• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.4
• /
• pp.9-16
• /
• 2000

This paper shows the performance of a multiuser detection DS-CDMA receiver based on of the hybrid scheme of parallel interference cancellation (PIC) and successive interference cancellation (SIC). The proposed hybrid interference cancellation is presented and is compared with existing PIC, SIC and Hybrid It of other type schemes. The performance criteria used for comparison are complexity, delay and average bit error rate (BER) performance obtained by simulation in Rayleigh-fading channel (Jake's model) with additive white Gaussian noise (AWGN). In the proposed hybrid IC, the BER performance approximates the one of SIC and the delay is half of the SIC. And the number of cancellation of the hybrid It is reduced about a fourth.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.217.1-217.1
• /
• 2010

본 연구에서는 실제 천연가스 구성성분인 메탄 (90%)+에탄 (7%)+프로판 (3%) 혼합기체를 사용하여 심해저 퇴적부에 존재하는 천연가스 하이드레이트 개발과 가스 하이드레이트 형성법을 이용한 천연가스 수송 및 저장법 개발을 위한 열역학적 특성을 살펴보았다. 천연가스 하이드레이트 개발 연구에서는 심해저 퇴적층의 영향을 살펴보기 위해 기공의 직경이 6.0, 15.0, 30.0, 100.0 nm인 다공성 실리카 젤을 사용하여 기공 직경에 따른 3상(하이드레이트 (H)-물 (LW)-기상 (V)) 평형을 측정하였다. 천연가스 하이드레이트 수송/저장법 연구에서는 천연가스 하이드레이트 형성 압력을 낮추어 줄 수 있는 열역학적 촉진제인 TBAB(농도: 5, 10, 40, 60 wt%)와 THF(농도: 1, 5.56, 10 mol%)를 첨가하여 각각의 농도에 따른 혼합 가스 하이드레이트의 3상 평형을 측정하였다. 그 결과 다공성 매질인 실리카 젤의 경우 기공 직경의 크기가 작아질수록 벌크상태의 하이드레이트에 비해 평형 온도는 낮아지고, 평형 압력은 높아져 저해효과가 커짐을 알 수 있었고, 열역학적 촉진제를 첨가했을 경우 TBAB의 농도가 40 wt%, THF의 농도가 5.56 mol%일 경우 촉진 정도가 가장 크게 나타났으며, 그 이상의 농도일 경우 가스 하이드레이트 형성 반응에 참여하지 않은 TBAB와 THF에 의해 오히려 촉진 정도가 감소하는 것을 알 수 있었다. 또한 $^{13}C$ NMR 분석을 통해 혼합 가스 하이드레이트의 격자 형성과 기체 포집에 따른 구조적인 변화에 대해서도 살펴보았다.

• Journal of the Korean Institute of Gas
• /
• v.7 no.4 s.21
• /
• pp.14-19
• /
• 2003

Generally the accident by gas explosion in the working place is occurred at the condition of non-uniform mixture rather than uniform one. This study could predict the explosion phenomenon of non-uniform mixture with model explosion chamber which realize various practical conditions As a result, the mixing level of gas in the chamber depends on discharge area and velocity when there is gas discharge in certain space. In addition, as non-uniform increases, explosion pressure and its increasing rate decrease. However, firing risk after the explosion flame by infrared heat increase due to the increase of residence time of flame.

• Journal of the Korean Geotechnical Society
• /
• v.28 no.10
• /
• pp.79-88
• /
• 2012

Small amount of salt and various microorganisms are contained in natural soils or clays near the shore. In this study, most common clay minerals such as kaolinite and bentonite are used to evaluate the effect of salt and microorganism on liquid and plastic limits. The effect of time after mixing clays with water was also investigated for the consistency limits of clays. The test was conducted immediately, 1 day, or 7 days after mixing soils. For liquid limit tests two different test methods were used, the percussion cup method by Casagrande and the fall cone method. When sea water or microbial solution was used for mixing soils rather than distilled water, the liquid limit of kaolinite decreased by 6-15% and that of bentonite further decreased up to 37-53%. The liquid limit obtained from the fall cone method was approximately 10% for bentonite and 20% for kaolinite, which are higher than those from the percussion cup method. The effect of time on liquid and plastic limits was significant for those tested immediately or 1 day later but the values obtained after 1 day or 7 days did not vary a lot, regardless of soils, mixing waters or test methods.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.12 no.2
• /
• pp.72-81
• /
• 2004

