• 한국세라믹학회지
• /
• 제35권8호
• /
• pp.775-782
• /
• 1998

This experiment is third study concerning BaO-{{{{ { { Pr}_{ 2} O}_{3 } }}-{{{{ { TiO}_{2 } }} (Ln=Sm, Nd, Pr, La..) system which is known to show a high dielectric constant and Q value in microwave dielectric materials. The process of cry-stallization and the microwave dielectric properties of the specimens sintered at 1220-140$0^{\circ}C$ for 2 hr was investigated in the BaO-(Na,{{{{ { { Pr})_{2 }O }_{3 } }}-{{{{ { TiO}_{2 } }} as well as BaO-{{{{ { { Pr}_{ 2} O}_{3 } }}-{{{{ { TiO}_{2 } }} system. The single phase BaPr2Ti5O14 and Ba(Nd,{{{{ { { Pr})_{2 }O }_{3 } }}Ti5O14 was finally formed from the Pr2Ti2O7 (Nd, Pr)2Ti2O7 as a secondary phase in the BaO-{{{{ { { Pr}_{ 2} O}_{3 } }}-{{{{ { TiO}_{2 } }} and BaO-(Nd, {{{{ { { Pr})_{2 }O }_{3 } }}-{{{{ { TiO}_{2 } }} system respectively The dielectric constant of the specimens sint-ered at 1280~131$0^{\circ}C$ showed the maximum value as 105(BaO-{{{{ { { Pr}_{ 2} O}_{3 } }}-{{{{ { TiO}_{2 } }} system) and 88 (BaO-(Nd,{{{{ { { Pr})_{2 }O }_{3 } }}-{{{{ { TiO}_{2 } }} system) and the Q values of them showed higher value than 1800 which are due to the maximum den-sity. However the dielectric properties of the specimens sintered at higher temperature than 131$0^{\circ}C$ were reduced due to the increases of pore which were resulted from the sudden grain growth.

• 한국세라믹학회지
• /
• 제28권4호
• /
• pp.305-314
• /
• 1991

This study was conducted to research the formation and the color development of NiO-ZnO-Fe2O3-TiO2-SnO2 system for the purpose of synthesizing the spinel pigments which are stable at high temperature. After preparing ZnO-Fe2O3 as a basic composition, {{{{ chi }}NiO.(l-{{{{ chi }})ZnO.Fe2O3 system, {{{{ chi }}NiO.(l-{{{{ chi }})ZnO.TiO2 system, and {{{{ chi }}NiO.(l-{{{{ chi }})ZnO.SnO2 system were prepared with {{{{ chi }}=0, 0.2, 0.5, 0.7, 1 mole ratio respectively. The manufacturing was carried out at 128$0^{\circ}C$ for 30 minutes. The reflectance measurement and the X-ray analysis of these specimens were carried out and the results were summarized as follows. 1. In the specimens which included NiO, it was difficult for the spinel structure to be formed. 2. As increasing the contents of NiO and Fe2O3, all the groups which were yellow or green colored changed to brown. 3. NiO-ZnO-Fe2O3 system and NiO-ZnO-TiO2 system formed the spinel structure and the illmenite structure appeared in NiO-TiO2 system.

