• Applied Chemistry for Engineering
• /
• v.22 no.2
• /
• pp.203-208
• /
• 2011

Dumping of wastes at sea will be strongly prohibited from 2012 by London Dumping Convention. So, finding the method for treatment of food waste at ground is needed urgently. The solution for above mentioned problem is the resource development from food waste leachate by using Upflow Anaerobic Sludge Blanket (UASB) process. In this research, we try to find out the effect of effluent recirculation and internal return influence on organic removal efficiency and biogas production. Laboratory investigation was conducted for 25 days with only internal recycling, and then, effluent recirculation was performed. As the result of experiments, the organic removal efficiency was above 90%, and the content of methane was 78~80% during operating time. Also, when UASB reactor was operated to over the 3 Q effluent recirculation, there was not 1 N-NaOH consumption any more, therethrough the experiment was economically and stably carried out.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2011.05a
• /
• pp.251-251
• /
• 2011

해양 투기가 금지되면서 혐기소화를 통해 최종적으로 발생되는 폐기물 양을 줄이고 메탄 등의 바이오 가스를 얻어 이를 에너지로 얻기 위한 많은 공정들이 현장에 적용되고 있다. 하지만 혐기 소화 과정을 마친 후 유출되는 유출액은 고농도의 유기물질 및 암모니아성 질소, 인산염 등을 다량으로 함유하고 있어 적은 양이라도 하천이나 호수 등에 유입되면 수질 악화와 부영양화를 초래할 위험성이 크다. 이번 연구에서는 음식물류 폐기물로부터 바이오가스를 생산하기 위한 혐기소화 공정에서 발생하는 유출액의 방류수 수질기준 확보와 경제성을 만족시킬 수 있는 처리공정의 상용화 기술을 개발하기 위해 생물학적 처리， 물리 화학적 처리를 통합한 공정을 적용하였다. P건설사 혐기소화 유출액 pilot plant(1 ton/day) 운전 결과 50~70% 로 $NO_2$-N 이 약 1,000 mg/$\ell$정도로 축적되는 현상을 보였으며 상대적으로 $COD_{Cr}$의 농도는 400~600 mg/$\ell$로 C/N 비가 낮아 탈질이 어려울 것으로 판단하였다. 이에 실험실 규모에서의 실험을 진행하였다. $NO_2$-N와 $NO_3$-N을 기준으로 McCarty 양론비 기준 80% 에서 300%까지 메탄올을 주입해 제조 폐수와 실제폐수로 실험을 진행하였고 제조폐수로 실행된 실험에서 아질산 탈질의 효율을 확인하였다. 미생물이 메탄올에 순응 후 완전 탈질에 걸리는 시간은 약 2.5 일로 확인 되었으며 메탄올이 추가로 주입되지 않은 반응조의 $NO_2$-N의 탈질량은 메탄올이 이론값 100% 주입 된 반응조에 비해 30% 이하의 처리 효율을 나타냈다. 이론값을 기준으로 메탄올이 100% 주입된 반응조는 약 96.1%의 탈질 효율을 보였으며 메탄올 순응 후에 약 1.5 일의 HRT가 단축되었기 때문에 메탄올에 장시간 순응 시 탈질 효율이 더 좋아질 것으로 보인다. 아질산탈질에 대한 실험실 규모 연구결과를 토대로 pilot plant에서 재현성 검토를 목적으로 운전을 수행하였다. 무산소조의 HRT는 2.7 일 이었으며 호기조의 HRT는 4.1 일 이었다. 유입수의 평균 $COD_{Cr}$ 농도는 2,878 mg/L, T - N 농도는 2,723 mg/L로 나타났으며 $NO_2$-N 기준 C/N비 1.2-1.8의 메탄올을 주입하였을 때 96% 이상의 탈질율을 보였다.

