• Journal of the Society of Naval Architects of Korea
• /
• v.46 no.5
• /
• pp.498-509
• /
• 2009

Present study is concerned with the simulation of plasticity models for the cyclic stressstrain behavior of aluminum alloy AC4C-T6 that can be used for primary materials of LNG cargo pump. Material model of cyclic hardening and plasticity for aluminum alloy AC4C-T6 was investigated through experiments and numerical simulations. Monotonic tensile and cyclic tension-compression test under symmetric load cycles was performed at both room temperature and cryogenic temperature of $-165^{\circ}C$. Based on the experimental data plastic hardening models were evaluated for isotropic/kinematic/combined hardening. FEA (Finite Element Analysis) models which describe the cyclic stress-strain relationship were evaluated for the simulation of plasticity. An appropriate hardening model is proposed comparing the results of FEA with those of experiments.

• Korean Journal of Materials Research
• /
• v.3 no.6
• /
• pp.606-613
• /
• 1993

This was studied about aging characteristic of AC4A/$SiC_{w}$ 10-30v/o reinforced composite. Aging hardenability was decreased $SiC_{w}$ 30% > 10% > 20%. Aging hardening of T6 treatmented composite was higher absolute value than AC4A I/M material. And this results indicated initial hardening phenomenon according to increase $SiC_{w}$ volume fraction. Reinforced effect by pressure was the same effect as before aging treatment and the best condition pressure at 75MPa. Similar to reinforced effect according to $SiC_{w}$ volume fraction was 30 % > 10 % > 20 %. In case of pressure is low, whisker is not break the same time press with base metal after wetting. After it is wetting with base metal, a part transformed or wetting part break and whisker maintain original shape or a part transformed on the otherhand, in case of pressure is high, whisker is break in same time it was not against pressure and whisker's shape is near a polygon or spherical shape.

• Journal of the Korean Magnetics Society
• /
• v.26 no.6
• /
• pp.201-205
• /
• 2016

In this report, we measured the impedance spectrum in TMR device, and the relaxation behavior of the real and imaginary impedance spectrum was analyzed by using the equilibrant circuit of tunneling capacitance ($C_T$) and tunneling resistance ($R_T$). The relaxation frequency was increased with AC voltage in both the parallel and antiparallel alignment of two magnetic layers. The $R_T$ with AC voltage showed the typical bias voltage dependence. However, the $C_T$ showed large value than the expected geometrical capacitance. The huge increase of $C_T$ was affecting as a limiting factor for the high speed operation of TMR devices. Thus, the supercapacitance of $C_T$ should be considered to design the high speed TMR devices.

• Journal of Korea Foundry Society
• /
• v.13 no.5
• /
• pp.450-461
• /
• 1993

AC4C alloy casts in the metallic mold, zircon sand mold, silica sand mold and shell mold with the pouring temperatures of 680, 710 and $740^{\circ}C$ have been investigated. The tensile strength, elongation and hardness of AC4C alloy castings have been influenced by the kind of molds used. The mechanical properties in zircon sand mold castings were greater than those in other sand mold castings, but were inferior to the properties in metallic mold castings. Eutectic Si particle size and DAS were increased in the order of metallic mold, ziron sand mold, silica sand mold and shell mold. Also, they were increased with the increase of pouring temperatures. DAS, eutectic Si particle size and grain size decreased with the increase of mechanical properties as the cooling rate increased. The eutectic Si particle size and DAS of AC4C alloy castings after T6 treatment were decreased in as-cast. The variation of eutectic Si particle size has been effected on the tensile strength, elongation and fractured surface.

