• Journal of Korean Society for Quality Management
• /
• v.25 no.3
• /
• pp.39-50
• /
• 1997

Markov chain method to evaluate the properties of control charts with variable sampling intervals(VSI0 for simultaneously monitoring several correlated quality characteristics under multivariate normal process are investigated. For comparing the efficiencies and properties of multivariate control charts, we consider multivariate Shewhart, CUSUM and EWMA charts in terms of average time to signal(ATS) and average number of samples to signal(ANSS). We obtained stabilized numerical results with Markov chain method when the number of transient state is greater than 100.

• Proceedings of the KIEE Conference
• /
• 1987.07b
• /
• pp.1619-1621
• /
• 1987

In this experiment, we have the result that the speech interval can be extracted with a energy parameter by noise suppression through nonlinear product average in edge enhancement method.

• Proceedings of the KIEE Conference
• /
• 2006.10c
• /
• pp.585-587
• /
• 2006

Generally, LPF(low pass filter) circuits are used for converting square wave to average value, but these are not used necessary for average value of square wave in real time because of time constant of LPF. This paper deals with acquiring method for average value of square wave in real tine in case of frequency of output voltage is fixed, waveform of output voltage is square wave and duty of output voltage is varied like as 1 quadrant or 4 quadrant chopper.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.6A
• /
• pp.845-854
• /
• 1999

In the reverse link of DS/CDMA systems, the Peak-to-Average Ratio(PAR) performance can be analyzed by phase variations of spread signals. In the paper, we propose s PAR analysis method using phase variations of signals. Using this method, we analyze the PAR performances of existing spreading methods and suggest several methods improving the PAR performances. Also we show the proposed methods have negligible BER degradation compared to the existing ones.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.34C no.8
• /
• pp.88-100
• /
• 1997

This paper proposes a new concept for an optimal traffic signal cycle method which will reduce the average vehicle waiting time and improve average vehicle speed. Electro sensitive traffic system can extend the traffic cycle when there ar emany vehicles in the road or it can reduce the traffic consider vehicle length, so it can cause oveflow and reduce average vechicel waiting time at the intersection, we propose on optimal traffic cycle with fuzzy ruels and neural network. Computer simulation results prove that reducing the average vehicle waiting time which proposed considering passing vehicle's length for the optimal traffic cycle better than fixe dsignal method dosen't consider vehicle length.

• Journal of Environmental Science International
• /
• v.27 no.12
• /
• pp.1227-1239
• /
• 2018

In this study, daily precipitation data and daily average temperature data of meteorological observatories in Daegu, Busan, Daejeon, Seoul, Mokpo, and Gwangju cities inland and offshore were analyzed by using moving average method. Were compared. Overall, summarizing changes in precipitation and temperature over the 24 seasons, precipitation and temperature in all six stations increased compared to the past 1960s. In the case of precipitation, precipitation increased at the end of July and early August, whereas precipitation in April, September and early October decreased. In the case of temperature, especially in February, the temperature increased, and in Mokpo, the temperature from August to December showed a general decline. Changes in precipitation and temperature due to seasons in the 24 seasons affect agriculture and our everyday life, and further research is needed to determine how these changes will affect agricultural water supply, crop growth and daily life. The results of this study can be useful.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.10 no.4
• /
• pp.349-360
• /
• 2008

In this paper, the modeling procedure of random field with an elasto-plastic finite element algorithm and probability of failure on closely-spaced tunnel were investigated. Local average subdivision (LAS) method which can generate discrete random variables fast and accurately as well as change the resolution in certain region was used. And correlated value allocating and weighted average method were suggested to implement geometrical characteristics of tunnel. After the probability of failure on the test problem was thoroughly investigated using random finite element method, the results were compared with the deterministic strength reduction factor method and single random variable method. Of particular importance in this work, is the conclusion that the probability of failure determined by simplified probabilistic analysis, in which spatial variability is ignored by assuming perfect correlation, can be estimated from the safety factor determined by strength reduction factor method. Also, single random variable method can lead to unconservative estimates of the probability of failure.

• Journal of environmental and Sanitary engineering
• /
• v.16 no.1
• /
• pp.91-101
• /
• 2001

In order to propose a optimum method increasing accuracy and reproducibility in analysis of urine lead levels, we compared matrix modifier addition method and microwave digestion method. The results were as follows ; 1. Where the concentration of $Pd(NO_3)_2$(matrix modifier) was $50mg/{\ell}$, and ashing temperature was $900^{\circ}C$, the results were optimum. In case of matrix modifier addition method, the average coefficient of variation (CV) of normal man was 24.1%, and lead worker was 7.9%. The average urine lead levels of standard were $10.42\mu{g}/{\ell}$ and $19.89\mu{g}/{\ell}$ , the accuracies compared to reference values were 97.0% and 92.6%, respectively. 2. Microwave digestion temperature($160~180^{\circ}C$), time(15~25min) and the ratio of urine/ashing acid(1:1~4:1) did not significantly affect lead absorbance and background absorbance. Therefore we set up a optimum analytical conditions as follows: temperature, $160^{\circ}C$; time, 15min; the ratio of urine/ashing acid, 4:1. after samples were digested by the above analytical conditions, lead absorbance and background absorbance was measured at $450^{\circ}C$ as ashing temperature. The average coefficient of variation (CV) of normal man was 12.4%, and lead worker was 6.2%. The average urine lead levels of standard urine were $10.66\mu{g}/{\ell}$ and $23.31\mu{g}/{\ell}$, the accuracies compared to reference values were 99.3% and 103.9%, respectively. From the results, we suggest that microwave digestion method is a more favorable method than matrix modifier addition method because of easiness to reduce organic matter, possibility to analysis at low temperature and accuracy.

• Journal of the Korean Professional Engineers Association
• /
• v.19 no.1
• /
• pp.3-11
• /
• 1986

The analysis of Geotechnical stability problems by the limit equilibrium method involve assuming the shape of the failure and then investigating many surfaces of the shape to identify the one on which failure seems most likely to occur. These arbitrary assumptions most frequently concern to the locations or directions of side force on slice and the overall factor of safety is considered identical to the local factor of safety. In this paper, let the factor of safety of a slope at wedge block stage differently, when an upper part of the potential sliding mass has a simple active stress field and the lower part of the passive stress field and overall factor of safety is obtained by the average of local factor and computer program based on the modified wedge Method is proposed for this thesis. The new algorithm based on tile modified new method is made for estimating the safety factor of Earth Dam. Compared with conventional method for many cases tile average values of the factor of safety determined by the modified new method are very nearly the same. For all of the cases studied the difference was found 0.03. Finally this new method is thought to be very useful in slope stability analysis.

• Journal of the Korean Data and Information Science Society
• /
• v.24 no.4
• /
• pp.919-929
• /
• 2013

We compared two basic methods, combine-accumulate method and accumulate-combine method, using the past quality information in multivariate quality control procedure for monitoring mean vector of multivariate normal process. When small or moderate shifts have occurred, accumulate-combine method yields smaller average run length (ARL) and average time to signal (ATS) than combine-accumulate method. On the other hand, we have found from our numerical results that combine-accumulate method has better performances in terms of switching behavior than accumulate-combine method. In industry, a quality engineer could select one of the two method under the comprehensive consideration about the required time to signal, switching behavior, and other physical factors in the production process.