• Environmental and Resource Economics Review
• /
• v.21 no.1
• /
• pp.175-210
• /
• 2012

As London and post-Koyto protocols presumably affect emission of organic waste in Korea in 2012, appropriate treatment of organic waste becomes very important. Organic wastes are regarded as non-point pollutants. It has been criticized that direct emission charges on the emission of non-point pollutants are not effective due to the high uncertainty in the relationship between pollution sources and pollution levels. This study suggests indirect emission charges on production of livestocks or consumption on foods. Furthermore, it is assumed that revenue from the emission charges will be recycled to support biogas production. Biogas can be fueled to produce energy. In order to evaluate potential economic and environmental impacts of recycling the indirect emission charges on organic wastes, a static CGE model was developed. Simulation results of emission charges on the production of livestock show that livestock, agriculture, and food industry will confront relatively high burden while emission charges on consumption of food will affect more broadly and consumers will suffer more. Production charge on livestock sector will lead to higher reduction in GDP and total expenditure relative to the consumption charge. GHGs reduction effect was higher for the consumption charge relative to the production charge. Synthetically, consumption charge on food sector is more desirable as an alternative charge for the emission of organic wastes.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.27 no.1
• /
• pp.77-85
• /
• 2019

Biogasification is a technology that uses organic wastes to reproduce as environmental fuels containing methane gas. Biogasification has attracted worldwide attention because it can produce renewable-energy and stable land treatment with prohibit from landfilling and ocean dumping of organic waste. Biomethane is produced by refining biogas. It is injected into natural gas pipeline or used transportation fuel such as cars and buses. 90 bio-gasification facilities are operating in 2016, and methane gas production is very low due to it is limited to organic wastes such as food waste, animal manure, and sewage sludge. There are seven domestic biomethane manufacturing facilities, and the use of high value-added such as transport fuels and city-gas through upgrading biogas should be expanded. On the other hand, the rapid biogasification of organic wastes in domestic resulted in frequent breakdowns of facilities and low efficiency problems. Therefore, the problem is improving as technical guidance, design and operational technical guidance is developed and field experience is accumulated. However, while improvements in biogas production are being made, there is a problem with low utilization. In this study, the problems of biomethane manufacturing facilities were identified in order to optimize the production and utilization of biogas from organic waste resources. Also, in order to present the design and operation guideline of the gas pretreatment and the upgrading process, we will investigate precision monitoring, energy balance and economic analysis and solutions for on-site problems by facility.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.35 no.2
• /
• pp.93-101
• /
• 1999

A simple experimental method was used in an attempt to realize the elevation of the fishing ability of purse seine in the sea area of Cheju Island, the changes of seine volume and tension in the purseline during pursing. Experiments carried out on the six types simplified reduced model seines which were made of knotless nettings. The nettings were woven in different leg length 4.3, 5.0, 5.5, 6.0, 6.6 and 7.7mm of polyester 28 tex two threads two-ply twine, and each of the seines were named I, II, III, IV, V and Ⅵ seine. Dimension of seine models were 450cm for corkline and 85cmfor seine depth, each seines rigged up 160g of float for a floatline and 50g (underwater weight) of lead for a leadline. These model purse seines were made of the scale of 1/200 of its full scale, a 120 ton in the near sea of Cheju Island. Designing and testing for the model purse seines were based on the Tauti's law. Experiments were measured in the observation channel of a flume tank at the static conditions set up shooting and pursing equipments. Motion of purse seine during purse line was recorded by the two sets video camera for VTR which were placed in top and front of the model seine. The reading coordinate of seine volume carried out by the video digitization system, disk data for the purseline tension. An analysis were performed on the changes seine volume and tension in the purseline during pursing. The results obtained were as follows: 1. The seine volume during pursing was largest for Ⅵ seine with smallest d/l followed by V, IV, III, II and I seines, and tension in the purseline was small. 2. Seine volume during pursing can be expressed by the following equation; CVt=l-EXP[｛2.79 (d/l）＋0.35｝t-33.37 (d/l) ＋ 0.57] Where CVt is volume ratio, d is twine diameter, l is leg length and t is pursing time (sec). 3. Tension in the purse line during pursing can be expressed by the following equation; T= 1- EXP ｛0.57t ＋ 13.36 (d/l)+2.97｝ Where T is tension (kg) in the purseline during pursing.

