• Membrane Journal
• /
• v.25 no.4
• /
• pp.320-326
• /
• 2015

In this study, permeation experiments were carried out using the symmetric and asymmetric sinusoidal flux continuous operation (SFCO) modes for the submerged flat sheet membrane in the 0.5 wt% emulsion type cutting oil solution. The effective area and nominal pore size of the used microfiltration membrane were $0.02m^2$ and $0.15{\mu}m$, respectively. The emulsion cutting oil was rejected over 99% based on turbidity. Transmembrane pressure increased lower as the aeration rates increased. The symmetric SFCO mode was a little more effective than the symmetric SFCO mode in low permeate flux between 10 and $15L/m^2{\cdot}h$. However, the symmetric SFCO mode was shown very effectively in high permeate flux between 25 and $30L/m^2{\cdot}h$.

• 한국생물공학회:학술대회논문집
• /
• 2000.11a
• /
• pp.220-223
• /
• 2000

Sophorolipid, a glycolipid type biosurfactant produced from Candida Bombicola, inhibited the growth of bacteria and fungi. Between two types of sophorolipid, acid and lactone form, the latter had more strong antimicrobial activity. Culturing parameters including oil substrate, initial glucose concentration, aeration, culture mode, affected the ratio of two forms. The fatty acid moety varied depending on the oil having different fatty acid chains. Minimum inhibitory concentration of lactonic sophorolipid toward Propionibacterium acne was below 0.5ppm. This result indicated the potentials of sophorolipid as antimicrobial agent in various area including cosmetics.

• 한국생물공학회:학술대회논문집
• /
• 2000.11a
• /
• pp.356-359
• /
• 2000

A two-stage fed-batch fermentation was carried out to increase xylitol productivity by Candida tropicalis. The first stage for cell growth was performed in the pH-stat and continuous fed-batch modes. The higher cell growth and lower ethanol production obtained in the fed-batch mode where the growth medium was fed when pH of culture broth increased over 5.7. And also the effect of oxygen transfer on xylitol production was investigated by changing agitation speed under 0.5 vvm of aeration. The maximum xylitol productivity and yield were obtained at 500 rpm of agitation.

• Membrane Journal
• /
• v.28 no.1
• /
• pp.62-66
• /
• 2018

In this study the cleaning spherical beads with same density as water were fabricated. Bead moving velocity was measured with respect to the aeration rate and bead concentration in water reservoir. The permeation experiments for FR (filtration and relaxation) and SFCO (sinusoidal filtration continuous operation) modes were simultaneously carried out under the condition of 1 to 3% cleaning spherical bead concentration, 20 LMH and 500 mL/min aeration rate in the MLSS 8,000 mg/L activated sludge solution. The used membrane was the $90cm^2$ effective area and $0.4{\mu}m$ nominal pore size flat membrane. The TMP (transmembrane pressure) decreased as the bead concentration increased, and was shown most effective in FR mode with 2% bead concentration.

• KSBB Journal
• /
• v.14 no.4
• /
• pp.503-510
• /
• 1999

In order to analyze nutritional factors affecting in situ bioremediation of diesel degradation and cell viability were studied by varying nutritional conditions. In column experiments packed with diesel-contaminated soil, nitrogen was found to be the major limiting nutrient. When nitrogen was added to soil at four different levels of C : N (100 : 5, 100 : 10, 100 : 15, and 100 : 20 mg N/kg dry soil), the greatest simulation of microbial activity occurred at the lowest, rather than the highest nitrogen addition. However, no significant effects was observed when phosphorus and air were added. No matter how the incubation mode varied, less than 50% of the diesel was remained after 7 days of treatment, presumably because the residual hydrocarbons were adsorbed on soil particles, adsorption

