• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.2 s.117
• /
• pp.105-110
• /
• 2007

In this paper, a microstripline-type linear amplitude equalizer is implemented to achieve the linearity of the slope of the amplitude over $6{\sim}18$ GHz with resistors inserted between their immediate pairs of a TX-line and a stub. The values of resistors and stubs are explored to have the optimal linear slope and return loss performance. Experiments reveal the slope of around 9 dB variation and return loss of less than 10 dB desired over $6{\sim}18$ GHz and validate the design methodology.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.11
• /
• pp.63-70
• /
• 2001

We demonstrate the MMIC (monolithic microwave integrated circuit) frequency doublers generating stable and low-cost 29 GHz local oscillator signals from 14.5 GHz input signals. These devices were designed and fabricated by using the M MIC integration process of $0.1\;{\mu}m$ gate-length PHEMTs (pseudomorphic high electron mobility transistors) and passive components. The measurements showed S11 or -9.2 dB at 145 GHz, S22 of -18.6 dG at 29 GHz and a minimum conversion loss of 18.2 dB at 14.5 GHz with an input power or 6 dBm. Fundamental signal of 14.5 GHz were suppressed below 15.2 dBe compared to the second harmonic signal at the output port, and the isolation characteristics of fundamental signal between the input and the output port were maintained above :i0 dB in the frequency range 10.5 GHz to 18.5 GHz. The chip size of the fabricated MMIC frequency doubler is $1.5{\times}2.2\;mm^2$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.2
• /
• pp.207-212
• /
• 2012

In this work, a 70/140 GHz dual-band push-push voltage controlled oscillator(VCO) has been developed based on a 0.18-${\mu}m$ SiGe BiCMOS technology. The lower band and the upper band oscillation frequency varied from 67.9 GHz to 76.9 GHz and from 134.3 GHz to 154.5 GHz, respectively, with tuning voltage swept from 0.2 to 2 V. The calibrated maximum output power for each band was -0.55 dBm and -15.45 dBm. The VCO draws DC current of 18 mA from 4 V supply.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.6
• /
• pp.816-824
• /
• 1999

Design and performance of 18 GHz phase locked dielectric resonator oscillator(PLDRO) for Point-to-point radio link using analog phase locked loop is described which achieve high stability and low SSB phase noise. The module consists of an 18 GHz voltage controlled dielectric resonator oscillator(VCDRO), buffered amplifier, analog phase detector which are integrated to form a miniature hybrid circuit. In addition, containing a low phase noise VHF PLL has been designed to lock any other conventional N times frequency of crystal oscillator. The module achieves stable phase locked state, exhibits output power of 21 dBm at 18.00 GHz, -34 dBc harmonic suppression and -75 dBc/Hz phase noise at 10 kHz offset frequency from carrier.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.5
• /
• pp.453-458
• /
• 2010

In this work, a 18 GHz divide-by-4 injection-locked frequency divider(ILFD) based on ring oscillator has been developed in $0.13-{\mu}m$ Si RFCMOS technology. The free-running oscillation frequency is from 4.98 to 5.22 GHz and output power is about －30 dBm, consuming 33.4 mW with a 1.5 V supply voltage. At 0 dBm input power, the locking range is 3.5 GHz(17.75~21.25 GHz) and with varactor tuning, the operating range is increased up to 5.25 GHz(16.0~21.25 GHz). The fabricated chip size is $0.76\;mm{\times}0.57\;mm$ including DC and RF pad.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.4
• /
• pp.131-136
• /
• 2008

Two Ka-band 3-stage power amplifiers were designed and fabricated using $0.18-{\mu}m$ CMOS technology. For low loss matching networks for the amplifiers, two substrate-shielded transmission line structures, having good modeling accuracy up to 40 GHz were used. The measured insertion loss of substrate-shielded microstrip-line (MSL) was 0.5 dB/mm at 27 GHz. A 3-stage CMOS amplifier using substrate-shielded MSL achieved a 14.7-dB small-signal gain and a 14.5-dBm output power at 27 GHz in a compact chip area of 0.83$mm^2$. The measured insertion loss of substrate-shielded coplanar waveguide (CPW) was 1.0 dB/mm at 27 GHz. A 3-stage amplifier using substrate-shielded CPW achieved a 12-dB small-signal gai and a 12.5-dBm output power at 26.5 GHz. This results shows a potential of CMOS technology for low cost short-range wireless communication components and system.

