• Journal of Biomedical Engineering Research
• /
• v.39 no.6
• /
• pp.278-283
• /
• 2018

Nowdays, many people suffer from the neck pain due to forward head posture(FHP) and text neck(TN). To assess the severity of the FHP and TN the craniovertebral angle(CVA) is used in clinincs. However, it is difficult to monitor the neck posture using the CVA in daily life. We propose a new method using the cervical flexion angle(CFA) obtained from a wearable sensor to monitor neck posture in daily life. 15 participants were requested to pose FHP and TN. The CFA from the wearable sensor was compared with the CVA observed from a 3D motion camera system to analyze their correlation. The determination coefficients between CFA and CVA were 0.80 in TN and 0.57 in FHP, and 0.69 in TN and FHP. From the monitoring the neck posture while using laptop computer for 20 minutes, this wearable sensor can estimate the CVA with the mean squared error of 2.1 degree.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7A
• /
• pp.794-806
• /
• 2004

This paper deals with correction of frequency offset and analysis of quantization angle noise in the IEEE 802.1la OFDM system. The rotation phase per symbol due to the carrier frequency offset is estimated from auto-correlation of the short Preambles, which are over-sampled for the reduction of noise in OFDM signals. The pilot signals are introduced to estimate the rotation phase per OFDM symbol due to estimation error of the carrier frequency offset and the sampling frequency onset. During the estimation and correction of the frequency onsets, a CORDIC processor and a look-up table are used for the conversion between a rotation phase and its complex number. Being calculated by a limited number of bits in the CORDIC processor and the look-up table, the rotation phase and its complex number have quantization angle errors. The quantization errors are analyzed as SNR (signal to noise ratio) due to the quantization bit numbers. The minimum bit number is suggested to meet the specification of IEEE 802.1la properly. Finally, the quantization errors are evaluated through simulations on number of quantization bits and SNR of received signals.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.9
• /
• pp.4131-4138
• /
• 2012

In this paper, we propose a Pedestrian Position Information System(PPIS) using low-cost inertial sensors in GPS-disabled area. The proposed scheme estimates the attitude/heading angle and step detection of pedestrian. Additionally, the estimation error due to the inertial sensors is mitigated by using additional sensors. We implement a portable hardware module to evaluate performance of the proposed system. Through the experiments in indoor building, the estimation error of position information was measured as 2.4% approximately.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.6
• /
• pp.955-961
• /
• 2016

Fault location estimation is an important element for rapid recovery of power system when fault occur in transmission line. In order to calculate line impedance, most of fault location algorithm uses by measuring relaying waveform using DFT. So if there is a calculation error due to the influence of phasor by DC offset component, due to large vibration by line impedance computation, abnormal and non-operation of fault locator can be issue. It is very important to implement the robust fault location algorithm that is not affected by DC offset component. This paper describes an enhanced fault location algorithm based on the DC offset elimination filter to minimize the effects of DC offset on a long transmission line. The proposed DC offset elimination filter has not need any erstwhile information. The phase angle delay of the proposed DC offset filter did not occurred and the gain error was not found. The enhanced fault location algorithm uses DFT filter as well as the proposed DC offset filter. The behavior of the proposed fault location algorithm using off-line simulation has been verified by data about several fault conditions generated by the ATP simulation program.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.13 no.4
• /
• pp.713-720
• /
• 2018

The Signal Intelligence (SIGINT) system based on Angle-of-Arrival(AOA) estimation, interference suppression, and transmission beamforming techniques is a cutting edge technology for efficiently collecting various signal information. In this paper, we present the efficient structure of a satellite system consisted of an AOA estimator, an adaptive beamformer, a signal processing and D/B unit, and a transmission beamformer, for collecting signal information. For accurately estimating AOAs of various signals, efficiently suppressing interference or jamming signals, and efficiently transmitting the collected information or data, we employ Multiple Signal Classification (MUSIC), Minimum Variance Distortionless Response (MVDR), and Minimum Mean Square Error (MMSE) algorithms, respectively. Also, we evaluate and analysis the performance of the presented satellite system through the computer simulation.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.244-244
• /
• 2000