• Korean Chemical Engineering Research
• /
• v.56 no.1
• /
• pp.73-78
• /
• 2018

The main objective of this study was to evaluate the effects of acetate on the cultivation of anabena under mixotrophic condition. Four different types of acetates were used for the anebena cultivation. Among them, ethyl acetate was found to be the most effective and the growth rates linearly increased as the amount of ethyl acetate increased. When 40 mM of ethyl acetate was used, the highest values of specific growth rate of $0.979day^{-1}$ and maximum biomass productivity of $0.293g\;L^{-1}\;d^{-1}$ were obtained. On the contrary, input of acetic acid and butyl acetate inhibited the growth of anabena. For aeration tests, 0.54 vvm was optimum for anabena cultivation. For a semi-continuous cultivation test, ethyl acetate was used after 0.54 vvm test was finished. Then, test continued under 0.54 vvm and 40 mM of ethyl acetate. Lower specific growth rate and maximum biomass productivity were obtained compared to those from batch cultivation tests. However, the greatest maximum concentration of 5.91 g/L was obtained during the semi-continuous cultivation test.

• 한국생물공학회:학술대회논문집
• /
• 2001.11a
• /
• pp.390-393
• /
• 2001

The optimal temperature, pH and aeration rate for spore production by Bacillus polyfermenticus SCD in 500 ml shake flask and 5-1 jar fermenter were found to be $32^{\circ}C$, 7.0 and 1.0 vvm. respectively. When batch culture processes was performed under optimized culture conditions. viable cells were $3.3{\times}10^{10}$ CFU/ml and spore cells were $3.3{\times}10^{10}$ CFU/ml. Fed-batch culture processes were also examined with regard to higer maximum viable cell and spore production. The highe viable cells and spores were obtained in 5-1 jar fermenter at 72 h cultivation time by strategy in an intermediate feeding mode with 60% glucose solution 150 ml and 5% soybean flour solution 150 ml fed to the fermenter twice, and the productivity of spore cells was significantly increased. Finally. volumetric productivity of spore cells on fed-batch culture indicated $9.9{\times}10^8$ CFU/ml/h, which was approximately 2 times higher than batch culture. Thus, fed-batch culture show a promise as an industrial production method.

• Journal of Microbiology and Biotechnology
• /
• v.16 no.11
• /
• pp.1690-1698
• /
• 2006

In order to investigate the effect of dissolved oxygen (DO) level on AVM $B_{1a}$ production by a high yielding mutant of Streptomyces avermitilis, five sets of bioreactor cultures were performed under variously controlled DO levels. Using an online computer control system, the agitation speed and aeration rate were automatically controlled in an adaptive manner, responding timely to the oxygen requirement of the producer microorganism. In the two cultures of DO limitation, the onset of AVM $B_{1a}$ biosynthesis was observed to casually coincide with the fermentation time when oxygen-limited conditions were overcome by the producing microorganism. In contrast, this phenomenon did not occur in the parallel fermentations with DO levels controlled at around 30% and 40% throughout the entire fermentation period, showing an almost growth-associated mode of AVM $B_{1a}$ production: AVM $B_{1a}$ biosynthesis under the environments of high DO levels started much earlier than the corresponding oxygen-limited cultures, leading to a significant enhancement of AVM $B_{1a}$ production during the exponential stage. Consequently, approximately 6-fold and 9-fold increases in the final AVM $B_{1a}$ production were obtained in 30% and 40% DO-controlled fermentations, respectively, especially when compared with the culture of severe DO limitation (the culture with 0% DO level during the exponential phase). The production yield ($Y_{p/x}$), volumetric production rate (Qp), and specific production rate (${\bar{q}}_p$) of the 40% DO-controlled culture were observed to be 14%, 15%, and 15% higher, respectively, than those of the parallel cultures that were performed under an excessive agitation speed (350 rpm) and aeration rate (1 vvm) to maintain sufficiently high DO levels throughout the entire fermentation period. These results suggest that high shear damage of the high-yielding strain due to an excessive agitation speed is the primary reason for the reduction of the AVM $B_{1a}$ biosynthetic capability of the producer. As for the cell growth, exponential growth patterns during the initial 3 days were observed in the fermentations of sufficient DO levels, whereas almost linear patterns of cell growth were observed in the other two cultures of DO limitation during the identical period, resulting in apparently lower amounts of DCW. These results led us to conclude that maintenance of optimum DO levels, but not too high to cause potential shear damage on the producer, was crucial not only for the cell growth, but also for the enhanced production of AVM $B_{1a}$ by the filamentous mycelial cells of Streptomyces avermitilis.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.3
• /
• pp.35-43
• /
• 2008

