• Journal of the Korean GEO-environmental Society
• /
• v.18 no.12
• /
• pp.13-23
• /
• 2017

This paper discusses about the reinforcement materials and construction method in order to cope with roadbed settlement in operating railway. In Korea, concrete tracks have been introduced to urban railways, high-speed railways, and general railways, but some recently constructed concrete tracks have experienced roadbed settlements. Reinforcement of the railway roadbed is urgent task for safe operation of railway, but it is difficult to reinforce the roadbed and there are no case history of reinforcing railway roadbed under an operating railroad track. Therefore, in this study, the target performance level for roadbed reinforcement was determined, and infiltration and solidity injection efficiency were investigated for selected reinforcement materials. As a result of the study, it was found that the generally used reinforcement materials and methods for geotechnical works need to be improved for applying in railway roadbed reinforcement.

• Magazine of RCR
• /
• v.16 no.1
• /
• pp.30-34
• /
• 2021

• Journal of the Korean Society for Railway
• /
• v.14 no.3
• /
• pp.256-261
• /
• 2011

Recently a limited section of trackbed with ballast at KTX railway were reported to have settled down and led to problems such as reduced speed and passenger discomfort. Therefore, an urgent remedy for the settled trackbed is required to recover normal operation of KTX trains. In this paper, a new technique is proposed to visualize the elastic modulus of cross sections at railway trackbeds under ballast for practical identification of potential settlement. The proposed technique is based on ICSW technique, enabling use of impact source and overcoming inherent limitations of CSW method. To verify validity and feasibility of the proposed method, the method was employed to construct cross-sectional images of elastic modulus of two railway trackbeds and compared with other tests such as SASW, PBT, DCP and portable FWD tests.

• Journal of the Korean Society for Railway
• /
• v.16 no.1
• /
• pp.40-46
• /
• 2013

Based on Korean railway design standards, the thicknesses of the reinforced roadbeds of conventional and high speed railways are different, and so too, for the size distribution of the ballast particles. Accordingly, considerable cost would be required to increase operating speeds of conventional lines, in particular related to changing from a ballasted track system to a ballastless one. In this study, applicability of a roadbed which supports conventional ballasted track, for use as a ballastless track for a high speed rail line was examined. A reinforced roadbed for a conventional railway is 20cm thick, and the type of material used for a conventional reinforced roadbed is M-40 (crushed gravel for road embankments). A dynamics test was conducted to evaluate the occurrence of the permanent settlement of the track substructure. These results suggest that, without changes to the track substructure, an operational speed of 400km/h is feasible with a ballastless track. This result; however, is from laboratory experiments. Further studies, such as numerical analyses or field validation, are required.

• Journal of the Korean Society for Railway
• /
• v.12 no.6
• /
• pp.835-843
• /
• 2009

Recently the more stable roadbed is required due to the high speed and design load. Therefore the reinforced roadbed was introduced as the solution. But the thickness and stiffness of reinforced roadbed in design code is being conservatively assessed by the foreign code without considering the domestic construction condition. In this paper, adequate Young's modulus, drain capacity, freezing depth, economical efficiency, bearing capacity, construction condition and 3-D finite element method were employed to determine the proper thickness of reinforced roadbed at the embankment section.

• Journal of the Korean Society for Railway
• /
• v.11 no.1
• /
• pp.54-60
• /
• 2008

In the trackbed design using elastic multilayer model, the stress-dependent resilient modulus $(E_R)$ is an important input parameter, that is, reflects substructure performance under repeated traffic loading. However, the evaluation method for resilient modulus using repeated loading triaxial test is not fully developed for practical purpose, because of costly equipment and the significantly fluctuated values depending on the testing equipment and laboratory personnel. The this study, the paper will present an indirect method to estimate the resilient modulus using dynamic properties. The resilient modulus of crushed stone, which is the typical material of sub-ballast, was calculated with the measured dynamic properties and the range of stress level of the sub-ballast, and approximated with the power model combined with bulk and deviatoric stresses. The resilient modulus of coarse grained material decreases with increasing deviatoric stress at a confining pressure, and increases with increasing bulk stress. Sandy soil (SM classified from Unified Soil Classification System) of subgrade was also evaluated and best fitted with the power model of deviatoric stress only.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.2
• /
• pp.255-265
• /
• 2003

A series of laboratory tests were performed to evaluate engineering properties of geobag system which is used for urgent restoration of the collapsed roadbed. In this study, the suitable geobag size was proposed as 44cm wide and 66cm long, and the suitable filling ratio of geobag was also proposed as 80% through the static loading tests. Also a series of model tests were carried out to investigate the characteristics of the engineering behavior and the distribution of earth pressure of the geobag roadbed under static and dynamic loading.

• Proceedings of the Korean Society of Disaster Information Conference
• /
• 2017.11a
• /
• pp.239-240
• /
• 2017

철도노반 현장의 저성토구간의 연약지반구간에 대하여, 성토높이 3m 이내인 저성토구간의 경우 열차하중에 따른 연약지반의 처리를 어떻게 하는 것이 향후 재난발생을 예방할 수 있는지에 대하여 설계기준 원문을 대상으로 적용방법에 대한 분석을 실시하였다.

• Journal of the Korean Geosynthetics Society
• /
• v.1 no.1
• /
• pp.23-29
• /
• 2002

Since 1980's in U.S.A and Japan, the studies on increasing the bearing capacity of railway roadbed using geocell system have been conducted for repair and reinforcement of railways constructed on soft soils. In this study, the railway roadbed reinforced with geocell system, used for repair and reinforcement of existing railways in Korea, has been analyzed and investigated the results of the previous studies conducted in Korea and other nations. And the method for estimating the railway roadbed thickness was developed based on the equivalent method using the multi-layer theory and the deformation modulus Ev.

• Journal of the Korean Society for Railway
• /
• v.18 no.4
• /
• pp.354-362
• /
• 2015

Since allowable settlement of concrete slab track is about 30mm, a lot of attention must be paid to the settlement of the earthwork (reinforced trackbed, upper subgrade, under subgrade) under the concrete track. To this end, more experimental data should be accumulated through tests for these materials. In this study, we evaluate the long-term settlement of reinforced trackbed and subgrade materials using factors such as repeated loading conditions, water content, and grain size distributions in a large triaxial test and a large oedometer test. In cases in which the performance of the reinforced trackbed layer meets the design criteria, the settlement caused by train load was considerably small. But, when the water content increases in the subgrade, unexpectedly large settlement might occur for certain grain size distributions of the subgrade materials.