• KIEAE Journal
• /
• v.16 no.3
• /
• pp.121-128
• /
• 2016

Purpose: The vacuum glazing should constantly retain the gap in vacuum state to maintain high thermal performance. To do so, pillars are used to prevent the glazing from clinging to each other by the atmospheric pressure and therefore surface of the vacuum glazing is consistently affected by residual stress. The vacuum glazing could be applied to curtain wall systems at spandrel area to fulfill a rigorous domestic standard on U-value of the external wall. However, this can lead to high glazing temperature increase by heat concentration at a back panel and finally thermal stress breakage. This study experimentally determined weakness of the vacuum glazing systems on the thermal stress breakage and investigated effect of the residual stress. Method: The experiment first built two scale-down mock-up facilities that replicate the spandrel area in curtain wall, and then installed single low-e glass and vacuum glazing respectively. The two mock-up facilities were exposed to outside to induce the thermal stress breakage. Result: The experiment showed that the temperature occurred the thermal stress breakage was $114.4^{\circ}C$ for the single low-e glass and $118.9^{\circ}C$ for the vacuum glazing respectively. The result also showed the vacuum glazing reached the critical point earlier than the single low-e glass, which means that the vacuum glazing has high potential to occur the thermal shock breakage. In addition, the small temperature difference between two glazing indicates that the residual stress scarcely affects breakage of the vacuum glazing.

• Spatial Information Research
• /
• v.9 no.1
• /
• pp.1-13
• /
• 2001

Nowadays, SAR Interferometry is actively being studied as a new technique in topographic mapping using satellite imagery. It extracts height values using phase information derived by two SAR imageries covering same areas. Unlike when using SPOT imagery, it is not affected by atmospheric conditions and time. So to speak, we can say that SAR Interferometry is flexible in imagery acquisitions and can get height data economically over wide area. So, it is expected that SAR Interferometry will be widely using in GIS applications. But, in some area occurring geometric distortion, height data are misjudged or not extracted depending on phase unwrapping algorithms. IN the case of ERS tandem data, the accuracy of height data was worst in mountain area. It is the because of the short incidence angle resulted in layover effect. Of the phase unwrapping algorithms, path-following was better in height accuracy but could not get data in layover area. In this area, we could get height data using Height Sensitivity. In concludion, we could get DEM that maintained the accuracy of path-following method and have overall data across imagery.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.26 no.4
• /
• pp.555-560
• /
• 2002

Numerical simulations of freely propagating flames burning stoichiometric CH$_4$/O$_2$/$N_2$mixtures are performed at atmospheric pressure in order to understand the effect of the $O_2$enrichment level on CH$_4$/Air flame. A chemical kinetic mechanism is employed, the adopted scheme involving 54 gas-phase species and 632 forward reactions. The calculated flame speeds are compared with the experiments for the flames established at several $O_2$enrichment level, the results of which is in excellent agreement. As a result of the increased $O_2$enrichment level from 0.21 to 1, the mole fraction of CO in the burred gas is increased. The flame speed and the temperature in the burned gas are also increased, but the thickness of the flame is severely shrunken in the preheat region. The maximum of the calculated EINO is obtained around 0.6 and 0.7 of the $O_2$enrichment level in cases of flames for fuel-lean mixtures.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.34 no.8
• /
• pp.1091-1096
• /
• 2010

This study was conducted to provide reference data for designing an alarm system that can help prevent the overturning of a container crane under wind load. Two methods, namely, fluid-structure interaction (FSI) analysis and windtunnel test, were adopted in this investigation. To evaluate the effect of wind load on the stability of the crane, a 50-ton-class container crane that is widely used in container terminals was adopted as the analysis model and 19 values were considered as design parameters for wind direction. First, the wind-tunnel test for the reduced-scale container crane model was performed according to the wind direction by using an Eiffel type atmospheric boundary-layer wind tunnel. Next, the FSI analysis for the real-scale container crane was conducted using ANSYS and CFX. Then, the uplift force determined from the FSI analysis was compared with that determined from the wind-tunnel test. Finally, a formula to compensate for the difference between the results of the FSI analysis and the wind-tunnel test was proposed.

• Journal of the Korean Chemical Society
• /
• v.46 no.6
• /
• pp.523-527
• /
• 2002

Partition coefficient related composition of LPG are studied. Analysed sulfur compounds are ethyl mer-captan,n-propyl mercaptan and n-butyl mercaptan. The composition of liquid phase and gas phase in LPG are deter-mined by gas chromatography. The partition coefficient to related the boiling point of sulfur compounds, the temperature and the compositions of solvents, determined by using MLR(multiple linear regression) of SAS is follows; Kpc= $0.61222({\pm}0.6578)-0.04670({\pm}0.000959)Bp+0.26984(\pm0.06504)C4+0.003803(^{\circ}ae0.0019993)Tk,$ N=24, F=14.851, $R^2_{adj}$=0.6437. The boiling points of sulfur compounds at atmospheric pressure and the compositions of LPG effect mostly on partition coefficients. It is presumed that the gas odor elevating effects should be increased, where being on high tem-perature and larger amounts of n-butane.

