• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.24 no.7
• /
• pp.569-574
• /
• 2014

In order to investigate low frequency swishing noise of wind turbines, acoustic source model using a singularity in circular motion is introduced to derive analytic solution of Lowson acoustic analogy in time domain. Results in time and frequency domains computed by the solution show apparent modulation of amplitude and frequency. The solution indicates that time histories of acoustic pressure at receiver points varied significantly according to receiver's directional location, even when the retarded time distributions are similar. However, the corresponding time-averaged spectra of sound pressure at the receiver locations where the retarded time distributions are almost same are not significantly different. It can be inferred from these results that the time-averaged sound pressure spectra which cannot take into account the detailed difference in the time-variation of wind turbine noise may not represent the sound quality of wind turbines due to its swishing. Finally, as an introduction of procedure to quantify low frequency swishing noise level, relative variation of overall sound pressure level is obtained using tonal low frequency noise model.

• Information and Communications Magazine
• /
• v.16 no.10
• /
• pp.112-124
• /
• 1999

본 논문에서는 FTTC/VDSL (Fiber-to-the-Curb/Very High-speed Digital Subscriber Line) 전송시스템의 개발동향과 ANSI, ETSI, ITU등의 표준화 위원회에서 현재 진행중인 VDSL 시스템의 표준화 작업에 대해 기술하였다. 특히, POTS (Plain Old Telephone Service), BA-ISDA(Basic Access Integrated Services Digital Network), HDSL(High-rate Digital Subscriber Line), SDSL (Single-pair HDSL), ADSL(Asymmetric Digital Subscriber Line) 등의 다양한 xDSL (Digital Subscriber Line) 서비스들에서 발생하는 NEXT (Near-end Crosstalk)/FEXT (Far-end Crosstalk)와 같은 crosstalk를 최소화하기 위해 제안된 VDSL시스템의 주파수 대역과 PSD (Power Spectral Density) mask에 관해 설명하고, 순방향(down-stream) 채널과 역방향(upstream) 채널의 데이터 전송률이 대칭적인 VDSL전송시스템과 비대칭적인 VDSL 전송시스템 간의 주파수대역의 호환성 문제, RFI(Radio Frequency Interference) ingress/egress 문제의 해결 방안에 관해 기술하였다. 또한, 현재 VDSL Coalition과 VDSL Alliance 간에 논의 중인 VDSL 전송시스템의 변복조 방식에 관한 표준화 작업과정 및 순방향과 역방향에 할당될 band 개수에 따른 시스템 성능의 장단점 등에 관해 살펴보았다. 끝으로 현재 국내에서 개발되고 있는 FTTC/VDSL 전송시스템의 전체구조를 요약하고, 네트워크에서 가입자쪽으로 순방향 데이터 전송에 사용된 51.84 Mb/s 19-CAP (Carrierless Amplitude/Phase Modulation) 전송시스템과 가입자 댁내에서 네트워크 방향으로 역방향 데이터 전송에 사용된 1.62 Mb/s QPSK (Quadrature Phase Shift Keying) burst-mode TDMA (Time Division Multiple Access) 전송시스템 등의 동작 원리 및 구조를 기술하였다.

• Korean Journal of Optics and Photonics
• /
• v.9 no.2
• /
• pp.104-110
• /
• 1998

The energy transfer between two incident beams in a photorefractive Cu-doped(0.04 wt. %) ${(K_{0.5}Na_{0.5})}_{0.2}{(Sr_{0.61}Ba_{0.39})}_{0.9}Nb_2O_6$ crystal is investigated at 632.8 nm laser wavelength. In addition, the coherent two-wave coupling properties of a photoinduced refractive-index grating in the presence of amplitude modulation on the signal beam or reference beam are also experimentally investigated. Some preliminary exprimental results are presented for use as a dynamic photorefracitive combiners and pulse shaping elements in coherent optical communication systems and in optical signal processing.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.16 no.4 s.109
• /
• pp.404-413
• /
• 2006

