• Journal of Advanced Marine Engineering and Technology
• /
• 제36권3호
• /
• pp.378-386
• /
• 2012

For reduction of the amount of CO2 emitted from ships, power generation characteristics of two power generation systems consisting of a high-efficiency permanent magnet synchronous generator and diode bridge rictifiers are discussed in this paper. One of the discussed systems has three-phase stator windings, and the other has two sets of three-phase (six-phase) stator windings to reduce pulsation in the electromagnetic torque and DC current. Experimental results reveal that the power generation efficiency of the system having six-phase stator windings is higher than that of the system having three-phase stator windings for a light load. The maximum power generation efficiency of the system having six-phase stator windings is almost the same as that of the system having three-phase stator windings. For the electromagnetic torque of the system having six-phase stator windings, the width of pulsation is about one-fifth compared to the system having three-phase stator windings.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 추계학술대회 논문집 전력기술부문
• /
• pp.311-313
• /
• 2007

Three phase power flow is commonly considered exclusively for the distribution systems, where single or double phase circuits may be present and loads may not always balanced between the three phases. This paper deals with modelling and analysis of grid connected photovoltaic (PV) system in three-phase power flow, with the consideration of the PV inverter output power limitations.

• Journal of Electrical Engineering and Technology
• /
• 제9권3호
• /
• pp.1080-1088
• /
• 2014

By combining a wind turbine with an energy storage system (ESS), we are able to attenuate the intermittent wind power characteristic making the power derived from a wind farm dispatchable. This paper evaluates the influence of the phase delay of the low-pass filter in the conventional smoothing power control on the ESS capacity; longer phase delays require a larger ESS capacity. In order to eliminate the effect of the phase delay, we optimize the power dispatch using a zero-phase low-pass filter that results in a non-delayed response in the power dispatch. The proposed power dispatching method significantly minimizes the ESS capacity. In addition, the zero-phase low-pass filter, which is a symmetrical forward-reverse finite impulse response type, is designed simply with a small number of coefficients. Therefore, the proposed dispatching method is not only optimal, but can also be feasibly applied to real wind farms. The efficacy of the proposed dispatching method is verified by integrating a 3 MW wind turbine into the grid using wind data measured on Jeju Island.

• 한국전자통신학회논문지
• /
• 제5권5호
• /
• pp.498-503
• /
• 2010

최근, 전력공급의 안정성과 신뢰성 그리고 고품질화를 위해 인터넷을 기반으로 하는 산업용 디지털 분전반이 새롭게 요구되고 있다. 따라서 본 논문에서는 3상 4선식 전력공급방식을 기반으로 하는 산업용 3상 분전반이 설계된다. 그리고 3상 산업용 분전반을 위한 전력관리 모듈이 시험 제작되며, 끝으로, 3상 전구 부하 시험을 통해 시작품의 3상 전압, 전류 측정 기능이 검증된다.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 1999년도 춘계학술대회 논문집
• /
• pp.328-335
• /
• 1999

Three phase full bridge rectifier has been used to obtain dc voltage from three phase ac voltage source. The rectifier system has drawbacks that power factor is low and power flow is unidirectional. Therefore, when dc voltage increases due to regeneration of power the dynamic resister for dissipation of regeneration power must be installed. But three phase PWM converter can be controlled to operate with unity power factor and bidirectional power flow. Therefore when the PWM converter is used as do supply system, the dissipating resistor is not necessary. On this thesis, in order to design a controller having good performance, the hee phase PWM converter is completely modeled by using circuit DQ-transformation and thus a general and simple instructive equivalent circuit is obtained; the inductor set becomes a second order gyrator-coupled system and three phase inverter becomes a transformer as well. Under given phase angle(${\alpha}$) and modulation index(MI) of the three phase inverter, the dc and ac characteristics are obtained by analysis of the transformed equivalent circuit The validity of the equivalent circuit is confirmed through PSPICE simulation. And based on the dc and ac characteristics a controller with unity power factor is proposed.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 B
• /
• pp.1033-1036
• /
• 2002

This paper introduces a control method of series active power filter that compensate harmonic currents and eliminate a neutral line current in 3 phase 3 wire and 3 phase 4 wire power system with harmonic voltage source. These harmonic currents and neutral line current are caused by a nonlinear loads such as diode rectifiers and thyristor converters. Proposed methode extracts a voltage reference directly from performance function without phase transformation. Therefore, the control method is simpler than any other conventional methods. Experimental results for 3-phase 3-wire and 3-phase 4-wire series active power filter system were shown to verify the effectiveness of this control method.

