• Journal of KIISE:Computer Systems and Theory
• /
• v.31 no.9
• /
• pp.536-542
• /
• 2004

An architecture of direct digital frequency synthesizers (DDFS) is studied in this paper The Direct digital frequency synthesizers (DDFS) provide fast frequency switching with high spectral purity and are widely used in modern spread spectrum wireless communication systems. ROM-based DDFS uses a ROM lookup table to store the amplitude of a sine wave. In this paper, we suggest three new techniques to reduce the ROM size. One new technique uses more number of hierarchical levels in ROM structures. Another techniques use simple interpolation techniques combined with hierarchical ROM structures. A 12 bit sine wave is generated by using these techniques. Experimental results show that the new proposed techniques can reduce the required ROM size by up to 24%, when compared to that of a resent method[1].

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2006.05a
• /
• pp.422-425
• /
• 2006

본 연구는 도체주변에 감겨진 광섬유 코일에 따라 선형편광축이 자기장에 의해 회전하는 Faraday Effect를 이용한 GIS(Gas Insulated Switchgear,이하 GIS) 용 광 전류센서의 구성과 DAQ(Data Acquisition,이하 DAQ)보드를 장착한 PC를 이용하여 실시간 데이터 취득, 분석 그리고 저장을 동시에 수행하였다 광원은 1310[nm]의 레이저 다이오드를 이용하였다. 센서부는 GIS에 맞게 원형으로 제작하였고 $9/125[{\mu}m]$규격 단일모드의 일반 통신용 광섬유를 지름 31[cm]의 센서부 코어에 20[회] 감아 설치하였다. PC기반의 실시간 데이터 분석 프로그래밍은 NI사의 Labview를 이용하여 코딩하였으며 PD(Photo Diode,이하 PD)의 전기적인 신호는 터미널 블록을 거쳐 NI사의 16bit DAQ M시리즈를 이용하여 수집되어진다. 직접 코딩한 프로그램을 이용하여 $700A\sim1400A$ 측정한 출력값 선형적인 증가추세를 보여주었다. 또한 OCS(Oscilloscope,이하 OCS)를 이용한 측정시스템과의 출력신호 및 정밀도를 비교 검토하였다. 그리고 Labview에서 지원하는 Web Tool기능을 이용하여 Web기반의 원거리 측정에서도 안정된 출력을 보여주었다.

• ETRI Journal
• /
• v.42 no.6
• /
• pp.943-950
• /
• 2020

We propose 8.2-GHz band radar RFICs for an 8 × 8 phased-array frequency-modulated continuous-wave receiver developed using 65-nm CMOS technology. This receiver panel is constructed using a multichip solution comprising fabricated 2 × 2 low-noise amplifier phase-shifter (LNA-PS) chips and a 4ch RX front-end chip. The LNA-PS chip has a novel phase-shifter circuit for low-voltage operation, novel active single-to-differential/differential-to-single circuits, and a current-mode combiner to utilize a small area. The LNA-PS chip shows a power gain range of 5 dB to 20 dB per channel with gain control and a single-channel NF of 6.4 dB at maximum gain. The measured result of the chip shows 6-bit phase states with a 0.35° RMS phase error. The input P1 dB of the chip is approximately -27.5 dBm at high gain and is enough to cover the highest input power from the TX-to-RX leakage in the radar system. The gain range of the 4ch RX front-end chip is 9 dB to 30 dB per channel. The LNA-PS chip consumes 82 mA, and the 4ch RX front-end chip consumes 97 mA from a 1.2 V supply voltage. The chip sizes of the 2 × 2 LNA-PS and the 4ch RX front end are 2.39 mm × 1.3 mm and 2.42 mm × 1.62 mm, respectively.

• International Journal of Computer Science & Network Security
• /
• v.24 no.5
• /
• pp.79-88
• /
• 2024

The information retrieval domain deals with the retrieval of unstructured data such as text documents. Searching documents is a main component of the modern information retrieval system. Locality Sensitive Hashing (LSH) is one of the most popular methods used in searching for documents in a high-dimensional space. The main benefit of LSH is its theoretical guarantee of query accuracy in a multi-dimensional space. More enhancement can be achieved to LSH by adding a bit to its steps. In this paper, a new Dynamic Locality Sensitive Hashing (DLSH) algorithm is proposed as an improved version of the LSH algorithm, which relies on employing the hierarchal selection of LSH parameters (number of bands, number of shingles, and number of permutation lists) based on the similarity achieved by the algorithm to optimize searching accuracy and increasing its score. Using several tampered file structures, the technique was applied, and the performance is evaluated. In some circumstances, the accuracy of matching with DLSH exceeds 95% with the optimal parameter value selected for the number of bands, the number of shingles, and the number of permutations lists of the DLSH algorithm. The result makes DLSH algorithm suitable to be applied in many critical applications that depend on accurate searching such as forensics technology.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.9B
• /
• pp.1742-1754
• /
• 1999