Induction motors are the workhorse of our industry because of their versatility and robustness. The diagnosis of mechanical load and power transmission system failures is usually carried out through mechanical signals such as vibration signatures, acoustic emissions, motor speed envelope. The motor faults including mechanical rotor imbalances, broken rotor bar, bearing failure and eccentricities problems are reflected in electric, electromagnetic and mechanical quantities. The recent research has been directed toward electrical monitoring of the motor with emphasis on inspecting the stator current of the motor, The stator current spectrum has been widely used for fault detection in induction motor systems. The motor current signature analysis is the useful technique to assess machine electrical condition. This paper describes the motor condition detected by the current signatures Paralleled with vibration signatures analysis of induction motors with the roller bearing and the journal bearing type for large vertical pumps in power plant as examples to discuss for motor fault detection and diagnosis.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.430-430
• /
• 2012

Modulated pulsed power (MPP) 스퍼터링은 펄스 전압 shape, amplitude, duration의 modulation을 통해 증착율 손실을 극복하는 고출력 펄스 마그네트론 스퍼터링의 한 종류이다. Micro second 범위에서 on/off 시간을 다중 세트 형태로 자유롭게 프로그램 할 수 있어서 아킹 없이 고전류 영역의 마그네트론 동작을 할 수 있으므로, 고주파 유도 결합 플라즈마원이나 마이크로웨이브 투입 등의 부가적인 플라즈마 없이도 스퍼터링 재료의 이온화 정도를 획기적으로 높일 수 있는 장점을 가지고 있다. 본 연구에서는 $2{\times}1{\times}0.2$의 sputtering system에서 기판 캐리어를 이용해서 $400{\times}400mm$ 기판을 $272{\times}500mm$ 크기의 AZO target (Al 2 wt%)이 설치되어 있는 moving magnet cathode (MMC)을 이용하여 MPP로 증착했다. 두 종류의 micro pulse set을 하나의 macro pulse에 사용함으로서 weakly ionized plasma와 strongly ionized plasma를 만들 수 있다. 다양한 micro pulse set을 이용하여 평균 전력 2 kW에서 peak 전력을 4 kW에서 45 kW까지 상승 시킬 수 있으며, 이 때 타겟-기판 거리 80 mm에서 이온전류밀도는 $5mA/cm^2$에서 $20mA/cm^2$까지 상승했다. MPP는 같은 평균 전력에서 repetition frequency가 증가할 때, 증착 속도가 증가했으며, 같은 repetition frequency에서 macro pulse length가 증가할 때도, 증착 속도가 증가했다. 최적화된 marco, micro pulse set에서 증착 속도는 평균 전력 2 kW에서 110 nm/min이었고, 700 nm의 박막에서 비저항은 $1-2{\times}10^{-3}ohm{\cdot}cm$였다. 표면거칠기 Rrms는 약 3 nm였고, 400-700 nm 영역의 평균 투과도는 72-76%였다.

• Korean Journal of Materials Research
• /
• v.13 no.6
• /
• pp.365-368
• /
• 2003

Small amounts of additives such as mol % 0.13 NiO and mol % 0.01 $CaCO_3$were added to Cu-Zn-Mg ferrites. Basic composition of the Cu-Zn-Mg ferrites was $Cu_{Cu}$X/$Fe_{0.054}$ /$Zn_{0.486}$$Mg_{0.407}$ $Fe_{1.946}$ $O_4$(group A) and $Cu_{0.263}$$Fe_{0.027}$ $Zn_{0.503}$ $Mg_{0.262}$ $Fe_{1.973}$ $O_4$(group B). Specimens were sintered at different temperatures (1010, 1030, $1050^{\circ}C$) for 2 hours in air followed by an air cooling. Then, effects of various composition and sintering temperatures on the microstructure and the magnetic properties such as inductions, coercive forces, and initial permeabilities of the Cu-Zn-Mg ferrites were investigated. The average grain size increased with the increase of sintering temperature. The magnetic properties obtained from the aforementioned Cu-Zn-Mg ferrite specimens were 1,724 gauss for the maximum induction, 1.0 oersted for the coercive force, and 802 for the initial permeability. These magnetic properties indicated that the specimens could be utilized as the core of IFT (intermediate frequency transformer) and antenna in the amplitude modulation.

