• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.10
• /
• pp.1554-1560
• /
• 2012

In this paper, the even harmonic current(2nd, 4th, 6th, 8th) of the arc fault current and normal current were measured in computer load and analyzed. The BPF with GIC was developed to detection of harmonic, the exact center frequency and a high degree of sharpness could be easily obtained. The total even harmonic distortion due to series arc fault in computer load was 31.2%, this value was increased 3.9 times better than the total even harmonic distortion of normal current. The results of analysis of arc fault current RMS variation rate and Peak variation rate per half-cycle, The RMS average variation rate are as follows ; the 2nd harmonic was 0.24, the 4th harmonic was 0.15, the 6th harmonic was 0.19, the 8th harmonic was 0.25, respectively. The Peak average variation rate are as follows ; the 2nd harmonic was 0.19, the 4th harmonic was 0.12, the 6th harmonic was 0.13, the 8th harmonic was 0.15, respectively. The results of this analysis utilize data to detect of series arc fault on wiring of computer load.

• Korean Journal of Clinical Laboratory Science
• /
• v.45 no.1
• /
• pp.9-15
• /
• 2013

Hepatitis B virus (HBV) infection has recently shown to be associated with diabetes mellitus. The objective of this study was to investigate the relationship between chronic hepatitis B and diabetes mellitus indicators. We evaluated anthropometry, metabolic syndrome risk factors, fasting glucose, HbA1c, and C-peptide among the normal and HBV subjects. The partial correlation and average comparison analysis were used to assess the independent association between chronic hepatitis B and diabetes mellitus indicators. Average comparisons of normal and HBV subjects were significantly different in fasting glucose (p<0.000), HbA1c (p<0.000), C-peptide (p<0.000), alanine transaminase (ALT) (p<0.000) and aspartate transaminase (AST) (p<0.000). We may suggest that HBV infection is related to diabetes mellitus indicators such as fasting glucose, HbA1c and C-peptide.

• YAKHAK HOEJI
• /
• v.30 no.1
• /
• pp.14-23
• /
• 1986

This study was conducted to investigate the correlation between the dissolution rates and the bioavailabilities of commercial phenytoin products, and also the correlation between their biovailabilities in rabbits and those in humans. Dissolution test was conducted in pH 9. 0 alkaline borate buffer (0.2M) using basket method with seven phenytoin products commercially available. According to the dissolution rate, the phenytoin products were divided into three groups, such as rapid, intermediate and slow group. Three phenytoin products from each group were selected for the bioavailability test in rabbits and humans. The bioavailability test was carried out in rabbits and normal volunteers using cross over design. Single doses of 20mg/kg and 300mg/man were orally administered to rabbits and normal volunteers respectively. Average $C_{max}$, $t_{max}$ and AUC of three phenytoin products were determined from the serum concentration-time curve in rabbit and human experiments. The relative bioavailability evaluation was conducted using AUC of three phenytoin products. The correlations between the dissolution rate constants and bioavailabilities (AUC) of three phenytoin products in rabbits as well as those in humans were not found. Whereas, there was significant correlation between average AUC of three phenytoin products in humans and those in rabbits (r=0.993, p<0.1). From the results of this experiment, it can be concluded that the bioavailability of phenytoin products in humans may be predicted from the results of the rabbit experiment. Also it is assumed that the prediction of the bioavailability of phenytoin products in humans may be difficult from the only results of in vitro dissolution test.

• Korean Journal of Community Nutrition
• /
• v.6 no.2
• /
• pp.192-204
• /
• 2001

Osteoporosis and other related conditions pose a growing public health problem, especially in postmenopausal women. The main purpose of the study was to investigate the correlations among BMD, maternal factors, and life styles, and intake of nutrients in postmenopausal women. One hundred participants in Kyungge-do were divided into three groups according to their BMD measurements measured by DXA. Dietary analysis, anthropometric measurements, and questionares were administered to these women. The percentage of the osteoporosis, osteopenia(Osteopinia), and normal groups were 32%, 48%, and 20% respectively. The average age was significantly the highest in the osteoporosis group. The average age at menopause was 47.2. Osteoporosis group's age at menopause was significantly the lowest. The sleeping hours of the osteoporosis and osteopenia group were significantly longer than the normal group. The intake of vitamin B$_2$was positively correlated with the BMD of femoral neck. The BMD of these two sites was positively correlated with weight, BMI, waist, and hip size and negatively correlated with the length of the menstrual cycle, duration after menopause, the age at the last delivery, and sleeping hours. Spinal BMD positively correlated with hours of outdoor activity. Therefore, maternal factors, lifestyles, and intake of nutrients contribute to BMD.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.4 no.1
• /
• pp.37-42
• /
• 2005

The localization of manufacturing technique development is actualizing for low cost with supplies of display devices. We need more high cutting technique because consumers want flat glasses of various sizes. Recently, most general two methods are normal wheel cutting and laser cutting, but both of them have some faults. First, the wheel cutting has cracks and sharp edges of sections. Second, it is easy for laser cutting to cut curved lines. however, it has thermal damage and low traverse speed. I suggest a new cutting method by high-wave frequency vibration wheel cutting(HFVC), which is good for quality improvement. Vertical cracks and crack depth is observed, after HFVC. When the average of the crack depth is $30{\mu}m$ and the average of the wallner liner depth is $200{\mu}m$, it has the most high quality of the sections in this experiment. As a result, when we consider between the normal wheel cutting method and the HFVC method, the latter has low cracks and good quality.

