• 설비공학논문집
• /
• 제7권3호
• /
• pp.353-358
• /
• 1995

The emission characteristics of a semi-Bunsen type burner for gas boilers were studied experimentally. The experimental results reveal that nitric oxide emission increases with fuel flow rate. It is linearly proportional to total fue flow rate at a small amount of fuel up to 0.4 liters per minute. It does not change significantly within the range of fuel flow rate from 0.4 to 1.2 liters per minute per nozzle and increases at large fuel flow rate. The carbon monoxide emission reveals to be dependent upon the fuel flow rate per each nozzle and the number of fuel injection nozzles. Diameter of an injection nozzle could have an effect on the emission characteristics of this type of burners. However, there is no marked change in the nitric oxide emission if the total fuel flow rate is same with different nozzle sizes.

• 대한기계학회논문집B
• /
• 제28권3호
• /
• pp.359-364
• /
• 2004

For the development of high efficiency and low emission combustion systems, high temperature air combustion technology has been tested by utilizing preheated air over 1100 K and exhaust gas recirculation. In this system, combustion air is diluted with large amount of recirculated exhaust gases, such that the oxygen concentration is relatively low in the reaction zone, leading to low flame temperature. Since, the temperature fluctuations and sound emissions from the flame are small and flame luminosity is low, the combustion mode is expected to be flameless or mild combustion. Experiment was performed to investigate the turbulent flame structure and NO$_x$ emission characteristics in the high temperature air combustion focused on coflowing jet diffusion flames which has a fundamental structure of many practical combustion systems. The effect of turbulence has also been evaluated by installing perforated plate in the oxidizer inlet nozzle. LPG was used as a fuel. Results showed that even though NO$_x$ emission is sensitive to the combustion air temperature, the present high temperature air combustion system produce low NO$_x$ emission because it is operated in low oxygen concentration condition by the high exhaust gas recirculation.

• 한국연소학회:학술대회논문집
• /
• 대한연소학회 2003년도 제27회 KOSCO SYMPOSIUM 논문집
• /
• pp.89-94
• /
• 2003

For the development of high efficiency and low emission combustion systems, high temperature air combustion technology has been tested by utilizing preheated air over 1100 K and exhaust gas recirculation. In this system, combustion air is diluted with large amount of exhaust gases ($N_2$, $CO_2$), such that the oxygen concentration is relatively low in the reaction zone, leading to low flame temperature. Since, the temperature fluctuations and sound emissions form the flame are small and flame luminosity is low, the combustion mode is expected to be flameless or mild combustion. Experiment was performed to investigate the turbulent flame structure and $NO_X$ emission characteristics in the high temperature air combustion focused on coflowing jet diffusion flames which has a fundamental structure of many practical combustion systems. The effect of turbulence has also been evaluated by installing perforated plate in the oxidizer inlet nozzle. LPG was used as a fuel. Results showed that even though $NO_X$ emission is sensitive to the combustion air temperature, the present high temperature air combustion system produce low $NO_X$ emission because it is operated in low oxygen concentration condition in excess of dilution.

• 무역상무연구
• /
• 제48권
• /
• pp.27-56
• /
• 2010

Pollution emissions from international shipping and port activities have a significant impact on public health and global climate changes. The purpose of this paper is to review the status of pollution mitigation measures implemented to date in port industry and find out some implications for Korean ports. For this aim, the clean air strategies of the world major ports including six USA ports (Los Angeles/Long Beach, Now York/New Jersey, and Seattle and Tacoma), two European ports (Rotterdam and Gothenburg) and Busan Port were considered. Various measures to reduce emission from ports are evaluated by sectors-ocean going vessels, cargo handling equipments, truck and rail-, on the basis of categories such as reduction control technologies, operational changes and market-based measures. The policy implications of this paper are as follows. First, Clean Air Act Plans of Korean ports are required as soon as possible. Second, integrated approach is required to reduce emission effectively. Finally, the effect of port-related emission reduction can be maximized when various measures are conducted on a regional basis including neighboring ports. Furthermore, regional or global-based approach is useful to guarantee the level playing field among ports.

• 한국연소학회지
• /
• 제7권3호
• /
• pp.16-22
• /
• 2002

Combustion performance of an internally cycloned circulating fluidized bed for paper sludge was discussed through a series of batch type experiments. Operation parameters such as water content, feeding mass of sludge and secondary air injection rate were varied to find out the effect on the combustion performance, which was examined with carbon conversion rate and pollutant emission such as CO and NOx. A conventional solid fuel reaction was observed in the experiments of varying water content and feeding mass of the sludge, which is characterized with kinetic limited reaction zone, diffusion limited reaction zone and transition zone. Secondary air injection with swirl enhances the mixing of the gas phase as well as the solid phase, and improves combustion efficiency accompanied with higher carbon conversion rate and lower pollutant emission rate.