In this paper, we propose a rate control scheme, using histogram based rate-distortion (R-D) estimation, which produces a consistent picture quality between consecutive frames. The histogram based R-D estimation used in our rate control scheme offers a closed-form mathematical model that enable us to predict the bits and the distortion generated from an encoded frame at a given quantization parameter (QP) and vice versa. The most attractive feature of the R-D estimation is low complexity of computing the R-D data because its major operation is just to obtain a histogram or weighted histogram of DCT coefficients from an input picture. Furthermore, it is accurate enough to be applied to the practical video coding. Therefore, the proposed rate control scheme using this R-D estimation model is appropriate for the applications requiring low delay and low complexity, and controls the output bit-rate ad quality accurately. Our rate control scheme ensures that the video buffer do not underflow and overflow by satisfying the buffer constraint and, additionally, prevents quality difference between consecutive frames from exceeding certain level by adopting the distortion constraint. In addition, a consistent considering the maximum tolerance BER of the voice service. Also in Rician fading channel of K=6 and K=10, considering CLP=$10^{-3}$ as a criterion, it is observed that the performance improment of about 3.5 dB and 1.5 dB is obtained, respectively, in terms of $E_b$/$N_o$ by employing the concatenated FEC code with pilot symbols.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.9 s.351
• /
• pp.80-87
• /
• 2006

In this paper, we analyze the performance of IEEE 802.11b WLAN communication between access point(AP) and mobile equipment(ME) in 2.4 GHz band with noise and interference factors. WLAN communication at in-vehicle environment is assumed as the communication between main vehicle controller and electronic device such as sensor, ECU (Electrical Control Unit) in vehicle on telematics field for implementing wireless vehicle control system. Received interference level from other system's mobile equipment in the same band and automobile noise from each part of vehicle can be the main factors that can cause increasing error rate of control signal. With these (actors, we focus on the Eb/No the BER performance of WLAN for analyzing the characteristic of interference factors by the measured bit error rate.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.9
• /
• pp.835-842
• /
• 2009

DVB-SSP is a new broadcasting system for hybrid satellite communications, which supports mobile handheld systems and fixed terrestrial systems. However, a critical factor must be considered in upper layer decoding which including erasure Reed-Solomon error correction combined with cyclic redundancy check. If there is only one bit error in an IP packet, the entire IP packet is considered as unreliable bytes, even if it contains correct bytes. IF, for example, there is one real byte error, in an If packet of 512 bytes, 511 correct bytes are erased from the frame. Therefore, this paper proposed two kinds of upper layer decoding methods; LLR-based decoding and hybrid decoding. By means of simulation we show that the performance of the proposed decoding algorithm is superior to that of the conventional one.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.2
• /
• pp.111-116
• /
• 2009

In this paper, we propose a phase offset estimation algorithm which is based on turbo coded digital broadcasting system. The phase estimator is an estimator outside turbo code decoder using LMS (Least Mean Square) algorithm to estimate the phase of next state. While the conventional LMS algorithm with a fixed step size is easy implemented, it has weak points that are difficult the channel estimation and tracking in the multipath environment. To resolve this problem, we propose new phase offset estimation method with a variable step size LMS (VS-LMS). Additionally, we propose a scheme which consists of a conventional LMS. The performance is verified by computer simulation according to a fixed phase offset and a increased phase offset, the proposed algorithm improve the bit error rate performance than the conventional algorithm.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.2
• /
• pp.137-144
• /
• 2009

This paper deals with the performance comparison of jammer signal's angle spreading in the beamforming after the estimation of direction of arrival using 3D array antenna basis of the GPS signal. After the estimation of direction of arrival using array antenna, the beamforming is need for the direction of arrival by spatial filtering and the other direction are nulling for reducing intererence signal, it is possible to improving the received signal strength and quality. But we obtains the degraded performance by the angle spreading due to the multi-jammer signal in this process. In this paper, the MUSIC and LCMV algorithms are applied for the estimating the direction of arrival and for beamforming using the 5 types of 3D array antenna. we performs the comparison of performance by calculating the bit error rate applying the BPSK modem and the varying the azimuth and elevation angle of incoming jammer signal. As a result of simulation, the Curved (B) type 3D array antenna has a more better performance compared to the other type antenna.

• Journal of Convergence for Information Technology
• /
• v.10 no.9
• /
• pp.22-27
• /
• 2020

In the fifth generation (5G) networks, the mobile services require much faster connections than in the fourth generation (4G) mobile networks. Recently, as one of the promising 5G technologies, non-orthogonal multiple access (NOMA) has been drawing attention. In NOMA, the users share the frequency and time, so that the more users can be served simultaneously. NOMA has several superiorites over orthogonal multiple access (OMA) of long term evolution (LTE), such as higher system capacity and low transmission latency. In this paper, we investigate impact of channel estimation errors on successive interference cancellation (SIC) performance of NOMA. First, the closed-form expression of the bit-error rate (BER) with channel estimation errors is derived, And then the BER with channel estimation errors is compared to that with the perfect channel estimation. In addition, the signal-to-noise (SNR) loss due to channel estimation errors is analyzed.