• The Journal of Engineering Geology
• /
• v.26 no.3
• /
• pp.353-360
• /
• 2016

Tests of hydraulic rock splitting were conducted using double packer at the 1, 2 free surface in the limestone mining and granodiorite Suksan area, respectively. The method of hydraulic rock splitting was applying hydraulic power in the interval layer using double packer. As a result of tests, a crack occurred. At about 6.5 MPa and 13 MPa, a crack occurred in 2 free surface. Any crack did not occur in the 1 free surface. Rather, used 1 double packer was broken in the 1 free surface. Also, it was confirmed that the water pressure of the interval increased through the existing crack and the new crack in the test areas.

• Journal of the Korean Geotechnical Society
• /
• v.15 no.6
• /
• pp.155-165
• /
• 1999

In completely weathered granite gneiss,8 of 40cm cast-in-situ concrete piles are constructed, and static pile load tests are executed on the piles to study the bearing behavior of rock-socketed piles. Subsurface explorations are carried out on the test site in three phases, in which 14 borehole investigations as well as the seismic investigation are performed. Rock socketd depths of the piles in the weathered rocks are varied as 3m, 6m and 9m to separate the shaft resistance from the end bearing resistance, and for a couple of piles, styrofoam of 10cm thickness is installed under the pile point to eliminate the effect of the end resistance. Strain gages are instrumented on re-bars to pick-up the transferred loads along the pile length. From the results of the pile load tests, the allowable shaft resistance and the allowable end bearing values of weathered rocks are proposed as $8.6t/m^2\;and\; 84t/m^2$, respectively. The empirical equation relating the elastic modulus of rock mass with the uniaxial compressive strength of the rock specimen is also proposed for the weathered rocks.

• Tunnel and Underground Space
• /
• v.17 no.1 s.66
• /
• pp.43-55
• /
• 2007

An underground research tunnel, KURT, was constructed at Korea Atomic Energy Research Institute, for various in situ validation experiments related to the development of a high-level radioactive waste disposal system. KURT, which has length of 255 m (access tunnel 180 m and research modules 75 m) and size of $6m{\times}6m$ was excavated in a cryatalline rock mass. In the KURT project, different rock mechanics studies had been carried out during the concept design, site characterization, detailed design, and construction stages. From the geophysical survey, borehole investigation, and rock property tests in laboratory and in situ, the rock and rock mass properties required for the mechanicsl stability analysis of KURT could be achieved and used for the input parameters of computer simulations. In this paper, important results from the rock mechanics studies at KURT and the three-dimensional mechanical stability analysis will be introduced.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.875-883
• /
• 2008

The amount of granite distribution area occupies about 40 - 50% of Korean Peninsula. The granite irregularly Intruded through preCambrian to Tertiary times but in Jurassic time so called, Daebo granite most widely crops out in Korean Peninsula. In addition to Bulkuksa Grante which intruded at Cretaceous time crops out at the southern part of Korean Peninsula and in northern part Triassic Songrim Granite is distributed. These granites have equigranular texture and are relatively isotropic. Their uniaxial compressive strength is above $1,500kg/cm^2$ and also seismic velocity is over 2,000m/sec. When these rocks receive a weathering action, the feldspar weathers first and the quartz grains remain plentifully to make the "Masato(Korean name)". Also when the granite receives a weathering action, quite often it make sheeting joint which is topographically parallel to the earth surface and also make a (so called, onion structure. These weathering phenomena easily make a land sliding when it is heavy rain and weathering surface is irregular.

• Tunnel and Underground Space
• /
• v.19 no.3
• /
• pp.213-225
• /
• 2009

The purpose of the study is to evaluate the effects of chemical weathering on the granite and orthogneiss in Wonju area based on accelerated artificial chemical weathering. The rock samples were scrutinized the variation of index properties and ion exchanges caused by artificial chemical weathering which was implemented with leaching test for 170 days using double soxhlet extractor. The differential weathering and decrease of p wave velocity were obtained by weathering process without significant changes of porosity. In case of granite samples, the uniaxial compression strength was reduced by 20% and 16% for the F-grade and SW-grade, respectively. For MW-grade granite, however, was not able to examine the effect of strength reduction due to lack of sample number. Also, for orthogneiss, it is difficult to compare the values of uniaxial compressive strength between before and after the test because of its strong anisotropy.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.04a
• /
• pp.119-122
• /
• 2004

농어촌연구원 내 화강암질편마암지층에 2차에 걸쳐 3공에 대한 공압파쇄 시험 결과 B-1공은 점토성분의 파쇄대 충진으로 수량이 도리어 감소하였다. 공압파쇄 시험 중 파쇄 도달거리를 측정한 결과, P-2 공은 50m 거리에 위치한 B-1공에서의 공압파쇄시험 중에는 약 0.6m의 수위상승이 있었고, 20m 거리에 위치한 B-2공에서의 공압파쇄시험 중에는 약 3.1m의 수위가 상승하였다. 이는 공압파쇄의 유효거리가 암반층에서는 6～15m 정도라고 알려져 있으나 파쇄구간의 발달 정도에 따라 50m 이상 압축공기가 전달됨을 알 수 있다.