• Journal of Bio-Environment Control
• /
• v.23 no.3
• /
• pp.174-180
• /
• 2014

Standard weather data available to greenhouse environmental design are limited in most regions of the country. So, instead of using standard weather data, in order to find the method to build design weather data for greenhouse heating and cooling, design outdoor weather conditions were analyzed and compared by TAC method and frequency analysis using climatological normal and thirty years from 1981 to 2010 hourly weather data provided by KMA and standard weather data provided by KSES. Average TAC values of outdoor temperature, relative humidity and insolation using thirty years hourly weather data showed a good agreement with them using standard weather data. Therefore, in regions which are not available standard weather data, we suggest that design outdoor weather conditions should be analyzed using thirty years hourly weather data. Average of TAC values derived from every year hourly weather data during the whole period can be established as environmental design standards, and also minimum and maximum of them can be used as reference data.

• The Journal of the Korean life insurance medical association
• /
• v.7 no.1
• /
• pp.180-188
• /
• 1988

A study on the standard cardiothoracic ratio calculated from the photofluorography film of chest in a total of 8,030 insured persons(3,449 men and 4,581 women) was undertaken. The results were as follows: 1) The linear regression equations were formed from the 99% confidence ilmits of actually measured average cardiothoracic ratio by weight index. The cardiothoracic ratios by weight index estimated by above mentioned equations, namely theoretic values of cardiothoracic ratio, should be regarded as the standard cardiothoracic ratios. 2) It seems that the standard cardiothoracic ratio${\pm}10%$ deviation should be regarded as the normal limits of cardiothoracic ratio. 3) The tables of standard cardiothoracic ratio by weight index and the normal limits of cardiothoracic ratio by weight index were presented. 4) The average weight index and cardiothoracic ratio in all males and females were 0.993 and 43.3%, and 0.997 and 46.3% respectively. 5) In order to evaluate the cardiothoracic ratio more accurately, the establishment of the standard cardiothoracic ratio by build is considered to be reasonable.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.9
• /
• pp.4180-4196
• /
• 2017

In this paper, we analyze average capacity of an amplify-and-forward (AF) cooperative communication system model in multi-relay multiuser networks. In contrast to conventional cooperative networks, relays in the considered network have no embedded energy supply. They need to rely on the energy harvested from the signals broadcasted by the source for their cooperative information transmission. Based on this structure, a two-step selection scheme is proposed considering both channel state information (CSI) and battery status of relays. Assuming each relay has infinite or finite energy storage for accumulating the energy, we use the infinite or finite Markov chain to capture the evolution of relay batteries and certain simplified assumptions to reduce computational complexity of the Markov chain analysis. The approximate closed-form expressions for the average capacity of the proposed scheme are derived. All theoretical results are validated by numerical simulations. The impacts of the system parameters, such as relay or user number, energy harvesting threshold and battery size, on the capacity performance are extensively investigated. Results show that although the performance of our scheme is inferior to the optimal joint selection scheme, it is still a practical scheme because its complexity is much lower than that of the optimal scheme.

• Journal of Ocean Engineering and Technology
• /
• v.33 no.6
• /
• pp.526-534
• /
• 2019

The average coastline and the erosion control line introduced as the management coastline, and the average shoreline (MSL) was established from the observed coastline. Also, the median grain size and the wave height of 30-years return period were applied. The erosion control line (ECL) was established through the model, HaeSaBeeN. These two lines set the coastline for evaluation. Based on the observed monitoring data along the coastline, the 1-day variation according to the normal distribution was used to estimate the regional variation, and the width of the erosion was calculated by applying the median grain size (D₅₀) and the wave height of 30-years return period through the high-wave coastal erosion width model, i.e., HaeSaBeeN.

• Journal of the Korean Solar Energy Society
• /
• v.21 no.4
• /
• pp.73-83
• /
• 2001

Since the solar radiation is the main input for sizing any solar system, it will be necessary to understand and evaluate the insolation data. The horizontal global insolation data have been measured since May, 1982 and direct normal solar insolation data since December 1990 at 16 different sites all over the country and considerable effort has been made for constructing a standard value from measured data at each station. In the results, the average global total solar radiation of the nation is $3,055kcal/m^2.day(12.79MJ/m^2.day)$ and the average clear day direct normal solar beam radiation was $4,600kcal/m^2.day(19.26MJ/m^2.day)$, which indicates possible solar energy application of medium and high temperature technologies with high concentration.