• Journal of Environmental Impact Assessment
• /
• v.15 no.2
• /
• pp.121-127
• /
• 2006

The conventional water quality measurements by point sampling provide only site specific temporal water quality information but not the synoptic geographic coverage of water quality distribution. To circumvent these limitations in temporal and spatial measurements, the use of remote sensing is increasingly involved in the water quality monitoring research. In other to assess a trophic state of Yongdam reservoir using satellite imagery data, I obtained Landsat ETM data and water quality data on 16th September and 18th October 2001. The approach involved acquisition of water quality samples from boats at 33 sites on 16th September and 30 sites on 18th October 2001, simultaneous with Landsat-7 satellite overpass. The correlation coefficients between the DN values of the imagery and the concentrations of chlorophyll-a were analyzed. The visible bands(band 1,2,3) and near infrared band(band 4) data of September image showed the correlation coefficient values higher than 0.9. The October image showed the correlation coefficient values about 0.7 due to the atmospheric effect and low variation of chlorophyll-a concentration. Regression models between the chrophyll-a concentration and DN values of the Landsat imagery data have been developed for each image. The regression model was determined based on the spectral characteristics of chlorophyll, so the green band(band 2) and near infrared band(band 4) were selected to generate a trophic state map. The coefficient of determination(R2) of the regression model for 16th September was 0.95 and that of the regression model for 18th October was 0.55. According to the trophic state map made based on Aizaki's TSI and chlorophyll-a concentration, the trophic state of Yongdam reservoir was mostly eutrophic state during this study.

• 한국해양학회지
• /
• v.6 no.2
• /
• pp.92-98
• /
• 1971

Storm surges caused by typhoon Billie, 28 Aug. ∼ 2 Sep. 1970, on the west and south coasts of Korea are studied with the tidal data. Tracks and frequencies of the typhoons which affected the Korean peninsula and the yearly maximum tidal deviation at tide stations for the past twelve years are also reviewed. It is assumed that most of the typhoons affecting the Korea peninsula cause variations of sea level along almost all of the coast of Korea. Maximum storm surges at each tide station on the south coast appeared to be caused by typhoons during the summer, and by the north westerly monsoon and extraordinary cyclones on the west coast during spring and winter. In the coastal waters of the west coast where depths are shallower and the bottom configuration is flat, sea level variation is mostly caused by atmospheric pressure and wind effect. When a typhoon travels as in case of typhoon Billie, sea level ascends generally on the south coast and it descends on the west coast before the typhoon approaches near to the coasts. Considering the large tidal range on the western and southern coasts, it is assumed that the extraordinary destructive surges can be occurred when the tide is high water. Reviewing the monthly mean sea level variations on the each coast, hazards to be caused by storm surges can more fluently occur during the summer.

• Journal of The Korean Astronomical Society
• /
• v.46 no.2
• /
• pp.75-91
• /
• 2013

We estimate the power spectra of the cosmic microwave background radiation (CMB) temperature anisotropy in localized regions of the sky using the Wilkinson Microwave Anisotropy Probe (WMAP) 7-year data. We find that the north and south hat regions at high Galactic latitude ($|b|{\geq}30^{\circ}C$) show an anomaly in the power spectrum amplitude around the third peak, which is statistically significant up to 3. We try to explain the cause of the observed anomaly by analyzing the low Galactic latitude ($|b|$ < $30^{\circ}C$) regions where the galaxy contamination is expected to be stronger, and the regions weakly or strongly dominated byWMAP instrument noise. We also consider the possible effect of unresolved radio point sources. We find another but less statistically significant anomaly in the low Galactic latitude north and south regions whose behavior is opposite to the one at high latitude. Our analysis shows that the observed north-south anomaly at high latitude becomes weaker on regions with high number of observations (weak instrument noise), suggesting that the anomaly is significant at sky regions that are dominated by the WMAP instrument noise. We have checked that the observed north-south anomaly has weak dependences on the bin-width used in the power spectrum estimation, and on the Galactic latitude cut. We also discuss the possibility that the detected anomaly may hinge on the particular choice of the multipole bin around the third peak. We anticipate that the issue of whether or not the anomaly is intrinsic one or due to WMAP instrument noise will be resolved by the forthcoming Planck data.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.45 no.5
• /
• pp.44-51
• /
• 2008

UV lamp systems have been used for cleaning of display panels of TFT LCD or Plasma Display Panel (PDP). However, the needs for high efficient cleaning and low cost made high voltage plasma cleaning techniques to be developed and to be improved. Dielectric-Barrier Discharges (DBDs), also referred to as barrier discharges or silent discharges have been exclusively related to ozone generation for a long time. In this paper, a 6kW high voltage plasma power supply system was developed for LCD cleaning. The 3-phase input voltage is rectified and then inverter system is used to make a high frequency pulse train, which is rectified after passing through a high-power transformer. Finally, hi-directional high voltage pulse switching circuits are used to generate the high voltage plasma. Some experimental results showed the usefulness of atmospheric plasma for LCD panel cleaning.

• Journal of Environmental Science International
• /
• v.19 no.3
• /
• pp.281-293
• /
• 2010

The present study explores time and spatial thermal environment for Daegu, which is a city built on a basin area, according to varying land cover conditions of the earth's surface by analyzing data derived from meteorological observation and satellite images. The study has classified land use by utilizing MODIS satellite images and analyzed land surface temperature. Also, by using data acquired from automatic weather system, the study has evaluated the effects of atmospheric heating caused by city pavements by analyzing the sensible heat flux between the city's land surface and the atmosphere. The results are as follows. 1) Classification of land use in the Daegu area shows 46.64% of urban and built-up area, 1.39% of watersides, 35.19% of forest, 11.43% of crops, and 5.37% grasslands. 2) During the weekdays throughout the year, the land surface temperature was high for Dalseogu, Bukgu, and Seogu regions where industrial complexes could be found. Comparatively, lower temperature could be observed in the woodlands. 3) While the land surface temperature displayed the effects of pushing air upwards during the weekdays in urban areas, the reverse was true for forest regions. During the night, the temperature did not exert any significant influence on air movement.