• Proceeding of EDISON Challenge
• /
• 2015.03a
• /
• pp.627-631
• /
• 2015

유동 교란에 의하여 균일유동이 아닌 자유류가 항공기 날개 표면을 지나면 공력 계수들이 균일 자유류 유동과는 달라진다. 예를 들어, 항공기들의 편대 비행에서 앞의 항공기가 생성한 후류가 뒷 항공기에 영향을 주고, 두 개의 주익을 가지는 Tandem Wing 항공기의 경우 첫 번째 주익에서 발생된 후류가 두 번째 주익의 공력에 영향을 미친다. 본 연구는 NACA0012 익형의 앞쪽에 또 다른 익형을 배치하여 앞 쪽의 익형에서 발생한 후류가 뒤의 익형에 미치는 영향을 익형 사이의 거리에 따라 분석하였다. 앞쪽의 익형에서 발생한 압력계수와 뒤쪽에서 발생한 압력계수의 비교를 통해 후류의 효과가 어떤 영향을 끼치는지 확인 하였고, 두 익형 사이의 거리가 2c일 때 후류의 영향이 거의 없음을 확인 하였다.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 2018.05a
• /
• pp.193-194
• /
• 2018

최근 정부의 RPS(신재생에너지 의무할당제, Renewable Energy Portplio Standard) 확대 시행과 신재생 3020 정책에 맞물려 정부뿐만 아니라 기업체의 신재생에너지 발전설비용량과 발전량의 확대가 요구되는 시점이다. 특히 조류에너지는 환경친화적이며 지속가능한 에너지원으로서 그 관심이 더욱 커지고 있다. 그러나 조류발전 후보지는 유속이 매우 빠르고, 설치가 어려워 그에 따른 제반사항들이 다른 에너지원에 비해 상대적으로 많다는 단점이 있어, 조류발전단지 구축 시에는 후보지를 선정하고 타당성 조사를 수행하는 과정이 매우 중요하다. 따라서 본 논문에서는 최대의 조류에너지를 얻을 수 있는 해역을 선정하여 조류발전단지를 설계하고 후류의 특성을 분석하였다. 먼저 전자해도의 상세 수심 자료를 추출해 상용 프로그램인 ADCIRC 프로그램에 실제 지형을 수치 모형화하였고, 잠재적 에너지 분포가 높은 해역에 1MW급 수평축 조류발전 터빈을 설계하여 적용하였다. 또한 조류발전단지 내의 터빈의 배치 방법(Centered, Staggered Layout)에 따른 후류의 특성을 분석하여 연간 전력 생산량을 계산하였다.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.27 no.4
• /
• pp.273-279
• /
• 2014

In this paper, wind tunnel tests of a scaled wind turbine have been performed to investigate the effects of turbulent intensity of oncoming flow on turbine wake field. The scaled turbine model was carefully designed to satisfy the similarity conditions. The wind velocities and turbulent intensities were measured using hotwire anemometer in order to compare with existing wake model. It was found from the tests that the existing wake models well fit with test results at turbulent flow rather than at uniform flow. Finally modified wake model has been proposed based on the measured data.

• Journal of the Society of Naval Architects of Korea
• /
• v.36 no.3
• /
• pp.15-21
• /
• 1999

The flow characteristics around KRISO 300K VLCC double-body model have been experimentally investigated in a closed-type subsonic wind tunnel. The local mean velocity and turbulence statistics including turbulent intensity. Reynolds shear stress and turbulent kinetic energy were measured using a x-type hot-wire probe. The measurements were carried out at several transverse stations of the stern and near wake regions. The surface flow was visualized using on oil-film technique to see the flow pattern qualitatively. The flow in the stern and near wake region revealed complicated three-dimensional flow characteristics. The VLCC model shows a hook-shaped wake structure behind the propeller boss in the main longitudinal vortex region. The thin boundary layer at midship was increased gradually in thickness over the stern and evolved into a full three-dimensional turbulent wake.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.34 no.6
• /
• pp.1-9
• /
• 2006

