• 한국전기전자재료학회논문지
• /
• 제16권3호
• /
• pp.181-185
• /
• 2003

Influence of post gate oxidation anneal on Negative Bias Temperature Instability (NBTI) of PMOSFE has been investigated. At oxidation anneal temperature raised above 950$^{\circ}$C, a significant improvement of NBTI was observed which enables to reduce PMO V$\_$th/ shift occurred during a Bias Temperature (BT) stress. The high temperature anneal appears to suppress charge generations inside the gate oxide and near the silicon oxide interface during the BT stress. By measuring band-to-band tunneling currents and subthreshold slopes, reduction of oxide trapped charges and interface states at the high temperature oxidation anneal was confirmed.

• 한국자기학회지
• /
• 제5권5호
• /
• pp.636-640
• /
• 1995

FeN thin films were deposited on glass by RF diode reactive sputtering. The films were annealed in the air and in vacuum. The film annealed in the air showed sharp decrease of saturation magnetization and change of easy axis direction to hard axis direction and vice versa after $300^{\circ}C$ anneal. The coercivity decreased down to 0.5 Oe after $400^{\circ}C$ anneal. After $450^{\circ}C$ anneal, the film showed ${\varepsilon}-Fe_{2-3}N$ phase. The films annealed in vacuum showed coercivity increase after $300^{\circ}C$ anneal for the film deposited with initial substrate temperature of $35^{\circ}C$ and after $400^{\circ}C$ anneal for the film deposited with initial substrate temperatue of $170^{\circ}C$. These films showed $Fe_{16}N_{2}$ X-ray peaks after $450^{\circ}C$ anneal.

• 전자공학회논문지D
• /
• 제35D권10호
• /
• pp.83-90
• /
• 1998

MOS 캐패시터의 게이트 전극을 비정질 상태의 실리콘으로 형성하여 GOI(Gate Oxide Integrity)특성에 미치는 불순물 활성화 열처리의 효과를 조사하였다. LPCVD(Low Pressure Chemical Vapor Deposition) 방법으로 증착한 비정질 실리콘 게이트 전극은 활성화 열처리에 의하여 다결정 실리콘 상태로 구조가 변화하며, 불순물 원자의 활성화가 충분히 이루어졌다. 또한, 비정질 상태의 게이트 전극은 커다란 압축 응력(compressive stress)을 가지지만, 활성화 열처리 온도가 700℃에서 900℃로 증가함에 따라서 응력이 완화되었고 게이트 전극의 저항도 감소하는 특성을 보였다. 또한 얇은 게이트 산화막의 신뢰성 및 산화막의 계면특성은 활성화 열처리 온도에 크게 의존하고 있었다. 900℃에서 활성화 열처리를 한 경우가 700℃에서 열처리한 경우보다 산화막내에서의 전하 포획 특성이 개선되었으며, 산화막의 신뢰성이 향상되었다. 특히, TDDB 방법으로 예측한 게이트 산화막의 수명은 700℃의 열처리에서는 3×10/sup 10/초였지만, 900℃에서의 열처리에서는 2×10/sup 12/초로 현저하게 개선되었다. 그리고, 산화막 계면에서의 계면 전하 밀도는 게이트의 응력 완화에 따라서 개선되었다.

• E2M - 전기 전자와 첨단 소재
• /
• 제9권1호
• /
• pp.30-37
• /
• 1996

Previously, crystallization of a-Si:H films on glass substrates were limited to anneal temperature below 600.deg. C, over 10 hours to avoid glass shrinkage. Our study indicates that the crystallization is strongly influenced by anneal temperature and weakly affected by anneal duration time. Because of the high temperature process and nonconducting substrate requirements for poly-Si TFTs, the employed substrates were limited to quartz, sapphire, and oxidized Si wafer. We report on poly-Si TFT's using high temperature anneal on a Si:H/Mo structures. The metal Mo substrate was stable enough to allow 1000.deg. C anneal. A novel TFT fabrication was achieved by using part of the Mo substrate as drain and source ohmic contact electrode. The as-grown a-Si:H TFT was compared to anneal treated poly-Si TFT'S. Defect induced trap states of TFT's were examined using the thermally stimulated current (TSC) method. In some case, the poly-Si grain boundaries were passivated by hydrogen. A-SI:H and poly-Si TFT characteristics were investigated using an inverted staggered type TFT. The poly -Si films were achieved by various anneal techniques; isothermal, RTA, and excimer laser anneal. The TFT on as grown a-Si:H exhibited a low field effect mobility, transconductance, and high gate threshold voltage. Some films were annealed at temperatures from 200 to >$1000^{\circ}C$ The TFT on poly-Si showed an improved $I_on$$I_off$ ratio of $10_6$, reduced gate threshold voltage, and increased field effect mobility by three orders. Inverter operation was examined to verify logic circuit application using the poly Si TFTs.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2009년도 제38회 동계학술대회 초록집
• /
• pp.141-141
• /
• 2010

