• JSTS:Journal of Semiconductor Technology and Science
• /
• v.3 no.2
• /
• pp.89-95
• /
• 2003

In this paper, we have designed and fabricated high conversion gain Q-band active sub-harmonic mixers for a receiver of millimeter wave wireless communication systems. The fabricated active sub-harmonic mixer uses 2nd harmonic signals of a low local oscillator (LO) frequency. The fabricated mixer was successfully integrated by using $0.1{\;}\mu\textrm{m}$GaAs pseudomorphic high electron mobility transistors (PHEMTs) and coplanar waveguide (CPW) structures. From the measurement, it shows that maximum conversion gain of 4.8 dB has obtained at a RF frequency of 40 GHz for 10 dBm LO power of 17.5 GHz. Conversion gain from the fabricated sub-harmonic mixer is one of the best reported thus far. And a phase noise of the 2nd harmonic was obtained -90.23 dBc/Hz at 100 kHz offset. The active sub-harmonic mixer also ensure a high degree of isolations, which are -35.8 dB from LO-to-IF and -40.5 dB from LO-to-RF, respectively, at a LO frequency of 17.5 GHz.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.32 no.5
• /
• pp.752-757
• /
• 2003

This study was carried out in order to develop the method for isolation of red ginseng acidic polysaccharide (RGAP) haying immunomodulating antitumor activity from red ginseng by-product. The red ginseng by-product was obtained from red ginseng residues produced in processing of red ginseng ethanol extract. The yield of RGAP isolated by ultrafiltration was 20.9%. The active substance (GFP) was purified by DEAE-sepharose column chromatography RGAP induced nitric oxide (NO) exhibited tumoricidal activities against P8l5 (mastocytoma) tumor cells. Acid-hydrolyzed RGAP fragments were shown four to five spots. These sopts showed the same R$_{f}$ values with sugars designated as rhamnose, glucose, glactose and glucuronic acid. Some physico-chemical properties of RGAP were investigated. pH and dry reduction content at 105$^{\circ}C$ were 4.74 and 4.72%, respectively. Crude protein, ash and Pb contents were 3.30%, 4.74% and 2.30 ppm. These results suggest that we will be able to produce RGAP from red ginseng by-product by ultrafiltration in a large scale.e.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2003.05a
• /
• pp.424-428
• /
• 2003

We have developed the RF discharge Excited slab Waveguide $CO_2$ laser and measured the output power. We make used of concave and concave mirror, concave and convex mirror that negative branch and positive branch unstable resonator, respectively. The resonator active dimension is 2$\times$40$\times$400 mm and ratio frequency is 123 MHz. The gas mixing ratio is $CO_2$: $N_2$ : He=1 : 1 : 3. The pressure in resonator is from 10 to 60 torr and RF input power increased from 100 to 900 W. so that We obtained laser maximum output power of negative branch and positive branch resonator 50.9 W and 70.8 W and efficiency is 6.5 % and 9.2 %, respectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.2
• /
• pp.77-85
• /
• 2014

Recently, utilization of MIMO(Multi-Input Multi-Output) system using array antennas is evaluated significantly according to the extension of high-capacity and high-speed communication services. However, MIMO system has disadvantages such as high-complexity and high-power-consumption, because RF(Radio Frequency) chain is required as antenna number, and several array antenna is used in conventional MIMO system. In order to solve these problems, research about beamspace MIMO system using ESPAR(Electronically Steerable Parasitic Array Radiator) antenna that has single RF chain by using one active antenna and several parasitic elements has been studied actively. Beamspace MIMO system using ESPAR antenna is possible to solve the problems of conventional MIMO system, because this system is composed by single RF chain. In this paper, in order to improve the system security, chaos communication algorithm that has characteristics such as non-periodic, non-predictability, easy implementation and initial condition is applied to QPSK (Quadrature Phase Shift Keying) modulated beamspace MIMO system. We design the chaos QPSK modulated beamspace MIMO system, and evaluate SER performance of this system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.134-138
• /
• 2005

