• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 하계학술대회 논문집
• /
• pp.828-830
• /
• 2000

Various substrates were compared for the investigation of the optical properties of ZnO thin films. ZnO thin films have been deposited on (100) p-type silicon substrates and (001) sapphire substrates by pulsed laser deposition technique using a Nd:YAG laser with the wavelength of 355 nm. Oxygen and nitrogen gases were used as ambient gases. Substrate temperatures were varied in the range of 200$^{\circ}C$ to 600$^{\circ}C$ at a fixed ambient gas pressure of 350 mTorr. ZnO films have been deposited on various substrates, such as Si and sapphire wafers. We have investigated substrate effect on the optical and structural properties of ZnO thin films using X-ray diffraction (XRD) and photoluminescence (PL).

• 동력기계공학회지
• /
• 제20권6호
• /
• pp.93-98
• /
• 2016

Environmental problems are issued throughout all over the world and which are needed the strength management. In case of the diesel cars are also being developing and studying continuously about various after-treatments device such as EGR, LNT, SCR, DPF and DOC etc. which are used for decreasing $NO_X$ and PM. The air temperature goes up to $39^{\circ}C$ in summer and goes down to $-20^{\circ}C$ in winter because of the location. These changing of the temperature can effect to the engine and harmful exhaust gas discharged and it seems to make the increase - decrease different. The result of the evaluate while changing between the test-mode and the air temperature, which expresses that WLTC-mode is 2.2 times and FTP_75 mode is 4.1~6 times increase to the comparison NEDC-mode of the current regulation. The exhaust characteristic of $NO_X$ by the changing temperature increases in the low temperature and 4.3 times in $14^{\circ}C$ and 21.3 times in $-7^{\circ}C$ with maximum when it compares to $23^{\circ}C$. The fuel efficiency of the different weight car and engine with same data is about 5.7 % in maximum.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 1990년도 추계학술발표회논문집
• /
• pp.13-16
• /
• 1990

균일한 positive column의 상세한 이론이 충돌 단면적 곡선과 공진 방사 그리고 다단계 여기(multistage)와 이온화 과정을 고려하여 0.5에서 5mmHg 압력에서 수은과 희유가스(rare-gas)가 혼합되어 있는 D.C.형광 램프 방전에 대해 전개된다. 온도와 이온, 비여기원자, 여기원자의 밀도가 수치해석에 의하여 계산된다.

• International Journal of Automotive Technology
• /
• 제6권6호
• /
• pp.563-570
• /
• 2005

A numerical study of high pressure and temperature droplet vaporization and combustion is conducted by formulating one dimensional evaporation model and single-step chemical reaction in the mixture of hydrocarbon fuel and air. The ambient pressure ranged from atmospheric conditions to the supercritical conditions. In order to account for the real gas effect on fluid p-v-T properties in high pressure conditions, the modified Soave-Redlich-Kwong state equation is used in the evaluation of thermophysical properties. Some computational results are compared with Sato's experimental data for the validation of calculations in case of vaporization. The comparison between predictions and experiments showed quite a good agreement. Droplet surface temperature increased with increasing pressure. Ignition time increased with increasing initial droplet diameter. Temporal or spatial distribution of mass fraction, mass diffusivity, Lewis number, thermal conductivity, and specific heat were presented.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제49권5호
• /
• pp.313-319
• /
• 2000

In order to design the current carrying conductor for GIS, it is important to predict temperature-rise when rated current flows in the bus bar. However, it is not easy to apply the correct heat transfer coefficient on the boundary between different material for the thermal analysis. In this paper, the heat transfer coefficient which depends on parameters such like material constant, model geometry as well as ambient temperature, was calculated by analytic method. The calculated coefficient is used for the temperature rise prediction by F.E.M. The results show good agreement with experimental data.

