• 전력전자학회논문지
• /
• 제20권3호
• /
• pp.280-289
• /
• 2015

A high-efficiency full-bridge DC-DC converter with a current-doubler rectifier and an asymmetric pulse-width modulation is proposed. Through the asymmetric pulse-width modulation, the proposed converter achieves zero-voltage switching of power switches without the circulating currents. The proposed converter reduces the output current ripple through the current-doubler rectifier. A control strategy is suggested for the proposed converter to charge battery banks. A constant current and constant voltage charging is performed. The proposed converter achieved a higher efficiency compared with the conventional full-bridge DC-DC converter with a phase-shift modulation. The performance of the proposed converter is evaluated by the experimental results for a 1.0 kW prototype circuit.

• Journal of Power Electronics
• /
• 제17권1호
• /
• pp.31-40
• /
• 2017

A novel voltage-fed single-stage power factor correction (PFC) full-bridge converter based on asymmetric phase-shifted control for battery chargers is proposed in this paper. The attractive feature of the proposed converter is that it can operate in a wide output voltage range without an output low-frequency ripple, which is indispensable in battery charger applications. Meanwhile, the converter can maintain a high power factor and a controllable dc bus voltage over a wide output voltage range. In this paper, the realization of PFC and the operation principle of asymmetric phase-shifted control are given. A small-signal analysis of the proposed single-stage power factor correction (PFC) full-bridge converter is performed. Experimental results obtained from a 1kW experimental prototype are given to validate the feasibility of the proposed converter. The PF is higher than 0.97 over the entire output voltage range with the proposed control strategy.

• 전력전자학회논문지
• /
• 제15권2호
• /
• pp.103-110
• /
• 2010

본 논문에서는 대용량급 전력변환회로를 대상으로, 기존 위상천이 풀 브리지 컨버터의 환류 전류 문제를 해결하기 위하여 새로운 모드 가변형 비대칭 풀 브리지 컨버터를 제안한다. 제안된 회로는 구동시비율 D에 따라 50% 이하에서는 비대칭 풀 브리지 컨버터로 동작하며, 50% 이상에서는 능동 클램프 풀 브리지 컨버터로 동작하게 된다. 따라서 제안된 회로는 정상상태시 약 50% 시비율로 동작되므로 기존 위상천이 풀 브리지 컨버터의 문제점인 환류전류를 제거 할 수 있으며, 이를 통하여 도통 손실을 줄일 수 있다. 또한, 넓은 부하범위에서 영전압 스위칭 동작이 가능하며, 출력 전류 리플도 매우 작은 장점이 있다. 특히 순간정전시 능동 클램프 컨버터로 동작 모드가 변하여 50~100% 시비율로 동작되므로 넓은 입력전압범위에 대해 대응이 가능하다. 본 논문에서는 제안된 회로의 동작원리 및 PSIM simulation을 수행하였으며, 1.2kW급 시작품을 제작하여 제안된 회로의 타당성을 검증하였다.

• Structural Engineering and Mechanics
• /
• 제9권1호
• /
• pp.17-35
• /
• 2000

Dynamic response of a three span continuous bridge has been determined by full scale experiments on the bridge. In the experiments, a heavy vehicle was driven across the bridge at different speeds and along different lanes of travel and the strains were recorded at different locations. The bridge was made of reinforced concrete and was asymmetric in plan and in elevation. Frequencies and modes of vibration excited by the vehicle were determined. The dependence of the dynamic amplification on bridge location and vehicle speed was investigated and dynamic amplifications up to 1.5 were recorded, which was higher than values predicted by bridge design codes. It was evident that when this asymmetric bridge was loaded by an asymmetric forcing function, higher modes, which are lateral and/or torsional in nature, were excited. Dynamic modulus of elasticity and the support stiffness influenced the natural frequencies of the bridge, which in turn influenced the dynamic amplifications. Larger than anticipated dynamic amplification factors and the excitation of lateral and/or torsional modes should be of interest and concern to bridge engineers.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2019년도 전력전자학술대회
• /
• pp.139-141
• /
• 2019