• 한국세라믹학회지
• /
• 제14권3호
• /
• pp.187-192
• /
• 1977

For the purpose researching to the influence of tetrahedral and octahedral preference of cations of $Ni^{2+}$, $Ti^{4+}$ upon the formation and the color development of the $ZnO-SnO_2$ spinel containing $Ni^{2+}$ and $Ti^{4+}$ ions, the gradual substitution of $Ni^{2+}$ ions for $Zn^{2+}$ ions and of $Ti^{4+}$ ions for $Sn^{4+}$ ions of the spinel in NiO-ZnO-$SnO_2$-$TiO_2$ system was carried out. On samples prepared by calcining the oxide and basic cabonate mixtures at $1300^{\circ}C$ for 2 hours, the X-ray analysis, measurement of reflectance and the test of their stabilaity as a glaze pigment were also carried out. The results are summarized as follows 1) Single spinel was formed completely to x=1 in the $xNiO\cdot(2-x)ZnO\cdot{SnO}_2$system, and gave brilliant lightgreen hue. Moreover, $NiO\cdot{ZnO}\cdot{SnO}_2$ formed easily spinel than $NiO\cdot{MgO}\cdot{SnO}_2$ because Zn^{2+}$ ions had more strong tetrahedral preference than $Mg^{2+}$ ions. 2) As the gradual substitution of $Ti^{4+}$ ions for $Sn^{4+}$ ions in $NiO\cdot{MgO}\cdot{SnO}_2$ system, the spinels formed well and was nearly not changed in the hue. 3) The results of glaze test. (1) As the gradual substitution of $Ni^{2+}$ ions for $Zn^{2+}$ ions, the color changed from dull white to graish broun gradually in calcium-zinc glaze and calcium glaze, and from white to beige in tile glaze. (2) As the gradual substitution of $Ti^{4+}$ ions for $Sn^{4+}$ ions in $NiO-ZnO-SnO_2-TiO_2$ system, the color was become dull generally and was not change in tile glaze.

• Journal of Information Display
• /
• 제2권1호
• /
• pp.38-42
• /
• 2001

Thin films of $In_2O_3-SnO_2$(ITO), $SnO_2$, and $SiO_2$ were prepared on the PET substrate by DC magnetron roll sputtering. 135 nm thick ITO film on $SiO_2$/PET substrate has sheet resistance as low as 55 ${\Omega}/square$ and transmittance as high as 85%. $H_2O$gas permeation through the film was 0.35 g/$m^2$ in a day. These properties are enough on optical film for the plastic LCD substrate or touch panel. Both refractive index and sheet resistance of ITO was found to be very sensitive to $O_2$ flow rate. Oxygen flow conditions have been optimized from 4 to 5 SCCM at $10^{-3}$torr. It is also shown that both thickness of $SnO_2$ and refractive index of $SiO_2$ decrease as $O_2$ flow rate increases.

• 전자공학회논문지A
• /
• 제29A권4호
• /
• pp.22-27
• /
• 1992

The cyclic voltammogram characteristics at the magnetized SrO${\cdot}6Fe_{2}O_{3}$ ceramics/(($10^{-3}$M KCI + p-Si powders) and /(($10^{-4}$M CsNO$_3$ + n-GaAs powders) suspension interfaces have been studied using the microelectrophoresis and the cyclic voltammetric method. The negatively charged ions are specifically absorbed on the virgin and the magnetized SrO${\cdot}6Fe_{2}O_{3}$ ceramics surfaces. The zeta potentials of the p-Si and n-GaAs colloidal semiconductors are + 41mV and -44.8mV, respectively. The magnetization effects act as potential barriers at the magnetized SrO${\cdot}6Fe_{2}O_{3}$ interfaces. The positivelely charged p-Si and the negatively charged n-GaAs colloidal semiconductors act as potential barriers at the virgin SrO${\cdot}6Fe_{2}O_{3}$ interfaces. On the other hand, the charged p-Si and n-GaAs colloidal semiconductors act as potential barrier scavengers at the magnetized SrO${\cdot}6Fe_{2}O_{3}$ interfaces. The magnetization effects and the charged colloidal semiconductor effects are irreversible and interdependent.

• 한국전기전자재료학회논문지
• /
• 제30권6호
• /
• pp.372-375
• /
• 2017

ZnO thin films were deposited by RF magnetron sputtering and then diffused by using an As source in the ampouletube. Also, the ZnO p-n homojunction was made by using As-doped ZnO thin films, and its properties were analyzed. After the As doping, the surface roughness increased, the crystal quality deteriorated, and the full width at half maximum was increased. The As-doped ZnO thin films showed typical p-type properties, and their resistivity was as low as $2.19{\times}10^{-3}{\Omega}cm$, probably because of the in-diffusion from an external As source and out-diffusion from the GaAs substrate. Also, the ZnO p-n junction displayed the typical rectification properties of a p-n junction. Therefore, the As diffusion method is effective for obtaining ZnO films with p-type properties.

