• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.8
• /
• pp.740-747
• /
• 2015

Recently, mobile communication systems using the millimeter-wave frequency band have been proposed, and the importance of efficient compensation of the nonlinearity caused by 60 GHz high-power amplifiers(HPAs) is increasing. In this paper, we propose a predistorter structure based on multiple coefficient sets which are separately used to different ranges of input power values. These ranges correspond to varying levels of nonlinearity characteristics. The structure is applied to the 60 GHz HPA FMM5715X and the performance of correcting the nonlinearity of LTE signals is evaluated. Evaluation results using a hardware testbed demonstrate that the proposed predistorter structure achieves the maximum of 6 dB gain over the conventional method in terms of the adjacent channel leakage ratio(ACLR).

• Journal of electromagnetic engineering and science
• /
• v.7 no.4
• /
• pp.147-153
• /
• 2007

This paper represents an analog predistortion linearizer for the high power amplifier with low memory effect. The high power amplifier is implemented using a 90-W peak envelope power(PEP) LDMOSFET at 2.14-GHz and an envelope short matching topology is applied at the active ports to minimize the memory effect. The analog predistortion circuit comprises the fundamental path and the cuber and quintic generating circuits, whose amplitudes and phases can be controlled independently. The predistortion circuit is tested for two-tone and wide-band code division multiple access(WCDMA) 4FA signals. For the WCDMA signal, the adjacent channel leakage ratios(ACLRs) at 5 MHz offset are improved by 12.4 dB at average output powers of 36 dBm and 42 dBm.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.1
• /
• pp.24-36
• /
• 2003

The digital mobile communication will be developed till getting multimedia service in anyone, any where, any time. Theses requiring items are going to be come true via IMT-2000 system. Transmitting signal bandwidth of IMT-2000 system is 3 times as large as IS-95 system. That is mean peak to average of signal is higher than IS-95A system. So we have to design it carefully not to effect in adjacent channel. HPA(High Power Amplifier) located in the end point of system is operated in 1-㏈ compression point(Pl㏈), then it generates 3rd and 5th inter modulation signals. Theses signals affect at adjacent channel and RF signal is distorted by compressed signal which is operated near by Pl㏈ point. Then the most important design factor is how we make HPA having high linearity. Feedback, Pre-distorter and Feed-forward methods are presented to solve theses problems. Feed-forward of these methods is having excellent improving capacity, but composed with complex structure. Generally, Linearity and Efficiency in power amplifier operate in the contrary, then it is difficult for us to find optimal operating point. In this paper we applied algorithm which searches optimal point of linear characteristics, which is key in Power Amplifier, using minimum current point of error amplifier in 1st loop. And we made 2nd loop compose with new structure. We confirmed fabricated LPA is operated by having high linearity and minimum current condition with ACPR of -26 ㏈m max. @ 30㎑ BW in 3.515㎒ and ACLR of 48 ㏈c max@${\pm}$㎒ from 1W to 40W.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.11
• /
• pp.17-23
• /
• 2004

The implementation and design of the wideband IFIU using aperture open loop resonator and reversed phase technique to reduce the local oscillator leakage signal was represented in this paper. The local oscillator leakage signal is generated in stage of frequency conversion, especially in frequency conversion of fully digital modulation signal close to DC signal. The leakage signal and spurious signals, which have effects on adjacent channel or in-band channel as interference signals, were reduced below -60 dBc for 45 Mbps and 155 Mbps IF interface units. The group delay for both IFIUs shows low ripple characteristics of 15 ns and 8 ns, respectively. Also, the amplitude ripple characteristic in 150 MHz bandwidth with L-band center frequency satisfies the required specification of 2 dB. The implemented IFIU provides the required specifications for wideband satellite communication system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.6 no.5
• /
• pp.724-730
• /
• 2002

Digital communication systems are required to cause the minimum interference to adjacent channels, they must therefore employ the linear power amplifiers. In respect to linear power amplifiers, there are many linearization techniques. Feedforward power amplifier represent very wide bandwidth and high linearization capability. In the feedforward systems, overall efficiency is reduced due to the loss of delay line. In this paper, delay filter instead of transmission delay line adapted to get more high efficiency. Experimental results showed that ACLR (Adjacent Channel Leakage Ratio) has improved 17.43(dB), which is added 3.44(dB) by using the delay filter.