Capacitive power transfer has an advantage in the simplicity of the energy link structure. So, the conventional phase -shift full bridge sometime is not always the best choice because of its complexity and high cost. On the other hand, the link capacitance is usually very low and requires high-frequency operation, but, the series resonant converter loses zero-voltage switching feature in the light load condition, which makes the switching loss high especially in CPT system. The paper proposes a new low-cost topology based on asymmetric half-bridge to achieve simplicity as well as wide zero voltage switching range. The design procedure is presented, and circuit operations are analyzed and verified by simulation.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2001년도 하계학술대회 논문집 B
• /
• pp.989-991
• /
• 2001

The new converter topology using full bridge inverter for the switched reluctance motor drives is proposed. The proposed SRM drives are supplied by the pulse voltage source, while the conventional drives are supplied by dc voltage source. Proposed converter maintains the characteristics of asymmetric bridge converter and has advanced characteristics.

• International Journal of Railway
• /
• 제3권3호
• /
• pp.83-89
• /
• 2010

This paper attempts to extract the fundamental dynamic properties, i.e. natural frequencies, damping ratios of the 48 m-long, $20^{\circ}$ skewed real bridge with PSC girders wrapped by a steel plate. The forced vibration test is achieved by mounting 12 Hz-capacity of artificial oscillator on the top of bridge deck. The acceleration histories at the 9 different locations of deck surface are recorded using accelerometors. From this full-scaled vibration test, the two possible resonance frequencies are detected at 2.38 Hz and 9.86 Hz of the skewed bridge deck by sweeping a beating frequency up to 12 Hz. The absolute acceleration/energy exhibits much higher in case of higher-order twist mode, 9.86 Hz due to the skewness of bridge deck which leads asymmetric situation of vibration. This implies the test bridge is under swinging vertically in fundamental flexure mode while the bridge is also flickered up and down laterally at 9.86 Hz. This is probably by asymmetric geometry of skewed deck. A detailed 3D beam-shell bridge models using finite elements are performed under a series of train loads for modal dynamic analyses. Thereby, the effect of skewness is examined to clarify the lateral flickering caused by asymmetrical geometry of bridge deck.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1999년도 전력전자학술대회 논문집
• /
• pp.135-138
• /
• 1999

This paper analysis magnetic circuit of toroida SRM and simulate optimal switching angle. In this troidal SRM, two of three phase are energized at an arbitrary instance while it is with only one phase in case of typical SRM. It has many advantages in the size of machine and power efficiency. Not only typically Known topologies witched reluctance motors such as asymmetric converter but full bridge converter are safe to employ

• 한국지진공학회논문집
• /
• 제19권4호
• /
• pp.161-171
• /
• 2015

A series of tests was conducted for full-scale single-pylon asymmetric cable-stayed bridges using a system of multiple shaking tables. The 2-span bridge length was 28 m, and the pylon height was 10.2 m. 4 different base conditions were considered: the fixed condition, RB (rubber bearings), LRB (lead rubber bearings), and HDRB (high damping rubber bearings). Based on investigation of the seismic response, the accelerations and displacements in the axial direction of the isolated bridge were increased compared to non-isolated case. However, the strain of the pylon was decreased, because the major mode of the structure was changed to translation for the axial direction due to the dynamic mass. The response of the cable bridge could differ from the desired response according to the locations and characteristics of the seismic isolator. Therefore, caution is required in the design and prediction in regard to the location and behavior of the seismic isolator.

• 항공우주시스템공학회지
• /
• 제16권3호
• /
• pp.93-98
• /
• 2022

본 논문에서는 풀 브릿지 인버터의 비선형성을 고려한 단상 영구자석 동기 전동기의 오픈 루프 기동성을 개선하기 위한 구형파 전압 주입 기법을 제안한다. 일반적으로 단상 영구자석 동기 전동기는 3상 교류기와 달리 풀 브릿지 인버터를 채택하고 있으며 대칭 공극으로 자기 회로를 설계할 경우, 영토크 지점의 특정 위치에서 기동이 불가능할 수 있기에 비대칭 공극 설계가 요구된다. 이러한 단상 영구자석 동기 전동기의 구동 특성상 센서리스 운전 모드의 오픈 루프 제어시 기동 실패의 가능성이 상당히 높다. 본 논문에서는 이러한 문제를 해결하기 위해 인버터의 비선형성을 고려한 구형파 전압을 인가하여 기동 성능을 개선하는 기법을 제안하고자 한다. 제안한 알고리즘은 다수의 실험을 통해 타당성을 검증하였다.