• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.8
• /
• pp.767-774
• /
• 2010

In a passive-type PEMFC stack, axial fans operate to supply both oxidant and coolant to cathode side of the stack. It is possible to make a simple system because the passive-type PEMFC stack does not require additional cooling equipment. However, the performance of a cooling system in which water is used as a coolant is better than that of the air-cooling system. To ensure system reliability, it is essential to make cooling system effective by adopting an optimal stack design. In this study, a numerical investigation has been carried out to identify an optimum cooling strategy. Various channel configurations were applied to the test section. The passive-type PEMFC was tested by varying airflow rate distribution at the cathode side and external heat transfer coefficient of the stack. The best cooling performance was achieved when a channel with thick ribs was used, and the overheating at the center of the stack was reduced when a case in which airflow was concentrated at the middle of the stack was used.

• Korean Journal of Food Science and Technology
• /
• v.20 no.3
• /
• pp.363-370
• /
• 1988

An attempt was made in this study to investigate the possibility of processing oyster and sea mussel into an intermediate moisture food. To obtain a palatable and instant product, shucked samples were heated in soy sauce for 5 min., heated in seasoning solution for 10 min., and then dried by the method of hot-air blowing for 4-6 hours at $40^{\circ}C$. Optimum seasoning solutions consisted of 2% monosodium glutamate, 3.5% sodium chloride, 15% sorbitol, 2% propylene glycol, 5% glycine and 0.02% rosemary oleoresin in 72.48% water. Judging from water activity, thiobarbituric acid, viable cell count, volatile basic nitrogen, surface color and sensory evaluation, vacuum-packaging method in nylon/PE $(20{\mu}m/40{\mu}m)$ or polyester/viniliden chloride/polypropylene $(12{\mu}m/15{\mu}m/50{\mu}m)$ film bag did hardly damage to the quality of intermediate moisture products, but air-packaging method in polyethylene(0.06m/m) bag did considerable damage to the quality during storage for 60 days in an incubator with 49-51% relative humidity at $30^{\circ}C$.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.24 no.3
• /
• pp.310-320
• /
• 2014

Backgrounds: Endotoxin, which found in the outer membrane of the gram-negative bacteria cell wall, makes up almost all of the lipopolysaccharide(LPS). When people are exposed to endotoxin,it can result in diverse health effects such as an airway irritation and inflammation, fever, malaise, bronchitis, allergic asthma, toxic pneumonitis, hypersensitivity lung disease. Cases among the elderly, children or pregnant can occur more frequently than a healthy adult if they are repeatedly exposed to the existing endotoxin. Therefore, we investigated and assessed the environmental characteristics associated with the airborne endotoxin concentration level in six hospital lobbies. Method: Endotoxin from indoor air in six hospital lobbies was measured by an area sampling method and analyzed according to American Society for Testing and Materials International(ASTM international) E2144-01. Total suspended particulate(TSP), carbon dioxide($CO_2$), temperature and humidity were also measured by using direct reading measurements or airborne sampling equipment at the same time. Environmental characteristics were appropriately divided into two or three groups for a statistics analysis. One-way analysis variable(one-way ANOVA) was used to examine a difference of the endotoxin concentration, depending on the environmental characteristics. In addition, only variables with p-value(p<0.25) were eventually designed to the best model by using multiple regression analysis. Results: The correlation analysis result indicated that TSP(p=0.003) and $CO_2$(p<0.0001) levels were significantly associated with endotoxin concentration levels. In contrast, temperature(p<0.068) and humidity(p<0.365) were not associated with endotoxin concentration. Levels of endotoxin concentration were statistically different among the environmental characteristics of Service time(p=0.01), Establishment of hospital(p<0.001), Scale of hospital(p=0.01), Day average people using hospital(p=0.03), Cleaning time of lobby(p=0.05), Season(p<0.001), and Cleaning of ventilation system(p<0.001) according to ANOVA. Finally, the best model(Adjusted R-square=72%) that we designed through a multiple regression test included environmental characteristics related to Service time, Area of lobby, Season, Cleaning of ventilation system, and Temperature. Conclusions: According to this study, our result showed a normal level of endotoxin concentration in the hospital lobbies and found environmental management methods to reduce the level of endotoxin concentration to a minimum. Consequently, this study recognized to be requirement for the management of ventilation systems and an indoor temperature in order to reduce the level of endotoxin concentration in the hospital lobbies.

