• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.4
• /
• pp.10-16
• /
• 2007

This paper analyzes the output signal-to-interference-plus-noise ratio (SINR) for a multiple-input-multiple-output (MIMO) multicarrier code division multiple access (MC-CDMA) system with minium mean square error receivers. A previous work of a single antenna MC-CDMA system cannot directly applied to a MIMO MC-CDMA system because some assumptions for single antenna do not match the case of multiple antenna. Therefore this paper expands the concept of freeness to MIMO system by using the Marcenko Pastur law. The analysis shows that the output SINR asymptotically converges to a deterministic value and finds the value on the assumption of freeness. From the analysis, it is easy to calculate bit error rate and the calculation is verified by simulations.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.29 no.2 s.233
• /
• pp.169-179
• /
• 2005

Nucleate boiling experiments on heating surface of constant wall temperature were performed using R113 for almost saturated pool boiling conditions. A microscale heater array and Wheatstone bridge circuits were used to maintain a constant wall temperature condition of heating surface and to measure the heat flow rate with high temporal and spatial resolutions. Bubble images during the bubble growth were taken as 5000 frames per second using a high-speed CCD camera synchronized with the heat flow rate measurements. The bubble growth behavior was analyzed using the new dimensionless parameters for each growth regions to permit comparisons with previous experimental results at the same scale. We found that the new dimensionless parameters can describe the whole growth region as initial and later (thermal) respectively. The comparisons showed good agreement in the initial and thermal growth regions. In the initial growth region including surface tension controlled, transition and inertia controlled regions as divided by Robinson and Judd, the bubble growth rate showed that the bubble radius was proportional to $t^{2/3}$ regardless of working fluids and heating conditions. And in the thermal growth region as also called asymptotic region, the bubble showed a growth rate that was proportional to $t^{1/5}$, also. Those growth rates were slower than the growth rates proposed in previous analytical analyses. The required heat flow rate for the volume change of the observed bubble was estimated to be larger than the heat flow rate measured at the wall. Heat, which is different from the instantaneous heat supplied through the heating wall, can be estimated as being transferred through the interface between bubble and liquid even with saturated pool condition. This phenomenon under a saturated pool condition needs to be analyzed and the data from this study can supply the good experimental data with the precise boundary condition (constant wall temperature).

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.6 no.2
• /
• pp.139-149
• /
• 1994

In this paper, a finite element technique is applied to the prediction of the wave resonance phenomena in harbors. The mild-slope equation is used with a partial reflection boundary condition introduced to model the energy dissipating effects on the solid boundary. For an efficient modeling of the radiation condition at infinity, a new infinite element is developed. The shape function of the infinite element is derived from the asymptotic behavior of the first kind of the Hankel's function in the analytical boundary series solutions. For the computational efficiency, the system matrices of the element are constructed by performing the relevant integrations in the infinite direction analytically. Comparisons with the results from experiments and other solution methods show that the present model gives fairly good results. Numerical experiments are also carried out to determine the proper distance to the infinite elements from the mouth of the halter, which directly affect the accuracy and efficiency of the solution.

• Geomechanics and Engineering
• /
• v.11 no.1
• /
• pp.141-160
• /
• 2016

This study elucidates the uplift behaviors of the straight-sided and belled shafts. The field uplift load tests were carried out on 18 straight-sided and 15 belled shafts at the three collapsible loess sites under an arid environment on the Loess Plateau in Northwest China. Both the site conditions and the load tests were documented comprehensively. In general, the uplift load-displacement curves of the straight-sided and belled shafts approximately exhibited an initial linear, a curvilinear transition, and a final linear region, but did not provide a well defined peak or asymptotic value of the load, and therefore their uplift resistances should be interpreted from the load test results using an appropriate criterion. Nine representative uplift resistance interpretation criteria were used to define the "interpreted failure load" for each of the load tests, and all of these interpreted uplift resistances were normalized by the failure threshold, $T_{L2}$, obtained using the $L_1-L_2$ method. These load test data were compared statistically and graphically. For the straight-sided and belled shafts, the normalized uplift load-displacement curves were respectively established by the plots that related the mean interpreted uplift resistance ratio against the mean displacement at the corresponding interpreted criteria, and the comparisons of the normalized load-displacement curves were made. Specific recommendations for the designs of uplift belled and straight-sided shafts in the loess were given, in terms of both capacity and displacement.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.1
• /
• pp.102-107
• /
• 2021

This paper discusses the containment control problem for multi-agent systems with input saturations. The goal of the containment control is to obtain swarming behavior by driving follower agents into the convex hull which is spanned by multiple leader agents. This paper considers multiple leader agents moving at the same constant speed. Then, to solve the containment problem for moving leaders, we propose a PI-based distributed control algorithm. We next analyze the convergence of follower agents to the desired positions. Specifically, we apply the integral-type Lyapunov function to take into account the saturation nonlinearity. Then, based on Lasalle's Invariance Principle, we show that the asymptotic convergence of error states to zero for any positive constant gains. Finally, numerical examples with the static and moving leaders are provided to validate the theoretical results.

