• Journal of the Korean Institute of Telematics and Electronics
• /
• v.13 no.5
• /
• pp.24-29
• /
• 1976

In the phase locked AM signal detection, phase locked loop is used to extract a synchronous carrier from an input AM signal. Under the assumption that input noise is white Gaussian and free-running frequency of voltage controlled oscillator is the same that of an input carrier, operational behaviours of phase locked loop is analyzed and signal to noise ratio of the detection is derived quentitatively. The results show that the phase locked AM signal detection method offers a higher degree of noise mmunity than conventional AM signal detections.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.8 no.3
• /
• pp.27-32
• /
• 1971

This paper presents the analysis of the amplitude distortion occurring in the transmission of super wideband AM signal when the amplitude and phase variations of the upper and lower sidebands of the AM signal are symmetrical, and odd symmetrical with respect to the carrier. It is shown that the case where the amplitude variations of the upper and lower sidebands of AM signal are symmetrical with respect to the carrier while the phase variations of the upper and lower sidebands are odd symmetrical with respect to the carrier induce, no amplitude distortion in AM signal transmission.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.10 no.1
• /
• pp.18-26
• /
• 1973

In AM detection system, when the ratio of the frequency of the carrier to that of the modulating signal becomes less than a ratio of approximately 10:1, AM detectors become unable to detect the impressed signal in a satisfactory waveform. The failure of detecting such a super wide-band AM signal resulting from charging and discharging transient phenomena in associated diode circuit during the detecting of AM signal, has been a cause of limiting the channel capacity in AM or FM super multiplexing systems. This Paper presents the "Poly-phase Envelope Detection System" as a suitable method to solve the problem and the analyses of the system suggested. This system will make it possible to take the envelope out of the impressed AM signal to any desired degree of accuracy even when the ratio of the frequency of the carrier to that of the modulating signal approaches unity. Experiments were carried out to verify the validity of the theory of Poly-phase Envelope Detection System by adopting the frequency conversion method from among the two proposals.proposals.

• Speech Sciences
• /
• v.8 no.4
• /
• pp.45-58
• /
• 2001

Modulated components of a speech signal are frequently used for speech coding, speech recognition, and speech synthesis. Time-frequency representation (TFR) reveals some information about instantaneous frequency, instantaneous bandwidth and boundary of each component of the considering speech signal. In many cases, the extraction of AM-FM components corresponding to instantaneous frequencies is difficult since the Fourier spectra of the components with time-varying instantaneous frequency are overlapped each other in Fourier frequency domain. In this paper, an efficient method decomposing speech signal into AM-FM components is proposed. A variable bandwidth filter is developed for the decomposition of speech signals with time-varying instantaneous frequencies. The variable bandwidth filter can extract AM-FM components of a speech signal whose TFRs are not overlapped in timefrequency domain. Also, amplitude and instantaneous frequency of the decomposed components are estimated by using Hilbert transform.

• Proceedings of the IEEK Conference
• /
• 1998.10a
• /
• pp.211-214
• /
• 1998

The high power amplifier (HPA) for broadcasting transmitter systems has nonlinear property in terms of input signal power. Hence, it produces AM/AM and AM/PM modulation to the modulated signal. Therefore, the non-linearity results in bandwidth expansion and nonlinear distortion to in-band signal. In this paper, we propose a simple sain-based predistorter that requires less computational burden and less time for the full initialization of the pre-distorter ROM table.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.2
• /
• pp.220-227
• /
• 2011

With the rapid development of mobile communication technology, the technologies based on the diverse digital modulation schemes have been used for the frequency range of over 800 MHz. The only radiation immunity has been tested using only AM signal based on IEC 61000-4-3 without any consideration of the influence of electromagnetic radiation in Korea. However, it has not been tested by wideband digital modulation signals such as cdmaone(IS-95), WCDMA and PM signal. The purpose of this study was to review the standards. In addition, the input signals were analyzed and tested considering the environments in Korea. The results showed that the devices were influenced by digital modulation signal or PM signal more than by AM signal.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.6
• /
• pp.1061-1068
• /
• 2017

