• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.6 no.2
• /
• pp.63-70
• /
• 2001

Changes in concentrations of dissolved oxygen, ammonia, nitrate, pH, Fe and Mn were monitored from the laboratory incubation of an benthic chamber. The extent of sedimentary organic carbon and nitrogen decomposition was quantified by applying the concentration data to the chemical reaction equations of early diagenesis. The patterns of the concentration changes, observed during the 237 hr long incubation experiment, made it possible to divide the entire experiment period into four characteristic sub-periods (0-9 hr, 9-45 hr, 45-141hr, 141-237 hr). C/N ratio, estimated for each sub-period, was 6.63, 1.49, 0.81 and 0.02, respectively. This sequential decrease in C/N ratio suggests that during the incubation experiment dissolved nitrogen species diffuse more out of the sediment than dissolved carbon species. Greater diffusion of nitrogen indicates the preferential decomposition of organic nitrogen during early diagenesis of sedimentary organic matter. Comparison of the concentration data (sedimentary organic carbon and nitrogen, porewater organic carbon and ammonia)between the sediment pre and post incubation also indicates the preferential decomposition of nitrogen during early diagenesis of sedimentary organic matter.

• Journal of the Korean Institute of Gas
• /
• v.26 no.5
• /
• pp.22-27
• /
• 2022

Atomic Layer Deposition (ALD) is a facility that deposits an atomic layer on a wafer by causing a chemical reaction after decomposition using heat or plasma by inputting two or more gases during the semiconductor process. The main gas used at this time is NH₃ (Ammonia). NH₃ has a relatively narrow explosive range with an upper limit (UFL) of 33.6% and a lower limit (LEL) of 15%, but it can explode if a large amount suddenly gathers in one place. It is Velocity and fatal if inhaled or in contact with the skin. NH₃ (Ammonia) of ALD (Atomic Layer Deposition) facility is supplied to the chamber through the gas inlet and discharged after the reaction.

• Journal of ILASS-Korea
• /
• v.25 no.4
• /
• pp.196-203
• /
• 2020

Nowadays, urea SCR technology is considered as the most effective NOx reduction technology of diesel engine. However, low NOx conversion efficiency under low temperature conditions is one of its problems to be solved. This is because injection of UWS (Urea Water Solution) is impossible under such a low temperature condition due to the problem of insufficient of urea decomposition and urea deposits. In several previous studies, it has been reported that appropriate control of the amount of ammonia adsorbed on SCR catalyst can improve the NOx conversion efficiency under low temperature conditions. In this study, we tried to find out how much the NOx conversion efficiency increases with respect to the amount of ammonia adsorbed on the catalyst, and what the temperature conditions that the ammonia slip occurs. This study shows the results of 8 times repeated WHTC test with a diesel engine, in which UWS was injected with NH3/NOx mole ratio of '1'. Through this study, it was found that 13% of the NOx conversion efficiency of WHTC increased while the θ (ammonia adsorption rate) increased from "0%" to "22%". In addition, it is found that in cases of high θ value, the significant improvement of NOx conversion efficiency at low temperatures presented during the beginning period of WHTC and at high temperature and transient conditions presented during last part of WHTC test. The NH3 slip occurring condition was 250℃ of catalyst temperature and 10% of θ, and the amount of NH3 slip increased as the temperature and θ are increased.

• Journal of Korean Society of Water and Wastewater
• /
• v.18 no.6
• /
• pp.731-741
• /
• 2004

The purpose of this study was to evaluate the potential of a gamma ray irradiation to decompose hexahydro-1,3,5-trinitro-1,3,5-triazine (RDX) in an aqueous solution. The decomposition reaction of RDX by gamma ray irradiation was a first-order kinetic over the applied initial concentrations (10-40mg/L). The dose constant was strongly dependent on the initial concentration of the RDX. The removal of RDX was more efficient at pH below 3 and at pH above 11 than at neutral pH (pH 5-9). The required irradiation dose to remove 99% of the RDX (40mg/L) was 4, 8 and 1 kGy, at pH 2, 7 and 13, respectively. The dose constant was increased by two folds and over twelve folds at pH 2 and 13, respectively, when compared with that at pH 7. When an irradiation dose of 20 kGy was applied, the removal efficiencies of TOC were 80, 57 and 91% at pH 2, 7 and 13, respectively. Ammonia and nitrate were detected as the main nitrogen byproducts of RDX and formic acid was detected as an organic byproduct. The results showed that a gamma ray irradiation was an attractive method for the decomposition of RDX in an aqueous solution and it was found that a strong alkaline pH over 12 should be applied to the decomposition reaction of RDX.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.7 no.6
• /
• pp.1020-1033
• /
• 2015

In order to design a compact urea selective catalytic reduction system, numerical simulation was conducted by computational fluid dynamics tool. A swirl type static mixer and a mixing chamber were considered as mixing units in the system. It had great influence on flow characteristics and urea decomposition into ammonia. The mixer caused flow recirculation and high level of turbulence intensity, and the chamber increased residence time of urea-water-solution injected. Because of those effects, reaction rates of urea decomposition were enhanced in the region. When those mixing units were combined, it showed the maximum because the recirculation zone was significantly developed. $NH_3$ conversion was maximized in the zone due to widely distributed turbulence intensity and high value of uniformity index. It caused improvement of $NO_x$ reduction efficiency of the system. It was possible to reduce 55% length of the chamber and connecting pipe without decrease of $NO_x$ reduction efficiency.

