• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.12
• /
• pp.1308-1315
• /
• 2009

A full-polarimetric scatterometer(HPS: Hongik Polarimetric Scatterometer) for X-band is designed, fabricated, and verified using the theoretically well-known point-targets in this paper. The X-band full-polarimetric scatterometer consists of an OMT(Orthogonal-Mode Transducer)+horn antenna, the angle control part for the OMT+horn antenna, a transmitter/receiver with a network analyzer and a frequency-conversion circuitry, and a movable support of these parts. We use an inclinometer sensor to control the vertical and horizontal incidence angles. The full polarimetric data can be obtained because of the polarization switches and the OMT. The accuracy of the scatterometer system is verified by measuring the polarimetric RCS(Radar Cross Section) of one of the theoretically well-known point-targets, i.e., a corner reflector.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.4
• /
• pp.473-478
• /
• 2011

The extent of a rectangular conducting plane for measuring electromagnetic interference is discussed. Mutual coupling between the transmit and receive antennas is negligible, the effects of the ground plane on the normalized site attenuation(NSA) are considered by applying GTD(Geometric theory of diffraction). The calculation was done for the case that measuring distance(d) was 3 m for both horizontal and vertical polarizations. As the result, the size of the rectangular ground plane almost never affects upon NSA for horizontal polarization, but for vertical case, when both width and length of the rectangular plane are several times as long as distance, the effects of the edges are reduced under 1 dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.8A
• /
• pp.618-631
• /
• 2012

In this paper polarization adaptivity on transmit has been used to enhance the received signals directed to a pre-selected receiver in a near-field multi-input multi-output (MIMO) environment. The objective here is to select a set of weights on the transmitting antennas adapted to individual receivers based on the principles of reciprocity. Using the polarization properties, when the number of receiving antennas is greater than the number of transmitting antennas, the transmitted signal may be directed more to a particular receiver location while simultaneously minimizing the reception signal strength at other receivers. Numerical simulations have been made to illustrate the novelty of the proposed approach.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.6
• /
• pp.1287-1292
• /
• 2012

In this paper, a dual polarization patch antenna operates at the wide bandwidth of 1.525GHz~1.665GHz was designed and fabricated. To obtain the wide bandwidth and high gain, increased height of air floor from GND was applied, and to get wide band axial ratio and high gain, parasitic patch was applied. The simulation and measurement showed good agreements, the VSWR was less than 1.9 at the frequency bandwidth, the return loss was less than -10dB, and the LHCP(Left Hand Circular Polarization) and RHCP(Right Hand Circular Polarization) isolation was less than -13dB at the frequency bandwidth.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.3
• /
• pp.216-221
• /
• 2013

In this paper, wireless channel characteristics of massive MIMO system is analyzed by comparing angular spread, cross polarization discrimination(XPD) and delay spread of dual polarized 4 and 128 transmit array antenna systems, by using 3D rat-tracing simulator, Wireless Insite in microcell environments. The analysis shows that increasing the number of transmit antennas results in the smaller angular spread and delay spread, and the higher value of XPD.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.2
• /
• pp.127-134
• /
• 2015

In this paper, we propose 2.6 GHz single band dual polarization MIMO omni antenna for in-building applications. The proposed antenna operates at 2.6 GHz single LTE band, Up-link 2.52~2.54 GHz and Down-link 2.64~2.66 GHz. Horizontal and vertical polarizations of the antenna has been, respectively, constructed by the synthesis of four folded loop antennas and the folded monopole antenna. The height of the MIMO omni-directional antenna is minimized to be less than ${\lambda}/13.5$ from the ground. The measurement results show excellent MIMO omni antenna performance of 2.85 dBi vertical polarization gain, 2.29 dBi horizontal polarization gain, and 19.25 dB port isolation.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.2
• /
• pp.171-179
• /
• 2017

In this paper, microstrip antenna using multi-layer and folded structure for GPS application is presented for aircraft loading. Existing microstrip patch antenna used dielectric of high specific inductive capacity to miniaturize that cause smaller bandwidth and decline of efficiency due to dielectric loss. To compensate the existing flaws, Rogers TMM 10i(dielectric constant=9.8, loss tangent=0.002) is used for multi-layer dielectric miniaturization, and we construct folded radiating element on the surface of the dielectric applying perturbation effect. The antenna is designed in the bandwidth of GPS $L_1$ band, and the size of the antenna's radiating element is $20.3mm{\times}19.93mm$, and it gets 94.2% miniaturized characteristic of basic ${\lambda}/2$ microstrip patch antenna. Also the measured -10 dB bandwidth is 32.3 MHz(2.05%), 3 dB axial ratio bandwidth is 6.7 MHz(0.43%). Measured radiation patterns was maximum gain of 0.56 dBi at x axis polarization, 1.23 dBi at y axis polarization.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.10
• /
• pp.41-49
• /
• 2013

This paper suggests the dielectric resonator antenna using LTCC process for mm-wave car radar system. In this paper, dielectric resonator antennas (DRA) operated in 76-77 GHz frequency band are designed. And, using the LTCC process, the structures of dielectric resonator with SRR (split ring resonator) inside and those of dielectric resonator with probe inside are suggested. Linear polarization antennas and circular polarization antenna are designed for the DRA with probe inside. Three kinds of the DRA antennas are designed and their characteristics are calculated using CST RF simulation tool. The designed antennas are fabricated and measured and the measured results are compared with calculated results. The measured operating frequencies of DRAs are within 76 GHz to 77 GHz, which are close to the calculated results, and the measured gains are about 8.15 dBi to 10.82 dBi.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.7
• /
• pp.81-88
• /
• 2004

In case of mechanical down tilting, a horizontal pattern is distorted and beam width widens whenincreasing tilt angle, which causes an expansion of hand off region and burden base station equipment. In contrast, electrical down tilting has advantage that horizontal HPBW is kept constant with down tilting. In this paper, based on a phased array technology, dual polarized base station antenna with electrical down tilting was developed at 800MHz band. The antenna has down tilting range of 0$^{\circ}$ to 14$^{\circ}$, and 15㏈i gain. We use stacked microstrip patch as a radiated element and apply balanced feed technique to improve isolation between ports and discrimination of cross polarization. The effect of electrical down tilting was verified by field test.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.6
• /
• pp.1037-1044
• /
• 2021

In this paper, we propose DLP(Dual Linear Polarization) array antenna for 3.5 GHz band. The proposed antenna has 1×4 array antenna and design two port network. A cross shape is inserted at the bottom of the patch for impedance matching. The size of each patch antenna is 18.85 mm(W1)×18.85 mm(L1), array antenna is designed on the FR-4 substrate, which is 236.0 mm(W)×60.2 mm(L), thickness (h) 1.6 mm, and the dielectric constant is 4.3. From the fabrication and measurement results, bandwidths of 70 MHz (3.54 to 3.61 GHz) for input port 1, 75 MHz (3.55 to 3.625 GHz) for input port 2 are obtained on the basis of -10 dB return loss and transmission coefficient S21 is under the -20 dB. Also, cross polarization between two port obtained.