• Journal of Korean Society of Transportation
• /
• v.33 no.2
• /
• pp.182-191
• /
• 2015

The Korean government introduced an automated speed enforcement system (ASES), which uses traffic enforcement cameras, to counteract safety issues that are caused by speeding. As the information of the traffic enforcement camera locations is provided to the drivers via navigation systems and mobile applications in a timely manner, drivers can avoid enforcement by momentarily diminishing their speeds only near the camera locations. To prevent drivers' evasional behavior and improve the effectiveness of ASES, section control, which enforces speeding vehicles by measuring their average travel speeds over a stretch of road and checking against the speed limit, has been recently implemented. In this study, Section Speed Enforcement Zone and Comparison Zone are compared in terms of traffic stream characteristics under free flow conditions. To this end, loop detector data were obtained from the three study sites and analyzed. The study results demonstrated that drivers maintain their speeds below the speed limit over the enforcement section with a lower variance of speeds.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.13 no.4
• /
• pp.12-19
• /
• 2014

A signal plan focused on vehicle traffic could easily overlook vulnerable priority signals, although the importance of vulnerable movements is increasingly recognized in recent years. Especially, the vulnerable are sometimes faced with dangerous situations when crossing roads with a signal plan based on design values of average, non-vulnerable persons. This study is focused on how to minimize the vehicle delay while simultaneously considering traffic flow and providing traffic safety by increasing road crossing time for pedestrians. For this purpose, a priority signal control strategy for the vulnerable, considering vehicle traffic flow, has been tested. Practical implication and a microscopic computer simulation has shown that the proposed method could provide a small decrease (about 6.2%) in pedestrian delay, a small increase (about 8.5~13.3%) in travel speed of passing traffic, and a considerable decrease (16.2~26.9%) in vehicle travel time. These findings suggest that the proposed signal control strategy could increase pedestrian safety and diminish delay of vehicle travel.

• Journal of Korean Society of Transportation
• /
• v.30 no.1
• /
• pp.59-72
• /
• 2012

In aspects of traffic operation, a climbing lane may cause traffic congestion if the volume of traffic (v/c) grows and the ratio of heavy vehicle increases. Conversely, it would be effective, if the climbing lane is dynamically operated according to changes in traffic flow. However, there are no guideline to effectively control this climbing lane in aspects of traffic operation. In this study, we examine the necessity of flexible traffic operation criteria and its process for dynamic traffic management and also establish and analyze the effect of flexible traffic operation criteria in accordance with traffic properties using an example of climbing lane. We selected the operation criteria (critical travel speed), which decides whether to operate or close the climbing lane when the average travel speed of climbing lane is 50km/h based on VISSM (microscopic traffic simulation) analysis of Nakdong junction towards Masan with the volume of traffic (v/c), ratio of heavy vehicle as the traffic operation parameters. Based on the simulation result in accordance with the volume of traffic by the operation mode of climbing lane, the analysis on the effect of dynamic traffic management of climbing lane showed that the dynamic traffic management provides more convenience compare to the operation and close of climbing lane. Thereby, we proved that the dynamic traffic management of climbing lane is more effective.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.9 no.6
• /
• pp.559-565
• /
• 2016

For the purpose of the research, it is analyze the influence traffic Signal Progression on a CBD by expansion of Permissive Left-Turn on the advanced traffic management system program compared with traffic response control For this, divided a average distance between intersections, a traffic network on five district in four city. As the result, Volume of the traffic management system on a advanced traffic management system program compared with traffic response control is effective in traffic signal cycle 160sec 286car per lane, in 140sec 308car, 120sec 264car. As well, for a traffic network as the length of a traffic network 2.0~3.0km, under 2.0km, all of traffic signal cycle(160sec, 140sec, 120sec) a passing band and stop is more effective. But the traffic management system on traffic response control compared with the traffic management system on a advanced traffic management system program is effective in the length of a traffic network over 5.0km. For the efficiency of traffic signal system manage, it should be runned the traffic management system on traffic response control in addition to the traffic management system on a advanced traffic management system program on CBD. As the result of simulation the business in chungju-si, the travel speed of the traffic management system on a advanced traffic management system program is 41.2km/h and the travel speed of traffic response control is 37.5km/h. Therefore, it should be runned per length of a traffic network the traffic management system on traffic response control in addition to the traffic management system on a advanced traffic management system program on CBD.

