• Particle and aerosol research
• /
• v.12 no.3
• /
• pp.103-107
• /
• 2016

We conducted experiments on mask filters. We measured filtering efficiencies of several new mask filters which were manufactured by disassembling and reassembling of one type of mask filter. New filter (A+C: combination of the first layer and the third layer of the tested mask filter) showed the highest efficiency (97.7%) with the respiratory resistance of 98 pa.

• Journal of the Korean Society of Radiology
• /
• v.9 no.7
• /
• pp.445-448
• /
• 2015

Recently there has been increasing interest in the filter to reduce the proportion of low-energy photons in the polychromatic X-ray, affect the quality of the image quality by X-ray hardening effect is a situation that has been overlooked. In this study, by evaluating the change in FSR based on the filter and it was quantitatively discuss scatter dose affecting the medical image quality. The results of the experiment, as the thickness of the filter is increased, up to 13.9%p, that tends to FSR increases appearance were evaluated. Based on these results, in compliance with the thickness of the filter that has been recommended in KS standard, even while reducing the radiation dose of the patient, in addition to the noise to about 1%p within the FSR only medical image the contribution to it is conceivable. Therefore, even while reducing radiation dose of the patient, in order to improve the quality of the medical image, the use of appropriate filter is considered important.

• Korean Journal of Environmental Agriculture
• /
• v.21 no.3
• /
• pp.172-177
• /
• 2002

Photodegadation rates of carbofuran in aqueous solution were measured under various test conditions mainly following the guidelines of U.S. EPA and OECD. Half-lives of carbofuran in distilled water were 9.7 days. 3.3 days, and 1 hr under natural sunlight, SUNTEST with UV filter, and SUNTEST without UV filter, respectively. Waters from a paddy field accelerated the decomposition by factor of 6. It was confirmed that the use of SUNTEST could shorten the test period of photodegradation.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.40 no.7
• /
• pp.659-666
• /
• 2016

Magnetic disturbance is one of the main factors that deteriorate the accuracy of orientation estimation methods based on inertial/magnetic sensor signals. This paper proposes a parallel Kalman filter(KF) that explicitly detects magnetic disturbances and thus can accurately estimate 3D orientation in magnetically disturbed environments. Due to the parallel nature of the proposed KF, even severe magnetic disturbances only affect yaw estimation, while roll and pitch values remain accurate. Consequently, the proposed KF can be effectively used in various applications that involve magnetically inhomogeneous environments, such as robots, ships, and planes.

• Smart Media Journal
• /
• v.7 no.3
• /
• pp.9-15
• /
• 2018

This paper proposes an optimal gain modification method of the Multichannel Wiener filter (MWF) using speech presence probabilities. Conventional gain modification methods of MWFs have the problem of the increase of speech distortions while reducing residual noises with its relative heuristic approach. However, the proposed optimal gain modification method, derived by solving the unconstrained minimization problem of the probability-involved cost function, reduces amounts of residual noises and signal distortions simultaneously. Through an evaluation of the filtered waveforms and spectrograms, it is verified that the proposed method results in an improved SNR with less signal distortions compared to the conventional MWF.

• Journal of the Institute of Convergence Signal Processing
• /
• v.9 no.4
• /
• pp.321-328
• /
• 2008

In this paper, we propose the hardware architecture of two-dimensional discrete wavelet transform (2D DWT) and quantization for using JPEG2000. Color 2-D DWT processor is proposed that is to apply to JPEG 2000 Hard-wired Encoder. JPEG 2000 DWT processor uses the Daubechies' (9,7) bi-orthogonal filter, and we design by minimizing error of the DWT transformer by ${\pm}1$ LSB during compression and decompression. We designed the DWT filters that using by using shift and adder structure instead of multiplier structure which raise the hardware complexity. It is improve the operation speed of filters and reduce the hardware complexity. The proposed system is designed by the hardware description language Verilog-HDL and verified by Synopsys Design Analyzer using TSMC 0.25${\mu}m$ ASIC library.

