• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.20 no.10
• /
• pp.852-858
• /
• 2007

The dependence of substrate on the Ag photodoping phenomenon into amonhous $({\alpha}-)$ GeSe thin film has been investigated using holographic method. A 442 nm HeCd laser was utilized as a light source for the holographic exposure and a 632.8 nm HeNe laser to measure the variation of diffraction efficiency $(\eta)$ in real time. The films (Ag and ${\alpha}-GeSe$) were thermally deposited on the substrates, i.e. p-type Si(100), n-type Si(100) and slide glass. The sample structures prepared were two types: type I (Ag/${\alpha}$-SeGe/substrate) and type II (${\alpha}$-SeGe/Ag/substrate). The $\eta$ kinetics comprised to be three steps in which $\eta$ initially increases, is saturated to be maximized $(\eta_M)$, and then decreases relatively gradually. For the same substrate, the $\eta_M$ values of the type II were higher than those of type I. In addition, the type II exhibited the highest $\eta_M$ for p-type Si substrate, while that in type I was observed for n-type Si substrate. These tendency is explained by the diffusion of minority carrier in the films and the change of magnitude and direction in internal fields generated at the film interfaces. Atomic-force-microscope (AFM) was used to observe relief-type grating patterns.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.10
• /
• pp.817-821
• /
• 2000

In this work, we have investigated the dependence of annealing temperature(T$\_$a/) on optical and electrical properties of amorphous hydrogenated SiC(a-SiC:H) films. The a-SiC:H films were deposited on corning glass and p-type Si(100) wafer by PECVD (plasma enhanced vapor deposition) using SiH$_4$+CH$_4$+N$_2$ gas mixture. The experimental results have shown that the optical energy band gap(E$\_$opt/)of the thin films annealed at high temperatures have shown that the graphitization of carbon clusters and micro-crystalline silicon occurs. The current-voltage characteristics have shown good electrical properties at the annealed films.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.06a
• /
• pp.196-200
• /
• 2005

In this work, we investigated simple Aㅣ/TCO/a-Si:H(n)/c-Si(p)/Al hetero-junction solar cells prepared by low temperature processes, unlike conventional thermal diffused c-Si solar cells. a-Si:H/c-Si hetero-junction solar cells are processed by low temperature deposition of n-type hydrogenated amorphous silicon (a-Si:H) films by plasma-enhanced chemical vapor deposition on textured and flat p-type silicon substrate. A detailed investigation was carried out to acquire optimization and compatibility of amorphous layer, TCO (ZnO:Al) layer depositions by changing the plasma process parameters. As front TCO and back contact, ZnO:Al and AI were deposited by rf magnetron sputtering and e-beam evaporation, respectively. The photovoltaic conversion efficiency under AMI.5 and the quantum efficiency on $1cm^2$ sample have been reported. An efficiency of $12.5\%$ is achieved on hetero-structure solar cells based on p-type crystalline silicon.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.06a
• /
• pp.134-134
• /
• 2009

In this work, we report that crystallization speed as well as the electrical and optical properties about the N-doped $Ge_2Sb_2Te_5$ thin films. The 200-nm-thick N-doped $Ge_2Sb_2Te_5$ thin film was deposited on p-type (100) Si and glass substrate by RF reactive sputtering at room temperature. The amorphous-to-crystalline phase transformation of N-doped $Ge_2Sb_2Te_5$ thin films investigated by X-ray diffraction (XRD). Changes in the optical transmittance of as-deposited and annealed films were measured using a UV-VIS-IR spectrophotometer and four-point probe was used to measure the sheet resistance of N-doped $Ge_2Sb_2Te_5$ thin films annealed at different temperature. In addition, the surface morphology and roughness of the films were observed by Atomic Force Microscope (AFM). The crystalline speed of amorphous N-doped $Ge_2Sb_2Te_5$ films were measured by using nano-pulse scanner with 658 nm laser diode (power : 1~17 mW, pulse duration: 10~460 ns). It was found that the crystalline speed of thin films are decreased by adding N and the crystalline temperature is higher. This means that N-dopant in $Ge_2Sb_2Te_5$ thin film plays a role to suppress amorphous-to-crystalline phase transformation.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.06a
• /
• pp.172-175
• /
• 2009

n-type crystalline silicon wafers were passivated with intrinsic a-Si:H thin films on both sides using HWCVD. Minority carrier lifetime measurement was used to verify interface passivation properties between a-Si:H thin film and crystalline Si wafer. Thin film interface characteristics were investigated depending on $H_2/SiH_4$ ratio and hot wire deposition temperature. Vacuum annealing were processed after deposition a-Si:H thin films on both sides to investigate thermal effects from post process steps. We noticed the effect of interface passivation properties according to $H_2/SiH_4$ ratio and hot wire deposition temperature, and we had maximum point of minority carrier lifetime at H2/SiH4 10 ratio and $1600^{\circ}C$ wire temperature.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.171-171
• /
• 2012