The effect of thermal anneal on the characteristics of structural properties and the enhancement of luminescence and photovoltaic (PV) characteristics of silicon-rich silicon-nitride films were investigated. By using an ultra high vacuum ion beam sputtering deposition, B-doped silicon-rich silicon-nitride (SRSN) thin films, with excess silicon content of 15 at. %, on P-doped (n-type) Si substrate was fabricated, sputtering a highly B doped Si wafer with a BN chip by N plasma. In order to examine the influence of thermal anneal, films were then annealed at different temperature up to $1100^{\circ}C$ under $N_2$ environment. Raman, X-ray diffraction, and X-ray photoemission spectroscopy did not show any reliable evidence of amorphous or crystalline Si clusters allowing us concluding that nearly no Si nano-cluster could be formed through the precipitation of excess Si from SRSN matrix during thermal anneal. Instead, results of Fourier transform infrared and X-ray photoemission spectroscopy clearly indicated that defective, amorphous Si-N matrix of films was changed to be well-ordered thanks to high temperature anneal. The measurement of spectral ellipsometry in UV-visible range was carried out and we found that the optical absorption edge of film was shifted to higher energy as the anneal temperature increased as the results of thermal anneal induced formation of $Si_3N_4$-like matrix. These are consistent with the observation that higher visible photoluminescence, which is likely due to the presence of Si-N bonds, from anneals at higher temperature. Based on these films, PV cells were fabricated by the formation of front/back metal electrodes. For all cells, typical I-V characteristic of p-n diode junction was observed. We also tried to measure PV properties using a solar-simulator and confirmed successful operation of PV devices. Carrier transport mechanism depending on anneal temperature and the implication of PV cells based on SRSN films were also discussed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 추계학술대회 논문집
• /
• pp.157-158
• /
• 2007

Effects of post-metallization anneal (PMA) on interface trap characteristics of Si-$SiO_2$ are studied. The conventional PMA method utilizes forming gas anneal, where 10% hydrogen in nitrogen atmosphere is used. A new PMA method utilizes hydrogen rich PECVD- silicon nitride $(SiN_x)$ film as a hydrogen diffusion source and a out-diffusion blocking layer. It can be shown through charge pumping current measurement that the new PMA is indeed effective to decrease Si-$SiO_2$ interface trap density.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 하계학술대회 논문집
• /
• pp.539-542
• /
• 2001

In SiC semiconductor device processing, it needs high temperature anneal for activation of ion implanted dopants. The macrosteps, 7~8nm in height, are formed on the surface of SiC substrates during activation anneal. We have investigated the effect of thermally-grown SiO$_2$layer on the suppression of macrostep formation during high temperature anneal. The cap oxide layer was found to be efficient for suppression of macrostep formation even though the annealing temperature is as high as the melting point of SiO$_2$. The thin cap oxide layer (10nm) was evaporated during anneal then the macrosteps were formed on SiC substrate. On the other hand the thicker cap oxide layer (50nm) remains until the anneal process ends. In that case, the surface was smoother and the macrosteps were rarely formed. The thermally-grown oxide layer is found to be a good material for the suppression of macrostep formation because of its feasibility of growing and processing. Moreover, we can choose a proper oxide thickness considering the evaporate rate of SiO$_2$at the given temperature.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1998년도 추계종합학술대회 논문집
• /
• pp.565-568
• /
• 1998

The effects of denudation anneals on the properties of 256Mega-bit level devices were investigated. Based on the three-step anneal model, the redistribution of oxygen atom and the defect free zone depth were calculated. A significant outdiffusion of oxygen atoms is occurred during the denudation anneals at high temperature. Junction leakage current of P+/N-Well and N+/P-Well junctions, as a function of denudation anneal temperature, was decreased with increase of anneal temperature and is closely related with the behaviors of oxygen atoms. Also it is found that the denudation anneal at high temperature very effective for the fabrication of reliable 256Mega-bit level devices.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 하계종합학술대회 논문집(2)
• /
• pp.245-248
• /
• 2002

In this paper, the influence of Si surface damage on the NiSi formation has been characterized. The silicon surface is damaged using ion beam type spotter. Then, the effect of H2 anneal and TiN capping layer on the damaged has also been analyzed. The sheet resistance of NiSi formed on damaged Si increased rapidly as the damaging time increases while thermal stability of damaged NiSi was stabler than the undamaged one. In the case when H\ulcorner anneal and TiN capping layer were applied together, the characteristics of NiSi shows a little improvement of the sheet resistance.

• Journal of Magnetics
• /
• 제3권4호
• /
• pp.112-115
• /
• 1998

Possible sources of the stress-anneal-induced anisotropy in FINEMET-type magnets are reviewed and discussed resulting in a conclusion that the most probable origin of this anisotropy is the atomic pair directional ordering. It is also evidence that the anisotropy considered is usually of an easy-plane type.