• 한국세라믹학회지
• /
• 제33권2호
• /
• pp.149-154
• /
• 1996

ZnO and Al-doped ZnO thin films were prepared by sol-gel dip-coating method and electrical and optical properties of films were investigated. Using the zinc acetate dihydrate and acetylaceton(AcAc) as a chelating agent stable ZnO sol was synthesized with HCl catalyst. Adding aluminium chloride to the ZnO sol Al-doped ZnO sol could be also synthesized. As Al contents increase the crystallinity of ZnO thin film was retarded by increased compressive stress in the film resulted from the difference of ionic radius between Zn2+ and Al3+ The thickness of ZnO and Al-doped ZnO thin film was in the range of 2100~2350$\AA$. The resistivity of ZnO thin films was measured by Van der Pauw method. ZnO and Al-doped ZnO thin films with annealing temperature and Al content had the resistivity of 0.78~1.65$\Omega$cm and ZnO and Al-doped ZnO thin film post-annealed at 40$0^{\circ}C$ in vacuum(5$\times$10-5 torr) showed the resistivity of 2.28$\times$10-2$\Omega$cm. And the trans-mittance of ZnO and Al-doped ZnO thin film is in the range of 91-97% in visible range.

• 한국재료학회지
• /
• 제20권7호
• /
• pp.351-355
• /
• 2010

Transparent conducting aluminum-doped ZnO thin films were deposited using a sol-gel process. In this study, the important deposition parameters were investigated thoroughly to determine the appropriate procedures to grow large area thin films with low resistivity and high transparency at low cost for device applications. The doping concentration of aluminum was adjusted in a range from 1 to 4 mol% by controlling the precursor concentration. The annealing temperatures for the pre-heat treatment and post-heat treatment was $250^{\circ}C$ and 400-$600^{\circ}C$, respectively. The SEM images show that Al doped and undoped ZnO films were quite uniform and compact. The XRD pattern shows that the Al doped ZnO film has poorer crystallinity than the undoped films. The crystal quality of Al doped ZnO films was improved with an increase of the annealing temperature to $600^{\circ}C$. Although the structure of the aluminum doped ZnO films did not have a preferred orientation along the (002) plane, these films had high transmittance (> 87%) in the visible region. The absorption edge was observed at approximately 370 nm, and the absorption wavelength showed a blue-shift with increasing doping concentration. The ZnO films annealed at $500^{\circ}C$ showed the lowest resistivity at 1 mol% Al doping.

• 한국재료학회지
• /
• 제16권7호
• /
• pp.449-454
• /
• 2006

Al-doped zinc oxide (ZnO:Al) films for transparent electrodes in thin film solar cells were deposited on glass substrates at a low temperature of $200^{\circ}C$ by rf magnetron sputtering. The transmittance of the ZnO:Al films in the visible range was 87%. The lowest resistivity of the ZnO:Al films was about $5.8{\times}10^{-4}{\Omega}$ cm at the Al content of 2.5 wt%. After deposition, the surface of ZnO:Al films were etched in dilute HCl (0.5%) for the investigation of the change in the electrical properties and the surface morphology due to etching.

• The Korean Journal of Ceramics
• /
• 제7권2호
• /
• pp.85-92
• /
• 2001

Thin films of ZnO and Al doped ZnO were prepared by rf magnetron sputter techniques. When the oxygen fraction in Ar-O$_2$ sputter gas was about 2.0%, the films exhibited the composition of Zn:O=1.05:1. The films prepared at 250 W contain larger grains than the films grown at 100 W. However, high deposition rate seems to deteriorates the crystallinity as well as Al-substitution, resulting in lower concentration of mobile electrons. The Al-doped ZnO films which were deposited at $500^{\circ}C$ show resistance of 1$\times$10$^-2$ Wcm; optical band gap of the films ranges from 3.25 to 3.40 eV. These electrical and optical features are related with microstructural as well as crystalline characteristics of the films.

• 한국전기전자재료학회논문지
• /
• 제26권3호
• /
• pp.194-197
• /
• 2013

We investigated the effect of etching time on the surface roughness, and electrical and optical properties of ZnO and 2 wt% Al-doped ZnO (AZO) films. The ZnO and AZO films were deposited on glass substrates by RF magnetron sputtering technique. The etching experiment was carried out using a solution of 5% HCl at room temperature. The surface roughness was characterized by Atomic Force Microscopy. The electrical property was measured by Hall measurement system and 4-point probe. The optical property was characterized by UV-vis spectroscopy. After the wet chemical etching, the surface textures were obtained on the surface of the ZnO and AZO films. With the increase of etching time, the surface roughness (RMS) of the films increased and the transmittance of the films was observed to decrease. For the AZO film, a low resistivity of $1.0{\times}10^{-3}\;{\Omega}{\cdot}cm$ was achieved even after the etching.

