• 한국식품영양학회지
• /
• 제7권1호
• /
• pp.1-7
• /
• 1994

To investigate the characteristics of active sites of the D-xylanase and $\beta$-xylosidase purified from Penicillium verruculosum, effects of various chemicals on the enzyme activity were analyzed. The D-xylanase was activated by Cua), however it was inhibited by metal ions, Hg2+ and Mna+, by chemicals, N-bromosuccinimide, iodine, diethylpyrocarbonate, and 2,3-butanedione. These results suggested that the D-xylanase from Penicillium verruculosum contained tyrosine, histidine, arginine and tryptophan at the active center. The $\beta$-xylosidase was inhibited by Hg2+, N-bromosuccinimide and sodium dodecyl sulfate, however it was not effected by Mn2+ and Cu2). It was suggested that the enzyme contained tryptophan at the active center.

• Transactions on Electrical and Electronic Materials
• /
• 제18권2호
• /
• pp.70-73
• /
• 2017

We investigated n-i-p type single junction hydrogenated amorphous silicon oxide solar cells. These cells were without front surface texture or back reflector. Maximum power point efficiency of these cells showed that an optimized device structure is needed to get the best device output. This depends on the thickness and defect density ($N_d$) of the active layer. A typical 10% photovoltaic device conversion efficiency was obtained with a $N_d=8.86{\times}10^{15}cm^{-3}$ defect density and 630 nm active layer thickness. Our investigation suggests a correlation between defect density and active layer thickness to device efficiency. We found that amorphous silicon solar cell efficiency can be improved to well above 10%.

• Journal of Electrical Engineering and Technology
• /
• 제11권4호
• /
• pp.939-942
• /
• 2016

One of the most important characteristic curves of a solar cell is its current density-voltage (J-V) curve under AM1.5G insolation. Solar cell can be considered as a semiconductor diode, so a diode equivalent model was used to estimate its parameters from the J-V curve by numerical simulation. Active layer plays an important role in operation of a solar cell. We investigated the effect thicknesses and defect densities (N_d) of the active layer on the J-V curve. When the active layer thickness was varied (for N_d = 8×10¹⁷ cm^-3) from 800 nm to 100 nm, the reverse saturation current density (J_o) changed from 3.56×10^-5 A/cm² to 9.62×10^-11 A/cm² and its ideality factor (n) changed from 5.28 to 2.02. For a reduced defect density (N_d = 4×10¹⁵ cm^-3), the n remained within 1.45≤n≤1.92 for the same thickness range. A small increase in shunt resistance and almost no change in series resistance were observed in these cells. The low reverse saturation current density (J_o = 9.62×10^-11 A/cm²) and diode ideality factor (n = 2.02 or 1.45) were observed for amorphous silicon based solar cell with 100 nm thick active layer.

• 전자공학회논문지D
• /
• 제35D권6호
• /
• pp.46-53
• /
• 1998

저온 공정으로 제작되는 다결정 실리콘 박막 트랜지스터의 활성층을 이중 활성층(a-Si/a-SiN/sub x/)으로 제작하는 공정을 제안하고 다결정 실리콘 박막 트랜지스터를 제작하였다. 본 논문에서는 활성층의 아래쪽 실리콘 박막에 약간의 질소기를 첨가한 후 그 위에 순수한 비정질 실리콘 박막을 증착하여 엑시머 레이저의 에너지로 비정질 실리콘 박막을 결정화하여 사용하였다. 이중 활성층 (a-Si/a-SiN/sub x/)의 경우, 하부층의 NH₃/SiH₄ 유속비가 증가함에 따라, 상부 a-Si 층의 결정 성장이 촉진됨을 알 수 있었으나, n/sup +/ poly-SiN/sub x/ 층의 전도도 특성을 고려해 볼 때, NH₃/SiH₄ 유속비는 0.11의 상한치를 가짐을 알 수 있었다. 전계 방출 전류에 영향을 미치는 광학적 밴드갭의 경우, poly-Si 박막에 비해 증가하였으며, NH₃/SiH₄ 유속비가 0.11 이하에서도 0.1eV 정도의 증가를 보여, 이로 인하여 소자 제작시 전계 방출 전류가 억제될 것을 예상할 수 있다.

• 국제학술발표논문집
• /
• The 6th International Conference on Construction Engineering and Project Management
• /
• pp.344-348
• /
• 2015

The image data of the web camera is used to identify the construction status of the site in a remote office and it can be used for safety management. This study develops a construction schedule simulation system based on the active nD object linked with real image data of web camera from the construction site. The progress control method by 4D object uses a method that the progress of each activity is represented with different colors by progress status. Since this method is still based on a virtual reality object, it is less realistic description for practical engineers. Therefore, in order to take advantage of BIM more realistic, the real image of actual construction status and 4D object of planned schedule in a data date should be compared in a screen simultaneously. Those methodologies and developed system are verified in a case project where a web camera is installed for the verification of the system.