• Analytical Science and Technology
• /
• v.32 no.6
• /
• pp.243-251
• /
• 2019

Microplastics (MP) are found in large quantities in the oceans, posing a major threat to the ecosystem. In Korea, MPs have been reported to be detected in sea salts. In order to analyze MPs, information on their composition, size, and shape is required. FT-IR microscopy is used frequently to measure sizes larger than 20 ㎛. Recently, however, Raman microscopy, which can analyze ultrafine plastics below 20 ㎛, has been applied extensively. In this study, 10.0 g samples of commercially available salts were dissolved and filtered through a 45 ㎛ mesh filter with a size of 25.4 mm × 25.4 mm. These filtered samples were then analyzed by both FT-IR microscopy and Raman microscopy. A total of four MPs, including three polyethylene (PE) of size 70-100 ㎛ and a polypropylene (PP) of size 170 ㎛, were detected by FT-IR microscopy, while 10 MPs, including nine PE of size 10-120 ㎛ and one polystyrene (PS) of size 40 ㎛, were detected by Raman microscopy. Approximately, 1,000 MPs/kg was estimated, which was almost two times higher than the previous reported levels (~550-681 particles/kg in sea salts); this is because Raman microscopy can detect much smaller MPs than FT-IR microscopy. A total of 113 particles were found using Raman microscopy: Carbon (35, 31.5 %), minerals (28, 25 %), and glass (16, 14.4 %) were dominant, forming around 70% of the total, but MPs (10, 8.8 %) and cellulose (5, 4.5 %) were also found. Raman microscopy has great potential as an accurate method for measuring MPs, as it can measure smaller size MPs than FT-IR microscopy. It also has a reduced sample preparation time.

• Journal of the Korean Institute of Traditional Landscape Architecture
• /
• v.38 no.1
• /
• pp.92-102
• /
• 2020

The followings are the landscape preference aspects from the 816 landscapes(景, Kyung), which comprise the 78 modern Palkyungs, presented by the 78 local governments in Korea. First, the natural environment elements selected as Kyung(景), which are topographical landscapes, mostly consist of mountain elements such as mountains, terrace(臺), rocks and stones and water elements classified as rivers, oceans, and lakes. Natural elements also include old-growth and giant trees such as pines, ginkgos, Japanese cornels and fringe trees, tree-lined streets and forests, and plant elements such as azaleas, rhododendrons, lotuses, reeds, and silver grasses which provide seasonal landscapes. Second, more than half of Kyung, selected as human environment elements, are historical and cultural heritages such as graveyards, mountain fortresses, town fortresses, traditional villages, pavilion in villas, and temples. And it is followed by leisure tourism facilities such as traditional markets, exhibition halls, theme parks, beaches, and food streets, green-based structures such as trails, plazas, parks, and botanical gardens, and industrial heritages such as ranches, abandoned coal mines, stations, ports and bridges. Third, modern Palkyungs include objects not related to the views such as local representative facilities, regional products, and festivals. Fourth, although most of the modern Palkyungs consist of eight, some include 20, 38, or 100 in order to increase the number of objects of public relations. Fifth, a certain local government makes two modern Palkyungs with different subjects by introducing traditional Palkyung and modern Palkyung altogether. In this case, it presents several modern Palkyungs like by selecting Palkyungs in a limited area. Furthermore, one Palkyung includes numerous place names at a time in some cases. Sixth, Sosangjeonhyeong(瀟湘典型)-style modern Palkyung uses 'NakAn(落雁)' as the name of Kyung. Sosangyusahyeong(瀟湘類似型)-style modern Palkyung expresses 'Hyojong(曉鐘)' and landscape of glow of the setting sun, sunset, night view, dawn, sunrise and depicts cloud, sunset, moon, and snow. There are many Myeongsocheheomhyeong(名所體驗型)-style Palkyungs exhibiting the behavior of tourism and Myeongseunghyeong(名勝型)-style Palkyungs raising the awareness only by the names of the places. Seventh, modern Palkyung's naming styles are diverse, such as using only four letters instead of specifying Kyungmul(景物) or Kyungsaek(景色) in combination with Chinese characters or adding modifiers specializing in places.