• Korean Journal of Optics and Photonics
• /
• v.4 no.1
• /
• pp.73-83
• /
• 1993

The temporal differential equation describing the build-up of the space-charge field in the presence of square and sinusoidal alternating field in photorefractive materials is solved analytically. We also measured the average two-wave mixing gain and the full temopral gain variations in a B$i_{12}$Si$O_{20}$ crystal with applied fields of up to 7 KV/cm amplitude and 1 KHz repetition rate. It has been found that the experimental measurements agree well with the theoretical results.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.61 no.9
• /
• pp.1269-1274
• /
• 2012

In this paper, the iron loss was calculated using estimated iron loss coefficient at 650W Interior Permanent Magnet Synchronous Motor(IPMSM) and 250W IPMSM. The iron loss coefficients was estimated different according to electrical steel material used to stator and rotor core in motor. Aspect of The rotating flux field and alternating flux field was confirmed by magnetic field behavior and harmonic analysis in stator core, the iron loss was calculated using flux density by Finite Element Method(FEM) and estimated coefficients by iron loss coefficient estimation proposed in this paper. The iron loss experiment was performed for verified to iron loss calculation, and the iron loss coefficients were verified by comparison of iron loss calculation value and experimental value.

• Proceedings of the KIEE Conference
• /
• 2006.07c
• /
• pp.1697-1698
• /
• 2006

When the coil with alternating current approaches to the conductor the eddy current flows in conductor. Eddy current is concentrated on the conductor surface and decrescent because of skin effect. In this paper investigated eddy current characteristic that is happened in conductor. Analyzed characteristic using electromagnetic field finite element analysis program that is commercialized to analyze value of eddy current and penetration depth. Analyzed creation value of eddy current and penetration depth in conductor that change operation frequency and the material of conductor, coil outside diameter, inside diameter, position, type of conductor from analyzed eddy current characteristic. The results, using distribution of eddy current and penetration depth data is that will help to forecast ECT(Eddy Current Testing), Eddy current application and use field, eddy current loss.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.34 no.5
• /
• pp.271-282
• /
• 2021

The internet of things (IoT) technology is a key component for the advent of 4^th industrial revolution, which is the network of home appliances, infrastructures, and vehicles to remotely investigate these systems. For the operation of compact IoT devices, batteries are widely used as electric power, and the limited lifetime of batteries inevitably leads to periodic replacement. Magneto-mechano-electric (MME) generators may be alternatives to batteries inside the IoT devices by converting stray magnetic field into electric energy, since we are always surrounded by ambient alternating current (AC) magnetic fields induced from electric power transmission lines everywhere. This article reviews the recent domestic research progress in high-performance MME generators and their application field for IoT and electronic devices.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.503-506
• /
• 2004

In this paper, we suggest a new driving waveform for stable address discharge in AC PDP without the reduction of contrast ratio. To analyze the influence of cross-talk between discharge and non-discharge cells and verify that proposed waveform shows a stable address discharge, we measured the address discharge delay time. The proposed waveform shows the reduction of the cross-talk and concurrently the improvement of address voltage margin compared with those of selective reset waveform having one reset period in 1TV-Field..

• Journal of KSNVE
• /
• v.9 no.4
• /
• pp.747-753
• /
• 1999

This paper presents results of vibration analysis of a generator-stator core for 500 MW fossil power plant. A finite element analysis using a commercial S/W is performed to estimate alternating electromagnetic forces, mainly of 120 Hz in 60 Hz machines, acting on the core, and then to calculate forced response of the core. Results are compared with design requirements.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 1999.11a
• /
• pp.168-171
• /
• 1999

This paper describes the influence of conducting particle within the coaxial cylindrical electrodes gap under alternating voltage condition investigated using charge simulation method. If the conducting particles precent in the gas insulated system, they can cause decrement of breakdown voltage. Thus, three dimensions computations of electric fields and electrostatic forces have been carried out according to particle location. The results show a good agreement with those of outside country, which can offer a practical reference on the insulation design of domestic GIS.

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2001.11a
• /
• pp.219-220
• /
• 2001

Each atom is enclosed with $\pi$-rays, which were produced by the alternating magnetic field that is made by the electron's going and returning between atoms. If some resonant $\pi$-rays are supplied to and suppress the fencing $\pi$-rays, the bonding will be broken because the equilibrium distance for the electron moving between atoms can not be maintained. Electrolysis process supplies $\pi$-rays of Gibb's free energy to the reactant atoms and then the component atoms are divided into and are induced to both electric poles. (omitted)

• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2001.11a
• /
• pp.217-218
• /
• 2001

Each atom is enclosed with $\pi$-rays, which were produced by the alternating magnetic field that is made by the electron's going and returning between atoms. If some resonant $\pi$-rays are supplied to and suppress the fencing $\pi$-rays, the bonding will be broken because the equilibrium distance for the electron moving between atoms can not be maintained. Electrolysis process supplies $\pi$-rays of Gibb's free energy to the reactant atoms and then the component atoms are divided into and are induced to both electric poles. (omitted)

• Journal of the Korea Institute of Military Science and Technology
• /
• v.9 no.2 s.25
• /
• pp.11-19
• /
• 2006

The underwater electromagnetic signatures of a naval ship are mainly generated from three sources which are the permanent and induced magnetic field in the ship's hull and other ferrous components, the cathodic current electromagnetic field established by the Impressed Current Cathodic Protection(ICCP) system or the Sacrificial Anode and the stray electromagnetic fields generated by onboard equipment. These signatures can be minimized by certain design methods or installation of signature reduction equipment. In this paper, we represented the characteristic of the underwater electromagnetic signature and the signature reduction techniques for a naval ship. Also, we measured the electromagnetic field changes emitted from the real ship using the Electric and Magnetic field Measurement System(EMMS). We found that the underwater electromagnetic signature for a naval ship can be used as input or trigger signal in a surveillance system and an influence mine.