• 전력전자학회논문지
• /
• 제7권3호
• /
• pp.224-236
• /
• 2002

PWM기법의 성능을 비교하고 있다. 랜덤 펄스 위치 PWM기법은 2상 또는 3상 펄스들을 변조 구간내의 임의의 위치에 랜덤하게 배치하고 인버터 스위칭에 의하여 고조파의 스펙트럼을 광역화하는 RPWM기법이다. 시뮬레이션과 실험에 의하여 인버터 출력 전압의 고조파 스펙트럼과 맥동 전류 파형 그리고 모터의 가청 스위칭 소음의 저감 효과를 비교 검토하였다. 스위칭 손실 및 연산시간 그리고 구현의 용이성에서 3상 RPWM보다는 2상 RPWM이 양호하며, 고조파의 광대역화 측면에서는 3상 RPWM이 보다 좋은 성능을 지니고 있음을 알 수 있었다. 또한 가청 스위칭 소음저감은 2상 RPWM과 3상 RPWM이 거의 유사한 성능을 갖고 있음이 확인되었다.

• 전기학회논문지P
• /
• 제66권3호
• /
• pp.99-104
• /
• 2017

The three-phase four-wire power distribution system can be used to supply power to single-phase and three-phase loads at the same time. There are linear loads and nonlinear loads as single-phase loads connected to each phase. The nonlinear load generates a harmonic current during the power energy conversion process. In particular, the single-phase nonlinear load has a higher proportion of generation of the third harmonic current than the harmonics of the other orders. In a three-phase four-wire system, the third harmonic current flows through the neutral wire to the power supply side, affecting the power supply side and the line. Furthermore, the magnitude of the current flowing in the neutral line can be higher than the current flowing in the individual phase. If the neutral current is higher than the phase current, the breaker may be blocked. Therefore, it is necessary to reduce the amount of current flowing in the neutral line by harmonics. There is a method of zigzag connecting a single phase transformer by a method of reducing 3 harmonic current. In this study, the method of reducing the magnitude of the three harmonic currents flowing through the zigzag wire by comparing the polarity and the negative polarity characteristics of the single phase transformer was compared through measurement and simulation.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 제38회 하계학술대회
• /
• pp.187-189
• /
• 2007

In this paper, the cascade 3-phase IHMCL inverter using two low frequency transformers is proposed. The proposed inverter is constructed by connecting a 3-phase IHCML inverter. the cascade 3-phase IHCML inverter has several advantages. One advantage is that only one input power source is required because of using transformers to isolate. Another advantage is that the switching frequency of the high power switches is almost fundamental frequency of reference and the other the switching frequency of the low power switches is higher. It can be known that cascade 3 phase IHCML inverter has the excellent efficiency and the outstanding electric quality. lastly, we tested the 5kW cascade 3-phase IHCML inverter to clarify the proposed electric circuit and reasonableness of control signal for the proposed inverter.

• 한국정보통신학회논문지
• /
• 제26권8호
• /
• pp.1188-1195
• /
• 2022

6-단자 위상 상관기는 동위상 전력 분배기 한 개와 3-dB 90도 위상차 전력 분배기 세 개로 구성된 회로로 입력 신호의 위상을 판별하는 복조 회로에 주로 사용된다. 본 논문에서는 37.5-Ω 동축선 3개를 이용한 광대역 2:1 임피던스 변환 회로 구조의 동위상 전력 분배기와 Wireline 이용한 3-dB 90도 위상차 전력 분배기를 사용하여 광대역에서 동작하는 6-단자 위상 상관기를 제안하였다. 중심 주파수 1000MHz에서 제작된 제안된 광대역 6-단자 위상 상관기는 640~1270MHz 주파수 범위에서 동위상 전력 분배기 입력 신호에 대한 4개의 출력 단자로의 신호 전달 특성(S_i1)은 세기 -6.5±0.6dB와 위상 오차 ±3.4° 이내, 90도 위상차 전력 분배기 입력 신호에 대한 신호 전달 특성(S_i2)은 세기 -6.1±0.6dB와 위상 오차 ±6.2° 이내, 입력 반사계수(S₁₁ and S₂₂) -14dB 이하의 안정적인 값을 가졌다.