• 한국환경보건학회:학술대회논문집
• /
• 한국환경보건학회 2003년도 Challenges and Achievements in Environmental Health
• /
• pp.50-65
• /
• 2003

Air pollution is very serious in China. This paper reviews the relevant research and countermeasures in China. The followings are focused in this article: 1) three major types of air pollutions: sulphur dioxide, vehicle emission and indoor air pollution; 2) the health effect of the three types of pollution; 3) major countermeasures adopted by Chinese Government.

• 한국농공학회논문집
• /
• 제64권6호
• /
• pp.25-34
• /
• 2022

Recently, as a study to air cooled slag, which is an industrial by-product, research is being proceed to use it as a material for concrete. In this study, the workability, air content, compressive strength, CO₂ emission and economic feasibility of concrete were analyzed when air cooled slag, an industrial by-product, was applied as aggregate for rural road pavement concrete. As a result of the analysis, both the slump and air contents test results of concrete using the air cooled slag aggregate satisfied the target values, and the compressive strength was increased when the air cooled slag aggregate was used compared to when the natural aggregate was applied. On the other hand, the largest amount of CO₂ emission by raw material was found in aggregate. The carbon emission of rural road pavement concrete using air cooled slag aggregate increased when the Korean LCI DB was applied compared to when natural and crushed aggregates were applied, and the emission decreased when the German LCI DB was applied. This results are due to differences in the viewpoints of industrial by-products. However, considering the recycling of waste from the environmental aspect, it is necessary to simultaneously review the CO₂ emission and recycling aspects in the future. Also, the application of air cooled slag aggregate had the effect of improving the economic efficiency of rural road pavement concrete about 18.75%.

• 대한기계학회논문집
• /
• 제19권2호
• /
• pp.591-596
• /
• 1995

In order to investigate the reduction of NO emissions, natural gas was fueled for two-stage combustion apparatus. NO and CO emissions were described by five variables: total air ratio, primary air ratio, secondary air injection position, secondary air injection velocity, and swirl ratio. It was mainly observed that, as the primary air ratios of 0 and 0.4 NO emission decreased with increasing the secondary air injection position and secondary air injection velocity. The effect of weak swirl on NO emission was found to be insignificant.

• Journal of Advanced Marine Engineering and Technology
• /
• 제24권2호
• /
• pp.57-62
• /
• 2000

The effect of exhaust gas recirculation(EGR) on the characteristics of exhaust gas emissions, and SFC are experimentally investigated by four-cylinder, four-cycle and direct injection marine diesel engine. In order to reduce the soot contents in the recirculated exhaust gas to intake system of the engines, a soot removal system of a cylinderical-type scrubber is specially designed and manufactured for the experimental system. (1) SFC is increased in downward convex curve style with increasing excess air ratio, it is increased with increasing EGR rate at the same excess air ratio. (2) NOx emission is reduced in downward convex curve style with increasing excess air ratio, it is reduced with increasing EGR rate at the same excess air ratio. (3) Soot emission is decreased in downward convex curve style with increasing excess air ratio, it is reduced with increasing EGR rate at the same excess air ratio. (4) CO emission is increased in nearly straight line style with increasing excess air ratio, it is increased with increasing EGR rate at the same excess air ratio. (5) HC emission is not constant tendency with increasing excess air ratio, it is increased with increasing EGR rate at the same excess air ratio.

• 한국대기환경학회지
• /
• 제29권5호
• /
• pp.536-544
• /
• 2013

Even a small amount of hazardous air pollutants could have a harmful influence upon human beings, animals and plants. Hazardous air pollutants have the properties of toxicity, canceration and organism accumulation. They include heavy metals, volatile organic compounds, polycyclic aromatic hydrocarbons, dioxin, etc. The Clean Air Conservation Act has defined specific hazardous air pollutants and designated 35 pollutants, distinguishing them from common air pollutants for special control. This study investigates the history of the controls of specific hazardous air pollutants with reference to some relevant laws and regulations in Korea. It investigates the regulations at the permission stage, such as the restrictions on installation of emission facilities, the permission and reporting of installation of emission facilities, and the regulations at the operation stage, such as maintaining permissible emission levels, installation of measuring devices, dues for emission, self-measurement and securing environmental engineers. The current regulatory management is not so satisfactory in regards to the serious effects of specific hazardous air pollutants upon the human body. An advanced new concept, like the maximum available control technology in US, the facilities management standards, which will soon take effect, will be able to lessen the emissions of fugitive hazardous air pollutants. In addition, this study discusses some possible stricter controls on the emission facilities of specific hazardous air pollutants and proposes some measures to maintain and supplement the current systems.