• The Bulletin of The Korean Astronomical Society
• /
• v.38 no.1
• /
• pp.44.2-44.2
• /
• 2013

We probe the feasibility of high-frequency radio observations of very rapid flux variations in compact active galactic nuclei (AGN). Our study assumes observations at 230 GHz with a small 6-meter class observatory, using the SNU Radio Astronomical Observatory (SRAO) as example. We find that 33 radio-bright sources are observable with signal-to-noise ratios larger than ten. We derive statistical detection limits via exhaustive Monte Carlo simulations assuming (a) periodic, and (b) episodic flaring flux variations on time-scales as small as tens of minutes. We conclude that a wide range of flux variations is observable. This makes high-frequency radio observations - even with small observatories - a powerful probe of AGN intra-day variability; especially, those observations complement observations at lower radio frequencies with larger observatories like the Korean VLBI Network (KVN).

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.19 no.7
• /
• pp.667-672
• /
• 2009

This paper is concerned with the development of linear magnetic actuator for active vibration control. The newly developed linear magnetic actuator consists of permanent magnets and copper coils. On the contrary to the voice-coil type actuator, the linear magnetic actuator utilizes magnetic flux to generate the shaft movement. In this study, experiments on the prototype linear magnetic actuator were carried out to investigate its dynamic characteristics. Block and inertia forces generated by the actuator were measured. The experimental results show that the actuator can be used as both actuator and active tuned-mass damper. The linear magnetic actuator was attached to a cantilever as the active-tuned mass damper and active vibration control experiment was carried out. The experimental results show that the newly developed linear magnetic actuator can be effectively used for the active vibration control of structures.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.4 no.1
• /
• pp.26-34
• /
• 1999

According to increase of nonlinear power electronics equipment, active power filters have been researched and developed for many years to compensate harmonic disturbances and reactive power. However the commercial of active power filter is being proceeded slowly, because the cost of active power filter compared to the passive filter for harmonic and reactive power compensation is expensive. Especially, the use of DSP (Digital Signal Processing) chip, which is frequently used to control 3-phase active power filter, is a factor of increasing the cost of active power filters. On the other hand, the use of only analog controller makes the controller's circuits much more complicate and depreciates the flexibilities of controller. In this paper, a controller with low cost for 5[kVA] 3-phase active power filter system is designed. To reduce the expense of active filter system, the presented controller is composed of digital control part using Intel 80C196KC $\mu$P and analog control part using hysteresis controller for current control. Characteristic analysis of designed controller for active filter system is performed by computer simulation and compensating characteristics of the designed controller are verified by experiment.tegy can apply to the vector control, leading to better output torque capability in the ac motor drive system. This strategy is that in the overmodulation range, the d-axis output current is given a priority to regulate the flux well, instead the q-axis output curent is sacrificed. Therefore, the vector control even in the overmodulation PWM operation can be achieved well. For this purpose, the d-axis output voltage of a current controller to control the flux is conserved. the q-axis output voltage to control the torque is controlled to place the reference voltage vector on the hexagon boundary in case of the overmodulation. The validity of the proposed overall scheme is confirmed by simulation and experiments for a 22[kW] induction motor drive system.

• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.2
• /
• pp.84.1-84.1
• /
• 2011

In this study, we intend to inquire of how the temporal variation and spatial distribution of magnetic helicity injection in a CME-producing solar active region are related to the CME occurrence. We therefore investigate long-term (a few days) variation of magnetic helicity injection in the active region NOAA 9236 which produced multiple CME events. As a result, it is found that a noticeable increase in helicity of negative sign was first made for the first ~1.5 days and then 6 CMEs occurred while the relatively more injection of oppositely signed (positive) helicity was taking place for the next ~2 days. Afterwards, 2 CMEs in the region occurred while a more negative helicity is being injected again compared to a positive helicity. In addition, from helicity flux density maps, we found that the CMEs originated from this active region seem to be involved with the interaction of two magnetic field systems characterized by opposite signs of helicity.