• Korean Journal of Poultry Science
• /
• v.33 no.4
• /
• pp.283-293
• /
• 2006

Two experiments were conducted to investigate the effects of dietary activated charcoal mixed with wood vinegar (AC) on broiler performance and antibiotics residue in eggs. In experiment 1, a total of low hundred fifty, 1-day-old male broile. chicks (Ross) were divided into 6 groups, consisting 3 replicates of 25 birds each, and 134 one of the six experimental diets: devoid of AC and antibiotics (negative control), devoid of AC with 0.1% antibiotics (positive control), devoid of antibiotics with 1% AC, with 0.1% antibiotics and 1% AC, devoid of antibiotics with 2% AC, with 0.1% antibiotics and 2% AC, for 5 wks. Feed consumption and body weights were measured weekly. At the end of the experiment, eight birds from each group were selected and sacrificed. The relative weight of organs and characteristics of breast muscle were investigated. There were no significant differences in feed intake, body weight gain and feed conversion rate among the treatments. There were also no significant differences in the relative weight of breast meat, leg and liver. The abdominal fat tended to be decreased by the dietary AC. Significant differences were shown (P<0.05) in meat redness (a) and yellowness (b) among the treatments. However, the sensual characteristics of breast muscle was not affected by the dietary treatments. There were significant differences in total microbes, Coli forms and lactic acid bacteria (P<0.05) among the treatments. In experiment 2, a total of ninety, 40-wk-old Hy-line Brown laying hens were divided into 3 groups, consisting 3 replicates of 10 birds each and fed medicated control diet devoid of AC or diets containing 1% AC and 2% AC for 2 wks. The residue of antibiotics in Plasma and egg Yolk were significantly decreased (P<0.05) in 2% AC group compared to that of control. This study suggest that dietary AC may improve the external quality of edible meat and reduced antibiotics residue in chicken eggs without affecting laying performance.

• Progress in Superconductivity and Cryogenics
• /
• v.15 no.2
• /
• pp.34-38
• /
• 2013

AC Losses for face to face stacks of four identical coated conductors (CCs) were numerically calculated using the H-formulation combined with the E-J power law and the Kim model. The motive sample was the face to face stack of four 2 mm-wide CC tapes with 2 ${\mu}m$ thick superconducting layer of which the critical current density, $J_c$, was $2.16{\times}10^6A/cm^2$ on IBAD-MgO template, which was suggested for the mitigation of ac loss as a round shaped wire by Korea Electrotechnology Research Institute. For the calculation the cross section of the stack was simply modeled as vertically aligned 4 rectangles of superconducting (SC) layers with $E=E_o(J(x,y,t)/J_c(B))^n$ in x-y plane where $E_o$ was $10^{-6}$ V/cm, $J_c$(B) was the field dependence of current density and n was 21. The field dependence of the critical current of the sample measured in four-probe method was employed for $J_c$(B) in the equation. The model was implemented in the finite element method program by commercial software. The ac loss properties for the stacks were compared with those of single 4 cm-wide SC layers with the same critical current density or the same critical current. The constraint for the simulation was imposed in two different ways that the total current of the stack obtained by integrating J(x,y,t) over the cross sections was the same as that of the applied transport current: one is that one fourth of the external current was enforced to flow through each SC. In this case, the ac loss values for the stacks were lower than those of single wide SC layer. This mitigation of the loss is attributed to the reduction of the normal component of the magnetic field near the SC layers due to the strong expulsion of the magnetic field by the enforced transport current. On the contrary, for the other case of no such enforcement, the ac loss values were greater than those of single 4cm-wide SC layer and. In this case, the phase difference of the current flowing through the inner and the outer SC layers of the stack was observed as the transport current was increased, which was a cause of the abrupt increase of ac loss for higher transport current.

• The Korean Journal of Pesticide Science
• /
• v.6 no.3
• /
• pp.218-223
• /
• 2002

The rate of hydrolysis of insecticide, O,O-diethyl-O-(1-phenyl-3-trifluoromethylpyrazol-5-yl)phosphorothioate (Flupyrazofos) have been investigated in 25% (v/v) aqueous dioxane (${\mu}=0.1M$) at $45^{\circ}C$. The hydrolysis mechanism of flupyrazofos proceeds through the specific acid ($A_{AC}2$) catalysis below pH 4.0, specific base ($B_{AC}2$) catalysis above pH 11.0 and general acid & base ($B_{AC}2$) catalysis between pH 5.0 and pH 10.0 via trigonal-bipyramidal ($d^2sp^3$) intermediate as evidence by solvent effect ($|m|{\ll}|{\ell}|$), rate equation ($kt=ko+k_H+ [H_3O^+]+k_{OH}[OH^-]$) and product analysis. The half-life ($T\frac{1}{2}$) of hydrolytic degradation in neutral media at $45^{\circ}C$ was ca. 3 months.