• Korean Journal of Food Science and Technology
• /
• v.26 no.4
• /
• pp.422-427
• /
• 1994

The quality of salted and semi-dried mackerel prepared by cold osmotic dehydration using a high osmotic pressure resin during storage at $5{\pm}1^{\circ}C$ was evaluated. The moisture contents in salted and semi-dried mackerel decreased in. range of 4 during storage. The brown pigment formation content and peroxide value of salted and semi-dried mackerel prepared by osmotic dehydration were more lower than those of salted and semi-dried mackerel prepared by traditional drying methods such as sun-drying, hot-air drying and cold air drying. The viable cell count and histamine contents of cold osmotic dried products were much lower and revealed a tendency to increase during storage, but even these values after storage of 15 days showed that the salted and semi-dried mackerel was safety in respect of food sanitation. The ratio of saline soluble nitrogen to total nitrogen in cold osmotic dried products were higher than that of traditional dried products during storage. Judging from the results of chemical and sensory evaluation, shelf-life of salted and semi-dried mackerel by cold osmotic drying were more longer than that of salted and semi-dried mackerel prepared by traditional drying.

• Journal of the Mineralogical Society of Korea
• /
• v.18 no.3 s.45
• /
• pp.147-153
• /
• 2005

Naldrettite, recently discovered in the Mesamax Northwest deposit, Ungava region, northern Quebec, Canada, was reported as a new mineral. In order to confirm whether itis a natural equivalent of synthetic $Pd_2Sb$ phase or not, the pure $Pd_2Sb$ phase has been synthesized and investigated by reflected microscope, electron microprobe analyser, X-ray diffractometer, and micro-indentation hardness tester. Under reflected light synthetic $Pd_2Sb$ Phase is white with a creamy tint in both air and oil and weakly bireflectant. Anisotropism is strong, from brownish gray to greenish blue in air. Micro-indentation hardness test gives VHN100=293(242-322). Composition of the phase is $63.7\~64.3wt.\%\;Pd\;and\; 36.4\~36.8wt.\%$ Sb, and is entirely consistent. The phase, quenched from $500^{\circ}C$, is orthorhobic with space group $Cmc2_1$, and the cell parameters are a=3.366(1), b=17.523(3), c=6.929(2) ${\AA}$. All mineralogical properties of synthetic $Pd_2Sb$ compare very well with those of naldrettite, confirming that naldrettite is the natural analogue of the synthetic $Pd_2Sb$ phase.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.2
• /
• pp.1204-1210
• /
• 2014

New control methods are proposed for indoor air quality by removing fine airborne dust-particles. As suspended fine dust-particles contain inorganic dust as well as fine organic bacteria, studies for simultaneous control of these contaminants are required. In this study, photocatalytic disinfection of indoor suspended microorganisms such as E. coli and Bacillus subtilis is performed by three types of photocatalysts with UVA irradiation. The UVA irradiation strength was controlled to the minimum $3{\mu}W/cm^2$, and ZnO, $TiO_2$, and ZnO/Laponite ball were used as the catalysts. The results indicate that E. coli was removed over 80 % after about 2 hours of reaction with UVA and all three types of photocatalysts, whereas only with UVA, around 50 % E. coli removal was obtained. Among the catalysts, ZnO/Laponite composite ball was found to have similar sterilizing capacity to $TiO_2$. However, in case of B. subtilis, which has thick cell wall in its spore state, disinfection was not effective under the low UVA irradiation condition, even with the catalysts. Further studies need to figure out the optimal UVA irradiation ranges as well as photocatalysts doses to control airborne dust, to provide healthy clean air environment.

• Applied Chemistry for Engineering
• /
• v.22 no.3
• /
• pp.301-307
• /
• 2011

Optimal culture conditions of Spirulina platensis NIES 39 have been established using different types of light sources. Several types of photobioreactors were designed and the increase of biomass, the amount of $CO_2$, fixation and the production of chlorophyll content were studied. The result revealed that the input conditions of a 10 min period per 4 h at the condition of 5% $CO_2$ and 0.1 vvm, were excellent in the growth. The growth showing the maximum biomass accumulation is limited to 1.411 g/L when using the fluorescent bulb and the low powered surface mount device (SMD) type LEDs which were equipped-inside in the photobioreactor. However, the biomass exceeded up to 1.758 g/L level when a high powered red LED (color temperature : 12000 K) photobioreactor system was used. The $CO_2$ fixation speed and rate were increased. Although the total production of chlorophyll content undergoes a proportional increase in the biomass, the net content per dry cell weight (DCW) showed the higher production with a blue LED (color temperature : 7500 K) light than that of any other wavelengths. The carbon dioxide loss was marked as 0.15% of the inlet gas (5% $CO_2/Air$, v/v) at the maximum biomass culture condition.