• 한국결정성장학회지
• /
• 제16권2호
• /
• pp.59-65
• /
• 2006

Al이 첨가된 ZnO(ZnO : Al) 박막과 F이 첨가된 ZnO(ZnO : F) 박막을 sol-gel 법을 이용하여 glass 기판위에 코팅하였다. 공통적으로 (002)면의 c-축 배향성을 보였지만 I(002)/[I(002) + I(101)]와 FWHM(full width at half-maximum) 값은 차이를 보였다. 특히 입자크기에 있어서는 ZnO : Al 박막에서 첨가농도가 증가함에 따라 입자크기가 감소한 반면 ZnO : F 박막에서는 F 3 at%까지 입자크기가 증가하다가 그 이후로 다시 감소하는 경향을 보였다. 진기적 성질의 측정을 위해서 Hall effect measurement를 이용하였는데 ZnO : Al 박막의 경우 Al 1 at%에서 비저항이 $2.9{\times}10^{-2}{\Omega}cm$ 이었고 ZnO : F에서는 F 3 at%에서 $3.3{\times}10^{-1}{\Omega}cm$의 값을 보였다. 또한 ZnO : F 박막은 ZnO : Al 박막에 비해서 캐리어 농도는 낮았지만(ZnO : Al $4.8{\times}10^{18}cm^{-3}$, ZnO : F $3.9{\times}10^{16}cm^{-3}$) 이동도에 있어서 상당히 큰 값(ZnO : Al $45cm^2/Vs$ ZnO:F $495cm^2/Vs$)을 보였다. 가시광선 영역에서의 평균 광투과도에 있어서는 ZnO : Al 박막에서 $86{\sim}90%$의 값을 보였지만 ZnO : F에서는 $77{\sim}85%$로 상대적으로 낮은 광투과도를 나타내었다.

• 전기학회논문지
• /
• 제66권10호
• /
• pp.1488-1493
• /
• 2017

Boron-doped ZnO:Al films were deposited by rf magnetron sputtering. The structural and optical property variations of the films with the boron amounts were studied. ZnO nanorods were grown on $SiO_2/Si$ wafers and glass by a hydrothermal method. ~50 nm-thick boron-doped ZnO:Al films were deposited on the substrates as seed layers. The mixed solution of zinc nitrate hexahydrate and hexamethylenetetramine in DI water was used as a precursor for ZnO nanorods. The concentration of zinc nitrate hexahydrate and that of hexamethylenetetramine were 0.05 mol, respectively. ZnO nanorods were grown at $90^{\circ}C$ for 2 hours. X-ray diffraction was conducted to observe the crystallinity of ZnO nanorods. A field emission scanning electron microscope was employed to study the morphology of nanorods. Optical transmittance was measured by a UV-Vis spectrophotometer, and photoluminescence was carried out with 266 nm light. The ZnO nanorods grown on the 0.5 wt% boron-doped ZnO seed layer showed the best crystallinity.

• 한국진공학회지
• /
• 제19권3호
• /
• pp.206-210
• /
• 2010

RF 마그네트론 스퍼터링법을 이용하여 Al 도핑된 ZnO 박막을 Ar 유량에 따라 증착하고 박막의 다양한 특성을 연구하였다. ZnO 박막의 Ar 유량 변화를 통해 고품질 박막을 증착할 수 있었고 Al 도핑된 ZnO 박막에 대한 Ar 유량의 영향을 확인하였다. 모든 Al 도핑된 ZnO에서 80% 이상의 좋은 투과도를 보였다. Hall 측정과 X-ray photoelectron spectrometer 측정 결과, 비저항이 가장 작은 60 sccm에서 가장 작은 Al 도핑 농도를 보였다. Ar 유량에 따른 Al 도핑된 ZnO 박막에서의 전기적인 특성은 Al 도핑 농도보다 산소 공공에 의해 더 영향을 받음을 확인하였다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 추계학술대회 논문집 Vol.17
• /
• pp.535-538
• /
• 2004

Zinc Oxide (ZnO) films have attracted considerable attention for transparent conducting films, because of their high conductivity, good optical transmittance from UV to near IR as well as a low-cost fabrication. To increase the conductivity of ZnO, doping of group III elements (Al, Ga, In and B) has been carried out. Transparent conducting films have been applied for optoelectric devices, the development of the transparent conducting thin films on flexible light-weight substrates are required. In this research, the transparent conducting ZnO thin films doped with Aluminum (Al) on polymer substrates were deposited by the RF magnetron suputtering method, and the structural, optical and electrical properties were investigated.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.452-452
• /
• 2013

ZnO is one of the most attractive transparent conductive oxide (TCO) films because of low toxicity, a wide band gap material and relatively low cost. However, the electrical conductivity of un-doped ZnO is too high to use it as TCO films in practical application. To improve electrical properties of undoped ZnO, transition metal (TM) doped ZnO films such as Al doped ZnO or Ti doped ZnO have been extensively studied. Here, we prepared Ti doped ZnO thin films by atomic layer deposition (ALD) for the application of TCO films. ALD was used to prepare Ti-doped ZnO thin films due to its inherent merits such as large area uniformity, precise composition control in multicomponent thin films, and digital thickness controllability. Also, we demonstrated that ALD method can be utilized for fabricating highly ordered freestanding nanostructures of Ti-doped ZnO thin films by combining with BCP templates, which can potentially used in the photovoltaic applications.