• ETRI Journal
• /
• v.27 no.5
• /
• pp.539-544
• /
• 2005

An analog CMOS vision chip for edge detection with power consumption below 20mW was designed by adopting electronic switches. An electronic switch separates the edge detection circuit into two parts; one is a logarithmic compression photocircuit, the other is a signal processing circuit for edge detection. The electronic switch controls the connection between the two circuits. When the electronic switch is OFF, it can intercept the current flow through the signal processing circuit and restrict the magnitude of the current flow below several hundred nA. The estimated power consumption of the chip, with $128{\times}128$ pixels, was below 20mW. The vision chip was designed using $0.25{\mu}m$ 1-poly 5-metal standard full custom CMOS process technology.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.35C no.4
• /
• pp.50-59
• /
• 1998

This paper describes a 3.3V 8bit CMOS digital to analog converter (DAC) with two state current cell metrix architecture which consists of a 4 MSB and a 4 LSB current matrix stage. The symmetric two stage current cell matrix architecture allow the designed DAC to reduce hot only a complexity of decoding logics, but also a number of wider swing cascode curent mirros. The designed DAC with an active chip area of 0.8 mm$_{2}$ is fabricated by a 0.8 .mu.m CMOS n-well standard digital process. The experimental data shows that the rise/fall time, the settling time, and INL/DNL are6ns, 15ns, and a less than .+-.0.8/.+-.0.75 LB, respectively. The designed DAC is fully operational for the power supply down to 2.0V, such that the DAC is suitable for a low voltage and a low power system application. The power dissipation of the DAC with a single power supply of 3.3V is measured to be 34.5mW.

• Journal of the Korea Computer Industry Society
• /
• v.2 no.10
• /
• pp.1253-1260
• /
• 2001

In this paper, a new voltage-controlled tunable analog active element for low-voltage applications and information protection is proposed. The proposed active element is composed of the CMOS complementary cascode circuit which can extend transconductance of an element. Therefore, the unity gain frequency which is determined transconductance is increased than that of the conventional element. And then these results are verified by the $0.25\mutextrm{m}$ CMOS n-well parameter HSPICE simulation. As a result, the gain and the unity gain frequency are 42㏈ and 200MHz respectively in the element on 2V supply voltage. And power dissipation of the designed circuit is 0.32mW.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.1
• /
• pp.105-111
• /
• 2013

We have developed an analog associative memory implemented with an analog array which has linear writing and erasing characteristics. The associative memory adopts a winner-take-all strategy. The operation for reading in the memory is executed with an absolute differencing circuit and a winner-take-all (WTA) circuit suitable for a nearest-match function of a content-addressable memory. We also present a system architecture that enables highly-paralleled fast writing and quick readout as well as high integration density. A multiple memory cell configuration is also presented for achieving higher integration density, quick readout, and fast writing. The system technology presented here is ideal for a real time recognition system. We simulate the function of the mechanism by menas of Hspice with $1.2{\mu}$ double poly CMOS parameters of MOSIS fabrication process.

• Journal of Korea Society of Industrial Information Systems
• /
• v.18 no.5
• /
• pp.15-18
• /
• 2013

This paper presents an analog front-end for electroencephalogram(EEG) signal processing. Since EEG signals are typically weak and located at very low frequencies, it is imperative to implement an amplifier with high gain, high common-mode rejection ratio(CMRR) and good noise immunity at very low frequencies. The analog front-end of this paper consists of a programmable-gain instrumentation amplifier and a band-pass filter. A frequency chopping technique is employed to remove the low-frequency noise. The circuits were fabricated in 0.18um CMOS technology and measurements showed that the analog front-end has the maximum gain of 60dB and >100dB CMRR over the programmable gain range.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.5
• /
• pp.1061-1066
• /
• 2012

A digital memory has been widely used as a device for storing information due to its reliable, fast and relatively simple control circuit. However, the storage of the digital memory will be limited by the inablility to make smaller linewidths. One way to dramatically increase the storeage capability of the memory is to change the type of stored data from digital to analog. The analog memory fabricated in a standard single poly 0.6um CMOS process has been developed. Single cell and adjacent circuit block for programming have been designed and characterized. Applications include low-density non-volatile memory, control of redundancy in SRAM and DRAM memories, ID or security code registers, and image and sound memory.

• Proceedings of the IEEK Conference
• /
• summer
• /
• pp.77-81
• /
• 2004

In this paper, we propose a analog front-end (AFE) for noncoherent On-Off Keying (OOK) Ultra Wide Band (UWB) system based on power detection. The proposed AFE are designed using 0.18 micron CMOS technology and verified by simulation using SPICE. The proposed AFE consist of Sample-and-Hold block, Analog-to-Digital converter, synchronizer, delayed clock generator and impulse generator. The time resolution of 1ns is obtained with 100MHz system clocks and the synchronized 10-bit digital outputs are delivered to the baseband. The impulse generator produces 1ns width pulse using digital CMOS gates. The simulation results show the feasibility of the proposed UWB AFE systems.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.9
• /
• pp.685-691
• /
• 2003

This work describes a 3 V 12b 100 MS/s CMOS digital-to-analog converter (DAC) for high-speed communication system applications. The proposed DAC is composed of a unit current-cell matrix for 8 MSBs and a binary-weighted array for 4 LSBs, considering linearity, power consumption, chip area, and glitch energy. The low-glitch switch driving circuit is employed to improve the linearity and the dynamic performance. Current sources of the DAC are laid out separately from the current-cell switch matrix core. The prototype DAC is implemented in a 0.35 urn n-well single-poly quad-metal CMOS technology. The measured DNL and INL of the prototype DAC are within $\pm$0.75 LSB and $\pm$1.73 LSB, respectively, and the spurious-free dynamic range (SFDR) is 64 dB at 100 MS/s with a 10 MHz input sinewave. The DAC dissipates 91 mW at 3 V and occupies the active die area of 2.2 mm ${\times}$ 2.0 mm.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.11
• /
• pp.61-66
• /
• 2005

This paper describes a 10-bit 210MHz CMOS current-mode Digital-to-Analog Converter (DAC) consisting of 6 bit MSB current cell matrix Sub-DAC, 2 bit mSB unary current source Sub-DAC, and 2 bit LSB binary weighting Sub-DAC for Wireless LAN application. A new deglitch circuit is proposed to control a crossing point of signals and minimize a glitch energy. The proposed 10-bit CMOS current mode DAC was designed by a $0.35{\mu}m$ CMOS double-poly four-metal technology rate of 210MHz, DNL/INL of ${\pm}0.7LSB/{\pm}1.1LSB$, a glitch energy of $76pV{\cdot}sec$, a SNR of 50dB, a SFDR of 53dB at 200MHz sampling clock and power dissipation of 83mW at 3.3V

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.2
• /
• pp.20-27
• /
• 2011

A CMOS Image Sensor(CIS) mounted on mobile appliances always needs a low power consumption because of the battery life cycle. In this paper, we propose novel power reduction techniques such as a data flip-flop circuit with leakage current elimination, a low power single slope A/D converter with a novel comparator, and etc. Based on 0.13um CMOS process, the chip satisfies QVGA resolution($320{\times}240$ pixels) whose pitch is 2.25um and whose structure is 4-Tr active pixel sensor. From the experimental results, the ADC in the middle of CIS has a 10-b resolution, the operating speed of CIS is 16 frame/s, and the power dissipation is 25mW at 3.3V(Analog)/1.8V(Digital) power supply. When we compare the proposed CIS with conventional ones, the power consumption is reduced approximately by 22% in sleep mode, 20% in operating mode.