• 조명전기설비학회논문지
• /
• 제27권11호
• /
• pp.27-36
• /
• 2013

Islanding in a gird connected inverter of wind power generation system may influence a bad effect on equipments or yield safety hazards on grid so it should be detected rapidly and exactly. A passive method to detect islanding is comparatively simpler than an active method but suffers from non detection zone (NDZ). On the other hand, the active method can significantly reduce NDZ by injecting a disturbance into inverter output. To improve the reliability of islanding detection, this paper proposes a hybrid anti-islanding detection method combining the conventional passive method as well as the active method based on novel harmonic injection method using fourier transform. The proposed scheme is fast to detect islanding when NDZ does not exist because it has the nature of passive method. Under NDZ, the active method can detect occurrence of islanding reliably. The effectiveness and validity of the proposed scheme is proved through comparative simulations.

• 조명전기설비학회논문지
• /
• 제26권3호
• /
• pp.16-23
• /
• 2012

This paper relates to a study on the economic of electrical storage device for supplying power in sunless days, in the stand alone PV/Wind hybrid system, which it is applied to separate houses. In a photovoltaic/wind hybrid power system used in a separate house, when only the battery is used in sunless days, the capacity of the battery is become larger. For example, as in recent days, if cloudy days are frequent due to anomaly climate, it is difficult to supply power stably by only the battery based upon pre-estimated sunless days. Accordingly, in order to supply stably power of new renewable energy such as solar to any separate houses, it is preferable to reduce the capacity of battery by decreasing the number of sunless days when estimating the capacity of battery and to drive the small generator for compensation of the power shortage.

• 조명전기설비학회논문지
• /
• 제30권3호
• /
• pp.79-85
• /
• 2016

This paper analyzed the influence of wind power fluctuations in grid frequency of a stand-alone microgrid that is hybrid generation system with diesel generator, wind turbine, and Battery Energy Storage System (BESS). The existing island area power system consists of only diesel generators. So the grid frequency can be controllable from load change. But hybrid generation system with Renewable Energy Sources (RES) such as wind energy that has the intermittent output can bring power quality problems. BESS is one of the ways to improve the intermittent output of the RES. In this paper, we analyzed the role of BESS in a stand-alone microgrid. We designed a modelling of wind power system with squirrel-cage induction generator, diesel power system with synchronous generator, and BESS using transient analysis program PSCAD/EMTDC. And we analyzed the variation of the grid frequency according to the output of BESS.

• 조명전기설비학회논문지
• /
• 제28권5호
• /
• pp.60-67
• /
• 2014

Wind power is one of the fastest growing renewable energy sources. The blades length and tower height of wind turbine have been growing steadily in the last 10 years in order to increase the output amount of wind power energy. The amount of wind turbine energy is increased by increasing the capacity of wind turbine, but the costs of preventive, corrective and replacement maintenance are also increased accordingly. Recently, Condition Monitoring System that can repair the fault diagnose and repair of wind turbine in the real-time. However, these system have a problem that cannot predict and diagnose of the fault. In this paper, wind turbine predict methodology is proposed by using the SVM method. In the case study, correlation analysis between wind turbine fault and external environmental factors is performed by using the SVM method.

• 조명전기설비학회논문지
• /
• 제29권8호
• /
• pp.83-89
• /
• 2015

This study suggests the methodology to decide the number and adequate capacity of substation transformer in a large-scale offshore wind farm (OWF). The recent trend in transformer capacity of offshore substation is analyzed in many European offshore wind farm sites prior to entering the studies. In order to carry out the economic evaluation for the transformer capacity we present the cost models which consist of investment, operation, and expected energy not supplied (EENS) cost as well as the probabilistic wind power model of wind energy that combines the wind speed with wind turbine output characteristics for a exact calculation of energy loss cost. Economic assessment includes sensitivity analysis of parameters which could impact the 400-MW OWF: average wind speed, availability, discount rate, energy cost, and life-cycle.