• Asian Pacific Journal of Cancer Prevention
• /
• v.16 no.12
• /
• pp.5007-5011
• /
• 2015

Background: Breast cancer is a major cause of morbidity and mortality in Jordan and worldwide. Abnormality of DNA methylation is a possible mechanism for the development of cancer. Methylenetetrahydrofolate reductase (MTHFR) is involved in DNA methylation. Our aim was to study the association between genetic polymorphisms of MTHFR at two sites (C677T and A1298C) and their haplotypes and the risk of breast cancer among Jordanian females. Materials and Methods: A case-control study involving 150 breast cancer cases and 150 controls was conducted. Controls were age-matched to cases. Polymerase chain reaction/restriction fragment length polymorphism (PCR-RFLP) technique and sequencing were conducted to determine the genotypes. Results: There was a significant difference in genotype frequency of C677T in the 41-60 year age category [cases: CC (37.4%), CT (49.5%) and TT (13.2%); controls: CC (56.3%), CT (35.6%) and TT (8%), p= 0.04; $OR_{TT\;vs.\;CC}$: 2.5, 95% CI: (0.9-6.9); $OR_{at\;least\;on\;T$: 2.1, 95%CI: (1.2-3.9)]. There was no significant difference in genotype frequency of A1298C between cases and controls [cases: AA (46.6%), AC (41.8%) and CC (11.6%); controls: AA (43%), AC (47.4%) and CC (9.6%); p= 0.6]. There was a significant difference of MTHFR genetic polymorphism haplotypes among breast cancer cases and controls [cases/control: CA: 38.3/45.4%; CC: 28.9/25.2%; TA: 29.2/21; TC: 3.6/8.3; p value= 0.01; $OR_{TA\;vs.\;CA}=1.6$; 95% CI (1.1-2.5); p= 0.02]. Conclusions: Genetic polymorphism of MTHFR C677T may modulate the risk of breast cancer especially in the 41-60 year age group. Additionally, TA haplotype amends the risk of breast cancer. Future studies with a larger sample size are needed to validate the role of MTHFR genetic polymorphisms in breast cancer.

• The Korean Journal of Food And Nutrition
• /
• v.6 no.4
• /
• pp.314-321
• /
• 1993

We have cloned the Bacillus cellulyticus K-12 avicelase (Avi, E.C.3.2.1.4) gene (ace A) In E. coli. This was accompanied by using the vector PT7T3U 19 and Hind W -Hind m libraries of Bacillus cellulyticus K-12 chromosomal inserts created in 5.cofi. The Libraries were screened for the expression of avicelase by monitoring the immunoreaction of the anti-avicelase (immunoscreening). Positive clones (Ac-3, Ac-5, and Ac-7) contained the identical 3.5kb Hind III fragment as determined by restriction mapping and Southern hybridization, and expressed avicelase efficiently and constituvely using its own promoter in the heterologous host. From the immunoblotting analysis, a polypeptide which showed a CMCase activity with an Mr of 54000 was detected.

• Proceedings of the Korean Biophysical Society Conference
• /
• 2003.06a
• /
• pp.76-76
• /
• 2003

We report here the results on N-acetyl-N'-methylamide of 4-fluoroproline (Ac-Flp-NHMe) calculated using the ab initio molecular orbital method with the self-consistent reaction field (SCRF) theory at the HF level with the 6-31+G(d) basis set to investigate the stereoelectronic effects on the conformational preference of proline depending on the cis/trans peptide bonds and down/up puckerings along the backbone torsion angle $\square$ in the gas phase, chloroform, and water. In the gas phase, all potential energy surfaces for Ac-Flp-NHMe are quite similar to those of Ac-Pro-NHMe, except that up-puckered conformations are more stabilized than down-puckered ones. In chloroform and water, polyproline structures become dominant, whose populations are larger than those of Ac-Pro-NHMe. In chloroform and water, the populations of polyproline II (i.e., tF conformations) are quite similar to each other, but those of polyproline I (i.e., cF conformations) are larger by 5％ in water than in chloroform. In particular, all cis populations for Ac-Flp-NHMe in the gas phase, chloroform, and water are decreased than those of Ac-Pro-NHMe.