• The Korean Journal of Ecology
• /
• v.23 no.1
• /
• pp.39-43
• /
• 2000

Carbon dioxide (CO₂) and ozone (O₃) fluxes were measured over Glycine max canopy using the bowen ratio energy balance method at Fuchu - 20 km west of Tokyo, in late July and late September 1996. The CO₂, and O₃, fluxes were influenced by variation in leaf area index (LAI) during the measuring period. When LAI was more than 3.0, the CO₂ flux was found to be positively correlated with photosynthetically active radiation (PAR). The O₃, flux was always positive with an average deposition velocity for this case of about 0.5 mol m/sup -2/s/sup -1/. A positive correlation existed between the deposition velocity of O₃ and CO₂ during the period of LAI＞2.0.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.9
• /
• pp.1467-1471
• /
• 2007

The green-emitting CeMgAl11O19:Tb (CMAT) phosphor has been prepared at 1200 °C by the simple solid-state reaction using AlF3 as a self-flux. This preparation temperature is much lower than those (1500-1700 °C) for conventional solid-state reaction and spray pyrolysis method. In particular, the complete process to produce high-quality phosphor particles was carried out through the single-step heat treatment of the mixture of corresponding oxide-type metal sources. An addition of AlF3 as a self-flux significantly decreased the crystallization temperature of CMAT with plate-like shape. The particle morphology could be controlled from plate-like to spherical by using H3BO3 as an additional flux. Thus, an optimal morphology and luminescence characteristics of CMAT were achieved when both AlF3 and H3BO3 fluxes were simultaneously used. Compared with conventional solid-state process, which is accompanied by the calcination step(s), and other alternative liquid solution techniques such as sol-gel method and spray pyrolysis, no use of active precursors and liquid media that are harmful to the environment is a distinctive advantage for the industrial purpose.

• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.241-241
• /
• 2012

MOGABA is a project monitoring of gamma-ray bright AGN(Active Galactic Nuclei). Since May 2011, we have observed total flux, degree of linear polarization, and polarization angle of about twenty AGN once a week at 22, 43 and 86GHz using KVN(Korean VLBI Network) 21m radio telescopes. We have observed variation of total flux of BLLAC and OJ287 from May 2011 to March 2012. We have observed flares of total flux at 22GHz for those sources from October 2011 to November 2011. In this paper we report the variation of total flux, degree of linear polarization and polarization angle at 22, 43, 86GHz for BLLAC and OJ287.

• Membrane and Water Treatment
• /
• v.2 no.4
• /
• pp.207-223
• /
• 2011

Supported Liquid Membranes (SLMs) have been widely studied as feasible alternative to traditional processes for separation and purification of various chemicals both from aqueous and organic matrices. This technique offers various advantages like active transport, possibility to use expensive extractants, high selectivity, low energy requirements and minimization of chemical additives. SLMs are not yet used at large scale in industrial applications, because of the low stability. In the present paper, after a brief overview of the state of the art of SLM technology the facilitated transport mechanisms of SLM based separation is described, also introducing the small and the big carrousel models, which are employed for transport modeling. The main operating parameters (selectivity, flux and permeability) are introduced. The problems related to system stabilization are also discussed, giving particular attention to the influence of membrane materials (solid membrane support and organic liquid membrane (LM) phase). Various approaches proposed in literature to enhance SLM stability are also reviewed. Modification of the solid membrane support, creating an additional layer on membrane surface, which acts as a barrier to LM phase loss, increases system stability, but the membrane permeability, and then the flux, decrease. Stagnant Sandwich Liquid Membrane (SSwLM), an implementation of the SLM system, results in both high flux and stability compared to SLM. Finally, possible large scale applications of SLMs are also reviewed, evidencing that if the LM separation process is opportunely carried out (no production of byproducts), it can be considered as a green process.

• Proceedings of the KWS Conference
• /
• 2006.10a
• /
• pp.259-261
• /
• 2006

• Proceedings of the KWS Conference
• /
• 2007.11a
• /
• pp.82-84
• /
• 2007