• Journal of KIISE:Computer Systems and Theory
• /
• v.28 no.5
• /
• pp.213-217
• /
• 2001

Excessive memory buffer requirement in continuous media playback is a serious impediment of wide spread usage of on-line multimedia service. Skewed access frequency of available video files provides an opportunity of re-using the date blocks which has been loaded by one session for later usage. We present novel algorithm which minimizes the buffer requirement in multiple sessions of multimedia playbacks. In continuous media playback originated from the disk, a certain amount of memory buffer is required to synchronize asynchronous disk. Read operation and synchronous playback operation. As aggregate playback bandwodth increases, larger amount of buffer needs to be allocated for this synchronization purpose. The focus of this work is to study the asymptotic behavior of the synchronization buffer requirement and to develop an algorithm coping with this excessive buffer requirement under bandwidth congestioon. We argue that in a large scale continuous media server, it may not be necessary to read the blocks for each session directly from the disk. The beauty of our work lies in the fact that it dynamically adapts to disk utilization of the server and finds the optimal way of servicinh the individual sessions while minimizing the overall buffer space requirement. Optimality of the proposed algorithm is shown by proof. The effectiveness and performance of the proposed scheme is examined via simulation.

• Korean Journal of Environment and Ecology
• /
• v.31 no.2
• /
• pp.152-165
• /
• 2017

The greater long-tail hamster, Tscherskia triton, is widely distributed in Northern China, Korea and adjacent areas of Russia. Except for its distribution, biological characteristics related to life history, behavior, and ecological influences for this species are rarely studied in Korea. This study was conducted to obtain biological information on breeding, growth and development that are basic to species-specific studies. The study adopted laboratory management of a breeding programme for T. triton collected in Jeju Island from March, 2015 to December, 2016. According to the study results, the conception rate was 31.67% and the mice in the large cages had a higher rate of conception than those in the small cages (56.7 vs. 6.7%). The gestation period was $22{\pm}1.6days$ (ranges from 21 to27 days), and litter size ranged from 2 to 7, with a mean of $4.26{\pm}1.37$ in the species. The minimum age for weaning was between $19.2{\pm}1.4days$ (range of 18-21 days). There were no significant differences by sex between mean body weight and external body measurements at birth. However, a significant sexual difference was found from the period of weaning (21 days old) in head and body length, as well as tail length (HBL-weaning, $106.50{\pm}6.02$ vs. $113.34{\pm}4.72mm$, p<0.05; HBL-4 months, $163.93{\pm}5.42$ vs. $182.83{\pm}4.32mm$, p<0.05; TL-4 months, $107.23{\pm}3.25$ vs. $93.95{\pm}2.15mm$, p<0.05). Gompertz and Logistic growth curves were fitted to data for body weight and lengths of head and body, tail, ear, and hind foot. In two types of growth curves, males exhibited greater asymptotic values ($164.840{\pm}7.453$ vs. $182.830{\pm}4.319mm$, p<0.0001; $163.936{\pm}5.415$ vs. $182.840{\pm}4.333mm$, p<0.0001), faster maximum growth rates ($1.351{\pm}0.065$ vs. $1.435{\pm}0.085$, p<0.05; $2.870{\pm}0.253$ vs. $3.211{\pm}0.635$, p<0.05), and a later age of maximum growth than females in head and body length ($5.121{\pm}0.318$ vs. $5.520{\pm}0.333$, p<0.05; $6.884{\pm}0.336$ vs. $7.503{\pm}0.453$, p<0.05). However, females exhibited greater asymptotic values ($105.695{\pm}5.938$ vs. $94.150{\pm}2.507mm$, p<0.001; $111.609{\pm}14.881$ vs. $93.960{\pm}2.150mm$, p<0.05) and longer length of inflection ($60.306{\pm}1.992$ vs. $67.859{\pm}1.330mm$, p<0.0001; $55.714{\pm}7.458$ vs. $46.975{\pm}1.074mm$, p<0.05) than males in tail length. These growth rate constants, viz. the morphological characters and weights of the males and females, were similar to each other in two types of growth curves. These results will be used as necessary data to study species specificity of T. triton with biological foundations.