• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.5
• /
• pp.151-155
• /
• 2004

Millimeterwave OFDM wireless LAN system has been modeled for ACPR analysis. With simple AM-to-PM modeling for power amplifier and system simulation technique, power amplifier ACPR is simulated for OFDM modulation, Also, amplifier back-off value satisfying the required ACPR and the ACPR degradation have been predicted with the measured and modeled AM-tn-PM distortion.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.5
• /
• pp.711-718
• /
• 1999

Some of modern communication systems make use of broadband digital modulation with 5 MHz and 10 MHz. In the broadband communication systems, the nonlinear properties of power amplifier have a great effect on all systems. This paper analyzed the ACPR characteristics of WLL reverse link power amplifier with the varying AM and PM nonlinearities and suggests the required backoff from 1 dB compression point to satisfy the ACPR specifications. Also the comparions between the measured and the simulated characteristics are presrnted.

• Proceedings of the IEEK Conference
• /
• 2000.11a
• /
• pp.329-332
• /
• 2000

In this paper, we made 5W 2stage power amplifier for IMT-2000 repeater. We designed this amplifier by harmonic balanced simulation using nonlinear model to minimize distortion. After simulation, we acquired 47㏈m 1㏈ compression point at 2110 ~ 2170MHz single tone input. In addition, the ACPR of this amplifier was good. The test result was 47㏈m 1㏈ compression point, 42.6㏈ gain, -36.16㏈c ACPR at 2.5MHz, -44.34㏈c ACPR at 5MHz and -51.67㏈c ACPR at 7.5MHz.

• Proceedings of the IEEK Conference
• /
• 1999.06a
• /
• pp.187-190
• /
• 1999

In order to predict the effect of power amplifier non-linearity for digital modulated signal, this paper analyses the adjacent channel power ratio(ACPR) with the various AM-to-PM distortion levels. As the phase distortion increases from 0$^{\circ}$ to 12$^{\circ}$ at 1㏈compression point by 2.4$^{\circ}$ step, the input power level which satisfies the required ACPR decreases from 3.5㏈ to 6.5㏈ less than the 1㏈ compression input power.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.10
• /
• pp.1011-1016
• /
• 2003

In this paper, we investigate the relationship between the intermodulation signal of 2-tone and CDMA spurious emission of HPA. And confirm that the fifth IMD signal of HPA has more important effect upon CDMA ACPR characteristics than the third IMD signal. We present the method for the power amplifier to satisfy the 2-tone and CDMA specification simultaneously, and that is to use the predistorter for improving the third IMD signal of 2-tone for the power amplifier which is tuned to satisfy the CDMA specification and not to satisfy the 2-tone specification. The result by using the method which is presented from this paper shows that the ACPR is improved about 2 dB for CDMA 1FA(frequency allocation) signal and the third IMD signal is improved about 20 dB for CW 2-tone signals and we confirmed the specification is satisfied simultaneously.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.221-224
• /
• 2005

This paper discribes the nonlinear distortion of a pHEMT power amplifier. In the paper, we have used some commercially available power amplifiers for analyzing the relationship between the $IMD_3$ and ACPR for wireless LAN. And the $IMD_3$ results using two-tone test have been compared with ACPR to satisfy the requited 802.11g standard ACPR value. Measurement result shows that $IMD_3$ of 20MHz tone-spacing need to be more than 18.45dBc for power amplifiers. The WCDMA signal is fed into the power amplifier, for analyzing relationship between the asymmetrical $IMD_3$ and ACLR. With measurement result, the asymmetrical $IMD_3$ characteristic has increased with the increase of two-tone spacing. $IMD_3$ measurement result with maximum 20MHz of the two-tone spacing, shows that the difference between $IMD_3(lower)$ and $IMD_3(upper)$ is about 7dB. And the measured ACLR shows 5dB difference at -4MHz and +4MHz offset from center frequency.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.8
• /
• pp.857-864
• /
• 2010

In this paper, we analyse the effect of the path imbalances(gain and phase mismatches) in LINC(LInear amplification with Nonlinear Component) system, and propose a simple scheme using LUTs(Look Up Table) to compensate the path imbalances. The EVM(Error Vector Magnitude) and ACPR(Adjacent Channel Power Ratio) of the LINC system are degraded significantly by the path imbalances because it adopts an outphasing technique. The EVM and ACPR are theoretically extracted for two variables(gain and phase mismatch factors) and 2-D LUTs for those are generated based on the analysis. The efficient and simple compensation scheme for the path imbalances is proposed using the 2-D LUTs. A LINC system with the suggested compensation scheme is implemented, and the proposed method is verified with an experiment. A 16-QAM signal with 1.5 MHz bandwidth is used. Before the compensation, the path gain ratio was 95 % and phase error was $19.33^{\circ}$. The proposed scheme adjusts those values with 99 % and $0.5^{\circ}$, and improves ACPR about 18.1 dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.4C
• /
• pp.380-387
• /
• 2002

In this paper, the effect of the phase noise of a local oscillator on the ACPR of a transmitter and the reception sensitivity of a receiver to meet the TIA/EIA/IS-98-D for the CDMA mobile station was analyzed. And the optimum condition for performance of the local oscillator was suggested. It was found that the phase noise level of the local oscillator in a receiver and a transmitter should be below -138.3dBc/Hz and -120dBc/Hz, respectively, at 900kHz offset. It was confirmed that the reception sensitivity and ACPR efficiency were satisfactory when the signal of the local oscillator to the down-converter of a receiver with the phase noise level of less than -138.3dBc/Hz is supplied to the up-converter of the transmitter.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.5 s.347
• /
• pp.17-24
• /
• 2006

The optical feedforward is known as a complicated technique in spite of its superior linearization. Here we optimized the feedforward circuit parameters using a systematic approach for optimum efficiency. A systematic approach was verified by transmission experiments of 2.14 GHz two tones. The compared third order IMD was enhanced by 38 dB for two-tone case. The experimental results for transmission of W-CDMA signals were described. The ACPR was enhanced by 20 dB for 1 W-CDMA carrier and by 16 dB for 3 W-CDMA carriers. Also, noise level was reduced by 7 dB.

• ETRI Journal
• /
• v.19 no.2
• /
• pp.35-47
• /
• 1997

A power amplifier operating at 3.3 V has been developed for CDMA/AMPS dual-mode cellular phones. It consists of linear GaAs power MESFET's, a new gate bias control circuit, and an output matching circuit which prevents the drain terminal of the second MESF from generating the harmonics. The relationship between the intermodulation distortion and the spectral regrowth of the power amplifier has been investigated with gate bias by using the two-tone test method and the adjacent channel leakage power ratio (ACPR) method of CDMA signals. The dissipation power of the power amplifier with a gate bias control circuit is minimized to below 1000 mW in the range of the low power levels while satisfying the ACPR of less than -26 dBc for CDMA mode. The ACPR of the power amplifier is measured to be -33 dBc at a high output power of 26 dBm.