• Tunnel and Underground Space
• /
• v.19 no.4
• /
• pp.304-317
• /
• 2009

Most crystalline rocks have much higher compressive strength than tensile strength and show brittle failure. In-situ rock mass, strong enough in general sense, often fails in brittle manner when subjected to high stress exceeding strength in due of geometrically induced stress concentration or of high initial stress. Therefore, it is necessary to verify the brittle failure characteristics of rock and rock mass for proper stability assessment of underground structures excavated in great depths. In this study, damage controlled tests were conducted on biotite-granite and granitic gneiss, which are the two major crystalline rock types in Korea, to obtain the strain dependency characteristics of the cohesion and friction angle. A Cohesion-Weakening Friction-Strengthening (CWFS hereafter) model for each rock type was constructed and a series of compression tests were carried out numerically while varying confining pressures. The same tests were also conducted assuming the rock is Mohr-Coulomb material and results were compared.

• The Journal of Engineering Geology
• /
• v.24 no.4
• /
• pp.473-486
• /
• 2014

The objective of this study is to produce the rock slope hazard map on the Mt. Hwangryeong located at center of Busan Metropolitan City for evaluating the rock slope hazard susceptibility. The Mt. Hwangryoeng is located between Dongrae and Ilkwang faults and consists of various rocks such as sedimentary rock, andesitic volcanic rock, andesite, gabbro and granitic rocks. Thematic maps were carried out using ArcGIS for Database including the orientations and density of joints, strength of rock constructed through the field survey and results from previous studies. Also, rock slope hazard susceptibility for the Mt. Hwangryoeng area was studied using empirical method through checklists proposed by NDMI (National Disaster Management Institute). Results from using the empirical method indicated that rock slopes are evaluated from very stable to stable, but moderate stability has been partially presented along the edge of the mountain area.

• The Journal of Engineering Geology
• /
• v.13 no.2
• /
• pp.171-191
• /
• 2003

The objective of this present study is to understand long term(500 years) thermohydromechanical interaction behavior on joints adjacent to a repository cavern, when high level radioactive wastes are disposed of within discontinuous granitic rock masses, and then, to contribute this understanding to the development of a disposal concept. The model includes a saturated discontinuous granitic rock mass, PWR spent nuclear fuels in a disposal canister surrounded with compacted bentonite inside a deposition hole, and mixed bentonite backfilled in the rest of the space within a repository cavern. It is assumed that two joint sets exist within a model. Joint set 1 includes joints of $56^{\circ}$ dip angle, spaced 20m apart, and joint set 2 is in the perpendicular direction to joint set 1 and includes joints of $34^{\circ}$ dip angle, spaced 20m apart. The two dimensional distinct element code, UDEC is used for the analysis. To understand the joint behavior adjacent to the repository cavern, Barton-Bandis joint model is used. Effect of the decay heat from PWR spent fuels on the repository model has been analyzed, and a steady state flow algorithm is used for the hydraulic analysis.

• The Journal of Engineering Geology
• /
• v.2 no.1
• /
• pp.19-35
• /
• 1992

aThe elastic properties of the fault zone (width; 3~12m), the shattered zone (width; over 40m) and the fresh rock zone distributed under the core foundation of fill dam in granitic gneiss have widely different range. The deformation moduli of the fresh rock zone, the fault zone and the shattered zone obtained from in situ rock tests - Plate Load Test and Bore Hole Deformation Test - show a range of $42,000~168,000kg/\textrm{cm}^2,{\;}963~2,204kg/\textrm{cm}^2{\;}and{\;}1,238~2,098kg/\textrm{cm}^2$, respectively. The differential settlements hetween the fault zone and the fresh rock zone are expected after the dam construction. Therefore, the displacement of foundation and concrete fill are evaluated using FEADAM 84 program of finite element analysis. The geometric distribution of discontinuifies obtained from the site mapping and drilling is considered in the finite element analysis. The analysis shows that the differential settlements between the fault zone and the fresh rock zone is about 6cm, while that of concrete fill is within 0.5cm.