• Journal of Environmental Science International
• /
• v.19 no.3
• /
• pp.281-293
• /
• 2010

The present study explores time and spatial thermal environment for Daegu, which is a city built on a basin area, according to varying land cover conditions of the earth's surface by analyzing data derived from meteorological observation and satellite images. The study has classified land use by utilizing MODIS satellite images and analyzed land surface temperature. Also, by using data acquired from automatic weather system, the study has evaluated the effects of atmospheric heating caused by city pavements by analyzing the sensible heat flux between the city's land surface and the atmosphere. The results are as follows. 1) Classification of land use in the Daegu area shows 46.64% of urban and built-up area, 1.39% of watersides, 35.19% of forest, 11.43% of crops, and 5.37% grasslands. 2) During the weekdays throughout the year, the land surface temperature was high for Dalseogu, Bukgu, and Seogu regions where industrial complexes could be found. Comparatively, lower temperature could be observed in the woodlands. 3) While the land surface temperature displayed the effects of pushing air upwards during the weekdays in urban areas, the reverse was true for forest regions. During the night, the temperature did not exert any significant influence on air movement.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.458.2-458.2
• /
• 2014

We have demonstrated that simple brush-painted Ti-doped $In_2O_3$(TIO) films can be used as a cost effective transparent anodes for organic solar cells (OSCs). We examined the RTA effects on the electrical, optical, and structural properties of the brush painted TIO electrodes. By the direct brushing of TIO nanoparticle ink and rapid thermal annealing (RTA), we can simply obtain TIO electrodes with a low sheet resistance of 28.25 Ohm/square and a high optical transmittance of 85.48% under atmospheric ambient conditions. Furthermore, improvements in the connectivity of the TIO nano-particles in the top region during the RTA process play an important role in reducing the resistivity of the brush-painted TIO anode. In particular, the brush painted TIO films showed a much higher mobility ($33.4cm^2/V-s$) than that of previously reported solution-process transparent oxide films ($1{\sim}5cm^2/V-s$) due to the effects of the Ti dopant with higher Lewis acid strength (3.06) and the reduced contact resistance of TIO nanoparticles. The OSCs fabricated on the brush-painted TIO films exhibited cell-performance with an open circuit voltage (Voc) of 0.61 V, shot circuit current (Jsc) of $7.90mA/cm^2$, fill factor (FF) of 61%, and power conversion efficiency (PCE) of 2.94%. This indicates that brush-painted TIO film is a promising cost-effective transparent electrode for printing-based OSCs with its simple process and high performance.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.34 no.6
• /
• pp.59-66
• /
• 2006

Acoustic cavity as a stabilization device to control high-frequency combustion instabilities in liquid rocket engine is adopted and its damping capacity is verified in atmospheric temperature. First, harmful resonant frequency in a modeling chamber can be damped effectively by the installation of properly-tuned acoustic cavity. Besides, geometric effects of acoustic cavity on damping characteristics are analyzed and compared quantitatively. Satisfactory agreements have been achieved with linear acoustic analysis and experimental approach. Results show that the acoustic cavity of the largest orifice area or the shortest orifice length was the most effective in acoustic damping of the harmful resonant frequency. Finally, it is proved that an optimal design process is indispensable for the effective control of combustion instabilities.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.30 no.6_1
• /
• pp.575-581
• /
• 2012

In general, various modeling and estimation techniques have been proposed to extract the tropospheric and ionospheric delays from the GPS CORS. In this study, Kalman filter approach is adopted to estimate the tropospheric and ionospheric delays and the proper modeling for the state vector and the variance-covariance matrix for the process noises are performed. The coordinates of reference stations and the zenith wet delays are estimated with the assumption of random walk stochastic process. Also, the first-order Gauss-Markov stochastic process is applied to compute the ionospheric effects. For the evaluation of the proposed modeling technique, Kalman filter algorithm is implemented and the numerical test is performed with the CORS data. The results show that the atmospheric effects can be estimated successfully and, as a consequence, can be used for the generation of VRS data.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.53 no.1
• /
• pp.93-101
• /
• 2008

The effects of $CO_2$ enrichment on growth of maize (Zea mays L.) were examined. Parameters analyzed include growth characteristics, yields, photosynthetic rates, evaporation rates and photosynthesis-related characteristics under elevated $CO_2$. The plants were grown in growth chambers with a 12-h photoperiod and a day/night temperature of $28/21^{\circ}C$ at the seedling stage and $30/23^{\circ}C$ from the silking stage. The plants were exposed to two elevated $CO_2$ of 500, 700ppm and ambient levels (350 ppm). Chalok 1 and GCB 70 germinated three days after seeding, and germination rates were faster in the elevated $CO_2$ than the control. Germination rates displayed significant differences among the $CO_2$ treatments. At the seedling stage, leaf area, top dry weight, and photosynthetic rates, and plant height indicated positive relationship with elevated $CO_2$ concentrations. At the $5{\sim}6$ leaf stage, $CO_2$ concentration also indicated positive relationship with plant height, leaf area, top dry weight, and photosynthetic rates. At the silking stage, increased plant height of Chalok 1 was noted in the $CO_2$ treatments compared to the control. No significant differences were noted for GCB 70, in which leaf area decreased but photosynthetic rates increased progressively with $CO_2$ concentration. Stomatal aperture was a little bigger in the elevated $CO_2$ than the control. $CO_2$ concentration was negatively related to stomatal conductance and transpiration rates, resulting in high water use efficiency.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.10 no.1 s.20
• /
• pp.1-7
• /
• 2004

