• Journal of Korea Multimedia Society
• /
• v.12 no.9
• /
• pp.1233-1241
• /
• 2009

Over the 50 percents of women who are older than 45 years have osteoporosis. Because people hardly recognize this disease by themselves, the researches that measure bone mineral density have been doing widely to detect osteoporosis in the early stage. The most widely used methods for bone mineral density measurement are based on the X-ray imaging. Among them, DEXA(Dual-energy X-ray Absorptiometry) imaging is one of the important methods in bone mineral density measurement. DEXA images are useful methods to increase diagnosis efficiency by reducing anatomic noise as two images obtained from two different energy levels. However, it has some problems to a calibration parameter determined by the heuristic method for bone extraction. In this paper, we propose the method to extract bone in DEXA image using calibration parameter based on anatomic attenuation coefficient. The experimental results reveal that the proposed method is effective.

• Composites Research
• /
• v.30 no.6
• /
• pp.422-428
• /
• 2017

The moisture absorption behavior, tensile properties, and thermal analysis properties of MWCNT embedded nanocomposites exposed to temperature and moisture were evaluated. The contents of MWCNT were 0 wt%, 1 wt%, and 2 wt%, respectively. The specimens were exposed to immersed conditions at $25^{\circ}C$ and $75^{\circ}C$ for up to 600 hours. According to the results, the apparent moisture content increased as the exposure time increased, but the difference between the maximum moisture content and the moisture content at 600 hours was almost constant. The tensile modulus decreased with increasing exposure time and the degree of decrease was increased significantly as the MWCNT content and exposure temperature increased. The tensile strength decreased with longer exposure time without MWCNT, but increased with MWCNT due to the reinforcing effect of MWCNT. The storage modulus, glass transition temperature, tan d peak magnitude were low as the exposure time increased, but tan d curves with two peaks appeared when exposed to high exposure temperature for more than 300 hours.

• Korean Journal of Optics and Photonics
• /
• v.7 no.2
• /
• pp.129-135
• /
• 1996

We observed the absorptive optical bistability in the single layer amorphous $As_2S_3$ thin film which has an isolated electron pairs at roomtemperature, for the frist time, $Ar^+$ laser beam (λ=514.5 nm) was used as a light source and was focused by thin lens. The experiment was performed in cavityless system and the occurrence of optical bistability in this material could be explained by the temperature-dependent absorption coefficient of the sample. Also, this effect was explained by the reversible shift of the absorption edge in this material. The condition of optical bistability is determined by detuning value ($a_0L$) and this value was 0.12 when thikness of that sample was about 0.8 ${\mu}{\textrm}{m}$. The switching was observed clealy when light intensity is 150~180 mW and the swiching time was about $10^{-4}$ s.

• Magazine of the Korea Concrete Institute
• /
• v.5 no.3
• /
• pp.152-160
• /
• 1993

양생 초기에 있어서 콘크리트의 투수계수는 콘크리트의 건조수축에 영향을 미치는 요인으로서 콘크리트내의 물의 이동과 관련된 중요한 변수이다. 콘크리트의 특수성에 관한 연구는 주로 콘크리트의 건조수축이나, 동결융해에 대한 내구성 등과 연관되어 있다. 이들 대부분의 측정결과는 염소 이온등을 이용한 간접 측정방법이거나 충분히 양생된 안정한 콘크리트를 대상으로 하는 것이 대부분이므로 양생초기의 콘크리트의 투수계수에 관한 연구는 거의 없다고 할 수 있다. 본 연구에서는 싸이크로미터라는 수리에너지를 측정하는 쎈서를 이용하여 콘크리트의 투수계수의 측정을 시도하였다. 콘크리트의 투수계수와 확산계수를 측정하기 위한 세가지의 방법을 제시하였으며, 이를 적용하는 실험도 실시하였다. 또한 투수계수와 확산계수간의 변환을 위한 등온 흡수선을 개발, 적용하였다.

• Korean Journal of Environment and Ecology
• /
• v.14 no.2
• /
• pp.119-126
• /
• 2000

충남 사문암 지역인 광천, 홍성, 백동, 대흥 및 유구지역의 토양, 식물체(참억새, 쑥, 리기다소나무) 및 지표수, 갱내수의 중금속 함량을 분석한 결과 사문암 토양의 Ni, Cr 및 Co 원소가 변성암 토양에 비하여 10~13배높았으며 이 원소들이 serpentine factor로 생각된다 사문암 지역간에는 이들원소의 차이가 뚜렷하지 않았다 변성암 토양식물에서보다 사문암 토양 식물에서 Ni, Cr, Co등이 높았다 리기다소나무의 원소 흡수량은 비교적 낮았고 3종 식물에서 대체로 뿌리의 원소 함량이 지상부 함량보다 높았으며 사문암 토양에서는 Ni, Cr, Co, Mo, Sc, As 및 Fe 원소들이 쑥보다 참억새에서 높았다 사문암 토양에서 생육하는 식물체 지상부의 생물학적 흡수계수는 Ni, Cr, Co, Zn, Sc, As 및 Fe 원소는 참억새에 높고Zn은 쑥에서 높았다,. 사문암 토양에서 뿌리로부터 지상부로의 원소 전이는 Ni, Cr, Co, Zn As 및 Fe 원소에 대해 쑥에서 높았고 Mo와 Sc 원소는 리기다소나무에서 높았다. 따라서 사문암 토양에서 참억새가 중금속의 흡수율은 높고 중금속에 대한 내성은 강할 것으로 사료된다 대흥지역에서 광산의 오염이 지표수 및 갱내수의 Ni. Cr, Co, Zn 및 Fe 등의 원소 농도를 높게 하였으며 비오염 계류는 오염계류의 원소 농도를 희석시켰다.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.18 no.9
• /
• pp.753-760
• /
• 2006

