ died roughly 12 h more rapidly compared to indentical larvae infected with BmNPV. In addition, BmEGTZ- infected larvae prematurely stopped feeding and gain less weight compared to BmNPV-infected larvae. In order to investigate why BmEGTZ-infected larvae died more rapidly than BmNPV-infected larvae, the array of hemolymph proteins in BmEGTZ-or BmNPV-infected larvae were analyzed by SDS-PAGE. The hemolymph of BmEGTZ-infected larvae showed virus-specific proteins, including polyhedrin, about 12 h earlier than the hemolymph of BmNPV-infected larvae

• Journal of Advanced Navigation Technology
• /
• v.27 no.6
• /
• pp.849-854
• /
• 2023

In this paper, a high-efficiency power amplifier was designed by applying the operating point Class J using LDMOS(laterally diffused metal oxide semiconductor) and optimizing the output matching circuit so that the second harmonic impedance becomes the reactance impedance. The designed power amplifier has a frequency of 108 ~ 110 MHz, Characteristics of PAE(power added efficiency) is 71.5% at P_SAT output (54.5 dBm), 55.5% at P_1dB output (51.5 dBm), and 24.38% at 45 dBm. The CSB(carrier with sideband) amplifier, which is the reference signal in the spatial modulation method, has an operating output of 45 dBm ~ 35 dBm, and linear SDM(sum in the depth of modulation) characteristics(40% ± 0.3%) were obtained. We measure the characteristics in amplitude modulation according to the bias operating point of the power amplifier for CSB and propose the optimal operating point to obtain linear modulation characteristics.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.29 no.2
• /
• pp.145-152
• /
• 2014

The variation in the level of immune response related gene expression in silkworm, Bombyx mori following infection with Bombyx mori nucleopolyhedrovirus (BmNPV) was analyzed at different time intervals. The occlusion bodies of BmNPV orally inoculated to the two most divergent silkworm races viz., Sarupat (resistant to BmNPV infection) and CSR2 (susceptible to BmNPV infection) were subjected to oral BmNPV inoculation. The expression profile of gp 41 gene of BmNPV in the Sarupat and CSR2 races revealed that the virus could invade the midguts of both susceptible and resistant races. However, its multiplication was significantly less in the midgut of resistant race, while, in the susceptible race, the viral multiplication reached maximum level within 12 h. These findings indicate that potential host genes are involved in the inhibition of viral multiplication within larval midgut. The immune response genes arylphorin, cathepsin B, gloverin, lebocin, serpin, Hsp 19.9, Hsp 20.1, Hsp 20.4, Hsp 20.8, Hsp 21.4, Hsp 23.7, Hsp 40, Hsp 70, Hsp90 revealed differential level of expression on NPV infection. The gloverin, serpin, Hsp 23.7 and Hsp 40 genes are significantly up-regulated in the resistant race after NPV infection. The early up-regulation of these genes suggests that these genes could play an important role in baculovirus resistance in the silkworm, B. mori.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.9 no.1
• /
• pp.35-40
• /
• 2004

Bombyx mori densonucleosis virus type 1 (BmDNV1)- a non occluded virus causes flacherie disease in the susceptible stocks of the silkworm, Bombyx mori. However, some stocks are non-susceptible. Non-susceptibility to BmDNV1 in B. mori is a unique case where the virus infection is completely inhibited by a single gene of the host. A survey conducted by this institute in some parts of Karnataka state has revealed that, 43.05% of the total incidence of flacherie disease caused by non-occluded viruses, are due to the synergistic infection of B. mori densonucleosis and infectious flacherie virus. Earlier study indicated that rearing of BmDNV1 resistant silkworm stock is effective in protecting silkworm against BmIFV also. In the present study the response of 78 silkworm stocks which include 42 of non-diapausing and 36 of diapausing groups, to BmDNV1 is investigated. Newly ecdysed third instar larvae were inoculated per-os with 10% inoculum of BmDNV1 extracted from the mid-gut of infected silkworm. One non-diapausing and three diapausing silkworm stocks were found to be resistant to BmDNV1. Eleven silkworm stocks were found to possess moderate resistance whereas rest sixty three were found to be susceptible to BmDNV1. Genetic analysis has shown that the resistance to BmDNV1 is autosomally inherited and controlled by a major dominant or a major recessive gene in different silkworm stocks. These resistant stocks can be utilized as the resource material to develop BmDNV1 resistant commercial hybrids. The selection strategies, depending upon the mode of inheritance of resistance in the resource material chosen, are discussed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.12 s.115
• /
• pp.1240-1248
• /
• 2006

This paper presents an UHF band(911 MHz) RFID tag antenna which has near-isotropic radiation pattern and easy conjugate impedance matching characteristics to any commercial chips of usual practice through the application of an inductively-coupled feeding. The proposed antenna of compact size $40{\times}46mm\;(0.12{\times}0.14{\lambda})$ has, at normal incidence, the maximum RCS of $-18.5dBm^2$ and the 3 dB RCS bandwidth of 9 MHz(1 %) in case of short chip load. It has the maximum and minimum RCS' of $-16.9dBm^2\;and\;-21.4dBm^2$ depending on the incident angles. The difference of about 4.5 dB is relatively small compared with that (about 70 dB) of a pure dipole antenna. The designed antenna has been fabricated and its RCS' have been measured varying the angles of incidence. The measured RCS' have been found to have good agreement with the simulated ones.

• Journal of Advanced Navigation Technology
• /
• v.8 no.2
• /
• pp.184-190
• /
• 2004

A feedforward linear power amplifier (FLPA) has been developed for UHF-band RFID reader applications. The main and error amplifiers are composed of a 2 stage so that linearity of the FLPA can be improved. The FLPA has been implemented on an FR-4 substrate (Er=4.7 and thickness=0.8 mm) with 3-dB and 10-dB hybrid couplers for input/output power divider and combiner. For 2-tone measurement (input level=-11 dBm at $f_1$=915 MHz and $f_2$=916 MHz), the FLPA exhibits a -18.52 dBm of $IMD_3$, which indicates that $IMD_3$ cancellation with feedforward loop is more than 27 dB. From 890 to 960 MHz, 1-dB gain compression output power and power gain of the FLPA are higher than 30 dBm and 40 dB, respectively.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.4
• /
• pp.506-511
• /
• 2011

In this paper, a rectenna for wireless power transmission at 900MHz is proposed. Rectenna is a device transforming RF power into DC power and it may consist of a antenna, rectifying and charging circuits. In this paper, we designed a slot antenna to receive 900MHz signal, a rectifying circuit of about 40% efficiency at 0dBm input, and a charging circuit to store a weak power signal and supply constant voltage to load. From the experiment using a RFID reader as a transmitter for 1W power, it was found that the proposed rectenna receiving about 0dBm power can supply 3.3V constant voltage to 50$k{\Omega}$ load during 280sec.