• Journal of the Korean Geotechnical Society
• /
• v.34 no.12
• /
• pp.115-131
• /
• 2018

Extension plate attached PHC piles and bolts spliced PHC piles were installed in field test site. Pile integrities were checked during installation with dynamic pile test and the actual pile conditions after installation were compared with integrity index (${\beta}$ index) by PDA test. Theoretically the break in near pile end or pile end (especially extension plate itself) was very difficult to access by integrity index (${\beta}$ index) and also require a high level of knowledge and field experience on PDA test. First actual wave equation of bolts spliced PHC piles due to bolts spliced equipment can be different with welding spliced. Second wave length of the stress wave from installing can be longer than the height of bolts spliced equipment (about 100 mm). Third Beta processing in PDA analysis function is very difficult to access without a high level of knowledge and field experience on wave equation. Above-mentioned three reasons can make conclusion that traditional PDA test in domestic site can not access the integrity of bolts spliced equipment in bolts spliced PHC piles.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.30 no.1B
• /
• pp.89-100
• /
• 2010

The performance evaluation of a conventional Wave Resonator at the entrance of harbors against solitary wave has been performed using 3D numerical wave flume. A wave resonator has been designed for the attenuation of the transmitted wave energy by trapping the short periodic incident waves only. In this study, however, the controlled performance of the wave resonator by its various widths has been numerically investigated for solitary waves. Source distribution method based on the Green function and the 3D one-field Model for immiscible TWO-Phase flows (TWOPM-3D) using 3D numerical wave flume were used for the short-periodic waves and the solitary waves, respectively, and these models were verified through the comparisons with the previous experimental and numerical results by other researchers. It was confirmed that the wave resonator is effective enough to control the solitary waves as well as the periodic waves when it compares with the case of no resonance system. Further, it was found that there is the optimal width of a wave resonator to attenuate the target solitary waves.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.1
• /
• pp.235-241
• /
• 2013

This article examines the Internet fandom culture of YouTube and Facebook and Twitter for Korea Wave Fandom. This article the principle of shared network connection and re-mediated and looked at in terms of the spread and the value passed. Useful field of view which korea wave look forward to continue to release and Challenges. At the same time, Korea wave fandom optimized to analyze and understand the fundamental principles of the SNS, the new media and the spread of the wave, the need arises. Korea Wave fandom connection value granted, through the process of tracking. Watch for them through the propagation and spread of Korean culture and virtuous principles. Korea Wave fandom research this article in the future for fandom korea wave and dig into the more fundamental principles of deductive help understand expected.

• Broadcasting and Media Magazine
• /
• v.16 no.4
• /
• pp.31-45
• /
• 2011

사용자가 원하는 3D 사운드 혹은 소리의 공간감을 원하는 대로 재현할 수 있는 오디오 시스템은 오랜 기간 동안 인류가 가지고 싶었던 꿈의 기계였다. 그러나 과연 개인 혹은 사용자가 원하는 3D 사운드라는 것이 무엇이며 어떻게 정의하여야 하는지는 명확하지 않다. 이것은 매우 주관적인 개념일 뿐만 아니라 개인에 따라 다를 수 있으며, 그 평가에 대한 객관적인 방법 또한 존재하지 않는다. 관련된 연구를 살펴보면, 원하는 소리의 파동 전파 자체를 시공간 상에서 물리적으로 재현하는 WFS(Wave Field Synthesis)나 Ambisonics, 또는 머리전달함수(HRTF: Head Related Transfer Function)를 기반으로 한 많은 연구들이 있다. 이렇게 재현된 음장(sound field)을 보면 이들이 인지되고 평가되는 등의 객관화를 위하여는 청취 환경에 따라 그 특성이 바뀌고 동일한 환경에서도 청취자에 따라 다르게 인지되는 근본적인 문제점을 가지고 있다. 음장 재현 방법의 이러한 근본적인 문제는 놀랍게도 과거의 스테레오 시스템에서 볼 수 있는 밸런스 노브(balance knob)로부터 그 해결의 실마리를 찾을 수 있다. 밸런스 노브는 보편적인 최적의 소리를 찾는 대신에 청취자가 원하는 음향 효과를 얻을 때까지 직접적으로 소리를 청취하고, 스스로 조절하여 평가할 수 있는 매개체의 역할을 수행한다. 만일 밸런스 노브와 같이 청취자가 원하는 3D 사운드를 스스로 평가하고 조절하기 위한 방법을 마련할 수 있다면? 즉, 청취자가 시공간적으로 원하는 3D 사운드를 실시간으로 청취하고 변화시킬 수 있는 인터페이스를 구현할 수 있다면? 과연 그러한 것이 어떻게 가능할 수 있는지 체계적인 검토가 이루어질 수 있다면 매우 좋을 것이다. 본 고는 이러한 것을 가능케 할 수 있는 즉, 청취자가 자유 자재로 원하는 음장을 형성할 수 있는 렌더링 기법 및 즉각적인 피드백이 가능한 인터페이스를 소개하고 있다. 인터페이스는 현재까지 오디오 시스템에서 주로 사용되는 주파수 이퀄라이져(frequency equalizer)와 매우 유사한 특징이 있다. 이러한 점을 감안하여 "Spatial Equalizer$^{(R)}$"라는 이름을 붙여 보았다. Spatial Equalizer$^{(R)}$는 공간 상에 하나의 점 또는 다수의 점으로 표시되는 가상 음원을 사용자가 조종하여 원 소리의 공간감을 제어할 수 있도록 구성되어 있다. 공간 상에 다수의 점 음원들의 위치를 변화시키거나 크기를 변화시킴으로써 청취자가 원하는 공간감을 구현할 수 있도록 하고 있다. 중요한 것은 종전의 이퀄라이져와 같이 Spatial Equalizer$^{(R)}$에 의해 형성되는 음장이 어떤 객관적인 척도에 의해서 평가되는 대신 사용자에 의해 직접 주관적으로 평가되고, 선택된다는 점이다.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.15 no.3
• /
• pp.159-166
• /
• 2003