• Journal of the Korean Regional Science Association
• /
• v.33 no.1
• /
• pp.29-41
• /
• 2017

This study proposes an integrated accessibility measurement algorithm, which is applied to the Seoul Metropolitan public transportation system consisting of bus and subway networks, and analyzes the result. We construct a public transportation network graph linking bus-subway networks and take the time distance as the link weight in the graph. We develop a time-distance algorithm to measure the time distance between each pair of transit stations based on the T-card transaction database. The average travel time between nodes has been computed via the shortest-path algorithm applied to the time-distance matrix, which is obtained from the average speed of each transit route in the T-card transaction database. Here the walking time between nodes is also taken into account if walking is involved. The integrated time-distance accessibility of each node in the Seoul Metropolitan public transportation system has been computed from the T-card data of 2013. We make a comparison between the results and those of the bus system and of the subway system, and analyze the spatial patterns. This study is the first attempt to measure the integrated time-distance accessibility for the Seoul Metropolitan public transportation system consisting of 16,277 nodes with 600 bus routes and 16 subway lines.

• Journal of the Society of Disaster Information
• /
• v.16 no.4
• /
• pp.650-657
• /
• 2020

Purpose: In this study, the effectiveness of pilot project of PLSP (Priority Lane and Signal Preference) system, which was operated in Cheongju City, was analyzed. Method: The priority signal was operated by a police officer switching to a blue signal when approaching a fire truck through CCTV, and the priority lane of emergency vehicles was displayed on the road to enable preferential traffic. VISSIM simulation analysis was performed for the 1.2km section (3.8km) of the pilot project section and vehicle data was analyzed for some of the test operation sections. Result: Simulation analysis shows that the moving speed of the emergency vehicle can be increased by 42 km/h with the introduction of PLSP, which can be increased by approximately twice the speed. Travel time was reduced by about 3 minutes, and considerable improvements of 69% compared to cities that are not operating was analyzed. The pilot operation of Cheongju City showed a time-shortening effect of about two minutes on average, with the average time reaching 4 minutes and 14 seconds in the first period and the average time reaching 5 minutes and 40 seconds in the second period. Conclusion: The system has been shown to be effective in minimizing time-to-site arrival of emergency vehicles.

• Journal of Biosystems Engineering
• /
• v.43 no.2
• /
• pp.103-109
• /
• 2018

Purpose: This study has been conducted to develop a potato yield monitoring system, consisting of a segmentation algorithm to detect potatoes scattered on a soil surface and a counting system to count the number of potatoes and convert the data from two-dimensional images to masses. Methods: First, a segmentation algorithm was developed using top-hat filtering and processing a series of images, and its performance was evaluated in a stationary condition. Second, a counting system was developed to count the number of potatoes in a moving condition and calculate the mass of each using a mass estimation equation, where the volume of a potato was obtained from its two-dimensional image, and the potato density and a correction factor were obtained experimentally. Experiments were conducted to segment potatoes on a soil surface for different potato sizes. The counting system was tested 10 times for 20 randomly selected potatoes in a simulated field condition. Furthermore, the estimated total mass of the potatoes was compared with their actual mass. Results: For a $640{\times}480$ image size, it took 0.04 s for the segmentation algorithm to process one frame. The root mean squared deviation (RMSD) and average percentage error for the measured mass of potatoes using this counting system were 12.65 g and 7.13%, respectively, when the camera was stationary. The system performance while moving was the best in L1 (0.313 m/s), where the RMSD and percentage error were 6.92 g and 7.79%, respectively. For 20 newly prepared potatoes and 10 replication measurements, the counting system exhibited a percentage error in the mass estimation ranging from 10.17-13.24%. Conclusions: At a travel speed of 0.313 m/s, the average percentage error and standard deviation of the mass measurement using the counting system were 12.03% and 1.04%, respectively.

