• Carbon letters
• /
• 제10권3호
• /
• pp.181-189
• /
• 2009

Activated carbon spheres (ACS) were prepared at different heating rates by carbonization of the resole-type phenolic beads (PB) at $950^{\circ}C$ in $N_2$ atmosphere followed by activation of the resultant char at different temperatures for 5 h in $CO_2$ atmosphere. Influence of heating rate on porosity and temperature on carbon structure and porosity of ACS were investigated. Effect of heating rate and temperature on porosity of ACS was also studied from adsorption isotherms of nitrogen at 77 K using BET method. The results revealed that ACS have exhibited a BET surface area and pore volume greater than $2260\;m^2/g$ and $1.63\;cm^3/g$ respectively. The structural characteristics variation of ACS with different temperature was studied using Raman spectroscopy. The results exhibited that amount of disorganized carbon affects both the pore structure and adsorption properties of ACS. ACS were also evaluated for structural information using Fourier Transform Infrared (FTIR) Spectroscopy. ACS were evaluated for chemical composition using CHNS analysis. The ACS prepared different temperatures became more carbonaceous material compared to carbonized material. ACS have possessed well-developed pores structure which were verified by Scanning Electron Microscopy (SEM). SEM micrographs also exhibited that ACS have possessed well-developed micro- and meso-pores structure and the pore size of ACS increased with increasing activation temperature.

• 한국세라믹학회지
• /
• 제45권11호
• /
• pp.651-657
• /
• 2008

In this study, CNT/$TiO_2$ composites were prepared using surface modified Multiwall carbon nanotube (MWCNT) and titanium n-butoxide (TNB) with benzene. The composites were characterized by nitrogen adsorption isotherms, scanning electron microscopy (SEM), X-ray diffraction (XRD), energy dispersive X-ray analysis (EDX), FT-IR spectra, and UV-vis absorption spectroscopy. The UV radiation induced photoactivity of the CNT/$TiO_2$ composites was tested using a fixed concentration of methylene blue (MB, $C_{16}H_{18}N_3S{\cdot}Cl{\cdot}3H_2O$) in an aqueous solution. Finally, it can be considered that the MB removal effect of the CNT/$TiO_2$ composites is not only due to the adsorption effect of MWCNT and photocatalytic degradation of $TiO_2$, but also to electron transfer between MWCNT and $TiO_2$.

• Carbon letters
• /
• 제1권1호
• /
• pp.6-11
• /
• 2000

Coal tar pitch was chemically modified with 10 wt% benzoquinone (BQ) to raise the softening point of isotropic pitch precursor and the precursor was melt-spun into pitch fibers, stabilized, carbonized and activated with steam at $900^{\circ}C$. The weight loss of carbon fiber-benzoquinone (CF-BQ) increased with the increase of activation time like other fibers, but was lower than those of Kureha fiber at the same activation time in spite of larger geometric surface area. Those adsorption isotherms fitted into 'Type I' according to Brunauer, Deming, Deming and Teller classification. However, there was very thin low-pressure hysteresis that lower closure points of the hysteresis are about 0.42-0.45. From the pore size distribution curves, there might be some micropores having narrow-necked bottle; a series of interconnected pore is more likely than discrete bottles. FT-IR studies showed that the functional groups such as carboxyl, quinone, and phenol were introduced to ACFs-BQ surface after steam activation. Methylene blue decolorization and iodine adsorption capacity of ACF-BQ increased linearly with the increase of specific surface area and was larger than that of ACF-Kureha at the same specific surface area.

