• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.6
• /
• pp.698-705
• /
• 2010

A vehicle antenna for AM, FM, TDMB, GPS systems was designed and implemented. Omnidirectional AM antenna was designed by ferrite turn style antenna. For the FM and TDMB antenna, folded monopole antenna which helical is folded was applied. GPS antenna for the bandwidth achievement was designed by trapezoidal microstrip patch that has air substrate. Receiving signal strengths by the measurement were presented for the AM, FM and TDMB antenna. AM signal strength was -65.7 dBm, this strength is almost as same conventional pole antenna as -63.4 dBm. It can be replaced conventional pole or glass antenna by the studied antenna. Signal strengths for FM and TDMB were -55.66 and -43.50 dBm at center frequency, they are 5~10 dB higher than conventional antenna. Measurements of bandwidth and gain for the GPS antenna showed 135 MHz under VSWR 2 : 1 and 4.31 dBi, gains over GPS band were 3~5 dB higher than ceramic patch antenna.

• Proceedings of the IEEK Conference
• /
• 1998.06a
• /
• pp.30-33
• /
• 1998

In this paper, 60 GHz indoor broadband wireless channels are measured with various configurations in a typical coffice environment. Mesurements are taken at nine positions of the room and the base-station antenna is placed either at the center or at an edge of the measurement room, and the remote-station antenna is either sharp beam or broad beam type. The rms delay spread(RDS) and normalized received power (NRP) are estimated from the measurements. Bit error rate simulations are performed using impulse responses for two measurement positions with QPSK/DQPSK OFDM modulation. Using sharp beam antenna results in superior performances than using broad beam antenna in terms of both bit error rates (BER) and NRP penalty. Also, placing the bese-station antenna at the center is superior to placing it at an edge in terms of BER and NRP.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.77-81
• /
• 2001

This paper proposed a novel chip type ceramic dielectric antenna by using the advanced meander line technique that the radiational metals are formed on the face of ceramic dielectric(8 ${\times}$ 4 ${\times}$ 1.5 mm, alumina) and both facses of substrate(1.0 mm thickness, FR-4). The performance of the antenna model has a good agreements between measurements and computed results. Resultly, it has a 10 dB return-loss bandwidth(2.4～2.4835 GHz) and 1.7 dBi measured radiation gain for Bluetooth application. The proposed antenna model can overcome the problems of the radiation gain from the small antenna's size.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.3
• /
• pp.329-339
• /
• 1999

LPXDA(Log-Periodic X Dipole Antenna), consisting of X dipole elements, was proposed as a Log-periodic antenna with short boom length and good Performance relative to LPDA(Log-Periodic Dipole Antenna) . LPXDA for operating frequency band of 500 MHz~l,000 MHz was designed and radiation characteristics of the designed antenna was analyzed by moment method, and compared with LPDA characteristics. The proposed LPXDA, in this paper, was found to have shorter boom length by 20% and better radiation characteristics with variations of frequency relative to the LPDA. The calculated results show good agreement with measurements.

• ETRI Journal
• /
• v.32 no.4
• /
• pp.618-621
• /
• 2010

A low cross-polarization broadband stacked patch antenna is proposed. By means of the stacked patch configuration and probe-fed strip feed technique, the VSWR 1.2:1 bandwidth of the patch antenna is enhanced to 22% from 804 MHz to 1,002 MHz, which outperforms the other available patch antennas (<10%). Furthermore, the antenna has a cross-polarization level of less than -20 dB and a gain level of about 9 dBi across the operating bandwidth. Simulation results are compared with the measurements, and a good agreement is observed.

• Proceedings of the KSRS Conference
• /
• 2000.04a
• /
• pp.125-130
• /
• 2000

This paper deals with antenna configurations of a two-antenna synthetic aperture microwave radiometer for the high spatial resolution and precision of brightness temperature measurements. Four different types of antenna configurations are considered. The directional patterns of each type are compared in the paper.

• Journal of the Semiconductor & Display Technology
• /
• v.20 no.4
• /
• pp.102-107
• /
• 2021

In this paper, the measurements of received power was shown and compared in two developed 5.8GHz 25W wireless charging systems. One is the system using commercial transmission antenna, and the other is the system using transmission antenna combined with metamaterial. The system combined with metamaterial shows higher received power due to negative reflective index of metamaterial. In addition, a comparative analysis of the systems shows that the transmission efficiency in the systems can decrease the real gain of transmission antenna due to higher side robe of beam pattern. The side robe beams of transmitting antenna interferes transmitted beam with the reflected beams from the bottom region due to the side robes. The failure problems of the RF wireless charging systems are discussed and proposed in order to charge mobile devices through the RF wireless charging system.

• ETRI Journal
• /
• v.40 no.2
• /
• pp.180-187
• /
• 2018

In this paper, we introduce a ground radiation antenna that uses controlled endless metal rim modes. In the proposed technique, the metal rim mode is tuned and excited as a one-wavelength radiator by a small ground radiation antenna. The proposed antenna occupies a clearance of $1mm{\times}4mm$ in a $30mm{\times}20mm$ ground plane. A metal rim with dimensions of $34mm{\times}24mm$ surrounds the ground plane, and the metal rim is separated from the ground plane by a gap of 2 mm. In addition, a lumped capacitor is inserted between the metal rim and the ground plane to control the characteristic mode of the metal rim such that the resonance of the metal rim is tuned to be equal to the operating frequency. By performing simulations and measurements, we compare the performance of the proposed antenna with that of a reference antenna that does not have an inserted capacitor between the metal rim and the ground plane. The results show that a significant improvement of the radiation performance is obtained by employing the proposed technique.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.6 no.2
• /
• pp.113-118
• /
• 2007

KPCS internal antenna in this paper, is designed and fabricated using the theory based on the folded monopole antenna. I propose folded monopole internal antenna which has high gain low profile structure with easy installation into the handset of mobile phone. Design frequency is 1.8 GHz that is a center frequency of Korea PCS frequency band, and the impedance variances due to change of antenna structure as a length and width are simulated. Measurements show that input VSWR range under 2:1 is 1.72 - 1.88 GHz, and radiated H-plane pattern is omnidirectional under passive state. Active sensitivities and output power of phone applied antenna are $-105\;{\sim}\;-108\;dBm$ and $22.5\;{\sim}\;23.6\;dBm$ max., respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.12 s.91
• /
• pp.1131-1140
• /
• 2004

In this paper, we proposed a flate-plate antenna employing semi-annular slots for satellite broadcast reception. The radiating element of the antenna is dual annular slots fed by a strip dipole, which have a wider bandwidth than the rectangular slot. A $16{\times}16$ array antenna is designed using stripline T-junction power dividers. Measurements of the fabricated antenna show a gain of 28.0$\~$29.5 dB in 11.7$\~$12.8 GHz frequency range.