• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.12 s.105
• /
• pp.1378-1388
• /
• 2005

Spatial control of sound is essential to deliver better sound to the listener's position in space. As it can be experienced in many listening environments. the quality of sound can not be manifested over every Position in a hall. This motivates us to control sound in a region we select. The primary focus of the developed method has to do with the brightness and contrast of acoustic image in space. In particular, the acoustic brightness control seeks a way to increase loudness of sound over a chosen area, and the contrast control aims to enhance loudness difference between two neighboring regions. This enables us to make two different kinds of zone - the zone of quiet and the zone of loud sound - at the same time. The other perspective of this study is on the direction of sound. It is shown that we can control the direction of perceived sound source by focusing acoustic energy in wavenumber domain. To begin with, the proposed approaches are formulated for pure-tone case. Then the control methods are extended to a more general case, where the excitation signal has broadband spectrum. In order to control the broadband signal in time domain, an inverse filter design problem is defined and solved in frequency domain. Numerical and experimental results obtained in various conditions certainly validate that the acoustic brightness, acoustic contrast, direction of wave front can be manipulated for some finite region in space and time.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2006.05a
• /
• pp.197-202
• /
• 2006

The low-altitude earth observation satellite is generally equipped with high performance camera as a main payload which is vulnerable to vibration environment. During the launch process of a satellite, the combustion and jet noise of launch vehicle produce severe acoustic environment and the acoustic loads induced may damage the critical equipments of the satellite including the camera. Therefore to predict and simulate the effect of the acoustic environment which the satellite has to sustain at the lift-off event is very important process to support the load-resistive design and test-qualification of components. Statistical Energy Analysis(SEA) has been widely used to estimate the vibro-acoustic responses of the structures and gives statistical but reliable results in the higher frequency region with less modeling efforts and calculation time than the standard FEA. In this study, SEA technique has been applied to a 3-Dimensional model of a low-altitude earth observation satellite to predict the acceleration responses on the structural components induced by the high level acoustic field in the launch vehicle fairing. In addition, the expected response on each critical component panel was calculated by the classical method in consideration of the mass loading and imposed sound pressure level, and then compared with SEA results.

• Journal of the Korean Society of Laryngology, Phoniatrics and Logopedics
• /
• v.26 no.2
• /
• pp.104-111
• /
• 2015

Background and Objectives : Acoustic analysis of voice could be influenced so much by the quality of voice files which were recorded by recording device. In clinical practice, voice files that were recorded by analysis program directly or portable digital recording device were analyzed mostly. This study examined the feasibility of using Galaxy smartphone recordings for acoustic analysis of voice. Materials and Methods : Acoustic measures were compared between voice signals recorded from 30 normal speakers (15 males and 15 females) through Galaxy smartphone, portable digital recording device and CSL. Fo, jitter, shimmer, NHR (Noise-Harmony ratio) and Formant frequencies were analyzed by MDVP. Results : Fo, Jitter, Shimmer, NHR and formant frequencies from 3 devices were no significantly difference. The intraclass correlation coefficient (ICC) was higher between each of the voice perturbation measures. Conclusion : The findings indicated that Galaxy smartphone recording system was useful device for acoustic analysis of voice. Furthermore, Galaxy smartphone can be applied widely in various way for acoustic analysis of voice.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.22 no.4
• /
• pp.121-125
• /
• 2018

This paper presents the assessment of 7-wire strand monitoring using acoustic emission technique for bridges. 7-wire strand is widely used construction materials to provide additional tensile force to bridges. PSC (PreStressed Concrete) bridge and cable-stayed bridge are representatives for such cases. However, as the bridge aging progresses recently, corrosion problems of strand are emerging. For this reason, various NDT (Non-Destructive Test) methods for cable inspection are being studied and applied to the field. One of the NDT methods, acoustic emission technique, is known as an effective technique to detect cable damage and breakage. In this study, to evaluate the applicability of acoustic emission technique to bridges, acoustic emission signals according to damage of the strand were acquired and analyzed by tensile test. Moreover, The optimal AE sensor type was selected for field application. As a result, it is considered that the acoustic emission technique will be able to detect corrosion breakage and signs of rupture.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.10 no.1
• /
• pp.1-8
• /
• 2006

A linear acoustic analysis is conducted to examine bituning of acoustic resonators for acoustic damping in a combustion chamber of liquid rocket engine. Bituned resonators are tuned to the two principal modes, the first tangential(1T) and the first radial(1R) modes. First, the acoustic-damping effect of monotuned resonators is investigated. The damping capacity is quantified by damping factor as a function of the number of the resonators monotuned to 1T or 1R mode. Next, the damping characteristics of the bituned resonators are investigated. From the numerical data, the number of resonators, to be tuned to 1T and 1R modes, respectively, can be selected properly. Furthermore, the concept of resonator bituning is applied to reduce the degradation of damping effect caused by the mode split and thereby, optimal bituning frequencies are found.

• IEIE Transactions on Smart Processing and Computing
• /
• v.3 no.3
• /
• pp.153-159
• /
• 2014

As the number of treatments in the therapeutic ultrasound field targeted at fat tissue increase, the performance of the equipment should be evaluated for safety using a fat phantom. In this study, a fat phantom was fabricated using olive oil and a tissue-mimicking material (TMM) phantom. To evaluate the acoustic properties of the TMM phantom according to the changes in the olive oil, the composition ratio of a liquid mixture of olive oil with a surfactant was adjusted from 5-20% in 5% steps. The acoustic properties of the phantom were evaluated using the sound velocity, attenuation coefficient, density, and acoustic impedance. The experimental results showed that the sound velocity decreased with increasing amount of olive oil but the other acoustic properties did not change. In addition, the phantom using an olive-oil mixture with a 15% composition ratio was most similar to the acoustic characteristics of fat tissue with a sound velocity of 1477.35 m/s, an attenuation coefficient of 0.514 dB/MHz-cm, a density of $1.07g/cm^3$, and an acoustic impedance of 1.575 MRayl. These experimental results are expected contribute to the accuracy of the results using a TMM phantom and will be useful for the therapeutic ultrasound field targeted at subcutaneous fat tissue.