• KSBB Journal
• /
• v.14 no.3
• /
• pp.358-364
• /
• 1999

The effect of hydrogen peroxide on pretreatment of oakwood was investigated. Reaction temperature was $170^{\circ}C$ and reaction solutions used in pretreatment were aqueous ammonia, sulfuric acid and pure water. When 10% ammonia solution was used, the extents of delignification and hemicellulose recovery were 55% and 26%, respectively. These values were significantly higher as delinigfication and lower as hemicellulose recovery than those of acid hydrolysis. To overcome this problem, hydrogen peroxide was added into ammonia solution stream to increase hemicellulose recovery. But delignification and hemicellulose recovery were not increased as much as hydrogen peroxide loading was increased. And as hydrogen peroxide loading was increased, the decomposition of sugars solubilized from hemicellulose and cellulose were increased. So there were significant differences between the total amount in solid residue and liquid hydrolyzate, and the total amount in the original biomass. It was found that hydrogen peroxide added was reacted with substrate packed mostly in the front part of reactor. In order to increase hemicellulose recovery, it was necessary to treat with acidic solution than with alkali solution. Effect of hydrogen peroxide was higher in water than acid solution.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.20 no.1
• /
• pp.20-27
• /
• 2012

The $NH_3$-SCR characteristics of $NO_X$ over a V-based catalyst are experimentally examined over a wide range of operating conditions, i.e., $170-590^{\circ}C$ and $30,000-50,000h^{-1}$, with a simulated diesel exhaust containing $NH_3$, NO, $NO_2$, $O_2$, $H_2O$, and $N_2$. The influences of the space velocity and oxygen concentration on the standard-SCR reaction are analyzed, and it is shown that the low space velocity and high oxygen concentration promote the SCR activity by ammonia. The best $deNO_X$ efficiency is obtained with a $NO_2/NO_X$ ratio of 0.5 because of an enhanced chemical activity induced by the fast-SCR reaction, while at the $NO_2/NO_X$ ratios above 0.5 the $deNO_x$ activity decreases due to the slow-SCR reaction. The oxidation of ammonia begins to take place at about $300^{\circ}C$ and the reaction products, such as $N_2$, NO, $NO_2$, $N_2O$, and $H_2O$, are produced by the undesirable oxidation reactions of ammonia, particularly at high temperatures above $450^{\circ}C$. Also, $NO_2$ decomposes to NO and $O_2$ at temperatures above $240^{\circ}C$. Therefore, $NO_2$ decomposition and ammonia oxidation reactions deteriorate significantly the SCR catalytic activity at high temperatures.

• Journal of the Korean Chemical Society
• /
• v.30 no.2
• /
• pp.207-215
• /
• 1986

A new method was proposed to improve removal of nitrogen oxides $(NO_x)$ in exhaust gas by the reduction method using ammonia. At the relative humidity of 60%, 50 ppm of $NO_x$ was decomposed at the rate of 1% per hour in the reaction chamber. On the other hand, by adding $NH_3$ which was 5 times more concentrated than NOx, the decomposition rate increased to 6% per hour for 50 ppm $NO_x$ and 10% per hour for 20ppm $NO_x$. Within the actual exhausted gases, the decomposition rate of $NO_x$ reached the maximum 15% per hour because of coexisted reducing gases, such as hydrocarbon and carbon monoxide, and excess humidity containing trace metal ions. In the presence of acidic $SO_2$ gas, the decomposition rate of $NO_x$ decreased. The decomposition of $NO_x$ seems to be caused by the mist which is added to the system, and $NH_3$ in the mist which reduces $NO_x$.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1997.06a
• /
• pp.3-5
• /
• 1997

Synthesis of ammonium aluminum hydrogen carbonate(AAHC) via reaction of aluminum bicarbonate and aluminum salt and thermal decomposition is oner of the important processes for preparation of high pure and ultra fine alumina. Kato and coworkers[1] developed this process, at same time Von Erdos and Altorfe[2] found AAHC in the corrosive products of aluminum in the atmosphere of carbon dioxide and ammonia. Murase and Iga[3] synthesized acicular AAHC in a autoclave under 60 to 12$0^{\circ}C$ Hayashi[4] optimized the conditions for preparation of AAHC and alumina. Attemp has been made in this paper to reveal the conditions affect the morphology of the synthesized AAHC and the consequently produced alumina.

• Journal of the Korean Chemical Society
• /
• v.16 no.2
• /
• pp.84-92
• /
• 1972

A mechanism for the ring formation of nickel phthalocyanine (Ni-Pc) has been proposed based on chemical kinetics. The effect of the catalyst on the rate was examined, and ammonium molybdate has been found to be the most effective. The reaction order of the ring formation was determined to be of the 1st order over all, with only the concentration of urea affecting the rate of the ring formation. All the results including thermodynamic parameters support a conclusion that the rate-determining step seems to be the enolization of the urea-catalyst transition complex, followed by fast decomposition of the tautomeric enolized urea into ammonia and isocyanic acid. These intermediates then reacted with the phthalic anhydride to form imino and diimino-phthalimide, which condense to form nickel phthalocyanine in the presence of the nickel cation.