• 한국세라믹학회지
• /
• 제26권2호
• /
• pp.210-220
• /
• 1989

The properties of the powder of Al2O3-15v/o ZrO2(＋3m/o Y2O3) system prepared by co-precipitation method at the pH values of 7, 9, 10 and 11 were investigated. Al2(SO4)3.18H2O, ZrOCl2.8H2O and YCl3.6H2O were used as starting materials and NH4OH as a precipitation agent. Zirconium hydroxide decreased the specific surface area of aluminum hydroxide of AlOOH type, while increased the specific surface area of aluminum hydroxide of Al(OH)3 type, and formed co-network structure of Al-O-Zr type with the aluminum hydroxides. The rate of transition to $\alpha$-Al2O3 from co-precipitated materials occurred in the order of 7≒10, 9 and 11 of pH values. Al2O3 and ZrO2 interacted to bring about coupled grain growth, and the growth of ZrO2 crystallite size rapidly occurred within $\theta$-Al2O3 matrix. Segregation did not occur in the system Al2O3-15v/o ZrO2(＋3m/o Y2O3) and Y2O3 acted as a stabilizer to ZrO2. The lattice strain of tetragonal ZrO2 was increased by the constraint effect of Al2O3 matrix.

• 한국대기환경학회지
• /
• 제8권1호
• /
• pp.58-67
• /
• 1992

For removing $NO_x$ and $SO_x$ from the flue gases emitted from stationary sources, $V_2O_5-MoO_3/TiO_2$ catalysts were prepared by the conventional impregnation method (aqueous solution) and a sort of surface fixation method(nonaqueous solution) as reported excellent reproducibility catalysts. And these catalysts observed their catalytic activities as well as their surface properties. V-Mo-O oxide, prepared from nonaqueous solution of $VOCl_3$ and $Mo(CO)_6$ and aqeous solution method, was supported as amorphous state by XRD and SEM measurements. The infrared spectra of fresh and used catalysts showed that in used catalysts, V=O bands decreased and new bands of vanadium oxysulfate bands were very sensitive. So the catalysts prepared from nonaqueous solution may bring about the high activity. Results from catalytic activity measurements at 350$^\circ$C, in the presence of $SO_2, NO$ conversion was more increased than in absence of $SO_2$. As the $MoO_3$ was added to $V_2O_5/TiO_2 system, SO_2$ conversion increased. It found that from the results, $V_2O-5-MoO_3/TiO_2$ catalysts prepared from an nonaqueous solution may bring about the high activity for both the reaction of NO and $SO_2$ removal.

• 한국세라믹학회지
• /
• 제30권10호
• /
• pp.819-822
• /
• 1993

The purpose of this paper is a investigation of sensing mechanism for the carbon monoxide gas in CuO infiltrated ZnO ceramics. Potential barriers between CuO and ZnO can explain the selective sensing of carbon monoxide gas in the physically contacted CuO/ZnO ceramics. A specimen having no potential barrier between CuO and ZnO was prepared to see whether the gas sensing mechanism is related to the potential barrier. CuO and ZnO was prepared to see whether the gas sensing mechanism is related to the potential barrier. CuO was painted on the non electrode sides of ZnO ceramics. The CuO painted ZnO ceramics showed that the sensitivityfor the carbon moxnoxide gas was 1.3 times as high as that for the hydrogen gas. It is almost same gas sensitivity as that of the CuO infiltrated ZnO ceramics.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 추계학술대회 논문집 학회본부 C
• /
• pp.506-508
• /
• 2000

Oxide of the form $Mn_{3}O_{4}-NiO-Fe_{2}O_{3}$ present properties that make them useful as multilayer chip NTC thermistor for mobile phone NTC thermistor electric properties of $Mn_{3}O_{4}-NiO-Fe_{2}O_{3}$ system has been measured as a function of temperature and composition. In $Mn_{3}O_{4}-NiO-Fe_{2}O_{3}$ composition, it can be seen that resistivity and B-constant were increased as the ratio of $Mn_{3}O_{4}/F_{2}O_{3}$ and $Mn_{3}O_{4}$/NiO was increased. In particular, resistance change ratio (${\Delta}R$), the important factor for reliability varied within ${\pm}1%$, indicating the compositions of these products could be available for mobile phone.