RADARSAT is one of many possible data sources that can play an important role in marine surveillance including ship detection because radar sensors have the two primary advantages: all-weather and day or night imaging. However, atmospheric effects on SAR imaging can not be bypassed and any remote sensing image has various geometric distortions, In this study, radiometric and geometric calibrations for RADARSAT/SAT data are tried using SGX products georeferenced as level 1. Even comparison of the near vs. far range sections of the same images requires such calibration Radiometric calibration is performed by compensating for effects of local illuminated area and incidence angle on the local backscatter, Conversion method of the pixel DNs to beta nought and sigma nought is also investigated. Finally, automatic geometric calibration based on the 4 pixels from the header file is compared to a marine chart. The errors for latitude and longitude directions are 300m and 260m, respectively. It can be concluded that the error extent is acceptable for an application to open sea and can be calibrated using a ground control point.

• Journal of Construction Engineering and Project Management
• /
• v.8 no.3
• /
• pp.1-23
• /
• 2018

Since the protection the of human being from natural disaster and atmospheric factors have become an essential requirement, some attempts have been taken place to provide shelter and create a safe environment to a more comfortable life with welfare. For this purpose, using existing resources in nature and exploiting them in a different manner have been taken into account. Initially, the performed exploitations for construction had the least damage to the environment, but over time and as a result of population growth, aggressive exploitation of nature has led to destroying effects on the environment and resulted in consequences such as pollution and environmental destruction. Thus, the construction industry has been identified as the top pollutant factors of the environment. Among various construction factors, the building materials used in this industry are considered as the most important effective factors on the environment, as they have direct influences on the environment from the beginning of construction of the final steps. This research focuses on the review of the most of the existing green materials definitions and various approaches towards using eco-efficient construction materials. It presents and discusses possible ways of reducing the destructive effects on the environment by selecting and using green materials, review current literature and highlight the necessity of applying such materials in future constructions in all communities. This paper provides a base for this purpose that sustainable development communities and environment is realized by elimination of environmental pollution and approaching the criteria of green building by using sustainable materials.

• Proceedings of KOSOMES biannual meeting
• /
• 2007.05a
• /
• pp.43-50
• /
• 2007

In order to calculate the strength and to. see the variation af the stratification in the Southern Waters af Korea, the stratification parameter defined as potential energy anomaly (PEA, $V(J/m^3)$) introduced by Simpson and Hunter (1974) was used The data used in this paper were observed in August 1999 and February 2000 by National Fisheries Research and Development Institute (NFRDI). Also to know the effects af the temperature and the salinity an the stratification respectively, averaged temperature and salinity were used in the process af calculation the parameter. V is generally high in the offshore. However, in February, V in the onshore is higher than that of the offshore due to the vertical temperature gradient caused by the expansion of South Korean Coastal Waters (SKCW). In the summer, the increase af the atmospheric heating, the temperature inversion phenomenon act an the stratification as the buoyancy forcing. In most cases, the effects of the temperature on the stratification is stronger than that of the salinity. The temperature effect is predominantly due to the extent af the intrusion of Tsushima Warm Current into the study area. However, at stations where V is high the effect af the salinity is also significant. In the winter, V is very low due to the decrease of the buoyancy forcing, but same stations show the relatively high V due to the expansion of SKCW and Tsushima Warm Current.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.31 no.7
• /
• pp.85-93
• /
• 2003

Droplet vaporization at various ambient pressures is studied numerically by formulating one dimensional evaporation model in the mixture of hydrocarbon fuel and air. The ambient pressure ranged from atmospheric conditions to the supercritical conditions. The modified Soave-Redlich-Kwong state equation is used to account for the real gas effects in the high pressure condition. Non-ideal thermodynamic and transport properties at near critical and supercritical conditions are considered. Some computational results are compared with Sato's experimental data for the validation of calculations. The comparison between predictions and experiments showed quite a good agreement. The droplet lifetime increases with increasing pressure at temperature lower than the critical temperature, however, it decreases with increasing pressure at temperature higher than the critical temperature. The solubility of nitrogen can not be neglected in the high pressure and it becomes higher as the temperature and the pressure go up.

• Wind and Structures
• /
• v.28 no.2
• /
• pp.129-140
• /
• 2019

Accurately simulating the wind field of large-scale region, for instant urban areas, the locations of large span bridges, wind farms and so on, is very difficult, due to the complicated terrains or land surfaces. Currently, the regional wind field can be simulated through the combination of observation data and numerical model using observation-nudging in the Weather Research and Forecasting model (WRF). However, the main drawback of original observation-nudging method in WRF is the effects of observation on the surrounding field is fully mathematical express in terms of temporal and spatial, and it ignores the effects of terrain, wind direction and atmospheric circulation, while these are physically unreasonable for the turbulence. For these reasons, a spatial correlation-based observation-nudging method, which can take account the influence of complicated terrain, is proposed in the paper. The validation and comparation results show that proposed method can obtain more reasonable and accurate result than original observation-nudging method. Finally, the discussion of wind field along bridge span obtained from the simulation with spatial correlation-based observation-nudging method was carried out.