• Journal of Periodontal and Implant Science
• /
• v.37 no.2
• /
• pp.287-295
• /
• 2007

As a general treatment modality of subgingival tooth defect in aethetic area, implant or crown and bridge therapy after extraction of affected tooth can be used. But as more conservative treatment, crown lengthening can be considered and not to lose periodontal attachment and impair aethetic appearance, surgical extrusion can be considered as a treatment of choice. In this case report, 3 cases of surgical extrusion was represented and appropriate time for initiation of endodontic treatment according to the post-surgical tooth mobility was investigated. In 8 patient who has subgingival tooth defect in aethetic area, intracrevicular incision is performed and flap was reflected with care not to injure interproximal papillae. With forcep or periotome, tooth was luxated and sutured in properely extruded position according to biologic width with or without $180^{\circ}$ rotation. 8 cases show favorable short and long term results. In some cases, surgical extrusion with $180^{\circ}$ rotation can minimized extent of extrusion and semi-rigid fixation without apical bone graft seems to secure good prognosis. In 8 cases, endodontic treatment started about 3 weeks after surgery. This time corresponds with the moment when mobility of extruded tooth became 1 degree and this results concide with other previous reports. If it is done on adequate case selection and surgical technique, surgical extrusion seems to be a good treatment modalilty to replace the implant restoration in aethetic area.

• Archives of Plastic Surgery
• /
• v.36 no.5
• /
• pp.654-659
• /
• 2009

Purpose: A botulinum toxin type A (BoNT - A) injection has been used as a noninvasive management for lower face contouring since 2000. The aim of this study was to compare reduction rate of lower face width for a longtime according to repeated Botox$^{(R)}$ injections on masseter muscles for lower face contouring procedure. Methods: Forty - five patients were analyzed for single session of Botox$^{(R)}$ injection and 13 patients were evaluated for repeated Botox$^{(R)}$ injections for over two years. Single injection group was tracked regular intervals at 1, 3, 6, 10, 12 months after injection, and repeated injection group was measured at every injection time. Twenty - five to thirty units of Botox$^{(R)}$ was injected into each masseteric muscle at five to six points at the prominent portions of the mandibular angle. Standardized frontal view of digital photographs were analyzed by Adobe Photoshop$^{(R)}$ (version CS3) to measure an reduction rate of lower face width. Results: Reduction rate was 3.7%, 6.9%, 6.2%, 4%, 4% at 1, 3, 6, 10, 12 months post injection each other in single injection group. However, more than 8% reduction rate was found in repeated injection group persistently for more than two years. Conclusion: This study shows that effective duration of Botox$^{(R)}$ injection for lower face contouring is expected to continue over one year clinically. Moreover, repeated injections maintained lower reduction rate consistently for a long time. Therefore, repeated injections on masseter muscles at regular intervals are most effective procedure for lower face contouring.

• Archives of Plastic Surgery
• /
• v.36 no.6
• /
• pp.691-701
• /
• 2009

Purpose: Deviations of arterial palmar arches in the hand can be explained on the embryological basis. The purpose of this study was to provide new information about palmar arches through cadaver's dissection. The values of the location and diameter in these vessels were analyzed in order to support anatomical research and clinical correlation in the hand. Methods: The present report is based on an analysis of dissections of fifty - three hands carried out in the laboratory of gross anatomy. A reference line was established on the distal wrist crease to serve as the X coordinate and a perpendicular line drawn through the midpoint between middle and ring fingers, which served as the Y coordinate. The coordinates of the x and y values were measured by a digimatic caliper, and statistically analyzed with Student's t - test. Results: Complete superficial palmar archs were seen in 96.2 % of specimens. In the most common type of males, the superficial arch was formed only by the ulnar artery. In the most common type of females, the superficial arch was formed anastomosis between the radial artery and the ulnar artery. The average length of the superficial and deep palmar arch is $110.3{\pm}33.0mm$ and $67.9{\pm}14.0mm$ respectively. Regarding the superficial palmar arch, ulnar artery starts $-16.1{\pm}5.1mm$ on X - line, and $2.5{\pm}24.5mm$ on Y - line. Radial artery appears on palmar side $7.7{\pm}3.2mm$ on X - line, and $20.9{\pm}10.9mm$ on Y - line. But radial artery starts on $6.3{\pm}3.6mm$ on X - line, and $3.4{\pm}5.1mm$ on Y - line. Digital arteries of superficial palmar arch starts on $6.1{\pm}3.7mm$, $33.9{\pm}8.8mm$ on index finger, $1.8{\pm}3.4mm$, $40.1{\pm}7.3mm$ on middle finger, $-3.2{\pm}4.9mm$, $42.6{\pm}7.0mm$ on ring finger, and $-8.9{\pm}5.1mm$, $42.5{\pm}80mm$ on little finger in respective X and Y coordinates. Radial artery of deep palmar arches measured at the palmar side perforating from the dorsum of hand. It's coordinates were $9.7{\pm}4.8mm$ on X - line, $21.7{\pm}10.2mm$ on Y - line. Ulnar artery was measured at hypothenar area, and it's coordinates were $-20.4{\pm}6.3mm$ on X - line, and $30.6{\pm}7.4mm$ on Y - line. Conclusions: Anatomically superficial palmar arch can be divided into a complete and an incomplete type. Each of them can be subdivided into 4 types. The deep palmar arch is less variable than the superficial palmar arch. We believe these values of the study will be used for the vascular surgery of the hand using the endoscope and robot in the future.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.32 no.4
• /
• pp.709-716
• /
• 2005