• Bulletin of the Korean Chemical Society
• /
• 제25권8호
• /
• pp.1189-1194
• /
• 2004

The adsorption isotherms of N2 onto the metallic silver treated activated carbon fiber samples after acid treatment are Type I with a small amount of capillary condensation hysteresis. Increasing amount of acid treatment leads to a decrease in SBETs and external surface area. But, micropore volume and average pore diameter are presented in constant regular values with increasing amount of sulfuric acid treatment. SEM observes the surface morphology and crystal grown state of metal on the fiber surface. The results of EDX of Ag-activated carbon fiber pre-treated with acid show the spectra corresponding to almost all samples rich in silver with increasing the amount of acid treated. The FT-IR spectra of Ag-activated carbon fiber show that the acid pre-treatment is consequently associated with the homogeneous dispersion of metal with the increased surface acidity of the activated carbon fiber. The type and quality of oxygen groups are determined with Boehm titration method. From the those results, a positive influence of the acidic groups on the carbon fiber surface by acid treatment is also demonstrated by an increase in the contents of metallic silver with increasing of acidic groups.

• Journal of Electrochemical Science and Technology
• /
• 제8권1호
• /
• pp.77-86
• /
• 2017

The valorization of domestic wastes becomes a very important research axis that can reduce the energy consumption and protect our environment. The objective of this study is to remove zinc ions from wastewater by using banana peels after their activation as sensor in the working electrode for an environmental application. Banana peels were dried, crushed and treated with sulfuric acid then mixed with polyaniline to improve their electrical conductivity. Cyclic voltammetry and chronoamperometry were used for electrochemistry tests. The obtained voltammogramms at well optimized conditions of applied potential of -1.3 V/SCE and initial zinc concentration of 0.2M during 2 hours of electrolysis, showed the reduction peak of the zinc at a potential of -1.14 V/SCE, which confirmed the activity of this electrode. The modeling of experimental data revealed that the adsorption was fitted by the Langmuir isotherm with a maximal adsorption capacity of 3.4188 mg/g. Changes in the structure of the powder after the electrosorption was noticed by SEM and EDX. Finally, the dosage of the electrolytic solution showed a diminution of the zinc concentration with yield of 99.99%.

• Food Science and Biotechnology
• /
• 제16권1호
• /
• pp.154-158
• /
• 2007

Adsorption isotherms for chaga mushroom powder as influenced by particle size were investigated using a gravimetric technique. Samples were equilibrated in desiccators containing sulfuric acid solutions of known water activity (0.11-0.93), then placed in temperature-controlled chambers for approximately ten days. Equilibrium moisture content (EMC) of chaga mushroom powder increased with water activity in all samples. EMC was slightly greater in the samples comprised of smaller particle size, however there was no marked difference in appearance between the three samples. The chaga mushroom powder exhibited Type II behavior. When the BET model was used to determine mean monolayer values, 0.077, 0.077, and 0.070 $H_2O/dry$ solid was observed for <250, 250-425, and $425-850\;{\mu}m$ sized samples, respectively, however mean monolayer values were 0.121, 0.111, and 0.101 $H_2O/dry$ solid, respectively, when the GAB model was used. The experimental EMC values were related to the computed values from Henderson's model. The coefficient of determination and standard error for the linear regression were 0.997 and 0.003, respectively.

• 공업화학
• /
• 제9권5호
• /
• pp.729-733
• /
• 1998

은 침착된 활성탄의 표면 구조와 세공의 크기 분포등에 대하여 연구하였다. 침착물은 내부 표면에는 영향을 주지 않고 외부 표면에만 영향을 주는 것으로 나타났다. 또한 흡착 등온선은 침착되지 않은 활성탄이나 침착된 활성탄 모두 전형적인 BET 분류 type-I 임을 확인하였으며, 침착물 양이 증가할수록 흡착량이 감소하며 window blocking 현상이 나타남을 확인하였다. 침착물 양이 증가할수록 비 표면적 값은 감소하였으며, 미세세공 부피도 감소하였다. 은 침착된 활성탄의 평균 미세세공 반경은 침착물 양과는 무관하게 일정하였다.