Neutral beam assisted chemical vapor deposition (NBa-CVD) process has been developed as a nove,l room temperature deposition process for the light-soaking free nano-crystalline silicon (nc-Si) thin films including intrinsic and n-type doped thin film. During formation of nc-Si thin films by the NBa-CVD process with silicon reflector at room temperature, the energetic particles enhance doping efficiency and crystalline phase in nc-Si thin films without additional heating at substrate. The effects of incident NB energy controlled by the reflector bias have been confirmed by Raman spectra analysis. Additionally, TEM images show uniform nc-Si grains which imbedded amorphous phase without incubation layer. The nc-Si films by the NBa-CVD are hardly degenerated by light soaking; the degradations of photoconductivity were just a few percents before and after light irradiation.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.306.2-306.2
• /
• 2016

Niobium oxide thin films were synthesized by reactive rf magnetron sputtering. The target was metallic niobium with 2 inch in diameter and the substrate was n-type Si wafer. To control the surface properties of the films, Nb oxide thin films were obtained at various mixing ratios of argon and oxygen gases. Nb oxide thin films were analyzed with alpha step, scanning electron microscopy (SEM), X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS). The result of alpha step showed that the thickness of Nb oxide thin films were decreased with increasing the oxygen gas ratios. SEM images showed that the granular morphology was formed at 0% of oxygen gas ratio and then disappeared at 20 and 75% of oxygen gas ratio. The amorphous Nb oxide was observed by XRD at all films. The oxidation state of Nb and O were studied with high resolution Ni 2p and O 1s XPS spectra. And the change in the chemical environment of Nb oxide thin films was investigated by XPS with Ar+ sputtering.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.30 no.2
• /
• pp.115-118
• /
• 2017

Highly photosensitive and wide bandgap amorphous silicon oxide (a-$SiO_x$:H) films were developed at low temperature ranges ($100{\sim}150^{\circ}C$) with employing plasma-enhanced chemical vapor deposition by optimizing $H_2/SiH_4$ gas ratio and $CO_2$ flow. Photosensitivity more than $10^5$ and wide bandgap (1.81~1.85 eV) properties were used for making the a-$SiO_x$:H thin film solar cells, which exhibited a high open circuit voltage of 0.987 V at the substrate temperature of $100^{\circ}C$. In addition, a power conversion efficiency of 6.87% for the cell could be improved up to 7.77% by employing a new n-type nc-$SiO_x$:H/ZnO:Al/Ag triple back-reflector that offers better short circuit currents in the thin film photovoltaic devices.

• Journal of the Korean Electrochemical Society
• /
• v.3 no.1
• /
• pp.19-24
• /
• 2000

It is increasingly necessary to use poly-Si n's as high resolution and integration of Tn for LCD. Excimer Laser Crystallization (ELC) of a-Si is mainly used as a low temperature process. But the ELC method for the fabrication of poly-Si has the eruption problems associated with hydrogen in the a-Si film. So we need a dehydro-genation process additionally. Hydrogen in a-Si film can degrade the quality of poly-Si film and electrical properties of device due to the hydrogen eruption and voids which occur during the excimer laser annealing. In this study, we propose mesh-type PECVD as the a-Si film deposition method for achieving the low concentration hydrogen. Mesh-type PECVD was found to reduce the hydrogen content substantially. We could obtain a as-deposited a-Si film with hydrogen contents less than $1\%$ at $300^{\circ}C$. We also investigated the behavior by XeCl excimer laser annealing of a-Si fabricated by mesh-type PECVB. As a result, we were able to confirm the broad process window in contrast to the narrow process range typically obtained in ELC. Hydrogen eruption was not observed in poly-Si films after ELC These results suggests that mesh-type PECVD is a viable method to achieve the low hydrogen content a-Si and improve the process windows for ELC.

• Proceedings of the Korean Magnestics Society Conference
• /
• 2003.12a
• /
• pp.313-313
• /
• 2003