In this paper, we have developed a new type of the microwave phase conjugator for the active retrodirective antenna array. The circuit topology is consisted of a 2-port structure to avoid the complexity of LO and RF signal combination and matching, using the cascade connection of two single-ended mixers. The operating frequencies are 4.0 GHz, 2.01 GHz and 1.99 GHz for LO, RF, and IF, respectively. Conversion loss is measured to be -7 dB and 1-dB compression point 15 dBm with the LO power of 9 dBm. For the most important parameter, the isolation between RE leakage and IF signal is as high as 25 dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.4A
• /
• pp.415-422
• /
• 2004

DSRC provides high speed radio link between Road Side Equipment and On-Board Equipment within the narrow communication area. In this paper, a 5.8 GHz down-conversion mixer for DSRC communication system was designed and fabricated using 0.8 ${\mu}{\textrm}{m}$ SiGe HBT process technology and RF/LO matching circuits, RF/LO input balun circuits, and If output balun circuit were all integrated on chip. The chip size of fabricated mixer was 1.9 mm${\times}$1.3 mm and the measured performance was 7.5 ㏈ conversion gain, －2.5 ㏈m input IP3, 46 ㏈ LO to RF isolation, 56 ㏈ LO to IF isolation, current consumption of 21 mA for 3.0 V supply voltage.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.11
• /
• pp.101-106
• /
• 2014

This paper presents a wide dynamic range radio-frequency (RF) root-mean-square (RMS) power detector using an automatic gain control (AGC) loop. The AGC loop consists of a variable gain amplifier (VGA), RMS conversion block and gain control block. The VGA exploits dB-linear gain characteristic of the cascade VGA. The proposed circuit utilizes full-wave squaring and generates a DC voltage proportional to the RMS of an input RF signal. The proposed RMS power detector operates from 500MHz to 5GHz. The detecting input signal range is from 0 dBm to -70 dBm or more with a conversion gain of -4.53 mV/dBm. The proposed RMS power detector is designed in a 65-nm 1.2-V CMOS process, and dissipates a power of 5 mW. The total active area is $0.0097mm^2$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.1
• /
• pp.217-225
• /
• 2015

Recently, as the supply of smart phone is spreading and the exhibition industries are rapidly growing, future exhibitions are evolving toward active, customized, interactive, tangible services, which can give more satisfaction to visitors. To realize this services, the indoor localization in the exhibition of visitors is very important and according to the accuracy of localization the quality of services for exhibition are also different. In this paper, state-of-the art indoor localization techniques are investigated and new localization method are proposed. To achieve this goal, future exhibition service types are proposed, which are connected with IT technology. And also, BLE(Bluetooth Low Energy) technology including comparison of specifications and representative localization technologies are analysed. Furthermore we performed comparison study and simulation between RF and VLC channels. Finally based on this, we proposed converged VLC and RF(Wi-Fi and BLE) localization technique for exhibition.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.6
• /
• pp.514-520
• /
• 2002

In this paper, the study of a design and fabrication of the receiver MMIC mixer for L-band application is described. The mixer is composed of active LO and RF balun to integrate on a chip and applied a newly proposed bias circuit to compensate the process variations of active devices. The conversion gain of the mixer is -14 dB, IIP3 is approximately 4 dBm and port-to-port isolation is over 25 dB. The newly proposed bias circuit is composed of a few FETs and resistors, and can compensate the variation of the threshold voltage by the process variations, temperature changes and etc. The designed chip size is $1.4\;mm{\times}1.4\;mm$.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.7
• /
• pp.1558-1564
• /
• 2004

This paper shows the design of Active antenna which appled to 5.5GHz RF module for local wireless communication system. The LNA, which was designed Super low noise HJ FET of NE3210S01, is used to obtain a good noise figure characteristics. And the microstrip patch antenna was designed to obtain omnidirectional antenna characteristics. The measured LNA gain is 15 dB, input & output return loss is under -20 dB and VSWR under 1.5. The Single microstrip patch antenna input return loss is under -29 45, VSWR under 1.2.