• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.1
• /
• pp.211-218
• /
• 2000

This paper describes the improvement of broadband radio channel characteristics using a MMSE adaptive equalization technique as a fundamental study of high transmission rates in indoor radio channel. First, the performance of 16-QAM system that employs a MMSE linear adaptive equalizer in Rayleigh fading channel is analyzed. Next, in order to improve broadband radio channel characteristics, we apply an adaptive equalization technique employing the MMSE algorithm to the radio channel measured by using circularly polarized antenna under indoor NLOS(non-line-of sight) environment. Consequently, for 16-QAM with adaptive equalizer, we can achieve the improvement of about 13 dB at $10^{-3}$ error rate as compared with general 16-QAM. Moreover, it was found that the adaptive equalization technique could improve broadband radio channel characteristics over the all measured areas. Also, it was found that the employing both adaptive equalization and polarization diversity technique together could improve broadband radio channel characteristics and reduce fading more effectively.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.12 no.3
• /
• pp.204-215
• /
• 1987

In this paper, 16QAM techniques are described. The evaluated error rate performences are shown in figures as parameters of carrier-to-noise power ratio(CNR), carrier-to-interference power ratio(CIR), impulsive noise index, and Gaussian to impulsive noise power ration. Also, the error rate performances are measured experimentally by hardware system and compared with the theoretical results.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.10
• /
• pp.8-16
• /
• 2010

An orthogonal frequency division multiplexing (OFDM) system is a special case of multicarrier transmission, where a single data stream is transmitted over a number of lower-rate subcarriers. One of the main reasons to use OFDM is to increase robustness against frequency-selective fading or narrowband interference. However, in the radio systems the distortion introduced by high power amplifiers (HPA's) such as traveling wave tube amplifier (TWTA) considered in this paper, is also critical. Since the signal amplitude of the OFDM system is Rayleigh-distributed, the performance of the OFDM system is significantly degraded by the nonlinearity of the HPA in the OFDM transmitter. In this paper, we propose a simplicial canonical piecewise-linear (SCPWL) model based digital predistorter to compensate for nonlinear distortion introduced by an HPA in an OFDM system. Computer simulation is carried on an OFDM system under additive white Gaussian noise (AWGN) channels with 16-QAM and 64-QAM modulation schemes and modulator/demodulator implemented with 1024-point FFT/IFFT. The simulation results demonstrate that the proposed predistorter achieves significant performance improvement by effectively compensating for the nonlinearity introduced by the HPA.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.5
• /
• pp.723-729
• /
• 2011

In this paper, we simulate and evaluate the performance of MIMO systems adopting MMSE-OSUC receiver algorithm under Rayleigh fading channel environment. In the simulation, BPSK, QPSK, 16QAM, and 64QAM modulation is used with frame length of 100 symbols. First, the concept of MIMO is introduced by the analytical basis of the channel capacity of MIMO system. From the performance analysis results, the channel capacity is identified by the function of channel and it is affected by the channel characteristic. Next, based on this approach, the algorithm for performance evaluation over MIMO channel was analyzed. From the performance analysis results, it is found that MMSE-OSUC receiver algorithm generally outperform conventional ZF-OUSC receiver algorithm in performance but the performance difference between the two algorithms is reduced as modulation scheme with larger constellation point is used.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.5
• /
• pp.900-905
• /
• 2008

I perform bit error rate(BER) analysis of orthogonal frequency division multiplexing(OFDM) systems impaired by both direct current(DC) offset and carrier frequency offset. By analyzing the BER performance for real OFDM systems employing 16-quadrature amplitude modulation(QAM) and pilot symbol estimation, the dependency of BER on the DC offset and carrier frequency offset is quantified and compared to ideal performance. Results show that the magnitude of frequency offset and DC offset are required to be less than 0.01 and 0.007, respectively.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1995.10a
• /
• pp.36-40
• /
• 1995

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1987.10a
• /
• pp.130-138
• /
• 1987

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.10
• /
• pp.2247-2253
• /
• 2010

WiBro(Wireless Broadband Internet) is the standard of high-speed portable internet based on OFDMA/TDD (Orthogonal frequency division multiple access / Time division duplexing) techniques, and the subset of consolidated version of IEEE802.16e Wireless MAN standard. In this paper, we propose performance improvements of WiBro system using the LVQ(Learning Vector Quantization) blind equalization. Proposed method used the prefiltering LVQ neural network blind equalization in the Broadband WiBro system receiver. The prefiltering LVQ neural network constellates 16QAM that is transmitter data shape and the blind equalization removes ICI(Inter Carrier Interference). To verificate the proposed method usability, the MSE(Mean Square Error) and the BER(Bit Error Rate) are simulated. The simulation results shown that is improved the performances of the proposed WiBro system using the LVQ blind equalization than the existing WiBro system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.12 no.9
• /
• pp.1638-1645
• /
• 2008

WiBro(Wireless Broadband Internet) is the standard of high-speed portable internet based on OFDMA/TDD techniques, and the subset of consolidated version of IEEE802.16e Wireless MAN standard. In this paper, we propose the design method of WiBro system using the SOFM Blind Equalization. Proposed design method used SOFM neural network blind equalization with Bussgang algorithms in the Broadband 16 QAM WiBro system receiver. To verificate the proposed design method usability, the MSE and the BER are simulated. The simulation results shown that is improved the equalization performances of the proposed WiBro system using the SOFM Blind equalization than the existing WiBro system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.5A
• /
• pp.475-483
• /
• 2006

If channel coefficients errors exist in MIMO-OFDM systems, the performance degradation of systems will occurs. In order to improve the performance of MIMO-OFDM systems, the technique of obtaining accurate channel estimation in multipath fading channel is necessary. In this paper, we introduce and propose new channel estimation-modified ICA algorithm. Simulation results shows from BER and SER curves which compare the proposed algorithm under time-varying Rayleigh fading with perfect known channel. The result of channel estimation by the proposed algorithm in this simulation, it shows that PDF(amplitude of channel) are close to the case with perfect known channel at the receiver with respect to uncoded QPSK/16-QAM/64-QAM modulation. Also, we can see that BER and SER curves are very close to the case with perfect known channel. Therefore, we see that the proposed algorithm have a good performance in MIMO-OFDM systems.