Patients with cleft tip and palate present severe maxillary hypoplasia due to scar of lip and palate, often accompanied by compromised mastication, speech abnormalities. Sometimes maxillary hypoplasia persist even though active orthodontic treatment was done. In theses cases, patients born with cleft lip and palate will be potential candidates for maxillary advancement with bone grafting after growth to correct the functional deformities and improve aesthetic facial proportions. But, maxillary advancement using standard surgical approaches has several limitations : increased relapse tendency after maxillary advancement, necessity of additional bone graft and mandibular setback surgery. Distraction osteogenesis is current treatment modality to overcome these limitations, thus has become popular for treatment of maxillary hypoplasia associated cleft lip and palate, craniosyntosis. Especially, rigid external distraction, contrary to internal device, has advantages : better vector control of osteotomized segment, effective traction of the bony segments, the ease of the application and removal the distraction device. This study showed that relatively successful result could be generated by using rigid external distraction osteogenesis(RED) in the case of cleft lip and palate with severe maxillary hypoplasia, 6 years 7 months old.

• Journal of Korean Dental Science
• /
• v.4 no.2
• /
• pp.46-51
• /
• 2011

Purpose: For aesthetic reasons, composite resin brackets are widely used. However, related studies are rare. This pilot study sought to compare the stress distributions in two commercially available composite resin brackets with metal slot. Materials and Methods: Two commercially available resin brackets -- full-metal slot resin bracket (fSRB) and partial-metal slot resin bracket (pSRB) with straight wire appliance dimension of $0.022{\times}0.028$ in -- were selected. In each bracket, 3-dimensional finite element models were constructed, and stress level was evaluated using finite element analysis. By loading the tipping force and torsion moment, which are similar to those applied by the stainless steel rectangular wire ($0.019{\times}0.025$ -in), stress distributions were calculated, and von Mises stress values were obtained. Results: In pSRB and fSRB, the stress value of the torque moment was much higher than that of the tipping force. The pSRB showed higher stress value than fSRB in both tipping force and torque moment because of the difference in size and configuration of the metal frame inserted into the slot. More stress was also found to be concentrated on the slot area than the wing area in fSRB. Conclusion: The slot form of fSRB was found to be more resistant to the stress of tipping and torque than the slot form of pSRB. In addition, the slot areas -- rather than the wing areas -- of the bracket showed breakage susceptibility. Therefore, resistance to the torque moment on the slot area should be considered in bracket design.