• 한국농공학회지
• /
• 제35권3호
• /
• pp.81-90
• /
• 1993

Groundwater and animal wastes are typical example which are underutilized resources than their value in agriculture. This paper was to investigate the actual patterns of utilization of water curtain for greenhouses and methane gas utilization from swine wastes in a view point of promoting more efficient use of alternative energy. The results from measurements can be summarized as follows : 1.It was estimated that the maximum heating load per l0a was around 23,2804/hr and the heating load at January showed 3.93X 1064 respectively for strawberry greenhouses with insulation by the water curtain. 2.The average heating cost of the greenhouse with water curtain system amounted to about 75,000 Won per l0a. This result suggested that the greater cultivated area provides less heating cost. 3.The operating volume was about 73 percent of the optimum size of the digester. The net available methane gas rates of the produced gas remained close to 62 percent, But the conventional and small size of the digester was maintained at a lower level of around 20 to 29 percent. 4.It appeared that major problems of biogas production system were required to maintain the temperature of the fermentation above ambient temperature and the optimum volume of digester.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2005년도 제31회 KOSCO SYMPOSIUM 논문집
• /
• pp.181-188
• /
• 2005

Large eddy simulation(LES) methodology used to model the isothermal swirling flows in a dump combustor and the turbulent premixed flame in a model gas turbine combustor. The LES solver was implemented on parallel computer consisting 16 processors. In isothermal flow simulation, the results was compared with that of ${\kappa}-{\varepsilon}$ model as well as experimental data, in order to verify the capability of LES code. To model the turbulent premixed flame in a gas turbine, the G-equation flamelet model was used. The results showd that LES and RANS well predicted the mean velocity field of a non-swirling flow. However, in swirling flow, LES showed a better performance in predicting the mean axial and azimuthal velocities, and the central recirculation zone than those of RANS. In a model gas turbine combustor, the operation condition of high pressure and temperature induced the different phenomena, such as flame length and flow-field information, comparing with the condition of ambient pressure and temperature. Finally, it was identified that the flame and heat release oscillations are related to the vortex shedding generated by swirl flow and pressure wave propagation.

• 한국전기전자재료학회논문지
• /
• 제21권10호
• /
• pp.923-929
• /
• 2008

On the piezoelectric polymer, PVDF (poly vinylidene fluoride), the transparent conducting oxide (TCO) electrode material thin film was deposited by roll to roll sputtering process mentioned as a mass product-friendly process for display application. The deposition method for ITO Indium Tin Oxides) as our TCO was DC magnetron sputtering optimized for polymer substrate with the low process temperature. As a result, a high transparent and good conductive ITO/PVDF film was prepared. During the process, especially, the gas mixture ratio of Ar and Oxygen was concluded as an important factor for determining the film's physical properties. There were the optimum ranges for process conditions of mixture gas ratio for ITO/PVDF From these results, the doping mechanism between the oxygen atom and the metal element, Indium or Tin was highly influenced by oxygen partial pressure condition during the deposition process at ambient temperature, which gives the conductivity to oxide electrode, as generally accepted. With our studies, the process windows of TCO for display and other application can be expected.

• 대한기계학회논문집B
• /
• 제37권11호
• /
• pp.1015-1022
• /
• 2013

본 연구에서는 현재 개발중인 200kW 급 마이크로 가스터빈의 운전 특성을 모사하였다. 세부적인 성능 데이터를 이용하여 부분부하 제어방식(터빈 입구온도 제어방식(constant TIT control)과 터빈 출구온도 제어방식(constant TET control))과 외기온도에 따른 성능 및 작동특성을 분석하였다. 넓은 운전 범위에 대하여 압축기 서지마진과 터빈 입출구 온도 같은 작동 파라미터의 민감도를 단위 연료량 변화에 따라 예측하였다. 정상상태 계산으로 부분부하 변동 시 최대서지마진의 감소에 대한 정보를 민감도 분석을 통해 알 수 있다.

• 한국세라믹학회지
• /
• 제53권5호
• /
• pp.563-567
• /
• 2016

The structural properties of $HfO_2$ films could be improved by thermal treatment owing to their crystallization. We deposited $HfO_2$ films on sapphire by radio frequency (RF) magnetron sputtering, whose base vacuum pressure was lower than $4.5{\times}10^{-6}$ Pa, RF power was 100 W, working temperature was $200^{\circ}C$, working pressure was 3 mTorr, and the density of the active gas (Argon) was 20 sccm. After depositing the $HfO_2$ films, the samples were thermally treated by rapid thermal annealing (RTA) in $O_2$ ambient at different temperatures. Subsequently, the measured physical properties (structural, morphological, and optical) indicated that the crystallite size, refractive index at a wavelength of 632 nm, and packing density increased with rising temperatures. In particular, an $HfO_2$ film thermally treated at $800^{\circ}C$ in $O_2$ ambient had the highest refractive index of 2.0237 and packing density of 0.9638. The relation between optical and structural properties was also analyzed.