• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.2
• /
• pp.98-105
• /
• 2005

This paper presents the result of the aeroelastic stability test of the small-scaled hingeless hub system with composite paddle blades in hover and forward flight conditions. Excitation tests of hingeless hub system installed in GSRTS(General Small-scale Rotor Test System) at KARI(Korea Aerospace Research Institute) were carried out to get lead-lag damping ratio of blades with flexures as hub flexure. MBA(Moving Block Analysis) technique was used for the estimation of lead-lag damping ratio. First, blades with metal flexures, then with composite flexures of the same dynamic properties of rotor system as metal one were tested. Tests were done on the ground and in the wind tunnel according to the test conditions of hover and forward flight, respectively. Composite flexures were found to have better damping characteristics over metal ones in the non-rotating vibration test, and it was confirmed that the use of composite flexures would give observable improvement in aeroelastic stability compared to metal ones in all test conditions.

• The Journal of Engineering Geology
• /
• v.8 no.1
• /
• pp.25-34
• /
• 1998

It is not easy to understand exact soil properties, because soil is nonhomogeneous and anisotropic. There are raany inefficient cases in aspect of time and economy in site survey. So this study tried to analyze the correlation of cone resistance and seismic velocity in order to present an efficient method in ground investigation. A cone penetrometer is frequently used to investigate soil properties, which are especially fit to investigate coastal soft ground. A portable cone penetrometer was used in this research. A portable cone penetrometer has an advantage in investigating the state of soil swiftly and is convenient to manipulate. Also, seismic prospecting is one of the most PoPular methods among geophysical prospecting methods in the estimation of ground properties and its usage is continuously increasing in the survey of soft ground Cone resistance makes a regular group according to stratum in each depth. The results of seismic prospecting show a tendency to have a certain coherence according to the boundary of straturft Therefore, cone resistance and seisrnic prospecting have considerable relations that rnay irnprnve the efficiency of ground investigation.

• Journal of the Microelectronics and Packaging Society
• /
• v.26 no.4
• /
• pp.55-62
• /
• 2019

Stiffness-gradient stretchable electronic packages of the soft PDMS/hard PDMS/FPCB structure were processed using the polydimethylsiloxane (PDMS) as the base substrate and the more stiff flexible printed circuit board (FPCB) as the island substrate. The elastic characteristics of the stretchable packages were estimated and their long-term reliabilities on stretching cycles and bending cycles were characterized. With 0.28 MPa, 1.74 MPa, and 1.85 GPa as the elastic moduli of the soft PDMS, hard PDMS, and FPCB, respectively, the effective elastic modulus of the soft PDMS/hard PDMS/FPCB package was estimated as 0.6 MPa. The resistance of the stretchable packages varied for 2.8~4.3% with stretching cycles ranging at 0~0.3 strain up to 15,000 cycles and for 0.9~1.5% with 15,000 bending cycles at a bending radius of 25 mm.

• Tunnel and Underground Space
• /
• v.18 no.4
• /
• pp.252-262
• /
• 2008

In the uniaxial compressive test of a single specimen of transversely isotropic rock, its 5 independent elastic constants can not be defined since maximum 4 independent strain measurements are available theoretically. In order to solve this problem, one equation proposed by Saint Venant in 19C and confirmed by Lekhnitskii through the test experiences has been used for long time. Accordign to authors' experiences, however, this equation turned out to give erroneous elastic constants in some cases. Three new equations are suggested and their compatibilities are discussed in this paper. As the results of the analyses of the models, Lekhnitskii's suggested equation is effective for the specimen with the high dip angle whereas it results in the large erred output for that with dip angle less than $25{\sim}30$. It was found that the effectivenesses of three suggested equations and their compatibilities are subject to the dip angle and not to the amounts of elastic constants. Guide map to the selection of the compatible one of those suggested equations is presented as a result of the study.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.32 no.5
• /
• pp.484-493
• /
• 2012

Since the 1980s, there have been many research activities devoted to quantitatively characterizing and imaging human tissues based on sound speed, attenuation coefficient, density, nonlinear B/A parameter, etc., but those efforts have not yet reached the stage of commercialization. However, a new imaging technology termed elastography, which was proposed in the early 1980s, has recently been implemented in commercial clinical ultrasound scanners, and is now being used to diagnose prostates, breasts, thyroids, livers, blood vessels, etc., more quantitatively as a complementary adjunct modality to the conventional B-mode imaging. The purpose of this article is to introduce and review various elastographic algorithms for use in quasistatic or static compression type elasticity imaging modes. Most of the algorithms are based on the crosscorrelation or autocorrelation function methods, and the fundamental difference is that the time shift is estimated by changing the lag variable in the former, while it is directly obtained from the phase shift at a fixed lag in the latter.