A RVDT is a sensor that measures angular displacement and the output signal of RVDT is a DSBSC-AM signal. For this reason, a DSBSC-AM demodulation processor is required to determine the angular displacement from the output signal. In this paper, DADC(Digital Angle to DC) which extracts the angular displacement from the output signal of a RVDT is implemented based-on modified Costas Loop usually used in the demodulation of DSBSC-AM signal by using FPGA. DADC can used with both 4-wire and 5-wire RVDTs and can exactly compensate the phase difference between the input excitation and output signals of a RVDT unlike the conventional analog RVDT signal conditioners which require external components. Since digital signal processing technique that can enhance the linearity is exploited, DADC shows 0.035% linearity error, which is smaller than 0.005% that of a conventional analog signal conditioner. The DADC are tested in an integrated experimental environment which includes a commercial RVDT sensor, ADC and an analog output block.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.6
• /
• pp.698-705
• /
• 2010

A vehicle antenna for AM, FM, TDMB, GPS systems was designed and implemented. Omnidirectional AM antenna was designed by ferrite turn style antenna. For the FM and TDMB antenna, folded monopole antenna which helical is folded was applied. GPS antenna for the bandwidth achievement was designed by trapezoidal microstrip patch that has air substrate. Receiving signal strengths by the measurement were presented for the AM, FM and TDMB antenna. AM signal strength was -65.7 dBm, this strength is almost as same conventional pole antenna as -63.4 dBm. It can be replaced conventional pole or glass antenna by the studied antenna. Signal strengths for FM and TDMB were -55.66 and -43.50 dBm at center frequency, they are 5~10 dB higher than conventional antenna. Measurements of bandwidth and gain for the GPS antenna showed 135 MHz under VSWR 2 : 1 and 4.31 dBi, gains over GPS band were 3~5 dB higher than ceramic patch antenna.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.8
• /
• pp.3529-3550
• /
• 2016

In heterogeneous networks (HetNets), energy saving is vital for a sustainable network development. Many techniques, such as spectrum allocation, network planning, etc., are used to improve the network energy efficiency (EE). In this paper, micro BSs utilizing cell range expansion (CRE) and spectrum allocation are considered in multi-channel heterogeneous networks to improve EE. Hotspot region is assumed to be covered by micro BSs which can ensure that the hotspot capacity is greater than the average demand of hotspot users. The expressions of network energy efficiency are derived under shared, orthogonal and hybrid subchannel allocation schemes, respectively. Particle swarm optimization (PSO) algorithm is used to solve the optimal ratio of subchannel allocation in orthogonal and hybrid schemes. Based on the results of the optimal analysis, we propose three service control strategies on the basis of large-scale user behaviors, i.e., adjust micro cell rang expansion (AmCRE), adjust micro BSs density (AmBD) and adjust micro BSs transmit power (AmBTP). Both theoretical and simulation results show that using shared subchannel allocation scheme in AmBD strategies can obtain maximal EE with a very small area ratio. Using orthogonal subchannel allocation scheme in AmCRE strategies can obtain maximal EE when area ratio is larger. Using hybrid subchannel allocation scheme in AmCRE strategies can obtain maximal EE when area ratio is large enough. No matter which service control strategy is used, orthogonal spectrum scheme can obtain the maximal hotspot user rates.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.5
• /
• pp.105-113
• /
• 2009

In this paper, a vehicle antenna for AM, FM, TDMB, GPS systems was designed and implemented. AM antenna loaded into small space of shark shape was designed by ferrite turn style antenna. For the FM and TDMB antenna, folded monopole antenna which helical is folded was applied. GPS antenna for achieving characteristics both bandwidth and gain improvement was designed microstrip patch that has air substrate and fractal structure. Receiving signal strengths by the measurement were presented for the AM, FM and TDMB antenna. AM signal strength was -65.7dBm, this strength is almost as same conventional pole antenna as -63.4dBm. It can be replaced conventional pole or glass antenna by the studied antenna. Signal strengths for FM and TDMB were -55.66 and -43.50dBm at center frequency, they are 5~10dB higher than conventional antenna. Measurements of bandwidth and gain for the GPS antenna showed 135 MHz under VSWR 2 : 1 and 4.31dBi, gains over GPS band were 3~5dB higher than ceramic patch antenna.