This study was carried out to estimate the performance of modified sequencing batch reactor (SBR) process by the application of SBR process for small advanced wastewater treatment plant. Organic, nitrogen and phosphorus were able to remove in the unit reactor by SBR process and it would be able to select the suitable operation method. The plant was operated to achieve high performance with influent control, optimum anoxic/oxic condition using intermediate aeration method, and solid (sludge) /liquid (effluent) separation by modified decanter. The optimum operating mode was 3Cycles a day and intermediate input and aeration. Under these conditions, the treatment efficiencies were good with 60% of designed flow rate and low influent quality. When the influent concentrations of BOD and CODMn were 120.4 mg/L and 95.7 mg/L, respectively. The effluent concentrations of BOD and CODMn were 6.8 mg/L and 11.0 mg/L, respectively. The average removal efficiencies of BOD and CODMn were 94.4% and 88.5%, respectively. The removal efficiencies of T-N and T-P were 69.6% and 73.6%, respectively when the average T-N and T-P concentrations were 32.2mg/L and 4.65mg/L, respectively. The T-N and T-P removal efficiencies were slightly decreased to 58.8% and 68.5%, respectively in the winter season but its were also stable efficiencies. BOD, T-N and T-P were removed by 90%. 67% and 46% respectively in the first anoxic/oxic condition, in addition to T-P was removed by 70% in the second anoxic/oxic condition. From the results, modified sequencing batch reactor (SBR) process is suitable for small advanced wastewater treatment.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.13 no.4
• /
• pp.136-147
• /
• 2005

Leachate from landfill sites contains high organics, chloride and ammonium nitrogen in concentration which might be potentially major pollutants to surface and groundwater environment. Most of landfill leachate treatment plants in Korea consist of biological processes to remove BOD and nitrogen. However, the efficiencies of refractory organics removal, nitrification and denitrification have not met frequently the national effluent regulation of wastewater treatment facility, especially in winter season. Simultaneous removal of organics and nitrogen from leachate is strongly necessitated to meet the national regulation on effluents from leachate treatment facilities. The intermittently aerated biological activated carbon fluidized bed(IABACFB) process was applied to treat real landfill leachates containing refractory organics and high concentration of ammonium nitrogen. The IABACFB reactor consisted of a single bed in which BAC fluidizing and an aerating column. The fluidized bed is intermittently aerated through the blower located at the aerating column. Experiments were performed to evaluate the applicability of Intermittently Aerated BACFB for simultaneous removal of refractory organic carbon and ammonium nitrogen of leachate. Organics and ammonia nitrogen($NH{_4}{^+}-N$)are oxidized during the aerobic stage, and nitrite-nitrate nitrogen($NO{_x}{^-}-N$) are removed to nitrogen gas through denitrification reaction during anoxic state. The IABACFB reactor condition reached a steady state within 40 days since the reactors had been operated. The blowing mode of 60 min.-On/60 min.-OFF is more compatible to remove TOC and ($NH{_4}{^+}-N$) operated. The blowing mode of 60 min.-On/60 min.-OFF is more compatible to remove TOC and ($NH{_4}{^+}-N$) simultaneously than the mode of 30 min.-On/90 min.-OFF. The average removal efficiencies of TOC, the refractory organic carbon, and the average efficiencies of nitrification and denitrification were 90%, 75%, 80%, 95%, respectively.