• 환경생물
• /
• 제39권3호
• /
• pp.298-310
• /
• 2021

Prediction of the behavior of heavy metals over time is important to evaluate the heavy metal toxicity in algae species. Various modeling studies have been well established, but there is a need for an improved model for predicting the chronic effects of metals on algae species to combine the metal kinetics and biological response of algal cells. In this study, a kinetic dynamics model was developed to predict the copper behavior(5 ㎍ L^-1, 10 ㎍ L^-1, and 15 ㎍ L^-1) for two freshwater algae (Pseudokirchneriella subcapitata and Chlorella vulgaris) in the chronic exposure experiments (8 d and 21 d). In the experimental observations, the rapid change in copper mass between the solutions, extracellular and intracellular sites occurred within initial exposure periods, and then it was slower although the algal density changed with time. Our model showed a good agreement with the measured copper mass in each part for all tested conditions with an elapsed time (R² for P. subcapitata: 0.928, R² for C. vulgaris: 0.943). This study provides a novel kinetic dynamics model that is compromised between practical simplicity and realistic complexity, and it can be used to investigate the chronic effects of heavy metals on the algal population.

• Membrane and Water Treatment
• /
• 제13권6호
• /
• pp.321-335
• /
• 2022

Copper-based Metal-organic framework (MOF) namely ([Cu (INA)₂]-MOF) is synthesized by ball milling and characterized using scanning electron microscopy (SEM) for the topography, microstructure, and elemental evidence determination, powdered X-ray diffraction (XRD) for the crystallinity measurement, thermogravimetric (TG) analysis was performed to determine the thermal stability of the material, and Fourier transformed infrared (FTIR) spectroscopy for functional groups identification. The use of [Cu (INA)₂]-MOF as hazardous removal material of β-agonists as persistent hazardous micro-pollutants in our environmental water is first reported in this study. The removal efficiency of the Cu-MOF is successfully determined to be 97.7% within 40 minutes, and the MOF has established an exceptional removal capacity of 835 mg L^-1 with 95 % percent removal on Clenbuterol (CLB) even after the 5th consecutive cycle. The Langmuir model of the adsorption isotherms was shown to be more favourable, while the pseudo-second-order model was found to be favoured in the kinetics. The reaction was exothermic and spontaneous from a thermodynamic standpoint, and the higher temperatures were unfavourable for the adsorption study of the CLB. As a result, the studied MOF have shown promising properties as possible adsorbents for the removal of CLB in wastewater.

• Journal of Radiation Protection and Research
• /
• 제27권1호
• /
• pp.27-35
• /
• 2002

가압경수로 일차냉각수내 탈염공정의 효과적 운용을 위하여 Amberlite IRN-77 양이온 교환수지의 특성 및 Co(II), Ni(II), Cr(III), Fe(III) 이온의 흡착거동을 연구하였다. 용존 금속이온 농도가 약 $200\;mgL^{-1}$인 용액 100 mL에 대하여 이온교환수지 투입량은 약 0.6 g이 가장 적절하였으며, 이온교환 반응 속도 측정 결과 대부분의 흡착은 반응 1 시간 이내에 신속히 발생하였다. 수지에서의 양이온 교환은 Langmuir 흡착등온선을 잘 따르는 것으로 나타났으나, Fe(III)의 경우, 다른 금속과는 달리 쉽게 평형에 이르지 못하였으며 이는 공기와 오래 접촉한 결과 철산화물 또는 수산화물을 형성하며 용액 중으로부터 침전되기 때문인 것으로 관찰되었다. 전자가가 동일한 Co(II)와 Ni(II)가 동시에 포함된 모의 조제용액에 대하여 흡착실험을 한 결과, 각 이온은 거의 동일한 흡착거동을 보였다. 그러나 전자가가 큰 Cr(III)이 첨가된 경우, 이들은 기존에 수지에 흡착되어 있던 전자가가 낮은 금속들을 탈착시키고 대신 흡착하는 경향을 보였다. 따라서 이온교환수지를 이용한 효과적인 탈염 공정을 위해서는 용존 금속 상호간의 경쟁적 흡착관계의 규명이 필요한 것으로 여겨진다.