본 연구의 목적은 여러 가지 비행 모드 상의 로터 성능을 효율적으로 예측하는 것이다. 헬리콥터의 공력 특성을 예측하기 위한 비정상 source-doublet 패널 기법 기반의 수치 기법을 개발하였다. 후류의 형상 예측에는 시간 전진 자유후류모델이 사용되었다. 점성에 의한 확산을 고려한 후류의 roll-up 모사를 위하여 후류의 doublet 패널은 같은 강도의 와류고리로 대체하여 계산하였다. 후류와 양력면의 충돌 문제는 표면격자 내부에 들어간 와류고리의 포텐셜값을 제거하여 해결하였다. 제자리비행의 해석 시에 나타나는 와류 불안정성의 해결에는 slow starting과 vortex core growth 모델을 사용하였다. 로터 공력 해석 프로그램은 제자리비행과 전진비행에 대한 실험 결과와 비교하여 검증하였으며, 실험치와 일치하는 결과를 얻을 수 있었다.

• Journal of Energy Engineering
• /
• v.14 no.1
• /
• pp.30-36
• /
• 2005

This paper reports the experimental study of the heat transfer characteristics of the wake region behind a cylinder in cross flow. Local heat transfer coefficient was measured from the stagnation point (θ=0°) to 180°, and the variation of Nu in the axial direction along the cylinder was also studied. The results show that the heft transfer rate at the rear (θ=180°) near the duct wall can increase as much as 58% over the 2 dimensional value at the center of the duct. The heat transfer profiles in the wake region also show distinct effects of the aspect ratio and the heat transfer boundary condition.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.40 no.1
• /
• pp.21-29
• /
• 2016

The wake effects behind wind turbines were investigated by using data from a Met Mast tower and the SCADA (Supervisory Control and Data Acquisition) system for a wind turbine. The results of the wake investigations and predicted values for the velocity deficit based on the eddy viscosity model were compared with the turbulence intensity from the Lange model. As a result, the velocity deficit and turbulence intensity of the wake increased as the free stream wind speed decreased. In addition, the magnitude of the velocity deficit for the center of the wake using the eddy viscosity model was overestimated while the turbulence intensity from the Lange model showed similarities with measured values.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.1
• /
• pp.274-284
• /
• 1991

Mean flows and Reynolds stresses through circular and elliptic wire-mesh screens in the wind tunnel are measured by using the hot-wire system, and flow structures are investigated. Flow in the core of the wake are nearly uniform and the shear layer is developed along the edge of the screen The turbulent kinetic energy in the core decreases at the fast rate. However turbulence components are not in local equilibrium in the shear layer. The shear layer of the circular screen develops outward according to the radial mean motion. On the other hand, 3-dimensional transverse mean motion was turned to the main mechanism for the elliptic shape of the wake to be circular at the downstream.

• Aerospace Engineering and Technology
• /
• v.10 no.1
• /
• pp.129-135
• /
• 2011

A study of efficient plume cooling by core water injection type was performed by computational fluid dynamics. A side injection type is well known, on the contrary, a core injection type is not well known. In order to figure out the characteristics of core injection type, several calculations were performed by computational fluid dynamics along various mass flow rates and locations of water injection. On the basis of analysis it was the adequate cooling condition that water mass flow rate to total mass flow rate was two times at least and location of water injections was L/De=1.2.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.35 no.4
• /
• pp.275-280
• /
• 2007

A turbine stage consists of stators and rotors. The stator provides the required inlet flow conditions so that the rotor can produce the necessary power. Passing wakes generated from the trailing edge of the stator make an interaction with the rotor. In the present study, this flow mechanism is investigated using the numerical analysis. In case of a large gap distance between the stator and rotor, the flow can be solved independently. First, only the stator flow field is solved. Second, the rotor flow field is solved including the passing wake characteristics obtained from the stator analysis. The passing wake experiences the shearing as it approaches to the rotor blade leading edge. And it is chopped when it strikes the rotor blade. After that, the chopped wakes becomes the prolongation as it travels downstream. The flow according to the variation of the gap distance is also studied. Pressure jumps due to the passing wakes result in the pressure and lift loss and it gets stronger with the closer gap distance.