• Journal of electromagnetic engineering and science
• /
• v.9 no.1
• /
• pp.7-11
• /
• 2009

An Ultra-WideBand(UWB) Low-Noise Amplifier(LNA) is proposed and is implemented in a $0.18-{\mu}m$ CMOS technology. The proposed UWB LNA provides excellent wideband characteristics by combining a High-Pass Filter (HPF) with a conventional resistive-loaded LNA topology. In the proposed UWB LNA, the bell-shaped gain curve of the overall amplifier is much less dependent on the frequency response of the HPF embedded in the input stage. In addition, the adoption of fewer on-chip inductors in the input matching network permits a lower noise figure and a smaller chip area. Measurement results show a power gain of + 10 dB and an input return loss of more than - 9 dB over 2.7 to 6.2 GHz, a noise figure of 3.1 dB at 3.6 GHz and 7.8 dB at 6.2 GHz, an input PldB of - 12 dBm, and an IIP3 of - 0.2 dBm, while dissipating only 4.6 mA from a 1.8-V supply.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37A no.11
• /
• pp.993-1000
• /
• 2012

In this research, we proposed an efficient VLSI architecture of the lifting-based 2D DWT (Discrete Wavelet Transform) filter with 100% hardware utilization. The (9,7) filter structure has been applied and extendable to the filter length. We proposed a new block-based scheduling that computes the DWT for the lower levels on an "as-early-as-possible" basis, which means that the calculation for the lower level will start as soon as the data is ready. Since the proposed 2D DWT computes the outputs of all levels by one row-based scan, the intermediate results for other resolution levels should be kept in storage such as the Data Format Converter (DFC) and the Delay Control Unit (DCU) until they are used. When the size of input image is $N{\times}N$ and m is the filter length, the required storage for the proposed architecture is about 2mN. Since the proposed architecture processes the 2D DWT in horizontal and vertical directions at the same time with 4 input data, the total period for 2D DWT is $N^2(1-2^{-2J})/3$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.2 s.93
• /
• pp.154-160
• /
• 2005

Microwave Otters are essential device in modem wireless systems. A compact dimension BPF(Band-pass Filter) for IEEE 802.11a WLAN service is realized using LTCC multi-layer process. To extrude 2-stage band-pass equivalent circuit, band-pass and J-inverter transform applied to Chebyshev low-pass prototype filter. Because parallel L-C resonator is complicate and hard to control the inductor characteristics in high frequency, the shorted $\lambda/4$ stripline is selected for the resonator structure. The passive element is located in the different layers connected by conventional via structure and isolated by inner GND. The dimension of fabricated stacked band-pass filter which is composed of six layers, is $2.51\times2.27\times1.02\;mm^3$. The measured filter characteristics show the insertion loss of -2.25 dB, half-power bandwidth of 220 MHz, attenuation at 5.7 GHz of -32.25 dB and group delay of 0.9 ns at 5.25 GHz.

• Journal of Korean Society on Water Environment
• /
• v.22 no.2
• /
• pp.222-229
• /
• 2006

The treatment performance and operational parameters of a tertiary wastewater treatment process a biological filtration system were investigated. The biological filtration system consisted of a nitrification filter (Fiter 1) and a polishing filter with anoxic and aerobic parts (Filter 2). SS, T-C-BOD, and T-N in effluent were kept stable at less than 3, 5 mg/L, and 5 mgN/L, respectively, under a HRT in Filter (filter-bed) of 0.37~2.3 h. T-N at the outlet of Filter 2 were about 1~5 mgN/L under the condition of LV of 50~202 m/d. In Filter 2, denitrification was accomplished under LV of 50~168 m/d in a 1 m filter-bed. However, the denitrification capacity reached the maximum when the linear velocity was increased to 202 m/d. Relationship between increase in microorganism and headloss was clearer in Filter 2. As a result, the denitrification rate increased from 1.0~2.3 kgN/($m^3-filter-bed{\cdot}d$) as the headloss increased. The COD removal rate was 6.0~9.6 kgCOD/($m^3-filter-bed{\cdot}d$) when operated with Filters 1 and 2. These results mean that captured bacteria contributed a part of COD consumption and denitrification. The maximum nitrification and denitrification rate was 0.5 and 4 kgN/($m^3-filter-bed{\cdot}d$) in Filter 1 and 2.The ratio of backwashing water to the treated water was about 5~10 %. In Filter 1, wasted sludge in backwashing was only 0.7~5.3 gSS/($m^3$-treated water). In Filter 2, added methanol was converted into sludge and its value was 8.0~24 gSS/($m^3$-treated water). These results proved that this process is both convenient to install as tertiary treatment and cost effective to build and operate.