For disposal food wastes which is about 30% portion of tatal organic wastes, vermicomposting is more environmental-friendly treatment than lanfill, incineration, etc. Recently, the interest has been increasing but there are many problems on management of vermicopmposting in field especially. This study was conducted to investigate an optimal factors, which are limit NaCl conc., the mixing rate of food wastes and casting for growth of an earthworm related to efficient vermicomposting. The limit conc. of NaCl was 0.5% and in case of feeding food wastes to earthworms as a prey only, most earthworms were dead in a few hours due to excessive degradation of organic materials and high NaCl conc. However as feeding with the casting of proper mixing rate(3:7), most earthworms were survived until finishing composting. It was investigated the increaser degree of matureness of food wastes, the higher conc. of NaCl, therefore for efficient vermicomposting, it seemed proper mixing rate of food wastes and the casting is better than matureness of food wastes. and the most suitable mixing rate was 3:7 food wastes and the casting.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.2 no.3
• /
• pp.165-174
• /
• 2004

In order to simultaneously vitrify the ion exchange resin(IER) and combustible dry active waste(DAW) generated from Korean nuclear power plants, a vitrification pilot test was conducted using an induction cold crucible melter(CCM) . The energy necessary for startup of the glass using a Ti-ring was evaluated as about 290 kWh. The power supplied from a high frequency generator to melt the glass properly was ranged from 160 to 190 kW without any interruption. When the mixture of the IER and DAW was fed into the CCM, the concentration of CO was lowered up to 1/40 compared to feeding the IER solely. It may be caused by the DAW which can produce about 1.8 times higher heat compared to the IER. When the swelling phenomenon occurred in the glass melt, the concentration of $NO_2$, oxidizing gas, was higher than NO, reducing gas. Total feed amounts of the IER and DAW were 368 and 751 kg, respectively. And then, about 74 of volume reduction factor was achieved.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.46 no.6
• /
• pp.739-743
• /
• 2017

Product distribution and consumption in the military is difficult due to unique contracts and supply systems. It is difficult to change suppliers immediately when quality problem is encountered. Due to these special circumstances, the quality of products must be thoroughly controlled. Sesame oil is used to increase the taste and nutrition of food, but it is more expensive than other cooking oils. Oil producers may blend other cooking oils with sesame oil to make higher profits, so it has become important to identify good and bad products. In this study, pure sesame oil and blend oils were compared by analyzing their smell, taste, chemical components, and near infra-red spectra to determine quality differences between them.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.15 no.3
• /
• pp.178-185
• /
• 2011

Recently depletion of natural resources makes a deficiency of sand aggregation in the concrete works. In this study, the quality characteristics of concrete and aggregate according to blending fine aggregate in the river sand and the crash sand was analyzed by Normal method and Driscoll method which has used mixing of fine aggregate for asphalt mostly. Application of Discoll method to blend fine aggregate for concrete was studied in the first step to blend fine aggregates concrete. The fineness modulus, grading, slump, air content and compressive strength were tested by the two method, the results of Driscoll method was very similar to degree of err limits in comparison with those of Normal method in the same condition. As a result, Driscoll method is reasonable to use the fine aggregates mixture for concrete in river sand and crash sand.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.2
• /
• pp.8-15
• /
• 2004

This paper presents a method of improvement of color mixing in an RGB LED white lamp. The deviation from white light after RGB color mixing results mainly from the difference in the ray direction among LEDs. The authors propose a method using tilted lenses covered over each LED to deflect the overall direction of the ray generated from far-sited LEDs toward the center axis of the lamp. The degree of improvement is evaulated using a color discrimination method based on McAdam ellipse.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.12A
• /
• pp.1787-1795
• /
• 2000

이 논문에서는 레일레이 감쇄 채널에서 타이밍 또는 위상 오류를 갖는 혼합 간섭 제거 기법을 이용한 DS/CDMA 시스템의 평균 비트 오류 확률을 분석한다. 유도한 결과를 타이밍 또는 위상 오류를 갖는 일반 상관 수신기의 평균 비트 오류 확률과 비교 분석한다. 평균 비트 오류 확률은 정규 근사법을 이용하여 유도하며, 칩 시간에 대한 타이밍 오류의 비, 위상 오류의 정도, Eb/No에 따라 혼합 간섭 제거 기법을 이용한 수신기의 성능을 분석한다. 혼합 간섭 제거 기법을 이용한 수신기의 평균 비트 오류 확률은 타이밍 또는 위상 오류에 의해 증가하나 타이밍 또는 위상 오류가 작은 경우 오류가 없는 일반 상관 수신기에 비해 성능이 크게 개선된다.