• Journal of the Ergonomics Society of Korea
• /
• v.35 no.1
• /
• pp.11-27
• /
• 2016

Objective: The purpose of this study was to develop and evaluate high technology adaptive driving controls, such as mini steering wheel-lever system and joystick system, for the people with physical disabilities in the driving simulator. Background: The drivers with severe physical disabilities have problems in operation of the motor vehicle because of reduced muscle strength and limited range of motion. Therefore, if the remote control system with driver-by-wire technology is used for adaptive driving controls for people with physical limitations, the disabled people can improve their quality of life by driving a motor vehicle. Method: We developed the remotely controlled driving simulator with drive-by-wire technology, e.g., mini steering wheel-lever system and joystick system, in order to evaluate driving performance in a safe environment for people with severe physical disabilities. STISim Drive 3 software was used for driving test and the customized Labview program was used in order to control the servomotors and the adaptive driving devices. Thirty subjects participated in the study to evaluate driving performance associated with three different driving controls: conventional driving control, mini steering wheel-lever controls and joystick controls. We analyzed the driving performance in three different courses: straight lane course for acceleration and braking performance, a curved course for steering performance, and intersections for coupled performance. Results: The mini steering wheel-lever system and joystick system developed in this study showed no significant statistical difference (p>0.05) compared to the conventional driving system in the acceleration performance (specified speed travel time, average speed when passing on the right), steering performance (lane departure at the slow curved road, high-speed curved road and the intersection), and braking performance (brake reaction time). However, conventional driving system showed significant statistical difference (p<0.05) compared to the mini steering wheel-lever system or joystick system in the heading angle of the vehicle at the completion point of intersection and the passing speed of the vehicle at left turning. Characteristics of the subjects were found to give a significant effect (p<0.05) on the driving performance, except for the braking reaction time (p>0.05). The subjects with physical disabilities showed a tendency of relatively slow acceleration (p<0.05) at the straight lane course and intersection. The steering performance and braking performance were confirmed that there was no statistically significant difference (p>0.05) according to the characteristics of the subjects. Conclusion: The driving performance with mini steering wheel-lever system and joystick control system showed no significant statistical difference compared to conventional system in the driving simulator. Application: This study can be used to design primary controls with driver-by-wire technology for adaptive vehicle and to improve their community mobility for people with severe physical disabilities.

• Journal of Korean Society of Transportation
• /
• v.21 no.3
• /
• pp.47-56
• /
• 2003

Considering the high density developments along the major traffic corridors in Seoul, transit-oriented street designs will be a very effective to control traffic congestion along the corridors. For testing the effectiveness, we selected. for our case study, Kangnam Street, which is one of the most highly developed corridors in Seoul The traffic study on Kangnam street in 2000 shows that the daily average bus speed is 11.73km/h, which is 5km/h lower than the auto speed. The Central Bus Lane system was applied on the Kangnam street to test impact on bus speed as well as auto speed. Simulation results show that with Central Bus Lane have been improved the travel speeds of bus as well as auto on Kangnam street from 14.4km/hr to 35.0km/hr and from 25.1km/hr to 26.1km/hr, respectively. The bus market share increases about 6-8 percentages. Especially, 13.4% of bus users are increased for long-distance trips.

• Journal of Korean Society of Transportation
• /
• v.17 no.3
• /
• pp.61-70
• /
• 1999

The Purpose of this study is to test whether Braess Paradox (BP) can be revealed in a real world network. Fer the study, Namsan 2nd tunnel case is chosen, which was shut down for 3 years for repair works. The revelation of BP is determined by analyzing network-wise traffic impacts followed by the tunnel closure. The analysis is conducted using a network simulation model called SECOMM developed for the congestion management of the Seoul metropolitan area. Also, the existence of BP is further identified by a before-after traffic survey result of the major arterials nearby the Namsan 2nd tunnel. The model estimation expected that the closure of Namsan 2nd tunnel improve the network-wise average traffic speed from 21.95km/h to 22.21km/h when the travel demand in the study area and congestion Pricing scheme on Namsan 1st & 3rd tunnels remain unchanged. In addition, the real world monitoring results of the corridors surrounding Namsan 2nd tunnel show that the average speed increases from 29.53km/h to 30.37km/h after the closure. These findings clearly identify the BP Phenomenon is revealed in this case.