• Journal of the Korean Electrochemical Society
• /
• v.18 no.2
• /
• pp.68-74
• /
• 2015

To compare the microstructure and electrochemical properties between two binary alloys (Cr-Si, Ni-Si), two composition of binary alloys with the same capacity were selected using phase-diagram and prepared by matrix-stabilization method to suppress the volume expansion of Si by inactive-matrix. Master alloys were made by Arc-melting followed by fine structured ribbon sample preparation by Rapid Solidification Process (RSP, Melt-spinning method) under the same conditions. Also powder samples were produced by wet grinding for X-Ray Diffraction (XRD) and electrochemical measurements. As predicted from the phase diagram, only active-Si and inactive-matrix ($CrSi_2$, $NiSi_2$) were detected. The results of Scanning Electron Microscope (SEM) and Transmission Electron Microscopy - Energy Dispersive X-ray Spectroscopy (TEM-EDS) show that Cr-Si alloy has finer microstructure than Ni-Si alloy, which was also predictable through phase diagram. The electrochemical properties related to microstructure were evaluated by coin type full- and half-cells. Separately, self-designed test-cells were used to measure the volume expansion of Si during reaction. Volume expansion of Cr-Si alloy electrode with finer microstructure was suppressed significantly and improved in cycle capability, in comparison Ni-Si alloy with coarse microstructure. From these, we could infer the correlation of microstructure, volume expansion and electrochemical degradation and these properties might be predicted by phase diagram.

• Environmental and Resource Economics Review
• /
• v.18 no.4
• /
• pp.637-652
• /
• 2009

We measure and compare inducements of energy consumption in different industry sectors using inter-industry input and output tables of 1995, 2000 and 2005. We also compute the multiplier effects that relate to the directions of future economic effects. Key Findings are as follows. First, we observe continues decreasing linkage effects in all industries over period of 1995 to 2007. Second, backward multiplier of energy consumption were highest in the material related industry and chemical industry. As for inter-industry inducements, the indirect backward multipliers were high in the other industry. Third, the forward multiplier effect of energy consumption were as same as the backward multiplier effect's sectors. The indirect forward multipliers, however, were highest in the material related industry and chemical industry. The above findings show that since implementing pro-environmental policy in 2000s, the industries structure for reducing energy consumption has been transformed.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.116.2-116.2
• /
• 2015

우리는 실리콘 마이크로구조-ZnO 나노막대 피라미드 구조의 제작 및 표면 특성에 대해서 연구했다. 실리콘 마이크로 피라미드 배열을 구성하는 에칭된 기판 위에 임의의 주기적인 계층 구조로 된 ZnO 나노막대를 성장시켰다. 습식 화학 에칭은 피라미드의 Si 미세 구조를 제작하기 위해 사용되며, 산화 아연 나노막대를 $90^{\circ}C$에서 수열 합성 방법으로 성장시켰다. 본 연구에서는 성장 시간과 피라미드 크기에 따라 ZnO 나노막대 길이와 두께를 조절하여 표면적을 넓히는 실험을 진행하였다. 성장시킨 ZnO 나노 구조들은 XRD (X-ray diffraction), FE-SEM (Field Emission Scanning electron microscopy), WCA (Water contact angle)를 통해 특성을 분석하였다. 젖음성 연구를 통해 ZnO 나노구조가 짧고 긴 성장 시간에 따라 친수성과 초친수성임을 확인하였다.

• Composites Research
• /
• v.29 no.4
• /
• pp.151-155
• /
• 2016

Graphene has been a valuable candidate for use as electrodes for supercapacitors. In order to improve the surface area of graphene, three-dimensional graphene was synthesized on porous Ni nanostructure using thermal chemical vapor deposition and microwave plasma chemical vapor deposition. The structural and chemical characterization of synthesized graphene was performed by scanning electron microscopy, Raman spectroscopy, and X-ray photoelectron spectroscopy. It was confirmed that three-dimensional and high-crystalline multilayer graphene onto various substrates was synthesized successfully.

• Journal of the Korean Chemical Society
• /
• v.66 no.6
• /
• pp.436-441
• /
• 2022

Because the nanoporous electrodes has large electrochemical surface areas, extensive studies have been focused on their fabrication methods. In this paper, a method for introducing a nanoporous gold (NPG) structure on the surface of an ultramicroelectrode (UME) using potentiostatic anodization was investigated. A well-defined NPG structure was introduced on the surface of the UME when a potential of 1.3 V was applied in 0.1 M phosphate buffer solution (pH 8) containing 1 M KCl. The anodic oxidation efficiency was investigated by observing the effect of the applied potential, the reaction time, and the size of the electrode on the roughness factor (R_f) of the prepared NPG-UMEs. In a short time of about 10 minutes, NPG-UME with a large R_f value of about 2000 could be prepared, which could be effectively used for electrochemical glucose detection. The results shown in this work are expected to have great applicability when performing electrochemical analysis with a small sample volume.