• The Journal of Korean Academy of Prosthodontics
• /
• v.59 no.1
• /
• pp.97-106
• /
• 2021

Dental implants should be placed at ideal sites for implant-supported restorations. For a patient with insufficient residual ridge, mouth preparation including surgical intervention can be indicated to establish a soft and hard tissue environment favorable for a definitive prosthesis. Prosthodontic design based on computer-guided surgery and computer-aided design-computer-aided manufacturing (CAD-CAM) provides a visual blueprint allowing a clinician to assess the necessity of such a surgical intervention beforehand. In this case, a definitive restoration was planned and made via a CAD-CAM system according to the patient's oral status before treatment, simulated surgical interventions and serial provisional restorations. Based on the planning, a guided template was made and the implants were installed with bone augmentation using the template. Customized abutments, the first and the second provisional restorations were designed and fabricated by CAD-CAM. The definitive restorations were digitally made following the shape of the second provisional prostheses, which were confirmed in the patient's mouth. The patient was satisfied with the masticatory, phonetic and aesthetic functions of these definitive prostheses.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.35 no.4
• /
• pp.757-765
• /
• 2008

Maxillary central incisor impactions occur infrequently. Their origins include various local causes, such as odontoma, supernumerary teeth, space loss, and disturbances in the eruption path, also trauma and apical follicular cysts. Impacted teeth can cause serious dental and aesthetic difficulties as well as psychological problems especially in anterior regions. Although the impaction of maxillary incisor occurs less frequently than that of the maxillary canine, it is of concern to parents during the early mixed dentition stage because of the uneruption of the tooth. Forced eruption of impacted teeth should be considered in young patients because this technique can lead to suitable results from a periodontal, occlusal, and esthetic perspective at an earlier stage better than with other treatment options. This report presents the surgical and orthodontic treatment of cases with horizontally impacted and dilacerated maxillary central incisors. For each patient, we used the closed eruption method, placed an attachment on the impacted tooth on surgery, and fully closed the flap. Traction was applied immediately. The impacted tooth erupts through the healed tissue in a manner resembling normal eruption.

• Journal of the Korean Academy of Esthetic Dentistry
• /
• v.31 no.1
• /
• pp.11-18
• /
• 2022

Adult patients who need implant and prosthodontic treatment often need treatment to improve the existing occlusion through orthodontic treatment for long-term stable treatment results. However, due to non-aesthetic and uncomfortable orthodontic treatment with orthodontic brackets and wires, many adult patients give up treatment even though they know the need for it. Recently, as digital dentistry has affected all areas of dentistry, clear aligner orthodontic systems have begun to be widely used, and their use is increasing in adults and old-aged people due to the esthetic advantage and convenient oral care. SERAFIN clear aligner system developed in Korea has been developed with the aim of implementing a functional occlusion harmony and is used not only for partial orthodontic treatment but also comprehensive orthodontic treatment. This patient presentation is shown the treatment using SERAFIN clear aligner system for the treatment of patient with TMD, severe extrusion of maxillary second molars, and extracted teeth.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.35 no.5
• /
• pp.572-582
• /
• 2006

This survey was conducted from June 2004 to August 2004, through questionnaires given to 432 women aged ranging from 20 to 50 years, who were living in the Seoul metropolitan area. The questionnaires were designed to determine the physique, level of obesity and dieting survey as well as to uncover which diets were in fashion and their satisfaction degree. Dieting-related knowledge and dieting side effects were also investigated. The results were as follows: In dieting survey, as the age increased, dieting for health reason (52.3%) increased, whereas that for aesthetic reasons (32.6%) decreased (p<0.05). The most effective methods of dieting were exercise (50.2%) and diet (45.0%) regimens. In regards to exercise frequency, 46.5% for none, 23.5% for 1-2 times a week, suggesting that most respondents do not practice exercise for dieting purposes (p<0.05). Major source for dieting was shown to be obtained from relative family or friends (31.7%), newspapers or magazines (29.3%) and internet (14.9%). As the age decreased, information from the latter increased, whereas that from TV program (21.2%) decreased (p<0.05). Reasons for excess weight were bad eating habits (39.6%), lack of exercise (38.3%), pregnancy and childbirth (10.6%). In fad dieting, while organic foods and aerobic exercises scored the highest satisfaction degree among diet and exercise regimens, on the other hand, sauna, steam baths and high temperature half-immersion baths scored the highest among surgery and other special therapies. As the age increased, the satisfaction degree for organic foods such as organic vegetable and high functional boiled cooked rice increased (p<0.05). As the age increased, scores on dieting-related knowledge decreased. Side effects of dieting included dizziness 06.2%) fatigue (15.1%) indigestion/constipation (11.1%) physical weakness 00.5%), loss of concentration (7.8%), dry skin (7.4%) loss of motivation (6.7%). The above results showed that attitude toward dieting among adult women varied with age and in light of the well-being trend, organic foods and aerobic exercises scored the highest satisfaction degree through all age.