• 조명전기설비학회논문지
• /
• 제27권3호
• /
• pp.65-78
• /
• 2013

To analyze influences under open fault conditions in switching devices, an integrated simulation and condition monitoring scheme for a permanent magnet synchronous generator (PMSG) based variable speed grid-connected wind turbine system are presented. Among various faults in power electronics components, the open fault in switching devices may arise when the switches are destructed by an accidental over current, or a fuse for short protection is blown out. Under such a faulty condition, the grid-side inverter as well as the generator-side converter does not operate normally, producing an increase of current harmonics, and a reduction in output and efficiency. As an effective way for a condition monitoring of generation system by online basis without requiring any diagnostic apparatus, the estimation schemes for generated voltage, flux linkage, and stator resistance are proposed and the validity of the proposed scheme is proved through comparative simulations.

• 전기학회논문지
• /
• 제58권7호
• /
• pp.1356-1362
• /
• 2009

IEC 61400-25(Communications for monitoring and control of wind power plants) is established as a international standard by IEC TC 88 in 2007 with the growth of the wind power industry. In this paper, MMS service which is defined in lEC 61400-25 part 4 is implemented, and the wind power generator is objectified by using the VMD of MMS service. We also implemented MMS communication system between the wind power generator and the local control center using the proposed VMD. The performance of the developed MMS communication system is verified through the XML based user interface on the web browser.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2009년도 춘계학술대회 논문집
• /
• pp.232-234
• /
• 2009

신재생에너지 보급 확산을 위해서 정부에서는 2009년부터 2030년까지의 시평을 가진 '제3차 신재생에너지 기술개발 및 이용 보급' 기본계획을 수립하고, 이의 달성을 위하여 예산투자와 함께 기술개발 지원, 보급 보조 및 융자, 발전차액지원제도, 그린홈 100만호 보급사업 등을 다각적으로 추진하고 있다. 이러한 보급지원제도의 하위제도로써의 융자지원제도는 신재생에너지 설치자 및 생산자를 대상으로 장기저리의 융자지원을 해주는 제도이다. 이를 통해 초기 투자비를 경감, 사업적 경제성을 확보하여 신재생에너지설비 및 관련 산업을 보급, 육성하고자 하는 것이다. 융자지원을 위한 금리는 기준금리(국고채 3년물 수익률)에 연동하여 분기별로 조정되고, 시설자금, 생산자금, 운전자금으로 분류하여 태양열, 태양광, 바이오, 폐기물, 수력, 지열, LFG, 풍력, 연료전지 등의 분야에 지원한다. 따라서 본 연구에서는 융자지원제도 현황을 고찰하고, 기준금리의 변동에 따른 융자지원 금리의 변동을 함께 살펴보았다. 각 에너지원별 지원에 어떠한 영향을 주는지 알아보았다.

• Journal of Welding and Joining
• /
• 제33권3호
• /
• pp.4-11
• /
• 2015

The offshore wind power plants are watched as a new market to accomplish the needed energy, bringing technical and economical challenges. Advanced countries in the field of wind industry are now appling the 600 MPa, 150~200 mm thick high strength steel to offshore wind power plants. Moreover, the high efficient welding methods which is weldable ultra tick high strength steel with 1 pass welding are developed and applied in manufacturing the offshore wind tower. This article deals with the present world wide status of offshore power plants and the tendency of the development of high efficient welding technology for constructing the offshore wind tower. This article intends to offer the materials for development and raising of the domestic offshore wind power technology.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 추계학술대회 논문집
• /
• pp.33-37
• /
• 2004

Photovoltaic energy and wind energy are highly dependent on the season, time and extremely intermittent energy sources. Because of these reasons, in view of the reliability the photovoltaic and the wind power generation system have many problems(energy conversion, energy storage, load control etc.) comparing with conventional power plant. In order to solve these existing problems, hybrid generation system composed of photovoltaic(500W) and wind power system(400W) was suggested But, hybrid generation system cannot always generate stable output due to the varying weather condition So, the auxiliary power compensation unit that uses elastic energy of spiral spring was added to hybrid generation system for the present study. It was partly confirmed that hybrid generation system was generated a stable outputs by spiral spring was continuously provided to load.