We proposed the above-knee prosthesis using rotary MR damper in which knee joint is semi-actively controlled by microprocessor. Dissipation torque in the knee joint can be controlled by the magnetic field which is induced by applying current to a solenoid, Tracking control of knee joint angle was tested by 3-DOF Leg simulator. The experimental results show that the proposed above-knee prosthesis system had good performance in swing phase tracking and repetitive controller in conjunction with a computed control law and PD control law, reduced RMS tracking error as the repetitions of tracking. Moreover, desired knee angle trajectory was generated based on the estimation of gait period with the gyro signal and the tracking control was performed.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.30 no.7
• /
• pp.51-60
• /
• 2002

The Monte-Carlo simulation of statistical analysis is used to investigate the final conditions of states as well as the footprint boundaries resulting from the atmospheric re-entry dispersions. The re-entry dispersions in this paper are specified by a $7\times7$ covariance matrix of latitude, longitude, altitude, bank angle, flight path angle, heading error, and range at entry velocity. The error sources that affect these at re-entry for a deboost are the uncertainties associated with atmospheric density and temperature, initial errors, wind, and estimation error of aerodynamic coefficients. Using $3{\sigma}_n$ deviations of these errors and a nominal flight trajectory, the covariance matrix of state variables can be determined by performing a trajectory error analysis. Major considerations in the application of the Monte-Carlo method are the simulation of perturbed trajectories, bank reversal, and determination of the impact points for each of these trajectories. This paper analyzes the results of uncertainties from the viewpoint of aero-coefficients and bank reversal.

• Journal of Biomedical Engineering Research
• /
• v.22 no.3
• /
• pp.293-301
• /
• 2001

A patient-specific musculoskeletal model, whose parameters can be identified noninvasively, was developed for the automatic generation of patient-specific stimulation pattern in FES. The musculotendon system was modeled as a torque-generator and all the passive systems of the musculotendon working at the same joint were included in the skeletal model. Through this, it became possible that the whole model to be identified by using the experimental joint torque or the joint angle trajectories. The model parameters were grouped as recruitment of muscle fibers, passive skeletal system, static and dynamic musculotendon systems, which were identified later in sequence. The parameters in each group were successfully estimated and the maximum normalized RMS errors in all the estimation process was 8%. The model predictions with estimated parameter values were in a good agreement with the experimental results for the sinusoidal, triangular and sawlike stimulation, where the normalized RMS error was less than 17%, Above results show that the suggested musculoskeletal model and its parameter estimation method is reliable.

• Journal of the Korean Institute of Telematics and Electronics B
• /
• v.32B no.5
• /
• pp.777-787
• /
• 1995

This paper presents a new method for automatically calibrating robot link (Kinematic) parameters during the process of estimating motion parameters of a moving object. The motion estimation is performed based on stereo cameras mounted on the end-effector of a robot manipulator. This approach significantly differs from other calibration approaches in that the calibration is achieved by simply observing the motion of the moving object (without resorting to any other external calibrating tools) at numerous and widely varying joint-angle configurations. A differential error model, which expresses the measurement errors of a robot in terms of robot link parameter errors and motion parameters, is developed. And then a measurement equation representing the true measurement values is derived. By estimating the above two kinds of parameters minimizing the difference between the measurement equations and the true moving pattern, the calibration of the robot link parameters and the estimation of the motion parameters are accomplished at the same time.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.9
• /
• pp.881-885
• /
• 2008

To calculate the attitude in ARS(Attitude Reference System) using 3 gyros and 3 accelerometers, gyro drift must be compensated with accelerometer to avoid divergence of attitude error. Kalman filter is most popular method to integrate those two sensor outputs. In this paper, new Kalman filtering method is proposed for roll and pitch attitude estimation. New states are defined to make linear equation and algorithm for changing Kalman filter parameters is proposed to ignore disturbances of acceleration. This algorithm can be easily applied to low cost ARS.