• Elastomers and Composites
• /
• v.45 no.4
• /
• pp.309-315
• /
• 2010

The CIIR blends, which is use for shoes outsole, with SSBR, XNBR and KBR were prepared with various mixing ratio. The viscoelastic properties of these blends, such as tensile modulus, rebound resilience, storage modulus, tan${\delta}$, and creep properties were measured. In the rebound resilience measurement, KBR showed the highest value, which means the lowest energy absorption to stress. As SSBR, XNBR and KBR blends with CIIR, the rebound resilience of the mixtures showed tendency to increase in arithmetic average. In the creep measurement, CIIR showed the highest visconse strain to stress, SSBR and KBR showed lower visconse strain. Maximum tan${\delta}$ peak of CIIR, SSBR and XNBR appeared at $-30^{\circ}C$, $5^{\circ}C$ and $0^{\circ}C$ respectively.

• Journal of the Korean Geotechnical Society
• /
• v.35 no.7
• /
• pp.41-50
• /
• 2019

Gyeongju bentonite is a buffer material primarily considered in Korea and it is highly compacted as a part of an engineered barrier system (EBS) of high-level radioactive waste repository. The compacted bentonite undergoes swelling stress by groundwater penetration and thermal stress by decay heat from a canister. Therefore, the mechanical properties of the compacted bentonite buffer material is crucial for the performance assessment of EBS. This paper aims to evaluate deformation properties of Gyeongju compacted bentonite using seismic methods. Two sets of compacted bentonite specimens were prepared having dry densities of $1.59g/cm^3$ and $1.75g/cm^3$ with water contents of 10.6% and 8.7%. Free-free resonant column tests were performed to measure constrained and unconstrained compression wave velocities. With the measured wave velocities, Young's modulus ($E_{max}$) and constrained modulus ($M_{max}$), material damping ratio ($D_{min}$), and Poisson's ratio at small strain were determined. As results, this paper evaluates the deformation properties of Gyeongju compacted bentonite and compares them with the results of previous researches.

• Geophysics and Geophysical Exploration
• /
• v.16 no.3
• /
• pp.163-170
• /
• 2013

The amplitude variation with offset of seismic data can detect fluids in the sediment and resolve the petrophysical properties of hydrocarbons in the subsurface. We analyzed and described the amplitude variation in deep sea seismic data obtained from the Ulleung Basin, East Sea. By inspecting seismic CDP-offset and CDP-angle gathers which show a bright reflection event, we decided a target zone for amplitude variation analysis. From the seismic angle gather at the middle of Ulleung Basin, we recognized amplitude increase or decrease versus offset on the intercept-gradient curve. Using the product attribute and Poisson's ratio change attribute computed in terms of intercept with gradient, the top and the base of gas saturated sediments were described. The area of amplitude variation suggestive of the presence of gas saturated sediments is shown at the depth of 3 s traveltime. Anomalous features of seismic amplitude in the Ulleung Basin were classified by the crossplot of intercept and gradient. The background trend of crossplot between intercept and gradient shows an inverse proportional relation that is common for wet sediments. Anomalous amplitudes of Class III fall into the first and the third quadrants on crossplots. We inferred regional gas/water saturated area with the horizontal dimension of 150 m in the Ulleung Basin by cross-section with respect to cross-plot anomaly.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.6 no.2
• /
• pp.103-113
• /
• 2001

This study presents Quaternary sedimentation pattern around Dok-Island volcanoes (Dok Island and Dok Seamount), based on analysis of high-resolution (chirp) echo characters. Echo facies If, showing sharp, continuous bottom echo without subbottom reflectors, is recorded mainly from the flat tops of the volcanoes. This facies indicates sands and gravels (re) deposited by shallow marine processes. Echo facies IIA in the basin floor and basal slopes of the volcanoes and Oki Bank is characterized by semi-prolonged bottom and several parallel subbottom echoes. This facies reflects hemipelagic settling with intermittent influences of turbidity currents in the slope areas. Echo facies IIC is recorded from acoustically-transparent debrite masses on the basal slopes of the volcanoes and Oki Bank. Echo facies IIIA is characterized by irregular hyperbolic echoes in the slope areas of the volcanoes. It suggests hard rock basement or irregular volcanic edifices. Echo facies IIIC shows regularly-overlapping hyperbolic bottom echoes. It is interpreted to represent rock-fall deposits (talus) accumulated in the mid-slope area. Echo characters and topography suggest that the tops of Dok-Island volcanoes were flattened and lowered by shallow-marine erosional processes. The eroded sediments were transported to and deposited in the base of slope and basin plain mainly by debris flows and turbidity currents along submarine canyons and valleys.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.3 no.2 s.9
• /
• pp.89-97
• /
• 2003

Indirect tensile strength(IDT) test and resilient modulus(Mr) test were performed to evaluate experimental performance characteristics for the conventional and crumb rubber-modified(CRM) asphalt concrete using dry and wet processes asphalt. The IDT test was conducted under three temperatures(5, 10, 20$^{\circ}C$). According to the test results, it was shown that indirect tensile strength of CRM asphalt concrete was lower than that of the conventional one. However, toughness and maximum vortical strain of the CRM asphalt concrete were higher than those of the conventional one. The results of Mr test were presented that Mr of CRM asphalt concrete was higher than that of the conventional one. In addition, it was revealed that the overall laboratory performance characteristics of the wet-processed CRM asphalt concrete was better than those of the dry-processed one.