• Korean Journal of Food Science and Technology
• /
• v.54 no.2
• /
• pp.196-202
• /
• 2022

In this study, the quality characteristics of Jeung-pyun with different amounts of Makgeolli (50, 100, 150, and 200 mL) were investigated, and standardization of the Jeung-pyun production process is suggested. Higher Makgeolli contents resulted in an increase in Jeung-pyun qualities such as the b value, air cell size, springiness, and cohesiveness, whereas Jeung-pyun characteristics such as the L values, pH, number of air cells, hardness, and gumminess significantly decreased. The specific volume was highest following method M-150, and the expansion rate was lowest following method M-200. Altering the Makgeolli content did not significantly differ in moisture content and b values. In the sensory evaluation results, the M-150 method produced the highest-ranking results for all tested items (i.e., overall acceptability, appearance, flavor, taste, and texture). Therefore, this study suggests that Jueng-pyun produced with the M-150 mixing ratio has excellent quality and sensory characteristics. Furthermore, the results of this study can be used as preliminary data for the standardization of Jueng-pyun production.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.6
• /
• pp.643-648
• /
• 2010

Portable fuel cells are commonly operated in the dead-end mode because of such as high fuel utilization. However, the performance of such systems deteriorates continuously with an increase in the amount of by-products such as water vapor and nitrogen. In this study, to verify the effect of water vapor on Proton Exchange Membrane Fuel Cells (PEMFCs), constant-load experiments were carried out for a current density of 600 mA/cm2 and a voltage of 0.4 V, respectively. The performance of the cell was more stable under constant voltage conditions than under constant current density conditions. Condensed water accumulated in the anode channel near the cell outlet. The experimental results show how the relative humidity (RH = 0.15, 0.4 and 0.75) of air at the cathode side affect the performance of PEMFCs with dead-end anode. At RH values higher than 0.15, the mean power density increased by up to 51% and the mean purge duration decreased by up to 25% compared to the corresponding initial values.

• Korean Journal of Animal Reproduction
• /
• v.14 no.1
• /
• pp.1-8
• /
• 1990

These experiments were carried out to investigate the effects of cumulus cells for in vitro fertilization and development of bovine follicular oocytes matured in vitro. The bovine ovaries were obtained at a slaughter house and the follicular oocytes surrounded by cumulus cells were collected by puncturing follicles with 2~6 mm of diameter. Bovine oocytes were matured in vitro for 24~26 hours in a CO2 incubator with 5% CO2 in air at 39$^{\circ}C$. The medium used for maturation was TCM-199 supplemented with hormones, pyruvate, FCS and antibiotics. Epididymal spermatozoa were capacitated by in vitro culture for 2~3 hours in BO solution containing BSA(5mg/ml) and caffeine(2.5mM). Insemination was made by introducing about 10~15 matured oocytes into the suspension of capacitated spermatozoa. Six hour after insemination the eggs were transferred to TCM-199 supplemented with FCS(10%) and HEPES(25mM), cultured for 7~8 days with 10~15 eggs/well in 4-well multidishes(Nunc Co.) forming cumulus cell monolayer. The results obtained in these experiments were summarized as follows ; 1. The majority of the follicular oocytes with compacted cumulus cells existed in GV stage while those with dispersed or denuded cumulus cells existed GVBD and M II stage. 2. After 24~26 hours maturation, the maturation rates of the follicular oocytes cultured in TCM-199 containing hormones were slightly higher than those of oocytes cultured in medium without hormones, and the frequency of cumulus compacted or denuded oocytes reaching M II stage cultured in medium containing hormones was 75.7% or 51.7%, respectively(P<0.05). 3. After 20 hours in vitro insemination, percentages of ova fertilized were 61.4% or 51.4%, respectively, for cumulus oophorus intacted or removed, and increased frequency of ova with both male and female pronuclei was found when cumuli were present(P<0.05). 4. The rates of embryos developed to 2-, 4-, 8-, 16-cell and morula or blastocyst stage after cocultured with cumulus cells were 65.0%, 45.3%, 34.7%, 28.0% and 22.7%, respectively. The results for momla or blastocyst stage were significantly higher than those of the embryos cultured in the basic medium(P<0.05).