• The Journal of the Acoustical Society of Korea
• /
• v.22 no.5
• /
• pp.388-402
• /
• 2003

In this paper, we carried out the word, 4 continuous digits. continuous, and task-independent word recognition experiments to verify the effectiveness of the re-defined phoneme-likely units (PLUs) for the phonetic decision tree based HM-Net (Hidden Markov Network) context-dependent (CD) acoustic modeling in Korean appropriately. In case of the 48 PLUs, the phonemes /ㅂ/, /ㄷ/, /ㄱ/ are separated by initial sound, medial vowel, final consonant, and the consonants /ㄹ/, /ㅈ/, /ㅎ/ are also separated by initial sound, final consonant according to the position of syllable, word, and sentence, respectively. In this paper. therefore, we re-define the 39 PLUs by unifying the one phoneme in the separated initial sound, medial vowel, and final consonant of the 48 PLUs to construct the CD acoustic models effectively. Through the experimental results using the re-defined 39 PLUs, in word recognition experiments with the context-independent (CI) acoustic models, the 48 PLUs has an average of 7.06%, higher recognition accuracy than the 39 PLUs used. But in the speaker-independent word recognition experiments with the CD acoustic models, the 39 PLUs has an average of 0.61% better recognition accuracy than the 48 PLUs used. In the 4 continuous digits recognition experiments with the liaison phenomena. the 39 PLUs has also an average of 6.55% higher recognition accuracy. And then, in continuous speech recognition experiments, the 39 PLUs has an average of 15.08% better recognition accuracy than the 48 PLUs used too. Finally, though the 48, 39 PLUs have the lower recognition accuracy, the 39 PLUs has an average of 1.17% higher recognition characteristic than the 48 PLUs used in the task-independent word recognition experiments according to the unknown contextual factor. Through the above experiments, we verified the effectiveness of the re-defined 39 PLUs compared to the 48PLUs to construct the CD acoustic models in this paper.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.34 no.2
• /
• pp.171-175
• /
• 2014

In this study, we suggest a method to measure the thickness of thin films nondestructively using the dispersion characteristics of a surface acoustic wave propagating along the thin film surface. To measure the thickness of thin films, we deposited thin films with different thicknesses on a Si (100) wafer substrate by controlling the deposit time using the E-beam evaporation method. The thickness of the thin films was measured using a scanning electron microscope. Subsequently, the surface wave velocity of the thin films with different thicknesses was measured using the V(z) curve method of scanning acoustic microscopy. The correlation between the measured thickness and surface acoustic wave velocity was verified. The wave velocity of the film decreased as the film thickness increased. Therefore, thin film thickness can be determined by measuring the dispersion characteristics of the surface acoustic wave velocity.

• Phonetics and Speech Sciences
• /
• v.13 no.2
• /
• pp.103-109
• /
• 2021

In this study, we investigated longitudinal music perception of adult cochlear implant (CI) users and how acoustic stimulation with CI affects their music performance. A total of 163 participants' data were analyzed retrospectively. 96 participants were using acoustic stimulation with CI and 67 participants were using electrical stimulation only via CI. The music performance (melody identification, appreciation, and satisfaction) data were collected pre-implantation, 1-year, and 2-year post-implantation. Mixed repeated measures of ANOVA and pairwise analysis adjusted by Tukey were used for the statistics. As result, in both groups, there were significant improvements in melody identification, music appreciation, and music satisfaction at 1-year, and 2-year post-implantation than a pre-implantation, but there was no significant difference between 1 and 2 years in any of the variables. Also, the group of acoustic stimulation with CI showed better perception skill of melody identification than the CI-only group. However, no differences found in music appreciation and satisfaction between the two groups, and possible explanations were discussed. In conclusion, acoustic and/or electrical hearing devices benefit the recipients in music performance over time. Although acoustic stimulation accompanied with electrical stimulation could benefit the recipients in terms of listening skills, those benefits may not extend to the subjective acceptance of music. These results suggest the need for improved sound processing mechanisms and music rehabilitation.

• The Journal of the Acoustical Society of Korea
• /
• v.43 no.3
• /
• pp.285-292
• /
• 2024

When calculating sonar detection probability, underwater acoustic uncertainty is assumed to be normal distributed with a standard deviation of 8 dB to 9 dB. However, due to the variability in experimental areas and ocean environmental conditions, predicting detection performance requires accounting for underwater acoustic uncertainty based on ocean experimental data. In this study, underwater acoustic uncertainty was determined using measured mid-frequency (2.3 kHz, 3 kHz) noise level and transmission loss data collected in the shallow water of the East Sea. After calculating the predictable probability of detection reflecting underwater acoustic uncertainty based on ocean experimental data, we compared it with the conventional detection probability results, as well as the predictable probability of detection results considering the uncertainty of the Rayleigh distribution and a negatively skewed distribution. As a result, we confirmed that differences in the detection area occur depending on each underwater acoustic uncertainty.