• Bulletin of the Korean Chemical Society
• /
• 제10권2호
• /
• pp.172-177
• /
• 1989

Stereoselective solvolyses of optically active activated esters in the aggregate system of optically active polymeric surfactants containing imidazole and benzene moieties were performed. The catalyst polymers employed were copolymers of N-methacryloyl-L-histidine methyl ester (MHis) with N,N-dimethyl-N-hexadecyl-N-[10-(p-methacryloylo xyphenoxycarbonyl)-decyl]ammonium bromide(DEMAB). In the solvolyses of N-carbobenzoxy-D- and L-phenylalanine p-nitrophenyl esters (D-NBP and L-NBP) by polymeric catalysts, copoly(MHis-DEMAB) exhibited not only increased catalytic activity but also enhanced enantioselectivity as the mole ${\%}$ of surfactant monomers in the copolymers increased. The polymeric catalysts showed noticeable enantioselective solvolyses toward D- and L-NBP of the substrates employed. As the reaction temperature was lowered for the solvolyses of D- and L-NBP with the catalyst polymer containing 3.5 mole ${\%}$ of MHis, the increased reaction rate and enhanced enantioselectivity were observed. The coaggregative systems of the polymer and monomeric surfactants were also investigated. In the case of coaggregate system consisted of 70 mole ${\%}$ of cetyldimethylethylammonium bromide with polymeric catalyst showed maximum enantioselective catalysis, viz., $k_{cat}(L)/k_{cat}(D)$ = 2.85. The catalyst polymers in the sonicated solvolytic solutions were confirmed to form large aggregate structure by electron microscopic observation.

• Macromolecular Research
• /
• 제12권3호
• /
• pp.258-262
• /
• 2004

We have developed facile and rapid polycondensation reactions of N-trimellitylimido-L-leucine diacid chloride 1 with eight different derivatives of hydantoin compounds 2a-h, in the presence of a small amount of a polar organic medium, such as Ο-cresol, by using a domestic microwave oven. The polycondensation reactions proceeded rapidly-they were complete within 7-9 min-to produce a series of novel optically active poly(amide-imide)s (3a-h) in high yield with inherent viscosities of 0.33-0.51 dL/g. We characterized the resulting poly(amide-imide)s by elemental analysis, thermal gravimetric analysis (DSC, TGA, and DTG), and FTIR spectroscopy, and by measuring their viscosities, specific rotations, and solubilities. All of the polymers were soluble at room temperature in polar solvents such as N ,N-dimethylacetamide, N,N-dimethylformamide, dimethylsulfoxide, tetrahydrofuran, and N-methyl-2-pyrrolidone.

• 한국전자파학회논문지
• /
• 제29권11호
• /
• pp.857-867
• /
• 2018

현재 레이다의 발전 형태는 기존의 능동위상배열에서 디지털형 위상배열로 진화하고 있다. 디지털형 위상배열은 수신빔을 자유롭게 구성할 수 있는 장점이 있다. 이를 가능하게 하려면 각각의 복사소자별 수신신호가 디지털화되어야 한다. 본 논문에서는 이를 위한 디지털 송수신모듈을 설계 및 제작하고 시험결과를 제시하여 가능성을 확인하고자 한다. 디지털 송수신모듈은 4개의 송수신 채널을 포함한 쿼드팩 형태로 구성하였다. 고출력 송신을 위해 각 채널별로 GaN 소재의 고출력증폭소자(HPA)를 사용하였으며, 송신파형 발생과 수신신호 디지털변환을 위해 송수신 집적소자를 적용한 디지털 회로를 적용하였다. 제작한 결과, 각 채널별로 송신출력은 350 W 이상, 수신이득은 47 dB, 수신잡음지수 2 dB 이하를 만족하였다. 또한 모듈 내에서 최종 광신호로 변환된 수신출력을 저장하고, 분석하여 수신 특성을 확인하였다.

• 약학회지
• /
• 제29권6호
• /
• pp.375-379
• /
• 1985

The gas chromatographic behavior of optically active N-(N-benzoyl-L-valyl)-anilide used as stationary phase is described. N-(N-benzoyl-L-valyl)-anilide has been synthesized with good yield under mild condition via Schotten-Bauman process and coated on the Chromosorb W AW (80-100mesh) for the purpose of enantiomer separation. The behavior of this compound as optically active stationary phase for the separation of the enantiomers of N-TFA-D, L-amino acid isopropyl esters has been examined with respect to the correlation between the separation factors and column temperatures. All amino acid enantiomers examined were eluted within one hour and the elution pattern showed retention times increasing in the order of alanine, valine, leucine, threonine, proline and methionine.

• 한국전자파학회논문지
• /
• 제11권3호
• /
• pp.445-453
• /
• 2000

본 논문에서는 MMlC 설계에서 필요한 능동 인덕터의 설계 방법을 제시하였다. 제안된 가변 능동 인덕터는 궤환 커패시터와 궤환 저항을 가진 종속접속된 2개의 FET로 구성을 하였다. 제안된 가변 능동 인덕터는 낮은 직렬 저항을 가져서 상대적으로 높은 Q 값을 얻을 수 있고 높은 주파수대에서 사용이 가능한 우수한 동작 특성 을 가진다. 인덕턴스 값은 궤환 커패시터와 궤환 저항 및 바이어스 전압에 의하여 변화되어지며 궤환 저항과 회 로내 병렬 저항을 가변하였을 때 1 GHz에서 15 GHz까지 범위에서 인덕턴스 값이 0.2nH에서 L7nH까지 변화하 였다. 또한 제안된 능동 인덕터를 사용하여 대역통과 필터를 설계하였을 때 삽입손실은 약 0.4 dB이고 반사 손실은 20dB 이상의 우수한 결과를 얻을 수 있었다