• Journal of the Korean Vacuum Society
• /
• v.22 no.5
• /
• pp.225-230
• /
• 2013

Cryopump removes gas molecules by condensation and adsorption. Therefore, cryo-surface temperature and corresponding vapor pressure influence directly the pumping performance. If the surface temperature of any part is neither low nor high, there occurs the desorption of gas molecules condensed or adsorbed, and the emitted molecules can be captured again, which leads to a time-consuming and fluctuating change of the pressure. Though every gas can show such a pressure instability at a specified temperature range, the instability generated in a sputter system using Ar as a working gas and operating with a cryopump is especially undesirable. In this paper the cause of the argon instability is analyzed and corrective is provided through the measurement of the Ar recovery time.

• Journal of computational fluids engineering
• /
• v.20 no.3
• /
• pp.47-53
• /
• 2015

This study performed numerical simulation to elucidate the characteristics of flow past a rectangular cylinder with various values of the aspect ratio(AR) of the cylinder. We calculated the flow field, force coefficients and Strouhal number of vortex shedding depending on the Reynolds number(Re) and the aspect ratio. The $AR{\approx}1$ is preferred for drag reduction, and 0.375$AR{\approx}0$ is recommended if suppression of the lift-coefficient fluctuation and the shedding frequency is desirable. Furthermore the criticality of the Hopf bifurcation is also reported for each AR.

• Journal of the Korean Chemical Society
• /
• v.40 no.1
• /
• pp.20-27
• /
• 1996

A stable and accurate inverse method for extracting potential from spectroscopic data studied. The method is based on the Tikhonov regularization method to overcome the possible instability of nonlinear inverse problems using a priori smooth properties of the potential energy surface. The merit of this method is to treat the potential as continuous functions of the intermolecular coordinates instead of the conventional parameter fitting of restricted potential forms. Numerical study for the Ar-Ar show that from spectroscopic data the exact potential has been recovered whole region and the discrepancies by the dispersion force observed at the large distance between the exact and Morse potential or from RKR method can be eliminated by this method.

• Mass Spectrometry Letters
• /
• v.10 no.1
• /
• pp.27-31
• /
• 2019

In this article, the properties of ${CO_2}^+(CO_2)_n$ clusters in a Paul ion trap have been investigated using mass-selective instability mode which conducted by chosen precursor ions, mainly $Ar^+$ and ${CO_2}^+$ produced by a mixture of Ar and $CO_2$. Exposure of ${CO_2}^+$ ions to $CO_2$ molecules, lead to the formation of ${CO_2}^+(CO_2)_n$ clusters. Here, Ar gas react as a buffer gas and lead to form ${CO_2}^+(CO_2)_n$ cluster by collisional effect.

• The Bulletin of The Korean Astronomical Society
• /
• v.39 no.2
• /
• pp.97.2-97.2
• /
• 2014

In this paper, we study the stability and dynamics of a magnetic field producing the M6.6 class solar flare taking place in NOAA active region (AR) 11158 on 2011 February 13th. Toriumi et. al. (2013) recently suggest that a fine scale magnetic structure on the photosphere gives a major possibility to produce the M6.6 class flare. On the other hand, they don't discuss the torus instability as a plausible mechanism even though Zhao et. al. (2014) and Janvier et. al. (2014) suspect it as the trigger mechanism of X2.2 class flare taking place later in the same AR. We are the first to investigate the stability of a nonlinear force-free field (NLFFF) prior to the M6.6 class flare against the torus instability by using analytical and numerical approaches. Consequently, we found that our NLFFF is quite stable against small perturbation. This result supports that the flare is triggered by the photospheric motion suggested by Toriumi et. al. (2013). We further perform another MHD simulation with an anomalous resistivity using the NLFFF as an initial condition. As a result, we found the eruption of strongly twisted lines. We compare our simulation results with observations and discuss relevant dynamics in detail.

• Fire Science and Engineering
• /
• v.28 no.3
• /
• pp.34-42
• /
• 2014

The concentrations of inert gases ($N_2$, Ar, $CO_2$ and He) required to induce the flame instabilities such as swing, rotation, lifted and blow-out were measured in a cup burner nonpremixed flames for $CH_4$ and $C_3H_8$ fuels. Quantitative differences in the extinguishing concentration with fire suppression criteria (i.e. blow-out or onset of flame instability) were also examined. It was found that the difference in extinguishing concentration was increased with the appearance of lifted flame and the low extinguishing performance of inert gaseous. The maximum difference in extinguishing concentration with the suppression criteria was approximately 35% at the highest fuel velocity condition (1.3 cm/s) for the $C_3H_8$-air nonpremixed flame. It can be also expected that the extinguishing concentration by the criteria based on the onset of flame instability will provide the useful information from the viewpoint of the accurate and economical design concentration.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.8 no.3
• /
• pp.407-410
• /
• 1998

The characteristics of $(Ba,Sr)TiO_3$[BST] thin films with the variation of $O_2/Ar$ ratio in sputtering gas deposited on $RuO_2$ bottom electrode were investigated. Dielectric constant of BST film increases from 135 to 190 with increasing oxygen partial pressure from 10 to 50, which is mainly due to the improved crystallinity of BST film. The instability of $RuO_2$ surface in $BST/RuO_2$ interface and the increase in the surface roughness of BST thin films with higher $O_2/Ar$ ratio appeared to play an important roles on the degradation of the leakage current characteristics of $Al/BST/RuO_2$ capacitor with various $O_2/Ar$ ratio in sputtering gas. As a consequence, the leakage current of BST thin film showed the lowest value of $1.9{\times}10^{-7}\; A/{\textrm}{cm}^2$ at $O_2/Ar{\approx}1/9$.

• Journal of Ocean Engineering and Technology
• /
• v.12 no.3 s.29
• /
• pp.60-67
• /
• 1998

In this study, the J-Resistance Curve and material tearing modulus of SA508-C3 steel, which is one of the used nuclear pressure vessel steel, are measured ar room temperature, $200^{circ}C$ and $300^{circ}C$ according to load ratio analysis and ASTM E813, ASTM E1152, respectively. It is observed that J-R curve and Tmat value decrease as the temperature level increase. Applicability of $T_j$ proposed by Paris et al as instability parameter for ductile material is investigated. It is concluded that results are the $T_j$ parameter may be used as a crack instability parameter.

• Journal of Korea Game Society
• /
• v.16 no.6
• /
• pp.29-38
• /
• 2016

The Korean game industry has stopped growing due to internal and external instability. It is the fourth industrial revolution that has been mentioned as a new breakthrough in the domestic game industry in front of these internal and external instabilities. The fourth industrial revolution is changing the paradigm of the existing industrial structure, and has brought ecological changes not only to the manufacturing industry but also to the contents industry as a whole. In this paper, we will explore the development direction of domestic game industry through the 4th industrial revolution and study the relation between development of AI and AR / VR and game industry which will be the main core of the fourth industrial revolution in the future.

• Proceedings of the IEEK Conference
• /
• 2002.07c
• /
• pp.1807-1810
• /
• 2002

This paper presents a technique for avoid- ing indefiniteness in Maximum Likelihood (ML) criteria for Direction-of-Arrival (DOA) finding using a sensor ar- ray with arbitrary configuration. The ML criterion has singular points in the solution space where the criterion becomes indefinite. Solutions fly iterative techniques for ML bearing estimation may oscillate because of numerical instability which occurs due to the indefiniteness, when bearings more than one approach to the identical value. The oscillation makes the condition for terminating iterations complex. This paper proposes a technique for avoiding the indefiniteness in ML criteria.