• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.1A
• /
• pp.117-132
• /
• 2006

The existing analytical solutions for rectangular plates with three edges clamped and the other free are derived based on nondimensional differential equation and their characteristics are analyzed. Since Timoshenko and Woinowsky-Krieger's method (1959) can give solutions for the case limited to the aspect ratio of the plates less than one, this method are proved to be impractical for the bending moment calculation of the plates under consideration. Horii and Moto's method(1968) are modified by adding stabilizing terms to suppress overflow in the matrix computation, from which the series solution with maximum 150 terms can be obtained. By use of the series solution the convergence of computed bending moments is tested. The modified method can be shown to calculate the deflection properties for the plates with wide range of aspect ratios, but the computed x moment at the corner points formed by the free edge and the clamped edges can not satisfy the boundary condition and the cause of problem is discussed in detail.

• Journal of Korean Society of Steel Construction
• /
• v.12 no.2 s.45
• /
• pp.221-230
• /
• 2000

Checking the stability of anisotropic plates with free edges, it is impossible that buckling loads and modes are found via existing classical methods about various loads and boundary conditions. For solving this problems. finite difference method(FDM) is used to analyze the buckling behaviors for arbitrary boundary conditions. Using FDM, it is difficult to treat the fictitious points on free edges. So, this paper analyzes buckling behaviors of analytic models with one edge free and the other edges clamped and with opposite two edges free and other two edges clamped. The various buckling loads and mode characteristics through numerical results are given for buckling behaviors of anisotropic plates on free edges.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.18 no.3
• /
• pp.225-240
• /
• 2006

In order to calculate bending moments of rectangular plates with three edges clamped the other free subjected to both a uniform load and a triangular load, a finite difference equation for the non-dimensional governing equation are presented and numerical solutions with different aspect ratios and/or number of grid points are analyzed. The finite difference solutions are obtained by use of grid points up to 11,520 and the optimum grid points according to aspect ratios of the plate are presented as well. The obtained numerical solutions are shown to satisfy the given x moment boundary condition at the free edge, which can not be satisfied in Levy's analytical solutions and peculiar behaviour of the calculated moments is observed around the corners between the free edge and fixed ones. The numerical solutions of bending moments subjected to both a uniform load and a triangular load are compared with the corresponding analytical solutions which are shown in very good agreement on the solution domain except the neighborhood of the free edge.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.19 no.4 s.74
• /
• pp.399-406
• /
• 2006

The natural frequencies of Al square plates with a brass inclusion were analyzed by the rule of mixtures. The rule of mixtures is the method to derive natural frequency mutiplying effective inplane wane speed and nondimensional frequency parameters. Numerical models were Al square plates with an inclusion with cantilever type, 2 clamped edge-2 free edge type, 3 clamped edge-1 free edge type and fully clamped edge type. In cantilever type plates, 2 clamped edge-2 free edge type plates and 3 clamped edge-1 free edge plates with an inclusion, good agreement within 10% obtained from rule of mixtures' results and numerical analysis results within inclusion area ratio 1/9. It was found that the natural frequencies of the cantilever type, 2 clamped edge-2 free edge type and 3 clamped edge-1 free edge type plates with an inclusion decrease as the size of inclusion increases when inclusion is located center of plates. And when the density of inclusion is less than the plates, natural frequency of plates with an inclusion increases as the size of inclusion increases.