• Applied Chemistry for Engineering
• /
• v.20 no.5
• /
• pp.536-541
• /
• 2009

Plasma-polymerized acrylic acid films were deposited on Si wafer and KBr pellet by remote plasma-enhanced chemical vapor deposition (PECVD). Effects of plasma power, reaction pressure, indirect plasma method on the growth rate, chemical structure, and chemical bonding state of the films were investigated. Chemical structure and chemical state of the films were characterized by Fourier transformed infrared (FT-IR) spectroscopy and X-ray photoelectron spectroscopy (XPS) analysis and curve fitting technique. Growth rate of the film increased to a saturation value with plasma power of 100 W, but showed the maximum with reaction pressure at 300 mtorr. Whenever W/FM factor (applied energy per gas molecule) increased by increasing plasma power or lowering pressure, the fragmentation of acrylic acid molecules was promoted. From the XPS curve fitting analyses, we found that the intensity of carboxyl COO bonding peak decreased with W/FM factor, and the tendency of intensity change of carboxylic COO peak was contrary to those of ether C-O and carbonyl C=O peaks.

• Clean Technology
• /
• v.30 no.1
• /
• pp.55-61
• /
• 2024

Efforts are actively underway to address the issues related to the high cost of Pt-based catalysts for oxygen reduction reactions by designing high-performance Pt-based alloys through the control of their nanostructures. In this study, a method was proposed to control the nanostructure of Pt-based alloys, either hollow or core-shell, by adjusting the pH of the solution during the galvanic replacement reaction between the carbon-supported nickel-nickel nitride composite and the Pt ions. The physical characteristics, including the state, quantity, and morphology of the metal particles under different preparation conditions, were evaluated through X-ray diffraction, transmission electron microscopy, and inductively coupled plasma. When the prepared catalysts were employed for the oxygen reduction reaction, they exhibited an improvement in area specific-activity compared to a commercial Pt/C, with a 1.7 and 1.9-fold enhancement for the hollow and core-shell structured catalysts, respectively.

• Journal of the Korean Chemical Society
• /
• v.39 no.8
• /
• pp.627-634
• /
• 1995

Layered double hydroxides ($Mg-Al-CO_3$ systems, LDH), which are hydrotalcite-like anionic clay minerals, having different $Mg^{2+}\;to\;Al^{3+}$ ratio were synthesized by coprecipitation method. The subsequent products were characterized by the following methods; elemental analysis, X-ray powder diffraction, thermal analysis (DSC and TGA), FT-IR and $^{27}$Al-MAS NMR. X-ray powder patterns showed that the products formed were layered structure materials. Two heat absorption peaks were observed around 20 ∼280$^{\circ}C$ (surface water and interlayer water) and 280∼500$^{\circ}C$ (water from lattice hydroxide and carbon dioxide from interlayer carbonate) in DSC diagrams, and they were quantitatively analyzed by TGA diagrams (in case LDH4 16.2% and 28.6% respectively). FT-IR spectra indicate that the interlayer carbonate ions occupied symmetrical sites between two adjacent layers in a parallel direction. $^{27}$Al-MAS NMR spectra show only single resonance (8.6 ppm) of the octahedrally coordinated aluminum similar magnesium. When LDH4 was calcined at 560$^{\circ}C$ for 3 hours in air, its layered structure was destroyed giving a mixed metal oxide. However it readily became rehydrated in aqueous chromate solution to its original structure.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.25 no.5
• /
• pp.368-376
• /
• 2005

Coolant rubber hoses for automobile radiators can be degraded and thus failed due to the influence of contacting stresses of air and coolant liquid under thermal and mechanical loadings. In this study, for EPDM(ethylene-propylene diene monomer) rubber conventionally used as a radiator hose material the aging behaviors of the skin part due to thermo-oxidative and electro-chemical stresses were nondestructively evaluated. Through the thermo-oxidative aging test, it was shown that the surface hardness IRHD(International Rubber Hardness Degrees) of the rubber increased with a considerable reduction of failure strain. On account of the penetration of coolant liquid into the skin part the weight of rubber specimens degraded by electro-chemical degradation(ECD) test increased, whereas their. failure strain and IRHD hardness decreased largely. The penetration of coolant liquid seemed to induce some changes in inner structure and micro hardness distribution of the rubbers. Consequently, EPDM rubbers degraded by thermo-oxidative aging and ECD could be characterized nondestructively by micro-hardness and chemical structure analysis methods.

• Journal of the Korean Chemical Society
• /
• v.60 no.1
• /
• pp.93-98
• /
• 2016