In this study, we develop a finite element model to directly solve the Laplace equation while keeping the same computational efficiency as the models based on the extended mild-slope equation which has been widely used for calculation of wave transformation in shallow water. For this, the computational domain is discretized into finite elements with a single layer in the vertical direction. The velocity potential in the element is then expressed in terms of the potentials at the nodes located at water surface, and the Galerkin method is used to construct the numerical model. A common shape function is adopted in horizontal direction, and the cosine hyperbolic function in vertical direction, which describes the vertical behavior of progressive waves. The model was developed for vertical two-dimensional problems. In order to verify the developed model, it is applied to vertical two-dimensional problems of wave reflection and transmission. It is shown that the present finite element model is comparable to the models based on extended mild-slope equations in both computational efficiency and accuracy.

• The Journal of the Acoustical Society of Korea
• /
• v.18 no.2
• /
• pp.32-39
• /
• 1999

In this paper, the characteristics of the ray tracing method (RTM) based on the cylindrical wave are discussed for the high frequency vibration analysis of two-dimensional structures. A ray tube describing the emanating cylindrical wave is used to derive the governing equation for incident reflected, and transmitted ray tubes which satisfies the condition at the coupled boundary. The suggested ray model is applied to panel array structures, and the predicted results for 2-panel, 3-panel, and 4-panel array structures are compared to those by Statistical energy analysis (SEA) and Wave intensity analysis(WIA). More enhanced prediction was obtained compared to the SEA, and similar prediction performance was observed to the WIA. Additionally, the RTM has a novel feature that it can estimate the spatially smoothed distribution of vibration energy and vibration intensity. It is expected that the present RTM can be used as one of the useful tools for the high frequency vibration analysis of two-dimensional coupled structures.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.7 no.3
• /
• pp.223-228
• /
• 1987

An efficient method for the calculation of wave forces on a tension leg platform(TLP) is presented in this paper. It is based on the Morison's equation with two corrective terms. One is the reduction of the inertia forces on the vertical columns in order to include the wave diffraction effect particularly for small wave conditions. The other is the inclusion of the hydrodynamic forces acting at the bottoms of the columns. Numerical studies are carried out for a TLP in 1000 ft water with two different wave heading angles($0^{\circ}$ and $45^{\circ}$). The reponse amplitude operators(RAO's) for the TLP motions and top tether tension variations are obtained by the present method and the theoretically more accurate method based on the diffraction theory. A comparison has been made between the results obtained by two methods.

• Korean Journal of Optics and Photonics
• /
• v.28 no.6
• /
• pp.334-338
• /
• 2017

This research aims at investigating science teachers' perception of the refractive index of materials, and thus achieving proper information transmission and teaching of refractive index. Specifically, we have made questionnaires on what physical factors influence the refractive index of a liquid easily available in secondary schools. It was found that 80.0% of science teachers perceived that the density has the greatest influence on the refractive index, among a variety of factors such as molecular structure, the number of molecules per unit volume, mass of each molecule, and the wavelength of light, to mention just a few. This may be due to the fact that current textbooks deal with the refraction of light based on analogy to a mechanical wave. Such a misunderstanding may lead to confusion and misunderstanding for students.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2011.10a
• /
• pp.821-832
• /
• 2011

Recently, the noise of vehicle is the one of the key factors for customers to purchase a vehicle and the most important part which is related to the noise is the exhaust system. Thus, car makers have their own ways to assess this exhaust noise not only to decrease the level of noise but to enhance the feeling of it. Typically, to do these things in the early stage of development, the tuning code of the exhaust system has to be made by CAE tool, which is very reliable but expensive, and the prototype parts of this code would be made for the validation test. Then this process can be iterated to meet the target of the performance. In this study, a new algorithm which adapts the '3 dimensional convective sound wave theory 'and 'Doppler effect' has been developed. With this new algorithm, a brand new system for the calculation of tail pipe noise has been developed and validated by acoustic wind tunnel test. As a result of this study, various comparisons and have been carried out, for example, the comparison with other CAE tool has been performed for the validity and the improvement of the new calculation code could be achieved.

• Journal of Biomedical Engineering Research
• /
• v.16 no.4
• /
• pp.525-532
• /
• 1995

In this paper, a new try to measure nonlinear propagation characteristics of the pulse along blood vessel by using bispectral analysis is introduced, and the possibility of its application to the medical diagnosis is shown. In this method, the waveforms of pulse motion of blood vessel at two separated measuring points on the wall were detected from Doppler frequency modulation of transmitted probing ultrasonic waves. Then the auto- and crossbispectrum of detected waveforms are calculated to estimate the quadratic NTF (nonlinear transfer function) between the two measuring positions. In order to show relationships between the NTF and the nonlinear propagation characteristics, computer simulations have been performed. As the propagation distance increases, harmonic frequency components in NTF increases broadly due to the nonlinear effect in the propagation of blood pulse. In order to represent this phenomena quantitatively, we propose a new parameter, dispersion ratio of WTF. Basic experimental system was constructed by using 3.5MHz probing ultrasonic waves and the preliminary experiments were carried out on ague phantom and human body. Experimental results showed the validity of the measurement system enoughly.