• Journal of Biosystems Engineering
• /
• v.27 no.5
• /
• pp.459-466
• /
• 2002

In Korea, a need of automatic dairy farm management system has been increased to lower production cost and to strengthen international competition. However, the present management system was mostly relied on foreign technologies and caused some problems in post management and after-sales services. Therefore, though there is a problem of price and quality at present, domestic technologies of the management system should be developed for the long run. This study was conducted to develop an electronic identification unit for an automatic dairy farm management system. The developed system was consisted of a tag, a reader, a switching circuit, and a personal computer. The tag attachable to each individual cow was developed to transmit individual radio frequency(RF) code into the air with modulation of ASK(amplitude shift keying). And the switching circuit was added to avoid confusion on reception and transmittance. The reader attached to a feeding device was developed to transmit activating signal periodically and to identify code of the individual tag when the tag was approached to the device. The reader was consisted of an active filter, a detecter, a comparator and a microcontroller. The test result was feasible enough to apply it for the automatic farm management system and the identified maximum distance was about 37cm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.11C
• /
• pp.1070-1076
• /
• 2003

This paper presents and analyses the exact and general closed-form expression for the average bit error probability of M-ary square quadrature amplitude modulation (QAM) for maximal ratio combining (MRC) diversity reception in frequency-nonselective Nakagami-m fading. An L-branch Maximal ratio combining diversity technique with independent or correlated fading cases is considered. Numerical results demonstrate the error performance improvement by employing with the use of MRC diversity reception. The new expressions presented here can offer a convenient way to evaluate the performance of an arbitrary square M-W square QAM with an MRC diversity combiner for various cases of practical interest.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.1
• /
• pp.24-29
• /
• 2004

$CF_4$ gas is one of the most useful gases in modern technologies for semiconductor fabrication. However, there are many problems which should be solved in order to fabricate semiconductor device, for example, etching speed drop due to ion charge-up and etching selectivity drop due to the high electron energy. One of useful method in order to suppress their damages above is pulsed-time modulated plasma (PM). However, transient responses of charged particles occur when the source power is turned-on and -off in PM method. To control plasma properties in detail, such a transient phenomenon must be investigated. In this paper, we investigate $CF_4$ RF plasma properties under a one-dimensional fluid model. And also for dynamic and stable control of $CF_4$ plasmas, we investigated the transient behavior of the plasmas after step up or down of the amplitude of the power source voltage $V_s$(t). Fundamental properties of transient $CF_4$ plasmas was discussed. Furthermore, we intend to discuss new method for pulsed-time plasma modulation.

• Archives of Pharmacal Research
• /
• v.24 no.2
• /
• pp.100-104
• /
• 2001

Differential pulse polarographic(DPP) analytical procedure for the rifampicin antibiotic, which can be applied to monitor its synthetic process from the starting antibiotic of rifamycin B or rifamycin SV has been developed based on the electrochemical reduction of an azomethine group. Rifampicin exhibited a cathodic peak due to the azomethine group in the side chain of 3-[(4-methyl-1-piperazinyl)imino]methyl moiety and another cathodic peak due to the carbonyl group in rifamycin SV by DPP. The experimental peak potential shift of an azomethine reduction was -73 mV/pH in the pH range between 3.0 and 7.5, agreeing with involvement of 4 e-and 5 $H^5$ in its reduction. By the cyclic voltammetric(CV) studies, the azomethine and the carbonyl reductions in rifampicin were processed irreversibly on the mercury electrode. The plot of peak currents vs. concentrations of rifampicin ranging $1.0{\times}10^{-7} M~$1.0{\times}10^{-5} M yielded a straight line with a correlation coefficient of 0.9996. The detection limit was $1.0{\times}10^{-8} M with a modulation amplitude of 50 mV DPP has been successfully applied for the determination of rifampicin in the pharmaceutical preparations.