• ETRI Journal
• /
• v.19 no.2
• /
• pp.35-47
• /
• 1997

A power amplifier operating at 3.3 V has been developed for CDMA/AMPS dual-mode cellular phones. It consists of linear GaAs power MESFET's, a new gate bias control circuit, and an output matching circuit which prevents the drain terminal of the second MESF from generating the harmonics. The relationship between the intermodulation distortion and the spectral regrowth of the power amplifier has been investigated with gate bias by using the two-tone test method and the adjacent channel leakage power ratio (ACPR) method of CDMA signals. The dissipation power of the power amplifier with a gate bias control circuit is minimized to below 1000 mW in the range of the low power levels while satisfying the ACPR of less than -26 dBc for CDMA mode. The ACPR of the power amplifier is measured to be -33 dBc at a high output power of 26 dBm.

• ETRI Journal
• /
• v.30 no.1
• /
• pp.158-160
• /
• 2008

A highly linear and efficient GaN HEMT Doherty amplifier for wideband code division multiple access (WCDMA) repeaters is presented. For better performance, the adaptive gate bias control of the peaking amplifier using the power tracking circuit and the shunt capacitors is employed. The measured one-carrier WCDMA results show an adjacent channel leakage ratio of -43.2 dBc at ${\pm}2.5$-MHz offset with a power added efficiency of 40.1% at an average output power of 37 dBm, which is a 7.5 dB back-off power from the saturated output power.

• Proceedings of the KIEE Conference
• /
• 2003.07e
• /
• pp.31-33
• /
• 2003

Power amplifier linearity plays a major role in the design of RF communication systems. In this paper, predistortion type linearizer was designed an independently controllable AM/AM and AM/PM predistortion linearizers. This linearizer allows independent adjustment of the AM/AM and AM/PM curves by using two adjustable voltages to compensate the power amplifier non-linearities. The predistortion linearizer was improved the ACPR by 6dB with cdma2000 multi carrier signals. Applying this linearizer to two-tone 880MHz power amplifier, an improvement of adjacent channel leakage power up to 5dBm has been achieved.

• ETRI Journal
• /
• v.32 no.1
• /
• pp.151-153
• /
• 2010

A highly efficient linear and compactly integrated series-type Doherty power amplifier (PA) has been developed for wideband code-division multiple access handset applications. To overcome the size limit of a typical Doherty amplifier, all circuit elements, such as matching circuits and impedance transformers, are fully integrated into a single monolithic microwave integrated circuit (MMIC). The implemented PA shows a very low idle current of 25 mA and an excellent power-added efficiency of 25.1% at an output power of 19 dBm by using an extended Doherty concept. Accordingly, its average current consumption was reduced by 51% and 41% in urban and suburban environments, respectively, when compared with a class-AB PA. By adding a simple predistorter to the PA, the PA showed an adjacent channel leakage ratio better than -42 dBc over the whole output power range.

• Proceedings of the KIEE Conference
• /
• 2003.07d
• /
• pp.2690-2692
• /
• 2003

Amplifier linearity plays a major role in the design of mordern communication systems. An independently controllable AM/AM and AM/PM predistortion linearizers that consists of two bias feed resistance linearizers is proposed. This linearizer allows independent adjustment of the AM/AM and AM/PM curves by using two adjustable voltages to compensate the power amplifier non-linearities. The predistortion linearizer can improve the ACPR by SdB with cdma2000 multi carrier signals. By applying this linearizer to two-tone 880MHz power amplifier, an improvement of adjacent channel leakage power up to 5dBm has been achieved.