The purpose of the present work is to investigate the influence of the refrigerant adulteration by LiBr solution on the cooling capacity and COP for three different types of abso게tion chillers: a single-effect type, a series-flow double-effect type and a parallel-flow with double-effect type. A simulation program has been prepared for the cyclic analysis of absorption chillers. With some assumptions, the calculations have been performed by solving the mass balance equation, energy balance equation and the state equation simultaneously. The range of the LiBr concentration of refrigerant was 0% to 20% in the present study. For the single-effect absorption chiller, the maximum decrease in the cooling capacity was 10% at the 20% of LiBr concentration. For the double-effect chiller, the capacity was decreased by 11.1% for the parallel-flow type and the series-flow type. Also, the COP was reduced by 3.0% in single-effect, 2.8% in series-flow type (SR=0.4) and 2.3% in parallel-flow type.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.33 no.4
• /
• pp.321-328
• /
• 2009

Shock absorption performances of various rubbers were investigated by using drop impact test. Several types of rubber such as NR, NBR, EPDM, SR and PUR with three respective levels of shore hardness were used for the test. As in the cases, the absorbed impact energies in rubbers were measured under seven different loads against impact energy between 5-80J. The impact absorption efficiencies of the rubbers then were evaluated by means of both single impact energy condition and summation of all impact energy applied condition. As shown in the results, PUR and EPDM have better shock absorption performances than other rubbers. Further analysis was extended to determine a shear modulus of SR through the finite element implementation with Blatz-Ko model. As can be seen, relatively higher level of absorption energy results in a decreasing shear modulus.

• International Journal of Highway Engineering
• /
• v.8 no.2 s.28
• /
• pp.95-104
• /
• 2006

Hysteresis is a common feature exhibited in hydraulic properties of an unsaturated soil. This study focuses on hysteresis observed in a compacted weathered granite subgrade soils based on the pressure plate laboratory tests. It was found that the Soil-Water Characteristics Curve of a soil is hysteretic and unique. The results also show that the wetting and drying curves predicted using the Fredlund and Xing model is quite close to the laboratory-measured results. For a specific matric suction, water content or coefficient of permeability on a wetting curve is always lower than those found on a drying curve.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.55 no.4
• /
• pp.312-318
• /
• 2010

This study was carried out to develop and test a prototype program that recommends the nitrogen topdressing rate using the color digital camera image taken from rice field at panicle initiation stage (PIS). This program comprises four models to estimate shoot N content (PNup) by color digital image analysis, shoot N accumulation from PIS to maturity (PHNup), yield, and protein content of rice. The models were formulated using data set from N rate experiments in 2008. PNup was found to be estimated by non-linear regression model using canopy cover and normalized green values calculated from color digital image analysis as predictor variables. PHNup could be predicted by quadratic regression model from PNup and N fertilization rate at panicle initiation stage with $R^2$ of 0.923. Yield and protein content of rice could also be predicted by quadratic regression models using PNup and PHNup as predictor variables with $R^2$ of 0.859 and 0.804, respectively. The performance of the program integrating the above models to recommend N topdressing rate at PIS was field-tested in 2009. N topdressing rate prescribed for the target protein content of 6.0% by the program were lower by about 30% compared to the fixed rate of 30% that is recommended conventionally as the split application rate of N fertilizer at PIS, while rice yield in the plots top-dressed with the prescribed N rate were not different from those of the plots top-dressed with the fixed N rates of 30% and showed a little lower or similar protein content of rice as well. And coefficients of variation in rice yield and quality parameters were reduced substantially by the prescribed N topdressing. These results indicate that the N rate recommendation using the analysis of color digital camera image is promising to be applied for precise management of N fertilization. However, for the universal and practical application the component models of the program are needed to be improved so as to be applicable to the diverse edaphic and climatic condition.

• Journal of the Korean Chemical Society
• /
• v.45 no.1
• /
• pp.45-50
• /
• 2001

A combined spectrometer which could function as either the absorption spectrometer or the reflectance spectrometer was built and used for the comparison of the applicabilities of the two types of spectrometers. According to the results the sensitivity of the reflectance spectrometry was found to be useful for the quantitative analysis when the concentration of the analyte was too low or the molar absorptivity of the analyte was too small for one to perform the quantitative analysis using the absorption spectrometry.