• Proceedings of the KSR Conference
• /
• 2010.06a
• /
• pp.2089-2094
• /
• 2010

The importance of broadband wireless communication implemented at subway tunnels is growing up. At 18GHz wireless video transmission system, the transmitter requires a digital modulation method. At subway tunnel, A 18GHz's influence of the multi-pass padding is strong. OFDM digital modulation that is strong for multi-pass padding is recommended. In this paper, Suitable to a subway wireless video transmission OFDM receiver is designed. OFDM receiver system has 6dB gaion because uses diversity of space diversity and MRC(Maximum Ratio Combining) diversity. The transmitter system use C&ITechnologies's transmitter board. IF frequency of receiver is 480MHz. OFDM modulation parameter is as follow, The bandwidth is 8MHz, The numuber of carrier if 2,000, The modulation methode is QAM16, The guard interval is 1/32.

• ETRI Journal
• /
• v.40 no.6
• /
• pp.693-698
• /
• 2018

This paper presents a true-time delay (TTD) using a commercial $0.13-{\mu}m$ CMOS process for wideband phased-array antennas without the beam squint. The proposed TTD consists of four wideband distributed gain amplifiers (WDGAs), a 7-bit TTD circuit, and a 6-bit digital step attenuator (DSA) circuit. The T-type attenuator with a low-pass filter and the WDGAs are implemented for a low insertion loss error between the reference and time-delay states, and has a flat gain performance. The overall gain and return losses are >7 dB and >10 dB, respectively, at 2 GHz-18 GHz. The maximum time delay of 198 ps with a 1.56-ps step and the maximum attenuation of 31.5 dB with a 0.5-dB step are achieved at 2 GHz-18 GHz. The RMS time-delay and amplitude errors are <3 ps and <1 dB, respectively, at 2 GHz-18 GHz. An output P1 dB of <-0.5 dBm is achieved at 2 GHz-18 GHz. The chip size is $3.3{\times}1.6mm^2$, including pads, and the DC power consumption is 370 mW for a 3.3-V supply voltage.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.13 no.3
• /
• pp.1284-1287
• /
• 2012

In this study, we propose the structures of octagonal spiral planar inductors without underpass and via, and confirm the frequency characteristics. The structures of inductors have Si thickness of $300{\mu}m$, $SiO_2$ thickness of $7{\mu}m$. The width of Cu coils and the space between segments have $20{\mu}m$, respectively. The number of turns of coils have 3. The performance of spiral planar inductors was simulated to frequency characteristics for inductance, quality-factor, SRF(Self- Resonance Frequency) using HFSS. The octagonal spiral planar inductors have inductance of 2.5nH over the frequency range of 0.8 to 1.8 GHz, quality-factor of maximum 18.9 at 5 GHz, SRF of 11.1 GHz. Otherwise, square spiral planar inductors have inductance of 2.8nH over the frequency range of 0.8 to 1.8 GHz, quality-factor of maximum 18.9 at 4.9 GHz, SRF of 10.3 GHz.

• Progress in Superconductivity
• /
• v.2 no.1
• /
• pp.51-55
• /
• 2000

A $Y_1Ba_2Cu_3O_{7-\delta}$ square spiral microstrip antenna (YBCO antenna) was epitaxially grown on a $LaAlO_3$ substrate by laser ablation. Also fabricated was a gold square spiral microstrip antenna (gold antenna) having the same structure as that of the YBCO antenna in order to compare the properties of both antennas. Both the YBCO antenna and the gold antenna were operated in Ku (12-18 GHz) band, and their properties such as the return loss, SWR, power gain, and radiation patterns were investigated at 77 K. The return loss below -10 dB was obtained in two frequency ranges, i.e., 14.05-14.90 GHz, and 16-18 GHz for the YBCO antenna at 77 K (YBCO superconducting antenna), and in the frequency range of 15.05-17.60 GHz for the gold antenna at 77 K. The SWR bandwidths are 0.85 GHz and 2 GHz for the YBCO superconducting antenna, and 2.55 GHz for the gold antenna at 77 K. The gain improvement of the superconducting YBCO antenna over the gold antenna at 77 K was about 10 dB in the frequency range of 16 GHz to 18 GHz. The radiation patterns show the YBCO superconducting antenna has the omni-directional property of a spiral antenna.